Elantra MD (2010-15) :: Transmission Shifter - Gear Selector Would Get Stuck In Neutral
Aug 20, 2013
Just got my 2013 Elantra Limited last weekend. It appears the car is having some issues with the transmission shifter. I am not sure if its tranny related, but I highly suspect it is. Dealer gave me the usual bs not being able to duplicate the symptoms.
1. Intermittently, gear selector would get stuck in neutral, when I try to put the car into P, after a long or a short drive.
2. I would have to wiggle the shifter to get into P, or I would have to shift to D, and then I am able to shift back into P.
View 22 Replies
Advertisement
There is a medium sounding clicking coming from the gear selector area. I understand this must be the mechanism that prevents you from accidentally going into reverse when you are driving. However, the sound really is irritating and the car did not used to do this. I have taken it to the dealer, which states it is normal and there is nothing to fix. I have been doing some research online and it appears an easy fix is to just grease it back up. It appears over time the grease comes off or something. That being said, how do I get the initial gray plate off? (see picture)
View 6 Replies
I am the proud new owner of an 2004 GX 470 4X4 with 103K. I don't know how much cross over there is to tundra solutions. But, I own a 2000 Tundra, and I've been over there for a while as Listen Up Sonny. Anyway, I purchased the truck with two issues:
1. The 90K maintenance has been "deferred." I'm getting it into the shop for timing belt, waterpump, pulleys, and seals. I am going to do the spark plugs and fluids.
2. The issue I am still trying to figure out is that the dash shift indicator light for the High/Low gear shifter is stuck in Neutral. By this, I mean no matter where you shift the gear, the light indicates "N." I don't believe the transfer case is actually stuck in neutral since the car drives fine. I can get the center differential to lock and unlock. I am not sure if the transfer case will shift into Low as I couldn't really tell when testing it on a dirt low.
View 4 Replies
My manual transmission got stuck in 4th because of a melted oil trough sticking between the gears. I got all the plastic out, and the dog clutches/collars are "free." But, I don't know how to put the gears back into neutral. When it's reassembled, the stick doesn't work to change the gears. How can I get the gearbox back into neutral?
View 19 Replies
Volvo Automatic 1992 240 - So, just started to back out of the garage and, all of a sudden, my gear shift got stuck in neutral and then started shifting without engaging the transmission at all. Pushed it back into the space and, taking a look underneath, I realize the control rod's completely detached from the lever in the transmission.
I can re-attach it, but it just comes loose again when I shift. It seems like something should be in there to hold the control rod in place with the transmission lever, but I don't know what because I can't seem to find any documentation on what everything should look like down there.
Attaching a couple shots, one with a circle around the area that's coming un-attached since the angle's a bit off.
Attached File(s)
IMG_8972.jpg ( 1.09MB )
IMG_8978.jpg ( 938.64K )
View 1 Replies
I have a 2005 Elantra GT hatchback that I love with a 5 speed transmission. Lately every time I'm in 2nd gear, the transmission will pop out of 2nd into neutral. This only happens in 2nd gear. I heard it could be the shift collar (i.e. teeth?) that aren't grabbing in that gear.
View 5 Replies
I have an Elantra 2012 sedan GL and last year i tried installing HID's. It worked for a whole but then it stopped after. I learned that it wasn't getting enough power so then yesterday I bought a wiring kit to be able to wire my HID to tap to the battery to get more power. Everything was fine till I got to work but when I had to leave work., there was an issue. Whenever i switch the gear from park to drive or reverse or neutral. My car seems to jerk. And when I'm driving and it changes gears, it also jerks. Kind of the same thing how if your driving a manual car and you change gears wrong. This happens when my lights are off. But when i turn them on it then stops. And when i turn it back of it doesn't do it anymore.
View 5 Replies
This past Sat, when I started the car in the morning, noticed that the Gear selector indicator in the MFD is stuck. The display background is reversed and moving gears does not change the display, in the regular or sports mode. When I go from P to R (or D), I occasionally have a jerk. I drove the car car a bit since and no other apparent issues. It is a Triptronic.
View 6 Replies
Yesterday leaving a restaurant my truck shifted into reverse no problem but when I went into drive the shifter came all the way down to 1st and now the shifter can't go any higher than D and its stuck in 1st gear. The shifter moves with a lot of resistance between drive and 1st but never actually locking into any gear, I've taken the dash apart and I don't see any obvious damage but idk what to look for. I have also disconnected the cable from the column and now the shifter moves freely, so I hooked it back to the column and then disconnected it from the trans and it goes back to being stuck.
View 5 Replies
My auto transmission in my 2007 Elantra with 125,000 miles went into default mode, stuck in 3rd gear. No codes went off. I drove it home this way, but after sitting for 90 minutes, now it works fine. I've heard about the input and output sensors. What should I replace? I went to HMA service to get info on both sensors, but it wasn't detailed enough.
View 3 Replies
I have 2011 Elantra at ~20,000 mile, and strange things started happening since last year...and it kinda blew up today.
My dashboard has been flickering randomly for a while, as in everything goes dark and turns up again in the middle of driving.
And today it turned off and turned on (as it usually does), and the dashboard seemed broken; speedometer stuck at 0 mph, rpm meter stuck at 0, all warning lights turned on, gas meter going up and down and stuff.
Fortunately enough I was close to home so I drove it back home, and my gear shift was stuck at neutral (I could switch b/w N and D).
So I took out the shift lock release? thing and managed to put the gear to P and pull my key out. I stepped out of my car and I smelled something burning...not a very good sign. What should I do? Well I think I need to take it to dealership tomorrow but I'm not sure if it'll be safe to drive...
View 4 Replies
I have a 2011 Elantra 1.8 automatic Gls with 133k miles. While driving approximately 70 miles per hour the car downshifted to fourth gear, and would not shift up or down. I drove the car home and found that this is called "lump mode". I checked the codes, and found P0880 tcm voltage input. I replaced the fluid temperature sensor and harness, and checked continuity through the harness. I found no problems in the harness from the tcm to the solenoid connector. I then purchased a matching tcm, but the problem persisted. If the battery cable is left off for several days the problem will disappear until the car warms up.
View 4 Replies
I don't know what is causing this but I bought a 2012 elantra last week (500 miles on it so far). Yesterday when I went to start my car the clicker wasn't opening or locking the doors so I had to use my key to open the door. When I got in my car would start but was "stuck" in park and I couldn't shift past park (yes I had my foot on the brake). After about 10 minutes it just randomly worked... Today I was driving to work stopped to get gas and as I was stopping I realized I couldn't shift passed neutral to put in park (I could go back and forth between drive and neutral). While this was going on my windows would not go up or down. Again after 10 minutes the problem seemed to fix itself. What could be causing this?
View 12 Replies
Figuring out automatic shifter problem, the car only has 56k miles & it has problem (since 30k miles) shifting out of Park or stuck in Park, often I had to use the mechanical override to release it so I can put it in Neutral to start the engine. When placed in Drive, it kind of "floats," does not have the normal confident in-the-gear feel & sometimes it slips out of Drive to Neutral with the slightest bump of the gear shifter when driving or when stopped. When I shift, it does not have a free easy movement, it feels like the cable is restricted by corrosion or dirt, but everything looked good & seem shielded. Took it to a shop & they suggested that I just drive it... I've since put over 20k miles & its getting worse at finding Neutral to start the car with.
View 2 Replies
Fix a Loose Column Shifter on Ford Vehicles - YouTube
The first pic shows the torx screws that come loose, allowing the handle to get sloppy.
The second pic shows the black plastic adjuster wheel that centers the gear shift selector needle on the proper designated gear displayed in the indicator window.
View 12 Replies
I'm having an issue with my clutch and I'm really in a hole. Two days ago I was driving my car and everything was fine. Later in the day the shifter got stuck and would not budge out of 5th gear. Eventually it popped out. Driving like normal again and then yesterday I was on my way home from work and all hell broke loose. I was a mile away from my house and the car would not shift into any gear without a fight.
I also at this time lost my clutch pedal. It went really soft but did come back up.. it would not engage however. Limped it the rest of the way home and took a look at it. What I came across was a full brake/clutch reservoir, no leaks around the slave, and I didn't see any leaks around the master. I will say that after the car sat for about 10 mins the pedal felt normal again but quickly went soft after a few pumps.
2.0 AEG 5spd. Trans code DZQ if any of that would be relevant..
View 3 Replies
I have a 2013 Hyundai Elantra with an automatic with the Tiptronic transmission. last week I went to put the transmission into Tiptronic mode and it would not go in. it like crunch to the right and would not shift gear up or down nor would the gear number appear on the digital dash.
View 1 Replies
The gate to the right of the PRNDL gate of the automatic transmission in my 2003 1.8T with the "+" and "-" stopped working. What may be wrong? The transmission works fine and shifts normally. I did replace the fluid recently but did nothing except remove the fluid and refill.
View 2 Replies
I have a 1997 F-150, 2 wheel drive, 4.6L truck. Recently the transmission got to where it didn't shift properly. Then it got to where, after driving it about 10 to 15 miles the transmission would drop out of gear with the transmission selector in drive.
I have replaced the transmission sensor, the rear end sensor and it still does the same thing. Drive about 10 to 15 miles and, with the transmission selector in drive the truck will not pull. The motor can be rev'ed but the truck won't move just like it was in neutral.
What is wrong. The transmission shifts fine, the truck runs fine, but after 10 to 15 miles the transmission quits working.
View 1 Replies
I am just about committed to purchasing a 1997 Ford E350 extended cargo van with the 5.4. The transmission shifts through all the gears nice and firm (reverse also works). The only issue with the van is the column selector lever is very hard to move between the entire range of PRND21. It also does not "click" into the selected positions, you have to just line up the pointer to the desired gear selection.
Is this a complete deal breaker (internal transmission issue/replacement necessary) or, is it something relatively simple (such as a worn selector cable). The owner did admit the van has been sitting for sometime. It has 134,000 miles on it.
View 10 Replies
I have a 2002 Camry with (440K Kms) and automatic transmission. I am the second owner and had this car since 130K Kms so I have been driving it for a while. The car was in great condition but recently, the transmission started to give some trouble where it's gear changes were not smooth. Also, when I would come to a complete stop, trany would go into neutral even though I have not touched the gear shifter and it is still in drive.
I had my mechanic drain and fill transmission fluid since it was a bit dirty. A few days later, the car would park with gear box in "P" but no matter which gear I would put the gear shifter into, it would remain in neutral and won't pick up into any gear at all. So, I parked the car on the driveway. Couple of days later I wanted to try to see what the issue was and now, no matter what gear I put the gear shifter into, it stays into park.
View 14 Replies