Elantra XD (2001-06) :: 2002 - Gas Pump Cuts Off Almost Immediately After Start Pumping
Aug 6, 2015
So for about two months now, every time I get gas, the pump cuts off almost immediately after i start pumping. After that, I am able to pump about a second or two before the pump shuts off. It recently has started spitting gas back out of the tank (I'm assuming it's the gas I just pumped into it being spit out). I'm not sure what is wrong. I have not gotten into an accident, there is no smell of gas in the car, the gauge still works fine, and no check engine light on.
View 3 Replies
Advertisement
I drive a 2012 GTI w/ a stage 2 unitronic tune. My gas light came on today. Naturally I stopped to get gas. As soon as I began pumping the pump clicked off. It took me like 5 minutes to get one gallon of gas in and fuel started to spill out. What this might be ?
View 6 Replies
I am new here just bought a santa fe 2002 2.4 model and its playing up it will start run for a few mins then die and wont start again for a while. the crank sensor has been renewed as has the cam position sensor the fuel pump makes the normal noise so fuel is getting threw the only other symptom is when it cuts out and wont start i check both ignition coils and neither are sparking yet there is power to both, all fuses are fine .
View 21 Replies
It acts like it is fuel poor, As if the fuel pump is not pumping. It spins fast on start. Then another try and it starts! No relationship to hot or cold. Fuel OK. Battery strong. I find no corrosion on fuel pump leads.
View 8 Replies
I have a 2004 Elantra and recently every time I pump gas, the car doesn't want to start without pumping/hold down the gas pedal. Why is it doing this?
View 5 Replies
Just finished installing a new water pump on my 2002 Elantra GT when...
I went to start it, and it started for half a second and died. Further attempts to start were strained.
The battery is showing 12.58 volts on the multimeter so this was likely not the cause. I checked the fuses under the hood which all looked good. I don't know if it could be a relay or anything else electrical.
Other than the electrical side, there are two things I can think of that may be the cause.
First, being in a hurry to finish(which is probably the biggest mistake of all) I reconnected the battery too soon and wound up connecting the ground(I thought) wire to the alternator for a second causing an arc. I immediately removed the wire and followed proper procedures to reinstall it.
The only other thing I can think of is that one of the water pump bolts required removal of the idler pulley. The idler pulley demands the loosening of the timing belt tensioner in order to be reinstalled. Before removing anything I marked the position of the timing belt on the camshaft sprocket as well as the crankshaft sprocket so I'm really hoping I haven't lost timing.
Could it be something electrical? Did I over-tighten a belt or pulley? Is it timing?
View 15 Replies
2005 GX470 ... My Issue is that when I pump Gas ONLY in Calif it keeps stopping. I have tried all angles of the pump. I have tried holding back rubber on pump, but that will not work. This is something else. I have been to other states such as TX AZ NM & NV and this problem does not exist.
View 9 Replies
I have a 2004 Santa Fe and every time after I pump gas into it it will not start. I try to start it five to six times and it finally starts but chugs and stalls unless I pump the gas. This lasts until I've driven for a few minutes.
View 6 Replies
I have an issue of fuel pressure I believe on my 2003 3.5 Santa fe...It would start then stall...I'm at my wits end with this thing...I checked the relay and its good...checked all fuses and they are good...I don't hear the 2-3 second whine of the pump when I turn the ignition to the on position, so I suspected a bad pump...but before I bought a new pump I took out the back seat, removed the access cover and checked the connector to see if the pump is getting power...its not...I'm at a loss as to where to look next...
View 35 Replies
As in a previous post, i have been having issues with my truck starting then immediately dieing if i dont keep my foot on the gas.
Ive learned how to drive with 2 feet because of it, but I'm afraid i might be doing some type of damage since it keeps dieing and I have to keep starting it.
Once i get going for about 10-15 minutes its fine but its happening every time i start the truck.
Before it starts running correctly, it only idles around 400 rpm.
I think its the fuel pump, since my mechanic put a code scanner on there and it didn't throw any codes, he thinks it might be the fuel pump.
My question is, should i go with a ford pump from the dealer or are the ones sold from discount/o'reilly/napa just as good?
View 14 Replies
01 7.3. Cranks, won't start. Tank was at 1/4 but is full now. The lift pump runs, I can feel and hear that the motor is spinning when I cycle the key. I removed the fuel filter and cycled the key and get no fuel into the bowl. It looks like the lines are stainless from the pump to the tank so I doubt it is sucking air. I pressurized the tank with a shop vac and I get fuel coming into the filter housing. Am I missing something obvious? I have never seen an electric pump that would run and not pump fuel. I removed the suction line at the pump and don't feel any suction there.
View 14 Replies
This has been happening for awhile now. I will drive somewhere, distance isn't a problem, and then after I'm done, I'll go to start my car, and it won't start. It won't turn over or whatever the term is. The starter tries, but won't bite. Sometimes it will start and I can drive for a bit before it will die about a block or 2 later.
View 7 Replies
We have 2 Hyundai a 2015 Sonta and a 2002 Elentra I am having problems with the 02 Elentra
I have a 2002 elentra that cranks but will not start it tries to but wouldn't start. It started fine before this and it did start once but ran really rough and only for a few seconds.
View 4 Replies
My 2002 Elantra GLS seems to have some sort of heat related problem.
I live in Arizona, where temperatures routinely reach well over 100. In the morning my car will start fine, after driving it for some time and parking somewhere, if I try and start the car within a couple hours of driving it, it will crank but not start. Lifting the hood to cool it seems to expedite this to get it started.
I had a mechanic friend of mine hook up his OBD computer at his shop, nothing out of the ordinary. He suspected either a crankshaft or camshaft position sensor. No check engine light, nothing out of the ordinary on his computer check. I removed spark plug wires for cylinders 1 and 4 and I have spark while cranking when it fails to start. My mechanic friend said the spark would rule out a faulty crankshaft position sensor. I have also tried spraying starting fluid into the intake manifold, and it has no effect. The battery has been replaced within the last two months, connectors are new as well.
View 12 Replies
My GF has a 2002 Elantra, and recently, she's had a remote start kit put in her car. Previously, though, we were moving something in/out of her car and broke the shift knob and the rod became bent, so we had to bend the rod back to be able to put the car back into park. (The car is an auto).
Recently, she's had a couple rough/no starts from her car. There have been a few times where she would come over to my house and the car would not restart soon after she turns off the ignition. However, the car will start rough about 3 hours later and run perfectly fine once it cranks. This doesn't happen often, but enough to be troublesome.
The problem with this though is the fact that sometimes it starts and sometimes it doesn't, and it runs PERFECTLY fine. The lights are not dimming, the battery is not dying, the car has not required to be jumped. While having these problems we drove the car around for about 5-6 hours and it was perfectly fine. Her dad thinks it's the alternator, but the battery hasn't been losing any charge and the battery hasn't been dying. There has been one time where her father moved the shifter up and down and put it back into park and the car started just fine. Could this be related to the shifter, and how the car isn't reading that's it's fully in park to relay ignition? Her dad said he tested the alternator and it was "bad," but like I said, if the alternator was bad, her battery would be losing charge, and that is definitely not the case.
View 7 Replies
I had a rough idle and now car wont start. 2002 elantra, 4 cylinder. replaced tps, replaced fuel filer, cleaned IAC. I can hear fuel pump car wont stay running...
View 22 Replies
I have a 2002 Hyundai Elantra 2.0 5spd manual GT with 90k miles. I just bought the car 2 weeks ago. The previous owner claims he did regular maintenance on it. He said the timing belt and water pump were done around 65k miles but didn't have paperwork on it. Has brand new tires. Battery is a year and a half old. I just replaced the spark plugs and plug wires a few days ago just because I don't know when the last time the previous owner changed them. 3/4 showed normal wear and were probably needing to be replaced. One of them (the one all the way to the drivers side) had a decent amount of corrosion built up in the wall leading down to the spark plug and then around the fitting for the 5/8 socket had quite a bit of corrosion around it to. The end of the plug looked like the rest of the plugs however. Before I installed the new plug I cleaned it up. As far as I know there isn't any other mechanical issues. He said he had the clutched replaced too. Which I find a little odd because it doesn't even have 100k miles on it yet and if it wasn't driven like a race car, that clutch should last a lot longer I would think.
My girlfriend was driving it home from work today and it died on her when she stopped at the off ramp of a freeway. I showed up and pushed the clutch pedal down as hard as I could and it fired right up. However, I walked away then she called me back because she couldn't get it to accelerate after that. Unfortunately I didn't actually try to drive it at that point which was stupid so it's possible she just didn't have it in gear all the way however it appeared that she did. It then shortly after died and hasn't started since. I'm getting power to everything else in the car including headlights and some lights and everything else I can think of. It won't even attempt to crank. It just does nothing when I try to turn it over.
I believe a few people recommended changing the crankshaft sensor. I have read that if the crankshaft sensor goes bad it will have the problem I am currently facing. At this point I'm assuming my girlfriend just didn't have it in gear and that's why it couldn't accelerate because if that wasn't the case, then that sounds to me like it's slipping and the clutch needs to be replaced. Anyways, other than the crankshaft sensor, I am thinking possibly the starter or alternator. I know it has a MAP instead of a MAF sensor and I know where it is but I'm not sure if that would cause this issue because I figured it would at least turn over. If it was the alternator if the batteries were dead I would charge them and if it died again that would be a strong indicator it was the alternator. But the batteries didn't really read low and I threw them on the charger anyways and it said it was fully charged shortly after I did that, and then I tried starting it again and still nothing. So right now I'm leaning towards the starter or this crankshaft sensor. My buddy said to take a screwdriver to the starter and try to jump it but how exactly to do that to test it. I have read multiple things online for other vehicles that the crankshaft sensor being bad will cause the car to not start.
View 6 Replies
I have a 2002 Hyundai Elantra GLS with over 215,000 miles. About a month ago, I started my car and it revved up & down from 2 to 4 rpm. I took it to my mechanic and replaced the TPS, thinking it would fix it. What to do next. My mechanic fixes cars, but doesn't do it professionally. I don't have the money to take it to a dealership.
Now, after doing a tune-up and changing out other sensors the RPMs came down to 3 and will stay at 3 rpm when I start the car. When I drive it, it pulls on it's own without touching the gas pedal and is hard to brake. What else I need to fix or replace?
View 6 Replies
I am trying to fix the pesky hard start that I have. My car doesn't start right up anymore unless it is frozen cold. Other than that it takes 2-3 cranks sometimes 4 to turn over. That's annoying and embarrassing and I am trying to remedy it ASAP.
I have a check valve and Purge valve on hand right now. In my research it seems this is where I need to focus. I do have an engine code it was P0456 this time. I also have a gas cap.
I have a check valve because of the all too familiar cutting off early at fuel pump problem. I wanted to start there first since I am sure something needs repairing down by the fuel tank and since the problem is common. And hopefully the valve will work with the fill up and MAYBE with the start, if not that is where the purge valve comes in.
I got as far as get the 2 12mm bolts off and then couldn't make it any further.
View 2 Replies
Ok so I disconnected the fuel line and the fuel pumps when I turn the key to on and when I crank it it's not pumping gas ..
Changed the relay
Changed the crank pos sensor
I'm at a loss what would cause the fuel pump not pump when cranking?
View 2 Replies
Its a 2002 Santa Fe 2.0 turbo diesel. When driving the engine will suddenly cut out. Its as though the ignition has been turned off, there is no hesitation or warning, it just shuts down.
This is what has been done so far: New high pressure fuel pump fitted by main dealer in June. My mechanic has fitted a new high pressure fuel sensor, new low pressure fuel pump (at rear by fuel tank), changed relays around, checked all fuel injectors (found in good condition) and checked various connection plugs and wiring. At motorway speeds the engine will not cut, its only at lower speeds. When it cuts the EML comes on with a 'Fuel Pressure Fault' code. Sometimes the light doesn't come on. Sometimes the light comes on but will go out the next day. When the engine cuts out you have to wait 20 seconds before it will re-start. If you try to start before this the engine will only turn over without firing. The car has only done 79000 miles. The main dealer gave up and said they don't know where the fault is because the code is not specific enough.
View 6 Replies
