Elantra MD (2010-15) :: Fan Only Works On Highest Setting
Dec 30, 2015
I drive a 2012 E, and this is not about mine. It's a buddy whom has a 2013 or 2014 (I think all of the fan hardware is identical). His fan stopped working on the three lowest settings, but still blows fine on the highest setting.
Perhaps resistors knock the current down for the lower settings and they have failed? Just a wild guess....
View 4 Replies
Advertisement
My HVAC blower switch only works when I put it on 5 (the highest setting). What needs to be replaced (besides the whole truck)?
View 4 Replies
My 2010 Expedition Limited AC seems to be stuck in the highest fan speed setting. Changing the setting on the panel control do nothing to change the speed. But you can adjust the temp and it will respond. It is a dual control unit. When I try to turn the system to off completely it will go to what I believe is the vents and stay on full blast. If I turn the truck off and on again the whole system remains off until I turn it on again. The only way to turn it completely off is to turn it to off mode and turn the truck off.
View 1 Replies
Installing STs on my mk6 tomorrow. Doing it in a steep driveway. want to be on the highest setting when I leave. regular v1 st coil over.
View 1 Replies
So compared to my old Jetta, these wipers are "fairly" slow at the highest seeting, and in a down poor at 70 mph they do not clear the windshield fast enough.
View 5 Replies
So I have a 2005 GMC Sierra 1500 pickup that is in great condition. Recently, I have noticed that in the mornings on my way to work the blower fan would not run on the highest setting. After a while of driving, the highest setting would then work. This happened for about two weeks. Now, the blower will not turn on at all on any setting. Thought it might a simple fuse, but that looks fine. Should I take it to the shop? Could it be the blower motor that needs to be replaced?
View 3 Replies
I have a 2007 Nissan Versa and my AC will only run on the highest setting. The dealership suggested that the whole panel with AC dials needed to be replaced, they did say they were not sure this was the problem. In doing some research on the web I did see discussion regarding a Nissan Altima that had what sound like a similar problem and the fix was a part called the "blower resistor" which was much cheaper and could be fixed at home.
View 2 Replies
I thought I wouldn't have need of the defrost for several months yet, but today we had unusually cold rain and my windows soon fogged up. The fan (not a/c) was already running at a very low setting (one or two clicks only) when I depressed the defrost button. Roughly 15 seconds later, it was like a hurricane in the cabin! The fan moved to the highest setting all by itself. This did clear the windshield in seconds, but it was a bit disconcerting. This phenomenon repeated itself all three times that I engaged the defrost button. Is the defrost supposed to do that? I swear, the sudden change startled me so much, I hit my head on the ceiling of the cabin...
View 3 Replies
My A/C has been making a loud noise for a couple months now ,only when I put the A/C on the highest setting. I was LONG overdue for a cabin air filter change so I bought a new one and while I was down there I looked inside the blower motor and here's what I saw... It is now blowing fine and not making a noise . Sprayed some Ozium New Car spray on the new cabin air filter and my car is smelling great now !
View 4 Replies
2002 Dodge Ram 3500 van (engine unknown, but I think it doesn't matter). Blower operate only at highest speed setting. OK, that's the classic symptom of a failed resistor. Replacements are readily available at chain parts stores.
Where is the resistor located? This video shows me for a 2002 Ram 1500 van. Will it be the same on the 3500?
I've learned here that sometimes resistor failure results from bearings going bad in the blower, causing excessive current draw. Is there a way to test that other than with an ammeter? What's the correct current?
2a. If the blower motor is going bad, is that something we'll be able to replace ourselves? (Yes, I should tell them to get a Haynes or Chilton.) I don't like the idea of taking off dashboard panels.
2b. Is there any other "prime cause" I should look for if the blower motor seems OK?
Are there any other parts (other than the switch) whose failure would also give that symptom?
View 7 Replies
I'm having an issue with my heater/fan. When I started her up this morning, I noticed my heater (and fan for that matter) only work on the highest setting (4). It still blows hot, and runs at normal temp, but none of the vents are functional unless its blasting!
View 13 Replies
I have a Chevrolet Prizm 1998 and the heat and cooling system only works on the highest setting which is actually the fan setting. When I have it on any of the other settings such as low or med nothing comes out, it doesn't work. I can hear it click on but nothing comes out. So when I'm driving depending on the weather I have the heat or cold air blasting out of the fan until it gets annoying and I turn it off. I've checked the fuses and they're good. I have not checked the relays because I'm not sure how to do that. I haven't taken it to a shop because I'm poor and don't have a trustworthy mechanic and it works just not on low or med. Should I have this looked at? I don't want to be causing any damage but it seems like it could be something simple.
View 2 Replies
As the title says...The heater will only blow out hot air on setting 4. What could be problem before I take it to the dealership...
View 3 Replies
I have noticed on my 2011 Elantra, that the heated seat no longer remains on. I turn it on, level 1 or level 2, and a second later it turns off.
This only happens for the driver seat, passenger seat works fine. Why this might be?
View 4 Replies
So tonight I went to turn my fan on for my heat when I started my car and noticed it is will only work when it is on the highest speed (4 I think). What the issue could be?
View 10 Replies
My AC is not working on any setting but defrost. Warm air blows out on the reg AC settings, but if I turn it to defrost, chilly air comes out.
View 2 Replies
I have 2011 elantra, front driver power door lock only works sometimes.
View 2 Replies
My 2001 f350 a/c blower works better on a/c compared to max a/c . When I turn the selector to max a/c it makes more of a blowing noise but less air blows out of the vents though. When I select plain a/c it makes less noise but blows more air out of the vents. What is wrong and how to go about fixing it is 93 here today and won't get much cooler over the summer months .
View 5 Replies
I find that my 2010 V6 is always cold in the winter. I always need to turn the temperature control to the highest, but there is still not enough heat. This morning, it was -11c outside. After I drove 10 KM (about 20 minutes) , inside the car is still very cold. My feet were frozen. The air from the vent is only warm, not hot. I also find that this car takes longer to warm up. The temperature gauge won't start to move until I drive about 2.5KM.
View 5 Replies
I notice that wipers stop in position they were caught when I turn engine off (in the middle across windshield). Is it possible to set them to go down after ignition is off as other (not so luxury cars) do?
View 3 Replies
Don't know how to change the default screen setting so that it stays in either radio or Media screen. It automatically reverts to map after pressing the radio or media button.
View 3 Replies