Elantra MD (2010-15) :: Slight Bang Noise From The Driveline
Sep 26, 2013
I have been hearing a slight "bang" from the front of my car , mostly when I either step on the gas or let off. It's very faint, but annoying.
So last Monday I make an appointment for the car to be looked at, and after the dealership telling me I need two other things (recalls/TS done before they will even look at the problem I am calling about, I ask that a tech be available to ride with me to cut down on the diagnosing time. They tell me that all this work will take over 3 hours, and because I live 11 miles from the dealership, they won't give me a ride, I can either get a ride from someone, wait, or get dropped off at a local mall.
After dropping the car off they tell me, other than the banging, I need a ECM update and muffler clamps for the rattling heat shield. I tell them the heat shield was removed because it was falling off and I was on a long distance trip and couldn't stand the banging against the car. They tell me, don't worry, we'll fix it. I ask that a tech ride with me and was told that, if it's audible, we'll find the problem. So, my first mistake was that I trusted them, and I leave.
About 5 hours later I get a call telling me the car is all set. I ask about the banging, they tell me it couldn't be replicated by the tech after a 10 mile drive. I was a little upset. So I guess the whole point to this story, if having any kind of noise from the front end, or when shifting into park or reverse, it's probably the TSB for the driveline axle washers.....
View 12 Replies
Advertisement
I bought an Elantra last year and completely love it. I did notice a slight rollback when I first applied the handbrake but wasn't overly concerned because I always parked in gear anyway. But yesterday, my Elantra (parked on a sloping driveway, in first gear and with the handbrake on) rolled backwards about 5 minutes after my husband had parked it. It smashed into our wall, causing a lot of damage.
This terrifies me. My kids could've been (as they often do) unpacking their bags from the boot. My dogs often lie on the driveway. Someone could've been injured! What do I do?
View 17 Replies
Is this a normal thing? I notice that my 2013 Elantra has a slight shudder when stopped in drive, most noticeable when the Air is on. It's not always there, but I would associate this with a low RPM idle.
Is this normal for these cars? It goes away when in park/N, and sometimes if I turn the air off completely.
View 14 Replies
I've had my 2013 Hyundai for about a week now and I feel a slight vibration/shaking when the car is stopped and I have my foot on the brake. When I was in the finance office signing all the papers, etc. The finance manager was trying to sell me the free oil changes for 3 years/tire rotations/filter change for $600. He was adamant that if I do not get all my service done by Hyundai dealer all the warranties are voided. I asked him specifically this question at least 3 times as I was appalled at the notion, and time and time again he would say the second you bring it somewhere else for an oil change the warranty is voided. 5 days later I brought the vehicle back to get my sticker, and I asked the guy at service, he said absolutely not. He said it doesn't matter as long as you have the proof/receipts.
View 18 Replies
I know all Hyundai's 1.8L Nu engines have that quiet ticking noise. But is there a slight knocking sound on the left side of the engine (around the belt area)? Could this be just the timing chain noise? It does this on idle but when on a constant speed/rpm, the engine is quiet.
View 10 Replies
No codes, transmission makes a slight grinding noise when putting it into reverse only. Has a slight bump from 1st to 2nd. I flushed 16 quarts of the sp3 through it. Been researching and see a lot of talk about the output and input sensors. Not my car but my sisters. Needs axles, timing belt water pump, ps return hose, plus have champions in there and old ass hyundai wires.... thing does idle rough, motor mounts are new.
View 1 Replies
Have 2008 Santa fe with a driveline hum noise. Originally thought is was a wheel bearing so I replaced what I thought was the suspect ones (1 in front and 1 in the back). Noise still there! Carrier bearing on the drive shaft? Front axle shaft? I'm at a lose.
View 7 Replies
1988 F-150 4X4, 302, 5 speed manual Mazda transmission. I picked this truck up from a teenager and have been going through it fixing the odds and ends, just when I thought I was done a new one popped up.
There is an odd "clunk" in the driveline, but I cannot pinpoint where it is coming from. It happens almost exclusively in third gear, shifting up or down into this gear. It has happened in first gear one time that I can remember. When it happens, I hear the pop (clunk), then feel a slight jerk like when a chain slips on a bicycle.
I spent some time under the truck yesterday trying to locate it, but had no luck. Did find the yoke on the rear end , 8.8, a little loose. Found that the U-joints at each end of the driveshaft were worn out. The transfer case, BW 1356, was quite low on fluid. And there was nothing out of the ordinary with the transmission.
Tightened the yoke, replaced the U-joints, drained the T-case and refilled with fresh ATF and pulled the fill plug on the tranny to ensure it had ATF instead of gear oil in it. It did.
I hoped all of that had solved my mystery noise, but I wasn't that lucky so now I need to isolate it. Seems that if there was a problem in the T-case or rear diff, the noise would be present trough all gears wouldn't it? With it being primarily in one gear, could the problem be in the transmission? If so, can it be rebuilt for a reasonable price?
View 9 Replies
2007 Passat 2.0T, 48,000 miles
Essentially, I get a clunky/pop/crinkle sound from beneath my feet in the driver's side footwell. This sound/feel occurs when I either get back on the gas after slowing down but before the car fully stops or if I take my foot suddenly off the accelerator without touching the brake.
VW told me after three tries that the "noise is from the driveline changing directions, making some noise because loads are changing on the driveline when going from deceleration to acceleration" and that it was normal.
I have seen some posts about the subframe bolts either being faulty or worn on this site and other VW sites...
View 12 Replies
I have been recently working on a 2003 1.8T fwd Passat that I have owned since new. I recently changed the front rotors, pads and CV axles. At low speed everything is great. No vibrations or unusual harshness. Starting at about 35 mph a low frequency driveline noise starts from the driver side and starts to get drummed out by engine noise above 60 mph. The noise is not very noticeable from the passengers seat. Initially I suspected a tire, but I swapped tires front to back and the noise didn't change. I have tried loading and unloading the front tires in 45-50 mph s-turns and the noise doesn't change.( I was thinking wheel bearings). I put the car back up on stands and tried hand spinning the wheels. No unusual noise was present. I have not found any clearance issues where there might be something rubbing. I got the axles from Raxles and am at a loss. Could this be a wheel bearing or a bad CV joint? How can I tell?
View 7 Replies
It's NOT a truck. But my '97 Town car happens to use the same 4R70W transmission and 8.8" rear axle that the F150 from the same era used to use....
I'm troubleshooting what I first thought were bad pinion bearings in the rear differential. On the highway the car makes a shaking/growling kind of noise that fades in and out from 55 MPH and higher. Also when you're on the throttle there is a howling type of noise that comes from the rear of the car, the harder you're on the throttle the worse it is.
I got under the car convinced that my pinion bearings were shot, looking for the smoking gun. But I can't find any noticeable play on the pinion shaft of the rear axle. Slid on up to the front of the driveshaft and there's noticeable play on the extension housing of the transmission:
2013 12 27 19 06 40 - YouTube
Any chance this is causing my issue, or am I in for some expensive rear end work?
View 12 Replies
When I'm in 4 high and I coast I can hear something from the front drive line. It's a soft whirring/grinding type noise.
If I'm accelerating there is no sound . Only when the driveline forces reverse and the engine starts to slow the truck do I hear something.
With my hubs locked but in 2wd I don't hear anything.
Is this something to be concerned about or is it regular noise?
We have had a brutal winter so I've been in 4x4 75% of the time.
View 1 Replies
I have a 2010 with about 166k miles. I am getting a slight hesitation at slight acceleration or constant speed. It does not matter if it's on highway or freeway speeds. Now I am not sure if this in junction with me changing the PCV valve, cleaning the EGR pipe, or cleaning the TB for carbon recently. It started happening a week after it though.
View 19 Replies
Just wondering if I should be concerned. It doesn't happen every time, but it sounds like grinding of a gear or something like that. I made a video .....
View 19 Replies
My 2015 is making a strange noise most noticeable when making a slight right turn up a driveway. It sounds like a spring popping.
View 3 Replies
I have a 2010 Explorer XLT that I bought in 8/2012 with 7,000 miles on it. I had had a problem with a groaning noise and slight vibration starting at 34 mph, under load. I don't hear the noise if I let off the gas at 34. I hear it a little past 35 or so and it doesn't seem to groan again until about 60 mph or so. I also have a feeling of the all wheel drive engaging when I back out of the driveway, put it in drive and turn the wheel slightly.
I took it to the dealer this week under warranty and he calls me today and says the tires are worn differently all around and that is causing the problem. He says the tires could be out as much as, or as little as 1/16 of an inch and that is what is causing the all wheel drive to catch and also the groaning noise. I understand what he is saying, but I can't believe that is the problem or more would have been written about it.
I asked the guys about rotating the tires and he said it would not matter, it would just take the problem from one end of the vehicle to the other. These tires are not worn like the truck is out of alignment, it is just normal wear. It now has about 21k on the odometer. What do you all think of this diagnoses? The guy says the PTU thinks it needs the all wheel drive and therefore engages it. This truck can also be manually put in 4 wheel drive by flipping the switch.
View 14 Replies
I took my truck in for a clunking noise in the driveline as I come to a stop and sometimes when shift into park. It is now the 7th and I'm told parts have been ordered and the truck will be worked on when parts come in. I asked to speak to general manager and still no call back. I called customer relations and nothing they can do.
Honestly I think the have me on the back burner since I'm warranty work opposed to marked up repairs. Am I being unreasonable on my expectations of repair time? I called around and a ring and pinion job is quoted at 3 days at the most. Other repairs have been approved as well and parts are in for those, but they have not actually repaired them either.
View 14 Replies
Ive got a 2013 Accent with 16,000km on it. It has an automatic transmission. The noise is when i pass from R to D, or P to D. It is an intermittent noise, so it does not do it all the time. But when it does, it makes a loud "bang" that can be easily heard and felt in the floor. Ive had it checked by the dealer, but it never does it when its in the shop.
I always let the idle go down before shifting into gear and even if i hold the brake hard to change gears it does it anyway. It doesnt matter if the trans is cold or hot. And no, i never change gears when the car is still rolling, always when i have stopped completely.
View 7 Replies
I pulled the EX into the driveway today and as soon I put it in park as I was turning it off there was a loud pop / bang noise somewhere in the front. My husband was already taking it to get new tires so I told him about it and he left to go get the new tires. He said he right away noticed it pulling real bad to the right (I did not notice this and I am VERY in tune with my truck). When he got to the tire place they brought out a big bolt they found in one of the front tires. He said it drove fine all the way home after he got the tires put on. I get in it to run an errand after he brings it back and immediately notice it rides lower. We had the exact same tires put on it that we always do. I also notice a rattle noise and feeling under my left foot that is sitting on the floor as I am driving. I wonder if I broke a shock or something but he looked and says he can't see anything broken. I have a 9 hour trip to go on with my children soon so needless to say I am a little concerned.
View 14 Replies
While driving I went to speed up and heard a bang. I lost all drive. I have no movement in any gear. I got the truck home and looked around. Trans fluid looked and smelled ok. I couldn't move the rear drive shaft by hand with engine in neutral. I drained the transfer case and that fluid looked fine also. What it could be or what else to look for. The truck is a 2006 f350 with 6.0 and 185,000 miles. Up to this point I had no trans issues.
View 14 Replies
I have a '06 Mercury Mountaineer, right over 100,000 miles. For the past few months the car has started to make a sound and even produce an "clunk" that I can feel when I am slowing down to come to a stop. It only happens when I slow down to around 3-4mph or slower. The transmission has only around 10,000 miles on it. What could be causing this?
View 9 Replies
