Elantra MD (2010-15) :: Metallic Pop When Engaging Reverse
Sep 25, 2013
I've started noticing this only when she's cold and I have to back out of the garage in the morning. I generally wait 5-10 seconds after I start the engine before going into reverse but lately I've noticed a muffled metallic 'pank' coming from the engine compartment when the reverse gear engages. I can't say I feel any 'thump' to go with it and I'm racking my brain to see if this is a new development and I have a possible transmission issue or if it's been there all along and I never noticed.
View 31 Replies
Advertisement
I only notice this when I back the car from the garage and come to a stop before going forward. It is a very metallic clunk. It sounds like its coming from the rear passenger side but I am. not 100% certain. It happens when I actually stop before switching to drive.
It is a 2013 Two. 30,000 miles on it.
View 4 Replies
2010 Prius 52K miles... Not engaging in Drive or Reverse, Engine is not starting either. Got Message - Put in park , All the lights are ON , in the Dash .
View 11 Replies
In the last week the I've noticed a moldy metallic smell when I turn my ac on. I've tired to come up with what I would liken it to. Almost as it the ac hadn't been turn own in months or it was almost out of freon. It's only a month old so I wonder what it might be.
View 5 Replies
So fairly recently, I've noticed a metallic-ish click like noise from my back rear driver side wheel. I hear it on occasion when sitting down in my car and the car tilts slightly. I can reproduce the sound when I take my hand and rock the car just a little bit. What that might be? Or if I should be concerned?
View 9 Replies
just about a week ago, i've noticed this weird rattle coming from the front end, sounds metallic (maybe something is loose) but it only happens when I accelerate from 0-80km/h, but the sound isn't there if I slowly accelerate. Nothing seems to be wrong with how it runs, its just the sound that sounds horrible, like nails on a chalkboard.
Also, I've noticed the engine ticks really loud when it gets started. However, the sound goes away after a minute of idling.
There is about 19,000 kms on it and I got it in January .. I travel a lot maybe a little too much.. I want to take it in to the dealership, but I'm pretty far from it and would like to know what it could be before I take it anywhere to get fixed.
View 12 Replies
Tis the first of "Squeaks and Creeks" from me. Not really the best thing to hear, sitting at ~24K miles. Anyways, until (if) i can get a sound clip, I have this metallic rattle that only occurs about 1-3 mins after i start the car. This just started happening yesterday, and nothing out of the ordinary happened.
I start the engine, hear a raspy rattle from what sounds like under the engine, and if i give it some throttle it increases some, but not to the point where it sounds like something is banging around. It goes away after a few minutes so it could be anything. Shifts are still smooth, driving and getting on the gas does not fix nor make it worse, either in neutral or actually rolling. It simply goes away with 3 minutes time or so. It seems to have a limit for how much 'rattle' it gives off, and its something I can accept.
View 4 Replies
My car has developed some intermittent noise but I can't pinpoint the exact source, though it seems to be coming from the front. I hear it in 1st gear when accelerating, and it's more audible if I have my windows down. A faint metallic grinding/friction/rotating noise is how I think I could most accurately describe it. I do have an oil change coming up in the next few weeks and will mention it then.
View 2 Replies
Just took possession of new 2013 elantra with nav and leather for my wife.
Is there any way to convert odometer for km to miles,
same question for the inside/outside temp.
Outside gauges says 2C inside temp set at 71f.....
I have looked in the manual to no success...
View 10 Replies
In my 2012 Elantra Limited that has less than 2000 miles on it, I occasionally get a chattering type noise when I put the car in reverse. It goes away when the foot is off the brake and car is in motion but reappears when braking to shift to drive. It only happens probably 5-10% of the times that I need to put the car in reverse. I stopped by the dealership and asked if they knew what it was and he said it was the brake calipers and there was nothing to do to resolve the noise.
View 48 Replies
2012 elantra ltd.
Today noticed a knockng sound louder than the usual engine knock. It only occurs when we put car in reverse. Checked it with the brakes applied so as to eliminate it coming from any source due to the car moving ie axle/drive connections etc. Putting it in D with brakes on, not moving and it goes away. Put it back in reverse and it recurs.
Tried it even after the engine had warmed to temp guage showing half way. Let car sit for a bit (so engine was still warm) and it repeated. Drove for a few minutes and it would not occur. Shut car off for 1 hour, on restart the engine temp was showing it was still warm and the knock would recur in R.
View 9 Replies
I have a 2013 Elantra, owned since new... I recently started hearing a knocking sound coming from both front wheels while turning in reverse. I have yet to take my car in to have it looked at, if I can do it myself I will but I'm not sure where to start.
View 3 Replies
See this thread (or the countless others) for background info: [URL] .....
Basically, at least for me, ever since my R32 was new I would hear this metallic "tink" sound when in reverse. Usually noticed at the end of reversing, just about when I hit the brakes to shift into drive. It happened always. Flat ground, slopes, cold engine, warm engine, etc...
It sounded like a coin dropped from my engine and landed on a piece of sheet metal. It never bothered me enough to take it in for service, but it was still annoying.
After a fellow OZ R32 owner suggested dampening the tranny cable with silicone (or similar), I finally decided to take a crack at this sucker. You'll have to remove the airbox to access the heat shield.
Here's a closer look at the problem area:
And a closer look, showing the torn heat shield that protects the tranny cable from the exhaust. The obvious guess here is the tear was allowing the shield to move against itself, causing the noise I would hear.
All I did was bend the shielding away from the cable a bit so that they weren't pressed against each other anymore. Didn't bother trying to insulate the cable with silicone or anything. Fixed my problem 100%, can't believe I've waiting this long to do this 5 minute fix.
View 24 Replies
I just started hearing a loud click when I change from park to reverse and from reverse to drive. If I keep moving the knob between those three spots with my foot on the brake and hand brake off, I hear a loud click at each spot. Hard to describe... anyway, this only happens when I first start the car, by the time I get to work if I try doing that when I park there is no loud click sound. The thing is, I don't know if this was always happening and I just noticed it now, or if it just started.
View 14 Replies
It only really happens when the car has not been warmed up, like first thing in the morning. Aside from the noise, the car shifts and drives normally. Noise just developed, 28k on the car, it is a 2012 elantra. As I shift from P to R while backing out of my garage there is a metallic clink/ping as the transmission engages.
It is not a CLUNK sounds, it is deff more on the side of a metallic clink...
View 4 Replies
The other day I noticed the car slipped into reverse fairly hard, then when I placed it into drive it also slipped in fairly hard. Once I was out on the road it hesitated and then slipped into gear 3rd then 4th, and when I slowed down it seem to hesitate when gearing down. Two days passed and no problems, then today started up again, and now the "check engine" light came on...! Shifted ok on the way home this evening but check engine light still on. Only 34K, 2012 bought in June 2011. Has been an absolutely brilliant ride up until this week. I understand the tranny is sealed ? Any tips besides taking it to a dealer ? Problem is I live quite a ways from one, and finding the time.
View 14 Replies
I replaced my rear pads on Sunday and the car drives and brakes great. This morning I noticed when I backed into my parking spot at work that the brakes were engaging to the point where I was on a small incline and the car didn't roll at all when I let off the brake pedal.
This was my first time doing the rear pads on my MKVI and my first time doing brakes on a VW. Is there some extra step required that I'm missing? I know the piston was a PITA, definitely not used to having to turn a piston while compressing.
View 19 Replies
I have an Elantra 2012 sedan GL and last year i tried installing HID's. It worked for a whole but then it stopped after. I learned that it wasn't getting enough power so then yesterday I bought a wiring kit to be able to wire my HID to tap to the battery to get more power. Everything was fine till I got to work but when I had to leave work., there was an issue. Whenever i switch the gear from park to drive or reverse or neutral. My car seems to jerk. And when I'm driving and it changes gears, it also jerks. Kind of the same thing how if your driving a manual car and you change gears wrong. This happens when my lights are off. But when i turn them on it then stops. And when i turn it back of it doesn't do it anymore.
View 5 Replies
In today's show, a caller with a Ferrari noted that sometimes the transmission would crunch when engaging reverse. I've never had the pleasure of driving a Ferrari, but two Porsches I owned (in my single days) had similar issues. There is no synchro for reverse gear.(Ferarri may be the same) So if I idled in neutral to get the gears moving and then shifted to reverse quickly, the gears would crunch as they meshed. A little drag from the clutch not disengaging completely or the pilot bearing dragging would make it worse. Two solutions are
1)let the transmission coast down by holding the clutch in for a few seconds before engaging reverse, or
2) shift to second, then straight to reverse.
View 1 Replies
I have a 2015 with 10k miles on it and every once and a while, when I come to a complete stop and shift into reverse, I take my foot off of the brake pedal and the car will sit there for up to 5 seconds. Then, it kicks in and starts rolling backwards. This has happened 6 times now. Giving it gas doesn't seem to work along. I took it to the dealer today for it's 10k service, and they cannot find anything wrong with it. There are no codes in the computer, the fluid is where it should be, and they think the Neuspeed Power Module has something to do with it. I told them it happened before I installed that piece. I can assure you I am not racing in reverse.
View 7 Replies
For a few months now I have been hearing a tap clunk type noise coming from under the car when I shift the auto trans into drive and reverse. Also sometimes when the car is slowing when driving I hear the tap sound as it shifts into first. I drove in by my local dealer and they listened to it and said Elantra transmissions can get noisy there is nothing wrong. They told me I have plenty of Warranty left so if something happens I will be covered.
View 2 Replies
