I have just purchased a 2005 elantra fx and noticed a vibration all the time in the steering and you can feel it in the seat on the floor and peddles, not severe but enough to be annoying. I had the same vibration in my last car a 2001 elantra. Is this normal with these cars, or could it be something like engine mounts as there is a very very slight clunk on acceleration ?
View 2 RepliesI have driven my Hyundai for 79,880 miles. I brought it new in 2005. I had the front brakes replaced and afterwards felt a vibration through the gas pedal, steering wheel and seat. Both driver side and passenger sides had the vibration. You can feel the vibration at any speed. Sometimes it feels as if there is a part spinning unbalanced and bumping against something.
I replaced both front wheel bearings, both CV joints, and both front struts. These were all the original parts and they were all in need of replacement. The struts were so bad that they had no gas to resist a simple push at one end. I had all four tires high speed balanced.
I lifted the front end and stepped on the gas to get the tires going. I did it at high speed and my friend tells me he could hear a rattling of what he thinks are steel ball bearings coming from the drivers side of the automatic transmission. He thinks that there may be a bad bearing(s) in the transmission. I simply don't know. What the cause of the vibration might be? Could my warranty cover the repair?
Have a slight clunk noise inside the back of their gen 2? I've taken apart all the paneling used foam tape to secure things and took apart the spare tire area etc and the clunk persists. It seems to vary intensity every time I close the rear hatch. I now suspect this thingy I found mounted in the center of the rear hatch under the plastic...
View 6 RepliesMy 2010 Prius with 140000km has developed a vibration noticeable anywhere from 50-80 km/hr when in slight acceleration (just over 1/2 on the green bars) with the ICE running. Dropping the throttle or hard acceleration makes it disappear completely - which tells me it's driveline related. It feels like its coming from the passenger side, particularly rear, but it's definitely getting worse and I can now feel it in the driver's door panel so it's becoming a major concern.
My first thought (due to the location) was a bad muffler but it's not any louder. I'm starting to worry it may be a transaxle bearing. I can't see it being a cv joint as there's no noises when cornering and everything underneath looked OK at a recent oil change. I love this car (what Prius owner doesn't?) and I sure can't afford to replace it. It's been babied since day one.
2014 Camry, 4 cyl. 65K ... Wife's car has developed a vibration that is going to be hard to get a dealership service group to troubleshoot due to randomness. I drove it for 30-45 mins today and have this description:
-Vibration, either described as a 'buzz' or a 'high frequency vibration'
-Happens in the 28-38mph range (different points)
-Under very slight acceleration. (hard acceleration efforts produce nothing)
-Can't swear to it, but feel like it is always in 'high' gear
-feel it in 'seat of pants', NOT through the steering wheel
-Is faint on sound, but you can hear something
-Is typically only a second or two
-Is very hard to 'create', but then happens unexpectedly.
-My wife first reported it to me, and I took my son on the test drive today and he could feel it as well when it hit, but couldn't pinpoint it as it comes and goes so quickly, but again, you feel it in the seat/butt more than anywhere else.
I've checked lug nuts to try to eliminate something easy and they are fine.
Since it is relatively slow speeds and under very slight acceleration, can there be a 'solenoid' that is creating a false shift effort, but just vibrates the trans instead? Without any info other than what I have stated above, I'm leaning toward transmission, but again, probably not enough info to go on....
I just bought a 2008 Elantra SE with 26K miles. So far, I've really enjoyed it, except for, at times, it does vibrate somewhat during idle.
I took it to the nearest Hyundai dealer, and they clipped the throttle cables to the inside of the firewall. This did make some improvement, but I still feel vibration during idle when the engine is warm (doesn't seem to as long as RPMs are up). It's almost as if the idle is set a little too low.
Maybe this is just normal vibration? It's not too bad, just noticeable. Can idle in these cars be adjusted? It seems the car is too new to have clogged fuel injectors. Everything else about driving it feels great, acceleration, etc. Do you think using a higher octane gas would work?
I posted a while back about my 04 5.4 having an issue at idle. I did all the normal things like replace coil, spark plug, etc etc. No change to the issue. It still acts as though it's misfiring on a cylinder and I get codes P0306 and P0316. Finally took it to ford and had a diagnostic check ran. Everything on the top end was in working order. The tech even put a known working coil on 6 and nothing changed. I was told that it's either an intake or valve issue on that cylinder. But no definite answer to problem.
Fast forward to yesterday. I got a wild hair at lunch and went out and started truck. Pulled injector plug off of 6. No change to the way it was running. I did the same for 5, 7, 8, 1, and 2. All of which made a big difference in the way it ran. It was obviously misfiring with no fuel to cylinder. This gave me the idea to swap 5 and 6 when I got home to see if the issue followed the injector from 6. I did NOT. I pulled the plug on 5 and got the obvious change in the way it ran. So there is definitely something going on at cylinder 6 that I cannot figure out.
PCM, bad intake, bad valve? I'm not rich so a trip to ford for repair is gonna have to wait. Truck seems to run fine when driving except for slight hesitation during acceleration.
Lately I've noticed a momentary clunk or vibration in the steering column when turning the steering wheel while leaving a parking spot. It's not the same as hitting the end points of the steering range. It feels like some looseness in the coupling of the steering column.
It seems to happen when maneuvering in a parking lot, like after backing out of a parking space and then straightening out the wheels to go forward. It is random when it happens, only a couple of times a week so far. Should I take this in to be checked?
So I just developed a slight vibration in the steering wheel and the floor last week. It happens when I drive with my foot barely on the gas or coasting. If I punch it, the vibration goes away. Also, if I punch it from a stop and take my foot off the pedal I can hear a knock as the car lurches starting to decelerate and its only one knock. I thought it might be the driver side strut bushing because I recently replaced the passenger side but not the driver. So today I replaced the driver but that did not solve the problem. I have fairly new tires all around. I am not sure if it is tie rods or cv joints. All my boots on the cvs look good. What to check. Oh maybe also motor/trans mounts???
View 5 RepliesSo I've been lowered on Neuspeed Sports and Koni Yellows for the past week now. I've noticed that when driving at about 60 mph or more on the highway I occasionally get a slight vibration from the steering wheel. It doesn't always happen and I do not know if it is partly due to the road surface. it does not seem so.
Is this just because I have lowered the car and have not yet gotten an alignment done? I'm waiting a few weeks for the suspension to settle before I do that. It does look like my front camber is off a bit, but it's hard to tell for sure. I haven't had this happen before, and it doesn't happen continuously. Will an alignment remedy this?
I've had my 2013 Hyundai for about a week now and I feel a slight vibration/shaking when the car is stopped and I have my foot on the brake. When I was in the finance office signing all the papers, etc. The finance manager was trying to sell me the free oil changes for 3 years/tire rotations/filter change for $600. He was adamant that if I do not get all my service done by Hyundai dealer all the warranties are voided. I asked him specifically this question at least 3 times as I was appalled at the notion, and time and time again he would say the second you bring it somewhere else for an oil change the warranty is voided. 5 days later I brought the vehicle back to get my sticker, and I asked the guy at service, he said absolutely not. He said it doesn't matter as long as you have the proof/receipts.
View 18 Replies02 Camry XLE, I just changed both front rotors and pads (raybestos professional grade and akebono pro act pads). The hubs were pretty clean and I spayed brake cleaner and wiped them, washed the rotors with soap to remove any grease, lubed the pins etc...
I have not had a chance to bed-in the new pads/rotors. I am driving and braking slow/easy last 2 days. Now, I get a slight vibration felt in the steering and driver floor pan area around 70, 75 mph. (NOT when braking, just cruising.) I don't recall having this with old rotors.
Are these signs that the rotor is defective/out of balance themselves? I did go to discount tire and got my tires re-balanced, it's somewhat better... but not perfect.
I have a 05 Touareg V6. When coming to a stop (when speed reaches 5 mph or less) there is a slight vibration felt in the steering wheel. What causes this? What can I do to correct this? (I had new rotors and brakes put on about 2K miles ago.
View 1 RepliesSo sometimes (only sometimes, of course) when I step on the brakes, I get a slight vibration of the steering wheel. Doesn't seem to make a difference if it's gentle or not-so-gentle braking. Brakes cold or warm doesn't make a difference either. Nor does traveling in a straight line or not at that moment.
My understanding is that "warped" brake rotors are mostly a myth these days, especially for our beefy/hefty rotors. The car did not used to do this.
Rotors are "OEM slotted" from ECS, pads are Porterfield R4-S. All are well within tolerances. I know it's not an out-of-balance wheel, because wheels were swapped front to back not too long ago and there was no change.
So what else ought I check out? Tie rods/ends? Ball joints? I don't know all that much about this aspect of stuff..
Light rattle/clunk in the steering column when going over bumps or sawing the wheel back and forth?
Lately I'm getting the sound inside the car. It feels like a loose bushing or something.
I have just over 11K miles on my 2011 and now notice steering wheel vibration & slight shake at 70 mph. The passenger can also feel it.
View 14 RepliesI'm not sure if this is normal, but I have noticed a slight vibration in the steering wheel. This happens when the engine is completely warmed up and If I'm sitting at a complete stop in drive (no air conditioning, seat warmers, or headlights on) it happens. It is not a vibration where the idle goes up and down. The rpm gauge shows that it is between a consistent 550-600 rpms. When the headlights or air is on, the idle goes to around 700-750 and the steering wheel vibrations go away. I do not have any cel on and I know the car is not miss firing. I think it's just because the low idle.
View 9 RepliesThe last couple thousand of miles I have spent fighting vibrations (especially in steering wheel. Symptoms: When you hit the 65mph mark I am getting slight vibration in the steering wheel. Also passenger chair start shaking substantially more. I assume the shaking is of the whole car, but I feel it the most through the wheel and probably where my brain focuses on.
So far to correct the problem:
- Dealer replaced couple tires which showed excessive weight (the truck came with Michelin HP)
- Wheels were scratched through not careful person, so they have replaced them with a set from a demo
- Dealer balanced wheels 3+ times and done alignment
- Problem was not going away, so I have decided to try different tires and have bough new Michelin MS2
- Discount Tire has done several wheel balances, but seemed that it worked for a day or so
- Meantime also bolts holding lug nuts broke three times while tightening them (don't know if the same one but at three different occasions). Supposedly they have used spec pressure of 80lbs (83 Lexus recommended)
Dealer concentrates on wheel balancing, and is not taking action outside of this. I told the dealer that the problem cannot be wheel related. I think the cause could be one of the three (previous GX470 issues found on internet):
- Wheel bearing in the hub issue
- Drive shaft
- Transmission excluded as vibs are in all gears
- something with steering.
I am awaiting a call from the dealer when the FTS person will at the dealer again so he can trouble shoot the car.
It feels like I am having a front bearing issue, when turning the steering wheel to the right I feel a slight vibration in the steering, need to know which one is going out,??? I have already replaced the passenger side twice It just seems to not tighten completely as I can still move the tire slightly while up on a jack...
View 12 RepliesOver the past month or so my wife and i have noticed a slight vibration or? I don't really know how to best describe it other than a feeling. The truck has developed this feeling thru the steering wheel and pedals. The best way i can describe it is like a bearing going bad?
It is full time awd and I am assuming it is an awd issue. The truck has about 60,000 miles on it. It can be felt at all speeds. I rotated the tires with no change. My next step would be to go thru the front end, ball joints, tie rod ends, etc. But I really don't think the issue is in the steering. the truck drives straight and no steering vibration.
Took delivery of my 2015 GTI a few weeks ago. Overall the car is great, but I have a feeling the tires that came with it just plain suck. They are Pirelli P7 Cinturato A/S. According to Tire Rack, these are grand touring tires?! Not exactly what I'd expect to be put on a GTI. Anyway, I've noticed that at almost exactly between 60mph-70mph there is a "whine" sound coming from them, also just the slightest vibration in the steering wheel. At every other speed they are relatively quiet and the wheel is absolutely dead solid, no vibration. Could these tires just be of relatively poor quality? Should I have them put on a balancing machine to see if everything checks out? I'm assuming these were balanced on a Road Force machine at the factory since that is the OEM for VW/Audi, but I'm not 100% sure obviously.
View 16 Replies