Elantra XD (2001-06) :: Idles Really High For A While After Start
Feb 14, 2013
So, among other things my 06 Limited is acting a little weird when I start it up. If it's cold, as in hasn't run in a few hours, not so much temp, it idles really high for a while. I wait for it to come down under 1000 before rolling out. It makes a funny noise too. Sort of a tick-tick-tick with a little whine behind it. What it could be? How much it'd be to get it fixed? I'm past my 100,000, 107,000 to be exact. Of course the issues pop up after the warranty is up!
View 3 Replies
Advertisement
2001 elantra has been revving really high on cold starts, RPMs will stay at over 3000 till u switch it into drive or reverse, Never happens when engine is warm, had intake cleaned out, did not solve issue...
View 5 Replies
2002 Elantra idles high, 2.5 rpm, just when I start it up in the morning. The second I put brake on and put it into gear, it settles down and doesn't do it again until the next morning.
View 3 Replies
I have an 01 elantra that idles erratic while in park. Also when i remove plug wires from the number one and three cylinders it will smooth out which doesn't seem to make sense to me because they are being fired from different coils, but if i pull two or four it continues to rev. Could this be a timing issue, I have been told that it could be the IAC as well as the cruise control module, what was it?
View 1 Replies
I've read a lot on hear but can't seem to find what I need. I just replaced one of the battery cells. Now when I drive for about 20 min the engine idles high and the energy read out stops charging the hybrid battery. The AC recirculation turns off on its own. I have a few codes. the O2 sensor and cat code. The p3006. I had one cell that i didn't replace that was reading 6.9 volts. I thought that it would charge back up on its own. We went of vacation for 2 weeks and the car didn't get driven. I found out that's not good for an older prius.
View 5 Replies
I have a 05 Hyundai Elantra 2.0L engine(Manual) thats been acting funny. There's a couple issues im having with it.
1. Not matter how far the gas pedal pushed down RPMs wont go over 2,500
2. Car surges and jumps back and fourth sometimes.
3. Idles around 900rpm
4. Sometimes when I take off I'm able to get around 40 mph, and thats where it tops out at.
5. Shifting into 1st gear feels a little spongy
6. Also it can go all the way into 4th gear without dying and the top speed will only be at 10mph
Things I've done so far.
1. Compression test cylinders all came back fine
2. Replaced TPS
3. Checked to make sure exhaust wasn't obstructed
4. I got a stethoscope and listened for the ticking for the fuel injectors and also got some fuel injector cleaner.
View 18 Replies
Elantra has set for a couple months. Wife totaled her other car so is gonna start driving this again. Well any ways wen the car sets and idles it starts to overheat. When driving it never gets hot. New thermostat and fluids...
View 5 Replies
I got my first truck about a months ago 2001 ford f150 v8 5.4.. has 155,000 seems to run good.. but about 3 days ago i started to notice that when I am in my driveway ill start it let it idle for say a min or so... then when I go to put it in reverse it will idle up for a lil bit.. it didn't do that till about 3-4 days ago.. other them that everything is fine.. should i get the transmission fluid flushed??
View 7 Replies
I now have a 1991 ranger 3.0 super cab. I need a step by step walkthrough of how to time it. Keep in mind that I ha the distributor out while turning the engine over so I need from start to finish, including the spout connector. It runs right now but idles high at the start and the. Stumbles down to about 500rpm and sometimes dies....
View 12 Replies
A minor but persistent (year-long) rough idle on my 1991 240 has quickly turned into a Cold Start Nightmare over the past month:
SITTING HOURS OVERNIGHT (50 to 60-degree temp. overnight) - When I attempt to start in the morning, the engine idles high for 3-5 seconds and then immediately dies. To successfully start, I must keep pressing the accelerator pedal at least half-way down for 2-3 minutes. The engine sputters, almost backfires, shakes, lopes, almost dies, etc. After 2-3 minutes, everything runs just fine.
WARM ENGINE SITTING - Once the engine is warmed up, it will consistently start without problems. Still a slightly rough idle, but OK. The car does not die.
I have changed the battery, coolant temp. sensor, and spark plug wires.
View 3 Replies
I have a 2001 Ford Escape XLT V6 4X4. About 3 months ago I started to experience rough idle in the morning. It went a away for a month or so, but it is back now. I noticed that it occurs primarily after the vehicle has sat for long periods of time. More than 10 hours, give or take, and it happens, less than 10 and it generally doesn't. When the issue does occur it sometimes almost stalls. I can tell the computer attempts to make up for it usually. The check engine light came on originally but hasn't since, a mechanic could not pull any code and could not reproduce. The issue disappears within 3 to 5 minutes usually after everything seems to warm up. I'm had regular maintenance and I am an 75k. I've even tried using gas additives and tried a high grade of gasoline to no avail.
View 17 Replies
I have a elantra xd 2006 in which I feel wind noise on high speed. I have separated the mirrors and tested and there was no wind noise. What should I do? How can I find any information about aerodynamic of mirrors?
View 4 Replies
I replaced my battery. Once I connected my new battery, my fuel and temperature gauge started working strangely. They would either be high, then go low, then go back high. My interior lights, clock, and radio stopped working. Could it be a relay? I checked all the fuses with a test light and they all looked good.
View 1 Replies
I had some problems with my Elantra and I fixed (or tried to) them all this weekend. I needed a new IAC motor, the motor was reving up and down and I tested it, then changed it. I needed a fuel injector and changed that. I needed a lower thermostat housing and changed that.
These changes resulted in the following problems. The vehicle now revs at a high idle all the time at approximately 3000. What are the causes of this?
I know that when I was burping the coolant system (changing out all the hoses and the thermostat housing) I got antifreeze sprayed all over the top of the motor.
Here is the problems that I have now. Didn't have these before.....
The engine idles at or about 3000 rpm. Constant from startup until shutdown. It idles down when you shift it into gear but that is because of the strain on the motor with the brake used.
The transmission is now having problems shifting from 1st to 2nd. I checked the fluid, its good. There is however antifreeze on top of the transmission by some sensors. Do these sensors have anything to do with the shifting?
View 11 Replies
I purchased a used 2005 Elantra two weeks ago. In the last two days, it began spraying oil at high RPMs. The oil pools on top of the transaxle (driver-side engine compartment), and down the front of the engine onto the exhaust manifold, giving burning smell and smoke. Trying to find where it was coming from, I cleaned everything thoroughly, but I can't locate the leak/spray. If I drive under 3500 RPM, no oil sprays or accumulates. Over that, it does. Oil filter was tight (first thing I checked), can't find any obviously loose fittings or bolts. Where this may be coming from, or should I just bite the bullet and go to the dealer for diagnosis?
View 12 Replies
So my 2005 elantra gls has been having overheating problems. A few weeks ago, it overheated one day driving around town for about 30 minutes. I kicked on the heater and made it home. I went out the next day and didn't see any problems. Everything went fine for two weeks, then yesterday the problem happened again. I read about the thermostat often failing, so I did some research on that and replaced it today.
For replacing the thermostat, I followed the lower hose and found the housing, removed it and took out the old thermostat. Removed the old gasket, cleaned around the connection, dried it off. Then I put the new thermostat in , put some gasket sealer down and putthe new gasket on. Finally, put some more sealer on the outside of the gasket and put the housing back on.
After replacing it and immediately turning on the car, I got a High Oil Temp code. I cleared the code and let the car idle for while. After about 15 minutes I went for a drive around the neighborhood and then took it out on the highway for about 10 minutes. It started overheating by the time I got home. I turned it off and when starting it again I get the High Oil Temp code.
Is it possible that I didn't do something correctly with the thermostat. If not, what else could I look for and could I have bumped/damaged the oil temp sensor?
View 2 Replies
I have a 2002 Elantra GT, is consuming 22 miles per gallon, one of these days the car was alarmed with a check engine, the mechanic checks to see if he had a loose wire, then removed the battery, put it on again and check engine disappeared. Following this, the car is doing 30 miles per gallon. After 5 hours the alarm appeared again, we scan the car and gave the code P0420. These days the car has been decreasing again the miles per gallon.
I bought the car with 186.000 miles but the person who sold me the car said he had 68.000 miles, the board was stolen and damaged something, then had to buy a Yonker the board and that board came with the mileage, is this possible?
What is suggested to improve the fuel consumption?
It is possible to know how much mileage the car has traveled in reality?
With so many miles traveled, which recommended preventive maintenance?
This error code says that the catalyst has to be replaced but can also be a leak or may be some of the oxygen sensors.
View 9 Replies
When the car is cold & first started, the high pitch noise by the fuel injectors is the loudest. When it warms up the noise is reduced quit a bit.
I thought maybe the fuel injector O-rings are bad, but the car idles and runs fine ( no error codes). Maybe the intake manifold gasket, but the car idles and runs fine. It is a weird noise.
View 1 Replies
I'm experiencing some TPS failure symptoms and high fuel consumption.... I've unplugged the ecu harness to measure the voltages, measured a constant 6v on the return signal wire while it should be about 0v. While the input voltage is normal 5v. A strange reading as well is that signal reading with both battery terminals is 6v!!
Would this be a short on the ecu cable or is it a corrupted ECU? Also today I had tough hesitation in the morning while the engine was cold, after warm up it was normal! Is this related or its idle sensor?! ( Plugs and their cables are new)...
View 7 Replies
My friend was having trouble with her 2001 elantra. Her idle was erratic and her RPMs were constantly high. we checked every where for a vacuum leak but could not find one in any of the lines. We went on to switch out the idle air control valve, the throttle position sensor, and even cleaned out her throttle body. we threw up our hands and sent it to a shop. Come to find out there WAS a vacuum leak. apparently in the air idle control valve sensor there is a gasket that seemed to be missing. I of course didn't think about replacing a gasket when I replaced the sensor because I never saw one there.
View 1 Replies
So my mom recently bought a 2003 Elantra (75K miles, auto trans) and within a few days the CEL came on. She took it in to PepBoys and had them hook it to their scanner to get the codes out of it. The only code that came up was P0113 Intake Air Temp (IAT) Sensor high input. I've done a little research on the net but there is a lot of random info for this code out there. Is the IAT a separate sensor or is it combined in with the Mass Air Flow (MAF) sensor(if this car even has a MAF) or combined in with the MAP sensor? I've read on the net that it could be any of these 3, I think it's combined into the MAP.
I've also read that this code could be caused by a bad IAT, bad O2 sensor, an exhaust leak, bad wiring/ground(I checked the wiring/grounds visually and everything seems ok) or many other things. If it's as simple as replacing one of the sensors I can do that myself, I just don't want to go randomly buying things and either it be the wrong part or have it be the right part but not fix the problem. The car runs great, even with the CEL on. Yesterday when she stopped by my house I disconnected the battery for a couple minutes and reconnected it, started the car & no CEL. She drove the car for about 125-150 miles before the light came back on.
View 10 Replies
