Elantra MD (2010-15) :: One Clink / Ping Sound When Shifting From Park To Reverse?
Sep 27, 2012
It only really happens when the car has not been warmed up, like first thing in the morning. Aside from the noise, the car shifts and drives normally. Noise just developed, 28k on the car, it is a 2012 elantra. As I shift from P to R while backing out of my garage there is a metallic clink/ping as the transmission engages.
It is not a CLUNK sounds, it is deff more on the side of a metallic clink...
View 4 Replies
Advertisement
I have the 2012 Limited and I have noticed recently, or maybe it has always been like that and i just noticed it. When I shift gears put it in reverse or in drive, there is a knock or ping. How it can be fixed?
View 3 Replies
I have an Elantra 2012 sedan GL and last year i tried installing HID's. It worked for a whole but then it stopped after. I learned that it wasn't getting enough power so then yesterday I bought a wiring kit to be able to wire my HID to tap to the battery to get more power. Everything was fine till I got to work but when I had to leave work., there was an issue. Whenever i switch the gear from park to drive or reverse or neutral. My car seems to jerk. And when I'm driving and it changes gears, it also jerks. Kind of the same thing how if your driving a manual car and you change gears wrong. This happens when my lights are off. But when i turn them on it then stops. And when i turn it back of it doesn't do it anymore.
View 5 Replies
First time Lexus and RX350 owner. Not familiar with the new type of shift gear. When I shifted the gear from Park to Reverse straight down instead of moving to the right first, the vehicle would jerk and make a thud sound. Not sure if this would have damaged anything. After I have get used to moving the gear to the right first before shifting down, I would still sometimes have this jerk/thud. But if I do the whole shift movement (shift the right first) real quick then the chance of getting the jerk/thud is much less. Is it a manufacture defect or just I am not doing it properly?
View 5 Replies
My Hyundai Elantra 2014 SE makes a cool psst sound when shifting to 2nd gear (haven't tested next gears). It makes me feel like I have a Turbo! The sound is very low, tho. It only happens when i accelerate the car hard. Anyway, i don't think this is normal.
View 9 Replies
I have a 2013 Elantra, owned since new... I recently started hearing a knocking sound coming from both front wheels while turning in reverse. I have yet to take my car in to have it looked at, if I can do it myself I will but I'm not sure where to start.
View 3 Replies
My 2010 Corolla LE with 1.8L engine with auto transmission has about 37,400 miles on it. Ever since I bought it with 7k miles I notice a slight knock/ping sound when I accelerate up to 40 mph. The car is certified up to 100k.
Also, on cold starts recently, it seems to make a loud noise. Hard to describe but it's almost like something is grinding for a second or two. This does not seem to happen all the time.
View 8 Replies
I have noticed only recently a strange "ping" sound that is coming from the rear driver side wheel. The sound is exactly what two pieces of rebar sound like hitting together. The car only makes the sound once while slowing down at around 3mph and once again while accelerating at the same speed. The should can not be heard under heavy breaking however. I have jacked the car up and pushed on the wheel at 12 and 6 oclock and 3 and 9 oclock to see if it was a bad wheel bearing and it was not. It is a 2010 Subaru STI with 45000 miles. I am wondering what this could be.
View 5 Replies
My 2013 Elantra won't shift out of park. I know that I should check fuses, but what fuses might be associated with this. (The brake lights are not affected).
View 2 Replies
2002 Camry, Automatic Transmission
Have an occasional problem. When shifting from park to drive/reverse, I occasionally get a loud, brief (1 -2 seconds) rattling noise from the engine compartment. It's my daughter's car so not sure yet if this is a cold start only issue or if present after car has been driven, then stopped and re-started. The problem does only occur occasionally. Where to start troubleshooting? I've looked for loose external pasts with nothing found.
View 10 Replies
My 1998 Ford Explorer XLT v6 with about 233,000 miles on it has a bit of a problem. Infrequently, when I shift into reverse from park or neutral the engine dies. It restarts without issue. There are no strange noises or smells when this happens.
The transmission was rebuilt 10,000 miles ago by a reputable mechanic. Almost all of the 230k+ miles are highway miles. Each trip around 40 miles.
View 2 Replies
I recently purchased a 2005 Elantra Automatic, my question is, when shifting it out of park, the shifter doesn't stop at "D" but at "3" is there an adjustment or is it just a quirk of the car?
View 2 Replies
My car literally started doing this thing where it sounds like a vibration or humm when putting my Elantra into reverse.
View 2 Replies
Almost every morning, when I put my car in reverse and then step on the accelerator, I hear a sharp "clink" sound from the front of the car. After I've backed from the driveway to the street, I put the transmission in drive and step on the accelerator again and often hear the clink again. It doesn't happen EVERY time, but has become very common in the mornings. It only started doing this within the last month or two. I haven't observed any other problems.
The car has about 80k miles on it and has not had any transmission work done.
View 2 Replies
What can I do about my car it's not shifting, it's stuck in high gear and when I go from park to reverse it makes a loud thump. The check engine light came on and the codes are transmission control module it's a 2006 and only has 30,000 miles on it. It's hard to believe it's the brain so we changed the fluid and cleaned the sylinoids but then when I drove it around the block I put it in reverse it didn't make the loud noise and it shifted fine for a minute before I got around the block and almost home it made a loud banging noise and went back to not shifting again. What the problem could be.
View 5 Replies
Recently I've noticed that every time when shifting from park to drive and occasionally from reverse to drive in my 05 Golf GLS, I would have to remain off the gas for 3-4 seconds otherwise the car would jerk forward. If I press on the gas ever so slightly, the rpm would go up to around 1000 then jerk. Why this is happening?
View 2 Replies
The last couple winter's we've experienced a significant "clunking" sound when placing the van from Park to Reverse. It doesn't do this by moving the gear shift from Park to Drive or Neutral. This only happens when the engine is cold and has been sitting for several hours. Outside temps below 35-40 degrees. Don't have the problem in Spring, Summer, or Fall. We have 177K miles. Transmission fluid/filter has been changed regularly by my mechanic according to Honda's instructions.
No problems with the transmission or engine since we've owned the vehicle, and we've been the only owners. No leaking found. Honda thought the problem could be a rear engine mount. Just had another local mechanic (I'm 65 miles from the nearest Honda dealer) whom we trust replace the Rear Transmission Mount. Still have the clunking noise, and you can really feel it too. It's been a great van for us, and we'd like to keep it another 50K, if possible.
View 6 Replies
I started noticing that when I shift the car into reverse to back out of the driveway, the car door locks sound like they are trying to lock/unlock repeatedly for a couple of seconds. I know the car automatically locks the door when I shift out of park, but the multiple retries is a new behavior. All doors do lock. I do have the child locks enabled for the rear doors and that hasn't changed in 3-4 years. I also disabled them and the retries persist.
I have also noticed that around the same time (past month?) I must push the unlock button on the keyless entry remote twice to unlock all the doors--including the driver side door. In the past I only had to push the button once to just unlock the driver's door and the side lamps would flash, but one push doesn't do anything anymore. I've never changed the battery in the remote, but does the car care that the remote battery may be running low to exhibit this behavior? It's a 2010 SF with 52K miles.
View 5 Replies
I only notice this when I back the car from the garage and come to a stop before going forward. It is a very metallic clunk. It sounds like its coming from the rear passenger side but I am. not 100% certain. It happens when I actually stop before switching to drive.
It is a 2013 Two. 30,000 miles on it.
View 4 Replies
I have a 13 Altima and have been hearing a clunk/pop sound when coming to a stop and sometimes when changing from park to drive and park to reverse. It seems to also be there when accelerating too and the car is also seem to be vibrating when moving at lower speeds. Today i noticed something else. I parked the car and took the key out. I went to the side of the car and slowly rocked it back and forth and started to hear this clunk sound. I have uploaded it to youtube and can be found here [URL].... . After hearing the sound, I decided to take the driver wheel off and noticed it makes the same sound when i move the tires. It seems to be coming from the CV joint, where it connects to the transmission. why would a car make that clunk sound with the car/key off and swayed back and fourth? does this seem like a CV joint issue or something related to the transmission.
View 3 Replies
My brother-in-law asked me about his 2010 Hyundai Santa Fe. It has an automatic transmission, that's where the problem is. Several times recently it doesn't want to go into reverse or park. Shifts fine, fluid fine, no smell or noises. Vehicle has about 68,000 miles on it.
View 1 Replies