Elantra XD (2001-06) :: 2005 Hesitates To Start / Check Engine Light Flashing
Dec 28, 2015
This issue has only happened twice to me.
I go out to start the car, it cranks and cranks and cranks. I stop turning the key. I then try again and it hesitates to starts. I give it a little gas and it starts. When it does this, the car begins running very rough and idling rough. When I give it a little gas while it's parked, the check engine light begins flashing at me.
I turned the car off and came back to it the next morning (maybe 10 hours apart). It started right up no problem, no CEL either.
View 2 Replies
Advertisement
When I put the pedal down to the floor for a little fun my check engine light will start flashing. I'm not sure how many times or for how long but it worries me.. The check engine light has been on but the car does have 233,000 miles on it but new engine was put in 100,000 ago
View 1 Replies
I just purchased a 2005 elantra with 133k on it and she runs fine other than a slight erratic idle. And by slight I mean it will jump about 50-100 rpm idling and every blue moon it will jump up to 250 rpm sitting there. After idling for a while my CEL came on with the following codes.
P0507 idle air control rpm high
P0506 idle air control rpm low
P0170 fuel trim malfunction bank 1
P0121 throttle position sensor
What could be causing this? I took the iac off and cleaned it with maf cleaner but it didn't work.
View 9 Replies
So my gf's check engine light on her 01 Golf flashes once in a while, and it misfires. But the thing is, it doesn't stay on, and it's once in a while (like once or twice a week). She has new spark plugs, and new wires. I have a feeling it's the coil pack, but I really don't know if it needs to be replaced until the check engine light actually stays on.
View 14 Replies
Just a few days ago I was driving and I noticed as I went over 35 mph my car would stutter and the check engine light would start flashing. And when I slowed back down the car drove fine. I'm wondering what the problem could be? Feels like the car is losing power. Car is currently at 119k miles.
View 1 Replies
I have had a 2002 Prius since December of 2012, and it has been running fine since I got it; while it was in a wreck in May 2013 that has rendered both passenger-side doors and windows unusable, I have not seen that incident cause any other problems, and the car still runs perfectly fine. I am supposed to be driving from my current home state for a job soon, but about a week ago while I was driving on the interstate, the check engine light started flashing.
I was changing lanes and putting a good bit of pressure on the gas in order to pass someone that was going below the speed limit, putting my speed at around 80 mph when the check engine light started flashing. I started getting off of the interstate to find a place to stop and inspect things, but the light stopped flashing when I got down to around 45 mph on the exit ramp, and I was able to drive the rest of the way on the interstate without any trouble, even when I got in the 75 mph range again. The span of time between the light starting to flash and turning off again was probably about a minute or so.
View 7 Replies
I have a 2001 elantra 2.0 gls. It is running rough with low power and flashing engine light. It may have a bad 02 sensor but when checked for spark only the 2 and 3 cylinders were sparking. I can confirm this because when I unplugged the 1 and 4 spark plugs it made no difference in the way it was running. Next I tested the resistance on the coil packs. Both were an even 1.5 ohms. How can it be that the coil packs are good yet the plugs aren't firing? I also have moved plug wires around and have had no success.
View 8 Replies
My Girlfriend just got a 2003 Hyundai Elantra and everything was running great on it the first month she had it BUT the check engine light was on.. After about a month she called me up while driving and said that the check engine light was blinking and the car would hardly move. So I got to the car and looked at it and I noticed the oil filter was a little loose so I tightened it good this time and added a little bit of oil. It actually moved but it would hesitate. So we had it towed to a shop and they read the codes from the check engine light and told us it was leaking oil from the motor some where (not specific) and it also needed a new O2 sensor.
So I replaced the catalytic converter underneath the car and also a new sensor along with a new set of spark plugs. It ran alot better and I left it at that. Now about a week later she was coming home and noticed that when she turned left or right that the battery light and brake light on the dash came on. She drove it home and when she turned in the driveway the car went dead. It started right back up and we got it to the house and left it over night. I went out this morning and again it started right up. but when I lifted the hood I noticed the belts on the pulleys were all spinning very slowly. I'm not sure if it could be a timing chain or if it just needs new pulleys.
View 6 Replies
I have been experiencing some issues with my '06 rio5 (same engine as your hyundais). this forum is way more active than the kia forums, so figured id give it a shot here.
I am experiencing a rough idle at start up while the car is low on fuel (<1/4 tank). it idles rough for a few seconds, the check engine light flashes a bit, and then it runs fine.
The car is an '06 rio5 with approx 19k miles on it, five speed manual. Also, sometimes after refueling and it will just shut off while waiting at an intersection. Not sure whether these two issues are related, but thought i would mention it just in case they were.
View 14 Replies
My Car when it comes to a traffic light, wants to lurch just a bit, as I sit waiting for the light to change, I don't know whether it will stall, and also the RPM wants to rev on its own a little when I first get into the car to start it, and also while I am waiting at stoplights.
View 1 Replies
While I am driving the car it will start to die and skip. Happens randomly. Today I was driving up a small hill and it went quits on me started lurching with check engine light coming on and off. The car will turn over and start, but only for a few seconds before dying again.
Seems to happen when the car is running for a while. Also the ABS light flashes on then off randomly while driving sometimes although It hasn't been an issue. Will be checking tomorrow to see if it starts.
View 1 Replies
I've replace the input and output transmission speed sensors on my 01 GLS. check engine light is on again for 2 P0501 codes. There is no abs speed sensor on the left side but there is on the right side which doesn't look like it is seated correctly. The transmission is still shifting kinda funny sometimes. Should I have abs speed sensors on both sides? And what else should I do to fix the random erratic shifting?
View 3 Replies
I just bought a used 2004 Elantra that has 97,000 miles on it. When I took the vehicle out for a test drive it was smooth and quite. That was on Monday its now Saturday less than 300 miles later and the check engine light came on and it is having serious hesitation issues?! I am going to take it back where I purchased it from on Monday when they open but in the meantime I would like to know if its could be something simple?
View 14 Replies
My check engine light came on in my 2005 Elantra. During the course of trying to find out why I realized that my transmission fluid was a little low. I went to Walmart and got a bottle of the multi vehicle fluid the auto counter man said it needed. I did come online to check to see if that was the right fluid before putting it in and see that evidently the specs are very specific for what type of transmission fluid to use.
View 4 Replies
I have a 2004 standard Elantra GT. I had to get an emissions test and the CEL light will not stay off. My garage replaced two valves in the fuel tank and the neck to the tank and have done numerous "smoke tests" but can't find the leak. Now they are saying there is something wrong with the computer. They got it to stay off long enough to pass the test, but the light's on again. I see that there was a recall issued because of the cracked exhaust manifold, I think I had the catalytic converter replaced up at the cottage.
View 4 Replies
Have an 01 elantra as a second car and it's great. Just recently tho the check engine light came on and I've got a few codes that make sense since there has been some odd issues with it in the past month or so.
02 sensor CKT bank 1 sensor 2 (slow response)
shift solenoid D malfunction
shift solenoid C malfunction
shift solenoid B malfunction
Trans range circuit malfunction (PRNDL input)
So I know the 02 sensor needs to be replaced, that's fine. I'm more concerned about the rest of the codes because when cruising around 40mph the car tries to shift to 4th gear or something like that, it will bog down because the rpm is too low (maybe its overdrive, not sure).
That's a minor issue but has been there since we got the car over the summer, the bigger issue is the last couple of days, i've noticed that when driving the car around the city, slow down - turning - and then accelerating the engine/trans will buck harshly a few good times before it smoothens out, my guess is the gear change didn't go well.
View 13 Replies
As the title says I have plugged a code reader in and it says "cyclinder three misfire". So I pulled the plugs and good god they were nasty. Some having a gap of 80-90 thousandths of an inch. So I figured the plugs were the source of the problem, thus I replaced them but to my dimise the check engine light is still on, and still reading the same ol' "cyclinder three misfire". I have put 350 miles on it in 24 hours of changing it to allow for proper time of the circuit cycling for the light to change but not sure if it takes longer...?
I also went ahead and checked the plug wires resistance when I had the plugs pulled and they ranged from 1.5-2.5k ohms shortest to longest (cylinder 4-1). And if your curious the magic cylinder three was around 2k ohms for however long that wire is, my guess would be 18 inches. Would this be out of tolerance, I know the norm is 10k ohm for every 12 inches or so...?
My next guess would be replacing the power pack or I guess you car guys call it the "ignition coil"...? I will say that the car does run much smoother after replacing the plugs.
View 5 Replies
I just purchased my first foreign car ever. it is a 2002 Elantra it idles very rough changed plugs using NGK and wires new fuel filter and ran 2 full tanks of high grade fuel with STP fuel injector cleaner. but had no effect on idle also have no check or service engine light. What to check next?
View 3 Replies
I own an 04 Hyundai Elantra with around 196,000 miles on it, and have run across a problem I haven't had to deal with before. A few days ago, my check engine light came on while driving. I didn't really notice much, but when I started it again it began idling roughly. I got it home and pulled the code, which was P0341 (camshaft position sensor). This isn't the first sensor I've had go on the car (I replaced an oxygen sensor and throttle position sensor a couple years ago), however I ran into two problems:
1. How likely is it that it's the sensor that's bad as opposed to something like the timing belt or VVT adjustment?
2. Since the sensor isn't horribly expensive, I decided to try replacing it, but I can't get any socket to fit on the bolt that secures it. I've heard it's a 10mm, but nothing seems to fit snugly. Maybe there's just so much crud and corrosion that it's ruined the head. I tried using an extraction socket, but no luck.
View 5 Replies
I just got this very nice Elantra 04 with 64k on it. Yesterday suddenly I got the check engine light on. Today I went to Auto zone and they have checked my car and it showed code P2626. But there are more than a few suggestions about what could be. I don't know what to do. See the attachment below.
View 1 Replies
I have an 05 Elantra GLS auto transmission, ~83000 miles. Last Friday, the car was driving fine. I didn't drive it on Saturday, but when I started it up Sunday night, that's where the issue began. First, when I shift into reverse, the car makes a noise like as when you go over a pot hole. Idle RPM is around 800.
When I press the gas pedal, usually the response from the car to go forward is almost instantaneous, but now it take a second or two from the time I press down the gas pedal to when the car moves forward. The process is smooth though, no hiccups as it does that. Next, when I was driving on the highway between 70 - 80 MPH, the car's RPM was 4000 - 4500. It even sounds like the engine is "working harder" than it usually does. The 'Check Engine' light is also on with these codes: P0700 and P0885.
Another thing I noticed is that the car alternates between running fine and running with the conditions described above. If the car run with the symptoms described above, I shut off the car and restart it. Then it will run fine, but the check engine light will stay on. Then if I turn off the car and restart it, it will go back to the mode where I have the issues.
From some research, the P0700 code just means that the TCM has the actual code which is P0885. According to the tech manuals at [URL] ...., the P0885 has the following probable causes.
- Malfunction of the A/T control relay
- Malfunction of connector
- Malfunction of the PCM
The car actually ran fine today, with out any issues but the Check Engine light is stuck on. How to replace/service this PCM item? Or maybe this issue is covered under 100,000mile warranty?
View 3 Replies
