Elantra XD (2001-06) :: Starting After 5 - 10 Minutes Of Cranking / Shifting Into And Out Of Gear
Aug 31, 2010
2002 elantra gls 125k miles, Automatic
I have a very intermittent problem starting the vehicle first thing in the morning ( this has happened twice this week, but only 5-6 times in the past year or so). It will crank and sound as if it just about to start, but not quite fire. After 5-10 mins of cranking, shifting into and out of gear, rocking vehicle (not sure what actually causes it to start, if anything) the car fires and runs just fine, starting normally until the next "event".
Plugged it in and got no codes.. The only difference I can see is that every time this has happened recently the car has been parked in a parking garage at work on a minor incline for about 13 hours.
View 5 Replies
Advertisement
My 2006 Elantra (54,000 miles) shifts really, really hard when it's not cold and passes through the 35 mph range -- hard enough to make you glad you've got your seatbelt on. I've taken it to my regular mechanic and now it's in an automatic transmission shop.
My mechanic changed the fluid (twice), and took it through a "learning sequence". The fluid didn't look that bad and he reported that there were no codes to work with. He thinks I'm going to have to get a new transmission.
The AT shop has confirmed that there are no codes to work with and that the problem begins at 143 degrees. They tell me that the transmission is shifting into a higher gear without releasing the lower gear. They tried replacing a couple of solenoids, but that yielded no change in behavior. Now, they're telling me they "think" I need a new computer. I'm just afraid the trial & error approach is going to cost me a boat-load.
View 1 Replies
I bought my 2005 automatic 4 speed Elantra knowing of this problem and feeling good about being able to track it down. how ever This did not stand to be the case. Start up cold shifts through every gear smooth as silk with know slippage or harsh shifts. roughly 10 to 15 mins after the car reaches operating temp on the gauge it begins to slam into 3rd gear only. Most of the time it is a double slam. Like bam bam real fast but indeed does shift into the 3rd gear then into over drive smoothly. I can duplicate it any time i desire to by merely pulling it back into 2nd gear and manually pushing the shifter back up to 3rd. it will slam every time with out fail. The man i bought it from told me he had this trouble and changed the transmission out with a 500.00 used one and did the exact same thing...
So I felt must be electrical wiring or TCM bad but upon examination i found no codes present to date. he threw parts at it and replaced both input and output sensors based off some thing he read on the net. also he said he replaced the TPS with a TPS from a wrecked car, still same harsh shift. he however could not remember how the fluid looked upon changing it and the filter as he also did that, nor can he remember what fluid type he used. I know shot in the dark right??? What is the actually fix such a hard slam when shifting into 3rd.
View 3 Replies
I have a 2001 Elantra gls which I bought a year ago. It had shifting problems from 2nd to 3rd gear with CEL on. I replaced the input and output speed sensors and connectors and fixed the problem to a point. It was still shifting a little hard even after a fluid change with SP111. I added 2 bottles of Lubeguard red and it has worked immensely almost to the point of no problems....except. At slow speed shifting like going into a store parking lot or on a freeway with stop and go traffic, it will shift hard from 2nd to 3rd (I think) maybe 1st to 2nd not sure. If accelerating at normal speed shifts fine. No cel and the tranny fluid is on the full mark, not overfilled. Would a wheel speed senso cause this or damaged clutch pacs maybe?.
View 4 Replies
After car warms and while driving trans moves to 3rd gear and stays ??
View 2 Replies
O.K. first of all I had an issue with the Odometer pointer being jumpy. Sometimes it wouldn't move. Now I replaced the input sensor at first and did not fix the problem. I replaced the output sensor and fixed it. "BUT", Now, I have a problem with the transmission shifting. I get an engine light while driving and the 2nd gear seems to take its time shifting and when it does it make the left side drive shaft kick in hard and spends my wheel to a screeching effect. Plus a thump on the transmission. I rechecked the sensor for connection and reinstalled. Drove the car still have the same issue?
View 2 Replies
Having a problem with the engine cranking over a few times before actually starting. This only happens after the car has been sitting over night. Thought maybe it was a bad battery, but it has been replaced in the last few months.
When I turn the key to start, it tries to fire for up to 3 seconds before actually starting. This only happens on the first start of the day, after that it starts quickly with no problems.
View 2 Replies
I've only had the car a month, and it's happened maybe three times now. I turn the key, and it takes twice as long as usual to start, about 5 full seconds of the engine cranking before it ignites. I think each time was after I had driven the car an hour or two before (when I'm heading home after an outing). Most of the time, the car starts fine. What's going on?
View 11 Replies
Several weeks ago I made another thread because I was having crankshaft position sensor problems and essentially that was due to a short on the sensors wires which had become exposed. I replaced the sensor and it still did not work until later trying another brand which solved the problem.
I also changed all six spark plugs, wires, and plenum gasket with OEM parts. I was able to get to the back three plugs by following this tutorial with the guidance of a friend who is a mechanic. After getting this done, the car has run way better and smoother.
However, today it has been raining heavily and I needed to run an errand so I went to my car and turned the key but nothing happened. All the dash lights turned on and appeared normal. My radio works, lights work, etc; but I can not get the car to crank at all. I hear the fuel pump turn on and everything else sounds normal, but still no crank. There are no sounds from the starter at all, it is silent when I try to get the car to turn over.
I took a look at the car and the coil pack seems dry, the plug wires are secure, plus we had put di-electric grease on all those connections. The negative terminal on the battery has a solid connection. I even tried jumping the car to see if maybe it was due to the battery, but again nothing happened.
This has only happened once before when it was raining, before I had changed the plugs and wires, but I was able to get it to crank over after about 4 minutes of waiting and contemplating getting a tow. I took a look at all the fuses and they appear to be intact.
View 11 Replies
2002 GTi 337 not shifting out of 1st until is warmed up for 20 min. Then shifts fine. I've already attempted to add the "liquid gold" G-052-990-A2 ATF fluid from VW at $35qt. I put in about 200ML to no change, then another 200ML to no change. So from reading other posts in VWvortex I've seen many folks with the Jetta have had very similar symptoms. They are installing a new (Solenoid valve N92 (green) to fix this issue. Many of them are even using over the counter synthetic ATF. Before I dig in, just wanted to know what folks with the GTi 337 think about this? Am I dealing with basically the same transmission?
View 2 Replies
Tis the first of "Squeaks and Creeks" from me. Not really the best thing to hear, sitting at ~24K miles. Anyways, until (if) i can get a sound clip, I have this metallic rattle that only occurs about 1-3 mins after i start the car. This just started happening yesterday, and nothing out of the ordinary happened.
I start the engine, hear a raspy rattle from what sounds like under the engine, and if i give it some throttle it increases some, but not to the point where it sounds like something is banging around. It goes away after a few minutes so it could be anything. Shifts are still smooth, driving and getting on the gas does not fix nor make it worse, either in neutral or actually rolling. It simply goes away with 3 minutes time or so. It seems to have a limit for how much 'rattle' it gives off, and its something I can accept.
View 4 Replies
My ABS light and brake light come on within a few minutes of starting in gear. The brakes work fine and the brake shop says that the system is working fine, but I can't get the dang warning lights to turn off.
I've read online that it might be the sender mounted on the rear differential of my 2005 Jeep Liberty.
View 3 Replies
When I try to turn on the car it cranks and seems like it is about to start but just keeps cranking. I have put dry gas, shoot starter fluid up the air filter and tried jumping it. I have managed to get it started but dies a second later. Not sure what to do, someone told me that it might be the fuel filter.
View 2 Replies
I have two 2009 stick Focus SE 4drs (one for me and one for the Mrs.) Both are PZEV. Mine, with 66k runs great; hers, with 43k talks back when under initial load. When starting up from a stop or up shifting in any gear we get a snorting or knock in the 1000 -1500 rpm range. Once above 1500 rpm all is quiet. The funny thing is that if it is raining out, the noise does not occur. The car is also an absolute dog on any hill, putting the pedal to the floor does absolutely nothing (no knock, either) Having an identical car myself, and not experiencing these two things, I would guess that something is amiss. What might be the cause?
View 2 Replies
So I recently bought a Hyundai Elantra Gt 2003 that I totally love. But ever since I bought it, it struggles to turn on. It makes a cranking noise before it turns on, and it takes about 2 to 3 times for it to fully turn on. I changed the crank shaft sensor and the fuel pump. What can it be?
View 1 Replies
1993 Transport 3.8 L
Starting out from stop it seemed to get noisy and was very late shifting to 2nd. Slowed down and tried again; this time it did not want to shift to 2nd at all. Brought it home slowly.
Trans fluid was right up. I did another road test, running it manually through the gears so I could easily hear and feels the shifting. 1-2-D-OD perfect; did this twice of thrice. Starting out from stop on the highway a couple times, it shifted up perfectly. I did some kick-downs and manual shifting; everything is working fine.
Could this have been a linkage problem? Could running it manually through all the gears smarted up the linkage or something? Could it be related to the 'modulator valve'?
View 4 Replies
I recently bought my GL less than a week ago with under 10km on it. Its been great so far but I noticed a weird movement when shifting into 3rd gear (both up and downshifting). It started happening about 2 days into driving the car.
As I shift into third gear I feel a little kickback against the forward motion. It doesn't happen all the time and it doesn't seem to be dependent on the car speed or the speed of my actual shifting. Although it happens a lot more when I shift quickly into third.
I've been told that 3rd and 5th gears are the longest and I might just need to get something adjusted at the dealership.
This kickback doesn't happen on any other gear except third (MAYBE I felt it a little on 5th but I may have been searching for it after being told about 3rd and 5th gear being long).
View 24 Replies
My Hyundai Elantra 2014 SE makes a cool psst sound when shifting to 2nd gear (haven't tested next gears). It makes me feel like I have a Turbo! The sound is very low, tho. It only happens when i accelerate the car hard. Anyway, i don't think this is normal.
View 9 Replies
I hear a knock once in a while when starting my 2004 2.7 V6 Santa Fe and sometimes when shifting gears. I also hear it when going over rough rough, bumps, tracks etc... I'm thinking motor mounts 152k on the car.
My question would be how many mounts are there, exactly? I've seen three, but maybe another two for the transmission.
The front mount has some separation, but can't tell the others, as I haven't gone under the car with a flashlight just yet.
The majority of the knock seems to come from the driver's side. not sure if that narrows it down at all.
View 5 Replies
I bought a 2010 Elantra Blue in November. It has 1200 miles on it now, but as early as the 2nd week or so I became aware that there is occasionally resistance shifting into 2nd gear despite the clutch being fully depressed. It can also make a slight "crunching" noise after passing through the neutral position and fully into 2nd (though this sound is distinct from grinding, it's not the same as if you were grinding the gears). I've tried a million times to narrow down the cause (i.e. cold weather, low RPM shifting, high RPM shifting, slow shifting, fast shifting, gentle shifting, strong shifting) but every time I think I got it, and have corrected it, it happens again anyways.
View 13 Replies
I have a 2001 Elantra GLS. The tranny shifts smooth. At around 40mph, it wants to shift into what I guess is overdrive. At that speed it is like it can't figure out where it wants to be and will down and upshift. Aside from that the tranny has no other problems.
View 5 Replies
