2001 has no power from fuse 1 to switch. Hazards work, not sure about reverse lights. No gear indicator light on dash. I've changed this switch before, plug and play. Not this time.
View 4 RepliesI have a 2001 f150 4x4 with the 4.6 Triton motor, the front axle is not pulling in when I switch the selector on the dash, I know the transfer case is switching so that part is ok. I know there are 2 solenoids on the fire wall, my question is which one is which ? every store I call says one has the nub at 9 o' clock and one at 6 o' clock which one of these does the front axle, don't want to order the wrong one ? I checked the vacuum and the blue line going to the axle always has vacuum and as I read the diagram the blue line is 2 wd and the red line is 4 wd so is the 2wd solenoid stuck and preventing the 4wd one from pulling in or is the 4wd one bad ?
View 4 RepliesThe switch for turning overdrive off that's located on the auto trans shifter stopped working. I've taken off the column cover to see if the wires have been severed from the tilt wheel, but nothing wrong there. I also checked the fuses, and all is well. Is it possible that the switch is bad at the end of the shifter, or somewhere farther down the column?
View 14 RepliesCar Make/Model: 2001 Hyundai Elantra
So, in order to access the parking garage at work, free of charge, I MUST swipe my ID badge upon entering and exiting. That requires lowering my driver window (front left window) and extending my hand out. So, I pressed the switch downward to roll the window down, and I heard a small pop or click and all the sudden the switch was stuck in the downward position and my window would just roll all the way down. I would flick it upward, the window goes up, but then it retakes its downward position. I have to apply my window lock to keep it upward and sometimes I have to hold the switch up and immediately turn my car off to keep the window from rolling back down.
The window rolls up and down like it normally would. There is no slowness or delay.....the motion still seems pretty smooth.
Questions:
What are the possible problems and solutions?
How much to fix it, if I choose to?
My friend has a 2005 Tdi touareg (WVGZZZ7LZ5D053023). The low range indicator in the instrument cluster keeps on popping, the low range and high range indicator in the center console near the gear shift lever keeps on blinking at the same time. Driving the touareg was really slow, and the low and high range still keeps on blinking. There is no MIL appearing on the instrument cluster but scanning with VAG COM reveals this fault code below. I tried erasing the fault code but it keeps on coming back after a few seconds.
VCDS Version: Release 805.1
Data version: 20081223
Thursday,15,January,2009,14:30:13:39739
Chassis Type: 7L - VW Touareg
Scan: 01 02 03 05 06 08 09 11 13 15 16 17 18 19 1C 22 29 32 34 36
37 39 3C 46 47 55 56 57 64 65 68 69 6C 6D 6E 75 76 77
VIN: WVGZZZ7LZ5D053023 Mileage: 38400km/23860miles
-------------------------------------------------------------------------------
Address 22: AWD Labels: None
Part No: 0AD 927 755 AJ
Component: TRANSFERCASE 0100
Shop #: WSC 00000 000 00000
1 Fault Found:
00532 - Supply Voltage B+
002 - Lower Limit Exceeded - Intermittent
2005 Chevy Trailblazer. Whenever the temperature goes below freezing, the 4x4 selector switch does not work. After the car warms up (10 min), I need to turn it off and then restart it in order for the switch to work. I tried changing the selctor switch, that did not work. Is there some sort of solenoid or actuator that is freezing up?
View 2 RepliesI am needing to replace the selector switch for my 4x4 on my 2003 F150 Lariat FX4... I already have the new switch. Whats the best way to get in there to remove and replace the switch?
View 7 Replies2002 F150 XL... My heat & AC work fine, but the only position the fan selector switch will actually blow any air is on high. Bought an OEM replacement switch and installed it but the issue still exists.
View 4 RepliesMy selector switch does not light up when engaging four wheel drive on my 98 f150,could this be my GEM module gone bad ?
View 6 RepliesHow do you replace the reverse light switch on a 2002 Hyundai Elantra manual transmition?
View 3 RepliesMy Excursion is having an issue with the 4x4 system. The. 4x4 selector switch on dash lights up properly for 4x4, but the auto hubs don't actually engage. The hubs will lock only if I manually lock the hubs. I can hear relay click, so I don't think its electrical. The hubs had new o rings installed when I did front ball joints a few thousand miles ago, and the 4x4 worked fine up until today.
View 5 RepliesI have a windstar 1998 model got into it not reversing was told range switch faulty because its drives and parks. Had that replaced still not reversing though reverse light comes on.
View 5 RepliesThere is a medium sounding clicking coming from the gear selector area. I understand this must be the mechanism that prevents you from accidentally going into reverse when you are driving. However, the sound really is irritating and the car did not used to do this. I have taken it to the dealer, which states it is normal and there is nothing to fix. I have been doing some research online and it appears an easy fix is to just grease it back up. It appears over time the grease comes off or something. That being said, how do I get the initial gray plate off? (see picture)
View 6 RepliesJust got my 2013 Elantra Limited last weekend. It appears the car is having some issues with the transmission shifter. I am not sure if its tranny related, but I highly suspect it is. Dealer gave me the usual bs not being able to duplicate the symptoms.
1. Intermittently, gear selector would get stuck in neutral, when I try to put the car into P, after a long or a short drive.
2. I would have to wiggle the shifter to get into P, or I would have to shift to D, and then I am able to shift back into P.
The other evening, I noticed the fan speed selector button was no longer illuminated. I am assuming a bulb burned out. Can I get access to this bulb to replace it, and how? I know not to touch that T-shaped dash piece.
View 3 RepliesI have a 2001 Ford Excursion with the 5.4 and auto trans. I don't know for sure what specific tranny is in it but I do know what I want to do. I really like the pistol grip style shifters that a 2004 ish F-150 has and I wanted to make that conversion in my Excursion. Is it possible? Are the trannys the same to where I can switch out the gear selectors? And also how would I even do it?
View 7 RepliesAre there any 2008 Elantra drivers out there who have a problem with hesitation and dragging at the 35-40 mph range (3rd into 4th gears)? I'm told by the dealer that although there is a hesitation which he noticed as well after driving it, there is nothing that can be done until Hyundai issues a "fix." Learned my lesson here and will probably not purchase another Hyundai. My 2003 Elantra was a better ride.
View 3 RepliesIsn't the park gear selector indicators suppose to me illuminated when you turn on the lights, mine aren't. Why?? stick shift between seats on floor.
View 5 RepliesI have a 2001 Sport Trac. I was hooking up my boat, and went to put it into "R" and heard something that sounded like plastic break. Then, the gear selector seemed to move freely between all the gears. I know it is a pretty vague question, but what part do I ask for to repair it. Or more importantly, HOW do I repair it?
View 1 RepliesSo when I first got my car, the dealer had put in a full tank of gas and the miles to empty range was at 347~. After several fill ups since my purchase, the miles to empty has been dropping every time I filled up. A few fill ups ago, I remember it was 327. The latest fill up was about 318. What gives? Do the current MPG avg affect this number? What is the factor for the variance?
View 17 RepliesLast couple months, I've started to have some major vibration in the front end when reaching the 60-70 mph range. Some minor vibration in the 55-60 and 70-75 ranges, but primarily (and worse) in the 60-70 range. It only happens when I'm pressing the gas for more acceleration (particularly when I gun it), not when I'm coasting in that range. I had the tires balanced a month or so ago, so I know it's not that.
View 1 Replies