Elantra XD (2001-06) :: High Fuel Consumption And Preventive Maintenance
Oct 24, 2011
I have a 2002 Elantra GT, is consuming 22 miles per gallon, one of these days the car was alarmed with a check engine, the mechanic checks to see if he had a loose wire, then removed the battery, put it on again and check engine disappeared. Following this, the car is doing 30 miles per gallon. After 5 hours the alarm appeared again, we scan the car and gave the code P0420. These days the car has been decreasing again the miles per gallon.
I bought the car with 186.000 miles but the person who sold me the car said he had 68.000 miles, the board was stolen and damaged something, then had to buy a Yonker the board and that board came with the mileage, is this possible?
What is suggested to improve the fuel consumption?
It is possible to know how much mileage the car has traveled in reality?
With so many miles traveled, which recommended preventive maintenance?
This error code says that the catalyst has to be replaced but can also be a leak or may be some of the oxygen sensors.
View 9 Replies
Advertisement
I'm experiencing some TPS failure symptoms and high fuel consumption.... I've unplugged the ecu harness to measure the voltages, measured a constant 6v on the return signal wire while it should be about 0v. While the input voltage is normal 5v. A strange reading as well is that signal reading with both battery terminals is 6v!!
Would this be a short on the ecu cable or is it a corrupted ECU? Also today I had tough hesitation in the morning while the engine was cold, after warm up it was normal! Is this related or its idle sensor?! ( Plugs and their cables are new)...
View 7 Replies
It's great on gas below 2200 rpm. Averaging 34 combined. However whenever I'm in a situation where I need to accelerate, such as beat the yellow light, up a hill, or pass someone and I shift to a lower gear I lose 1-2 MPG at the drop of a dime. And then it takes forever to recover. What is going on here? Is the engine being flooded with fuel?
View 28 Replies
When I go out to do errands around town (I live right in town) I get horrendous gas mileage. Now, I understand gas mileage is high at the beginning of a trip, but for this long and this high and under these circumstances? I'm getting ABOVE 10l/100km when I have 80% charge available (for americans, that's disgustingly high MPG like, pick-up truck high), AND my foot is completely off the gas. Literally, coasting, or braking, and I'm still sucking up gas. What the heck?
Is this just because it takes a certain amount of time for the engine to run no matter what or something? I still don't see any reason for me to be eating up all that gas when my foot isn't even on the gas AND most importantly, I have charge available. Feels pointless for me to use my car for what I use it for 70% of the time, which is for quick errands around town at low speeds. Thought the prius was suppose to be a superstar for this kind of thing.
View 6 Replies
I replace all my spark plugs but my car still has no power and its eating gas like crazy.
View 3 Replies
My hyundai accent 2004 consumes fuel but does not bring out black smoke, what can i do?
View 15 Replies
I replaced my battery. Once I connected my new battery, my fuel and temperature gauge started working strangely. They would either be high, then go low, then go back high. My interior lights, clock, and radio stopped working. Could it be a relay? I checked all the fuses with a test light and they all looked good.
View 1 Replies
Just bought a 2012 Prius Three last Friday. The MFD (upper display) shows an average of about 53 mpg so far, and the corresponding 1 & 5 min bars seem to make sense (we have an 07 TCH so we're reasonably familiar).
But the Display Audio unit (6.1 inch) Car>Consumption graph seems to show 100mpg most of the time/most bars. That can't be right and it looks nothing like the MFD display. What am I missing?
View 1 Replies
When the car is cold & first started, the high pitch noise by the fuel injectors is the loudest. When it warms up the noise is reduced quit a bit.
I thought maybe the fuel injector O-rings are bad, but the car idles and runs fine ( no error codes). Maybe the intake manifold gasket, but the car idles and runs fine. It is a weird noise.
View 1 Replies
Regarding my problem (outline below):
>> Went for a refueling stop, and thereafter proceeded onto the highway
>> Approx. 500m into the drive onto the highway the car started jerking and running rough with an initial puff of smoke (none thereafter)
>> Immediately after this initial jerking/shuddering there was a significant increase in fuel consumption i.e. from a familiar 8.2L/100km to 18L/100km in the cruise
>> We continued driving not knowing what it was (I suspected a spark plug may have stopped working)
>> Pulled up at the gas station to observe what went wrong inside the engine bay - no signs of any leaks, fuel sprays, etc. but only that the engine was shaking
>> I checked the rear of the car while the car was idling and observed a pulsating sound...some light smoke and a fuel-rich egg-like smell
>> Asked around and I was led to think the catalytic converter was ruined, so the next day I had the catalytic converter cut out
>> After removing the catalytic converter the problem persisted...although the engine operated with slightly less flow resistance
Attempt at diagnosing the problem
>> My wife called in a technician from BMW at Canal Walk to come have a look and what errors were flagged
>> The tech ran the diagnostic and no fault codes were indicated, except a few short circuit faults due to my incorrectly placing -ve on +ve when I tried to charge my cars battery with jumper cables
>> He proceeded to ask if we changed the spark plugs, I said yes. He then looked at the oil on the intake manifold and said there could be a torn valve on the intake manifold and that air that is not measured by the air mass flow sensor is entering the engine, which is causing the car to rev hunt (this problem of rev hunting has been with us for a while). The engine also shuts down uncommanded at stops and sometimes between shifting gears with the subsequent loss of power steering (very dangerous!!)
>> We also had the O2 sensor replaced a month before this occurence
The images attached (#1- #3) are marked up to indicate the component I am referring to.
[IMG] FilesImage_1.jpg[/IMG]
[IMG] FilesImage_2.jpg[/IMG]
[IMG] FilesImage_3.jpg[/IMG]
Went to Cape City VW in Cape Town and the part number for that orange thing/diaphragm is 06A 198 205A 'Repair kit for valve'. Is this significant? The car sounds as strange at idle...as if has noisy valves. I can upload (if there is an option) a sound clip of how the car sounds if this assists.
View 1 Replies
I recently bought my new car through a family friend.2000 Hyundai accent auto owned by a 90yr old grandpa since new with only 45k on the clock. im used to driving a manual so I don't know if its just me not used to it but when I slow for a corner to say 15-20km/hr and accelerate out the transmission remains in 3rd gear unless I give it a really good prod then it changes to 2nd or 1st. the acceleration when It does this and stays in 3rd is ok but I just wonder if its normal or is it just burning out the torque converter. also im only getting about 380-400kms out of a tank when driving the same route my old 96 pulsar used to get 550kms from the same fuel. is this normal I would have thought this new car to be using if anything a little less.
View 1 Replies
It's time to do some oil change and is using 10w30 synthetic but the truck is eating fuel like crazy and I can hear some kind of knocking when full throttle .
Sparks , boots and fuel filter is new . The mechanic said I should put some lighter velocity oil . truck odo 130k v10 hot hot weather .
View 14 Replies
My 2005 Elantra has 240,000 miles on it and uses about a quart of oil per 1000 miles. It does not smoke, nor are there any oil leaks. I've owned this car since new and I've done all the maintenance work (oil changes, timing belts, CV boots, etc).
The oil consumption started at about 120,000 miles and has gotten progressively worse. Outside of the oil consumption, this car is in great shape. It starts and runs very well. My kids drive it about 1000 miles per week between work, college, and other events.
If it didn't burn so much oil, I'd go ahead and replace the clutch, struts, and shocks but can't validate the time and expense given the oil issue.
View 10 Replies
2003 Santa Fe, about 142,500 miles, 2.4L, 5-Speed Manual. It appears that oil consumption is 1 quart per 2500 miles.
No leaks present that I can see, no smell, no visible "smoke" from exhaust. I change my oil every 3K, so this doesn't seem too bad for the age and mileage.
Other issue: Throttle seems "sticky", especially when accelerating from lower RPM (under about 1700). I notice this especially when accelerating out of a corner in 2nd gear: If I'm attempting to climb a hill, she'll begin to hesitate as if the throttle isn't responding properly. I'm thinking it's more me, as I've recently gone from driving a 2000 VW Passat V6 to this Santa Fe with less horsepower moving a heavier vehicle. If I keep the RPMs above 2000 or just give the throttle a good press, she'll (usually) not "buck" or hesitate. Is there something I can check for? I've never really experienced this on other 4-cylinders, but those I4's have always been small cars.
View 1 Replies
Alrighty let me see if I can get everything. 01 6speed 450hp at rear wheels. Comp 910 valve springs, valve seals, 238-80% injectors, full RR, 38r turbo, napa air filter, Hydra with Gearhead tunes, 5"exhaust, 280k about 100k on rebuild. All mods done 40k ago. Now I have a horrible up pipe leak I assume is causing the low boost #'s I have to do another clutch so up pipes will be fixed when tranny is out this week. But I'm using 1-2 gallons of oil every 3k or so. I smell burning oil when I get out, mainly if I am getting on it then stop. I haven't pulled the fuel filter to see if its a injector o ring. (Tonight's project) but turbo sounds fine, I'm going check for shaft play tonight. What could be my loss of oil without it actually leaking on the ground?
View 14 Replies
So, my 2005 Gen II Prius went for a scheduled service on Wednesday, 70k miles, Toyota main dealer. They called and said it needed new front brake pads and disks, I was surprised but gave the go ahead. There would occasionally have been a mild squealing sound from the brakes at very low speed so I accepted the pads might need replacing, I was surprised the disks needed replacing but it hard to argue about brakes, especially as I only have the car a year (I'm the second owner and it has a full Toyota service history). It had a "major" service, new spark plugs, new front brake pads and disks.
Since collecting it I've noticed that the engine seems to kick in more often and needs higher revs. The fuel consumption seems higher, normally mid 50's MPG (imperial gallon) now 35MPG. However it hasn't been driven many miles since its been serviced so its a low distance for calculating MPG. I've also noticed that the car seems to slow more quickly without applying the brakes, a regularly driven hill that I coast down at 48kph now only gives 35kph. Also, if I drive on a flat road for a mile or 2 and coast to a stop the front brake disks feel VERY hot, way too hot to touch, drivers side more so that passenger side.
View 19 Replies
What is the hourly fuel consumption for a Toyota Prius at idle? Purpose is keep cabin warm for 8 hours. Would this damage engine?
View 10 Replies
My gen3 has 200k miles and eats atleast 1 to 2 quarts every 2 to 3k miles what can I use...
View 12 Replies
I have noticed my oil consumption has jumped to 1 1/2 quarts at 3000 miles..(it has been changed every 3 to 4000 miles) and is always very dark.. There's no leaks and the spark plugs were clean (just a little ash) when I changed them with the last oil change. No smoke from the tail pipe and the car still gets 45/48 mpg ..
View 8 Replies
I have a 1999 Honda Accord. It consumes oil but is not leaking, the compression is good, and there is no sign of burning. What could it be? Might sludge result in the problem?
View 19 Replies
We bought a 2007 Outback in April of 2012 (~75,000 mi.). After a couple of oil changes I noticed that the oil consumption seemed high. The dealer looked for leaks and replaced the head gaskets under warranty. Oil consumption still seemed high. The dealer started monitoring the oil consumption checking it every 1000 miles for six months or so. Consumption was about 1 qt. for 1200 miles. Reluctantly they agreed to look at the rings (98,000 mi.). They found burnt oil rings and replaced them.
Oil consumption went down to 1 quart in 1800 miles (improvement of 600 miles). The engine was still under an extended warranty when this happened. I was claiming that the cylinder bores must have been out of spec to see such a small increase in oil consumption and that they should have given me a new short block or rebored the old one with new pistons to match. My question is, what kind of a result I should expect from a ring job? Am I correct in thinking that something else must be wrong with the engine if the oil consumption improved so little?
View 19 Replies
