Elantra XD (2001-06) :: 2002 Gt Idling Very Rough With Rpm Jumps Back And Forth From 1500 To 2500
Oct 13, 2010
My wife drives a 2002 Hyundai Elantra GT. Recently the car started idling very rough with rpm jumps back and forth from 1500 to 2500 rpm. The check engine light came on and threw a code for the IAC. I also notice a clicking sound coming from the engine and I can see sparks arching at the coil/plug wire. The arching is happening at the coil with the numbers 1 & 4.
The car is difficult to drive. It shakes and surges and isn't pleasant to drive at all. These issues started happening very recently. The car ran great up until now. We've stopped driving it for the time being until we solve the problem.
We had the car serviced a few years ago and they changed the IAC and mentioned something about a gray wire that we should watch out for.
I'm not really sure what the issue is. I don't know if it is the spark plugs, wires, or coil. Or it could be the IAC or something else. I'm comfortable working on the car myself, but I would rather not try fixing many things if it is just one thing actually wrong.
So far, the only thing I've tried is to spray some carb cleaner into the throttle body towards the IAC in hopes that it would clean it and solve my problems.
Where the IAC is located. I want to try remove and clean it, but I'm unsure of exactly where it it. I know it is somewhere on the throttle body or intake manifold, but I'm not sure exactly what I'm looking for.
View 8 Replies
Advertisement
I have a 2002 Accent 1.6L 72K miles, idle surging between 1500 - 2500 rpm after stopping from 50 mph, (with Code P0121) replaced TPS - No Luck . I reset the DTS error codes, ran it with a new TPS and same exact problem, Code P0121 came back, and surging continued, this happens when I decelerate from high speed- 50 mph or so and it will not go to normal idle, surges between 1500 and 2500 rpm when in park.
If I give the throttle pedal a good kick, the problem goes away, and it idles fine, nice and smooth and at normal rpm, the DTS code will clear, and stays cleared, mil light goes out. It almost seems like something is sticking, I know its not the throttle itself because when I do a live data, the TPS shows "0", if I manually push the throttle shaft closed at the throttle body, it is fully seated shut, so I know its not a sticking cable or anything. Can a sticking MAF sensor cause this? Maybe what I'll try tomorrow is rapping the throttle body with a rubber mallet while its surging, maybe something is not returning to its normal position in there.
View 14 Replies
I have a 2001 Santa Fe that I am getting road ready for my son, The engine has recently started idling very high, 2500 RPM at startup. I disconnected the IAC servo and it drops right down to about 900 RPM. I replaced the IAC with a brand new one and it does the same thing at startup, 2500+ RPM. Checked vacuum hoses / tubes. I replaced 2 crack / dry vacuum hoses. Same problem for a while, then idle went down to about 1250. Started to drive it, test ride. while accelerating, seems OK as soon as I take my foot off of the gas, idle goes to 2500 - 3000 RPM until I apply brakes and then it drops back down to 1000 or so. (SOUNDS LIKE A VACUUM LEAK PROBLEM. I CANT FIND IT, IVE BEEN THROUGH 2 CANS OF CARB CLEANER AND HOURS OF REPLACING ALL VACUUM HOSES.)
View 2 Replies
My GF has a 2002 Elantra, and recently, she's had a remote start kit put in her car. Previously, though, we were moving something in/out of her car and broke the shift knob and the rod became bent, so we had to bend the rod back to be able to put the car back into park. (The car is an auto).
Recently, she's had a couple rough/no starts from her car. There have been a few times where she would come over to my house and the car would not restart soon after she turns off the ignition. However, the car will start rough about 3 hours later and run perfectly fine once it cranks. This doesn't happen often, but enough to be troublesome.
The problem with this though is the fact that sometimes it starts and sometimes it doesn't, and it runs PERFECTLY fine. The lights are not dimming, the battery is not dying, the car has not required to be jumped. While having these problems we drove the car around for about 5-6 hours and it was perfectly fine. Her dad thinks it's the alternator, but the battery hasn't been losing any charge and the battery hasn't been dying. There has been one time where her father moved the shifter up and down and put it back into park and the car started just fine. Could this be related to the shifter, and how the car isn't reading that's it's fully in park to relay ignition? Her dad said he tested the alternator and it was "bad," but like I said, if the alternator was bad, her battery would be losing charge, and that is definitely not the case.
View 7 Replies
I had a rough idle and now car wont start. 2002 elantra, 4 cylinder. replaced tps, replaced fuel filer, cleaned IAC. I can hear fuel pump car wont stay running...
View 22 Replies
I just picked up an 02 Hyundai elantra manual trans that needed a transmission. ran fine before I replaced transmission but after putting it all back together the car now how has an erratic idle. it will rev from 2-4000 rpms. I tried spraying for vacuum leaks idle didn't pick up any higher. replaced tps and iac and didn't make a difference. the only thing that did make any difference is unplugging map sensor. dropped idle to about 1200 rpm but ran rough. could this affect the idle.
View 1 Replies
Could not find anything about this on a search. I have 2 Sonatas. An 08 and an 09 both are 4cylinders. The 09 was purchased used in June of this year. With the colder weather setting in I have noticed that the 09 when started from cold jumps to 2500 rpm and settles to around 1000rpm for a short time then slows down a bit more to what I think is the normal idle speed. My 08 never goes that high and settles down to a normal idle quicker. If I read correctly the 08 and 09 have different air metering systems. Is this idle thing normal or am I dealing with an issue?
View 7 Replies
I have a 2001 Chevrolet 2500 HD crew cab truck and the drivers power seat will move in every direction but back. The motor hums when every button is pushed but when I push back the motor just clicks once and then nothing. Nothing is in the tracks or otherwise impeding the seat from moving backwards.
View 6 Replies
02 elantra 138418 miles. Before I cleaned throttle body engine idled fine, but know I can't get engine to idle below 1500 rpm, check engine lite is on, went to advance auto parts, he pulled code, he said idle air control stuck, i am hoping there is something i can do before spending $ and replacing it.
View 6 Replies
I have a 2007 elantra. I drove it for a while, then my ma needed a car (her tercel was a little unsafe) so I traded her. She loves the car, but as sometimes is the case, her dealer is not very nice. She has a severe side to side knocking noise in the steering- can be easily duplicated by sitting with the car idling and turning the wheel back and forth, even a little. Doesn't correspond with driving over bumps unless the wheel is inadvertently turned by the bump. If the suspension is unloaded (front wheels off the ground), noise disappears. No EPS lights, no codes in any system.
Listened with a stethoscope inside the car- not that loud through column within car. Inner and outer tie rods are tight, noise is not heard loudly with stethoscope through struts, upper mounts, lower arms. Under the car with loaded suspension (rhino ramps), noise is deafening in the rack, with a stethoscope. Dealer told her it needs a steering rack, I definitely understand why they would say that as the noise is clearly audible through the aluminum housing directly below the entrance of the column shaft into the rack. Only TSB I found was for a worm shaft flexible coupling, but the TSB says this is bump related.
View 7 Replies
The car is an '05 elantra, 97,000 miles, auto., car is new to me. First time on the freeway today, 30 miles @75-85 mph, at the end of the off ramp I could feel it surging, shift to neutral rpm's went to 1500, hoss the gas and back to normal. On the return trip off ramp, went to neutral, jab the gas, everything OK. I'm going to clean the throttle blade, check things, etc.
View 3 Replies
Our '02 Toyota Camry with 92,000 miles has been idling rough for awhile. I tried cleaning the throttle body which actually seemed like it made it worse for awhile. I do need to replace the valve cover gasket and I don't think the spark plugs have ever been replaced. Is that a good place to start?
View 6 Replies
My 2008 Accent started to stutter between 1500 and 2500 rpms. Now the check engine light has come on, and the engine is idling rough.
View 3 Replies
I just changed the engine in my 96 Honda civic, 1.6 base model. The change over went well and had no problems. When I have the car idle and it gets up to temp, the RPM's go from 2000 down to 500 then jumps to 2000 then down 500 again. When I put it into gear, drive or reverse, it stops jumping. What did I do wrong?
View 4 Replies
I've got a "new" Blazer -95 4.3 vin W about a month ago. It has run about 170,000 km.
But now it looks like it was a bad buy, it runs bad. The rpm starts jumping between 1500 - 2500. Suddenly the break and ABS warning lights in dashboard lights up, and sometimes all black out and it stalls.
At first it started acting like this when towing a trailer on the highway, doing 80 km/h. But now it does it at any speed.
View 14 Replies
The heat works fine when driving but when car is idling there is no heat, the blower is working just blowing cold air, the temp gauge reads normal???
View 3 Replies
I have a 2003 Camry 2.4 LE with 120k miles on it. It's been very well taken care of. As of now, here is the maintenance that has been completed at my dealership. By the way, I don't trust dealerships, but I do have one nearby that is actually beyond outstanding (and I know a little about cars):
- Regular oil changes, and always with 5W-30
- Radiator flush and thermostat replacement
- Tranny flush
- New front brakes, rear brakes cleaned, and lines flushed.
- Oil pan gasket replaced
- Valve cover gasket replaced
- Spark plugs replaced (at around 105k)
So, with this information being provided, here is my current problem. Lately, as I accelerate between 1500-2500 rpms, the engine has a louder than usual (but not too loud) groaning noise. Basically, the engine just sounds a tad louder than normal along with groaning noise. The engine also feels as though it is running kind of "dry" (if that makes any sense).
Now, above 2500 rpms, it's just fine. It's amazing on the highway, but I feel as though it has slightly lost acceleration in the city. The only issue with the car is the infamous greyish/blue smoke at startup, but that rarely happens and when it does, its a small amount of smoke, and it has never affected it's performance or gas mileage. Another thing is that I had to have that dreaded oil splash guard removed, because apparently the timing chain punctured it and it was about to fall off.
This problem has been recent within the last month. Just before this, the car has been on a roundtrip to Tucson from Tulsa, and Amarillo twice, complete with 32+mpg on the highway! So, what's wrong? Serptentine belt? PCV valve? Cam or something underneath the valve cover?
View 11 Replies
I have a 2001 4 cyl Camry with about 147K. I bought the car from the original owner a few weeks ago. The check engine light came on. The car idles very rough at low idle (e.g., while stopped with transmission in Drive). My mechanic changed out the EGR and another air flow valve that was apparently stuck open too much of the time, and also the engine idle air control valve. The check engine light is now off but I don't think it was related to the rough idle because that started before the check engine light. I have seen other forums that discuss the rough idle related to fuel dampener and also weak/broken motor mounts and haven't checked those out yet.
View 3 Replies
!995 honda accord, 5 speed. Idle is fine until the engine warms up, then fluctuates between 1500 to 2500 rpms. The idle control valve was cleaned- no change. Valve was also replaced -also with no change. Put old valve back on. Computer was disconnected after cleaning and also after each valve change.Would the next step be to remove and clean the fast idle thermo sensor? Also how do you check the coolant lines coming in. Anything else I would need to check, clean or replace.
View 2 Replies
So my 98 f150 xlt 4.6 is having a issue where the truck is jumping from 1500 rpm to about 2500 - 2600 rpm. You know sitting there trying to get up to speed. then all the sudden i look down and its at 1500 rpm. but still not really going anywhere. So i give it a little more throttle or gas and it jumps from 1500 to about 2500. Its been like this for a month but i thought it was crap fuel. What is the cause or maybe a solution?
View 4 Replies
I was going downhill. And I accidentally popped the car in neutral. Its a 2.0t fsi automatic transmission. And after putting it back in drive mode. The car went to 2nd gear and jerked the tires. I had to put it back in neutral because it was revving high rpm and it wouldn't switch. After I came to a full stop. The car was idling on 2500 rpm on neutral. I got an intake installed and replaced the pcv valve with one I got from ecs tuning last week. I am assuming I have a transmission problem.
View 6 Replies
