Elantra XD (2001-06) :: Hand Brake Stuck - How To Release
Nov 23, 2015
2001 Elantra, Hand brake stuck, is there a release button? I can not seem to release my hand brake. How can I release it so I can make adjustments?
View 2 Replies
Nov 23, 2015
Advertisement
Elantra XD (2001-06) :: Clutch Fork Stuck / Does Not Release
2002 Elantra
Replaced new clutch disc and new pressure plate.
Without turning on the engine, the clutch pedal seems to get harder to press, until it can't be pressed down anymore. The pedal can't be pressed down.
Clutch fork lever does not release.
Elantra XD (2001-06) :: Hand Brake Very Hard To Pull Up
On my wife's '06 Elantra, the hand brake is very hard to pull up, barely getting one click from it. I've done some looking around and have not been able to find a solution to the problem.
View 2 RepliesGolf V R32 :: When Headlight Switch Is At Off Position HID Came On When Release Hand Brake
I went test drove a R32 today and I noticed when the headlight switch is in the off position, the HID came on when I release the hand brake, is this normal? I thought the DRL suppose to be the inner two halogen lights not the HID. This way, having a switch is kinda pointless except to turn on/off the the instrumental lights because you have the HID on whenever you release the parking brake, doesn't matter if the switch is in the off position or the on/lowbeam position.
View 12 RepliesGTI 337/20th Anniversary :: Rattling Noise From Hand Brake Release Button?
Having this problem where the button to release the hand brake rattles constantly while driving? The only thing I can think is to replace the spring in it, but Idon't know how difficult that would be. Otherwise my only other thoughts are to find something thing enough that I can slide into it and hope it doesn't ever jam it up.
View 3 RepliesToyota - Pickup :: 1990 - Emergency Hand Brake Stuck
I have a 1990 Toyota pickup. I've been told to always put the brake on when I park. The brake is a hand lever under the dash that I pull out and then to release, I push a button, pull a little and then push. Yesterday I got into the truck and went to release the brake and it was stuck. I had my foot on the brake, and it was in 1st which isn't out of the norm for how I start the truck. I did notice that the handle seemed loose. I eventually got it back in after starting the truck again and putting it into first and trying to pull forward with the brake on. I'm concerned that if I use it again it will stick again and not go back in! What has happened!?
View 5 RepliesPhaeton :: Parking Brake Pedal Stuck / How To Release
This morning I drove my car to see my dentist. When I parked I engaged the parking brake as I always do out of habit. However this time when I was done at the dentist and got in my car I tried to disengage the parking brake pedal and it wouldn't release. It kept going lower. Now I think its pretty much floored. I had to leave the car in the parking lot as it started to rain heavily. How to release the brake pedal. ? I think it must just be a stuck lever or gear thats preventing the release mechanism from working. Any pics or have dis-assembled a parking brake pedal on the phaeton before.
View 4 RepliesElantra XD (2001-06) :: Clicking Sound Coming From Left Hand Side
What is the cause for a clicking sound coming from Left hand side wheelwell area when I make semi tight Left hand turns from a parked/stationary position?
View 4 RepliesSubaru - Impreza :: 2001 - More Resistant Hand Brake After Repair
I recently had my Subaru Impreza (2011) brought in for repairs to replace the brake pads and rotors. Upon driving home from the repair shop, I noticed that it was a lot harder to pull up on my parking brake than before when I parked.
My question is: is this a sign of something I should go back to the mechanic about? Is there such thing as the parking brakes being on TOO tight? I just wanted to be sure.
Hyundai - Elantra :: 2013 - Thunk Sound And Lurch When Release Foot From Brake Pedal To Go Into Drive
After driving in the rain and starting the car again after a few hours (as in starting the car again after work, or starting it first thing in the morning) the following happens: As soon as I release my foot from the brake pedal to go into "drive," there is a "thunk" sound from the rear of the car as well as a lurch. A soft "thunk" may have a soft 'thunk" sound, but a louder thunk will have a pronounced lurch/jerkiness from the rear. The car drives OK and has no problem with braking when I apply the brakes.
It happens only after driving in the rain. The dealer says the sound and movement are the normal result with disc brakes wearing off the rust on the rotors. Other wet weather concern (happened once): while driving in a couple inches of snow, the brakes began to grind and eventually failed to bring the car to a stop. Dealer rotated the rear rotors (due to uneven wear, although I had the car only two weeks at the time) and installed new rear brake pads. He said grinding brakes on an Elantra are normal in rainy, snowy, and dusty conditions. Is my car really safe to drive? Is there a problem? I'm considering trading it it as I don't feel safe. It is an otherwise OK car.
Ford - Mustang :: 2001 - Brake Malfunction - Front Calipers Won't Release
I have a 2001 mustang GT. I have 2 front calipers that are sticking. I changed both calipers twice, new brake hoses, bled all the wheels and the master cylinder. Why the calipers won't release?
View 19 RepliesElantra HD (2006-10) :: Right Rotor Is Stuck On Parking Brake
Doing a rear brake job on my 2008 elantra. Left went fine. However, the right rotor is stuck on the parking brake. It is loose, but held on to the springs of the parking brake.
How do you back off the parking brake? Also, how do you remove the parking brake cable?
Touareg :: Brake Light Stays On And When Drive Away Hand Brake Warning Comes Up
Having issue with the hand brake? It works fine, just when I want to release it, the brake light stays on and when you drive away hand brake warning comes up and I have to play with the handle to make the brake light go away after release...
View 8 RepliesElantra XD (2001-06) :: Stuck In Second Gear
I have a Hyundai elantra 2002 that is stuck in second gear. I was driving it, I came to a stop sign so I put it in neutral and when I shifted into first i heard a pop. I started driving and when I shifted into second I noticed the shifter was really loose, when I tried shifting into third I couldn't.. it is like there is a brick wall. I can shift from 1st to 2nd but the shifter just moves up and down. Also if I let the clutch up it stalls the car. I was told that my car is stuck in second gear.
View 1 RepliesElantra XD (2001-06) :: Car Would Slam Into 2nd / CEL Come On And It Get Stuck In 3rd Gear
I recently started getting transmission problems with my 2001 elantra.. the car would slam into second gear and the check engine light would come on and it get stuck in 3rd gear.. The codes I am getting are P0720, P0715, P1529. I searched and i found that most people that had this problem replaced the input and the output speed sensor and the problem is fixed.. so i went and i got two new sensors and replaced them i am still have the same exact problem... the car drives good for the first 5mins and then it would slam hard into gear, check engine light comes on the it get stuck in third gear...
View 6 RepliesElantra XD (2001-06) :: Car Stuck Into 2nd Or 3rd Gear While Driving
2001 Hyundai Elantra 183 miles.
codes- p0720 output speed sensor circuit malfunction, p0500 veh speed sensor a malfunction.
Recent fixes on my 2001 Hyundai Elantra.
A few months ago i had my speed sensor cleaned, and a power steering leak. No problem after that was fixed and cleaned the sensor. Soon after that my water pump went bad and i had that replaced along with 3 new belts. Just last week i had my front driver side replaced with a new wheel bearing and axle.
My Problem then and now.
My problem months ago, my car would be shifting into different gears as it pleased; while driving or sitting at a light i would feel it jump and it felt as if it was stuck into 2nd or 3rd gear as i was driving. My engine light would soon come on after this. To accelerate i feel as if i had to floor my pedal when the shifting or engine light came on. I looked up my codes and they are the same as they are now. I read about same problem and fixed it by just cleaning the speed sensor off. My friend and i did the same thing and it fixed those issues. My problem now is that i just had my axle and wheel bearing fixed (my car moves smoother and quiet) my engine light came on again, it had not been on since, i read the codes and they are my speed sensor same as before but my car has not been shifting as it was in the past. Would this be because the sensor needs to be cleaned again or replaced, or because of my new replacements on my wheel.
Elantra XD (2001-06) :: 2004 - Rear Brake Sticks / Parking Brake Is Broken
I have a 2004 Elantra GLS. My left rear brake was hanging (wheel was very hot to the touch after driving, while other wheels were not), so I had a friend check the brake pads. We decided to replace the pads and rotors. While doing so, the parking brake seemed stuck in the on position, so I opted to have him disconnect it completely until I could afford to replace it. I had used it for the first time about 2 weeks before I noticed the hot brake problem, so we figured that must have been why the brake was hanging.
My friend replaced the rotors and pads, put some penetrant/lubricant on the piston of the caliper and reassembled the brakes. He did use the special tool to spin the caliper in when putting the pads on, however he didn't know that was necessary and tried to force them in with a C-clamp first.
Now, I seem to have two problems:
1. The left rear brake still hangs sometimes. I will drive the car and when I park it I can feel the heat coming off of the left rear wheel. It is extremely hot, so I know the brake is hanging (even with the parking brake disconnected). What is the problem here? Is the caliper bad? Would replacing the caliper solve the problem? Does the parking brake have to be connected to stop the caliper from hanging up?
2. My second problem is the pulsating of the brakes. I am afraid the rotor is warped because of the heat, or maybe he didn't clean everything well enough before he put the new rotor on. How can I figure out what the problem is? Is there a way to check a rotor to see if it is warped? Could there be another reason I feel the pulsating brakes? By the way, the brake fluid is full.
If the caliper needs to be replaced and I can leave the parking brake disconnected, are there any special instructions my friend should know about before working on this? He does work on a lot of cars and rebuilds cars to sell, so he is pretty knowledgeable. I think the only thing he didn't know about was rotating the piston. I would like to provide him with detailed instructions if necessary.
Elantra MD (2010-15) :: Parking Brake Stuck / Vehicle Moved With Big Popping Sound
Went to leave for work this morning and released the parking brake and she wouldn't budge. Had to give it quite a bit of gas to finally move, along with a big popping sound. It was cold out, and haven't been using the PB in cold weather lately but did yesterday and this happened. Is there something that needs to be done with the brake? Thought I might have to get towed.
View 1 RepliesElantra XD (2001-06) :: Trunk Handle (latch) Gets Stuck In Or Out
A problem that has raised on my Elantra GT is in the hatchback, the trunk handle gets stuck in or out so when I try to open the trunk it wont, but if I push the handle in first and then open it then it opens, also I have to lock and open the car with the alarm remote several times before it opens. Now I know that the handle is bad and need to change it, the car is a 2002 and this happened on 2004 I told the dealer and refused to do anything about it unless paid for everything, They wanted like 300 to change a handle, i did not do it, I will buy a handle and do it my self, I just wanted to know if other people had run to this problem and if its hard to change the handle, the dealer said they needed to take the whole hatch apart, but as far as I can see its only 2 screws and the handle should come out. This is been a long time coming.
View 5 RepliesElantra XD (2001-06) :: Noise Coming From Cam Timing Chain - OCV Stuck
I have a problem with my 2005 elantra making a noise that sounded like it was coming from the cam timing chain. since it is still under the 10 year 100,000 mile warr. I brought it to my dealer. I had a P0011 code for advance timing also that keeps popping its ugly head. Dealer said that the chain would not be covered under warranty because of oil sludge and a faulty oil control valve. I went to remove the ocv from the head and when I removed the bolt the solenoid came off without the stem I tried an easy-out and managed to rotate it approx 1/8" but no luck getting it free to pull out.
View 1 RepliesElantra XD (2001-06) :: 2002 - Clutch Stays Stuck Engaged
My 02 elantra gls 5 speed clutch has gotten stuck engaged for about the third time now. First time was right after I bought the car i noticed the clutch would slip randomly for no reason. At first i thought the clutch must need replaced, but then other times I couldn't make it slip if i tried by going up steep hills with car full of people and shifting too soon on purpose and punching gas....no slip. So anyways i replaced the slave cylinder, and all was good till one day my wife calls me up stranded and says clutch pedal is rock hard and none of the gears will engage. so i tow the car home and fiddle around and realized the slave cylinder (brand new one) was stuck out. I opened the bleeder and it returned without me having to push on it or anything. i then bled the system thoroughly. So months have gone by and the slave cylinder got stuck out again, and again it was a simple turn of the bleeder valve and it went back and works fine. just curious as to how i can fix this problem permanently since its irritating and seems to be reoccurring. do i need to replace the master cylinder as well or did i buy a bad slave cylinder?
View 6 Replies