I have been getting this weird bumpy feeling when making left hand turns and even sometimes when going strait on the road. It does not seem to effect the breaking for acceleration of the car. This does not happen all the time and will start and stop without any change in driving.
View 22 RepliesMy wife informed me about a noise coming from the chassis of her truck.
2007 Explorer XLT 4x4, 4.0 OHV, AT, 89,000 miles on the odometer.
We took the truck to dinner last night so I could investigate the problem. This occurs while only making left hand turns at slow speed.
There is a definite clunk sound AND feel. It actually sounds and feels like we are driving over a loose manhole cover, and IT DOES feel like metal to metal contact on the driverʻs sids of the truck.
I got a heat shield that just will not stop causing me grief. When I installed the headers and pipes I had a heat shield that was too close to the passenger side pipes. I bent it down some to clear the pipe and got rid of a nasty metallic sound I had on the throttle and making left hand turns. Well that little sound returned last week and I crawled under and looked and sure enough the heat shield was touching again.
Who knows why maybe a bit a spring sag. So yesterday I bent it down a little more. Today I start getting a nasty clunk on dips and especially when on a bump why turning. I crawl under there too look and find the same heat shield now has a huge gouge on the under side of it where the leaf spring near the rear bushing is smacking it. I'm sure Ford put it there for a good reason so hate to remove it.
First pic of the hacked up bend job I put on it.
Second pic of the gouge in the bottom of it where it's hitting.
06 sonata v6 standard 16in tires. I do all my maintenance, but i am stumped. A sound that is best described as a rattle crossed with a metal object (bolt/nut) rolling down a rail. Strange i know. Checked for rubbing, nothing. Made sure all bolts and nuts were correctly tight. Does it whether braking or not during any speed. May be dropped object, but neither I or a mechanic could repeat during Right hand turn. I have changed my front pads and dbl checked that is not the cause ( was doing it before change anyway) my fear is I'm missing something and am fearful of a mechanical failure.
View 9 RepliesI have a 2005 Saturn Ion stalls when I make left hand turns! The engine light comes on and the car goes into limp mode! I stop the car and wait a minute or two and it starts right back up and after driving it for a while the engine light goes out! I took it to a shop and they replaced the throttle body and ignition coil on two different occasions and my car still does the same thing!
View 2 RepliesI have purchased a 2012 Elantra for my wife and I have noticed a fairly significant vibration/shaking when making hard right turns. It is most noticeable during medium to hard sweeping right turns at speeds between 30-45 mph. Strangely enough I have no left turn issues at all and do not notice any vibrations at or above highway speeds. We did hit a pothole on the right side with both front and rear tires making impact a few months ago around 55mph but there is no noticeable wheel or tire damage. I did take the car to a Hyundai dealership after noticing this issue and they did not have any issues or find anything wrong (just my luck). I am thinking of rotating the tires to the other side to see if anything changes. Also I should add I am sure this is not an ABS or stability control issue because I can hit the same corner in the opposite direction at greater speeds without any issues.
View 6 RepliesThe other day I hit a good size bump at speed, slightly bent a wheel which I didn't even notice at first. The car drove straight and had no other symptoms, thought everything was okay. A couple days later I heard a weird grinding noise while making a left hand turn, it was so faint I honestly thought it was the fender liner. After the noises continued and further examination I noticed that the carrier is rubbing the rotor on the lower drivers side corner.
View 1 RepliesThe car is a 2.8L w/ a manual tranny. The car was making a rhythmic clunking and clicking noise around right hand turns on the left wheel. So when the weight of the vehicle is applied to the left, that's when the noise occurs. The car has been in the shop for 6 days and the technicians have replaced both axle shafts (it was time to do so anyway) but the noise is still there!!! What could possibly be making that noise other than bad CV's? The rhythm of the noise coincides with the rotation of the wheel/shaft which is where they have focused. Could it possibly be bad strut mounts? This is driving me crazy!!! They tell me its perfectly safe to drive (how do they know this when thy don't know whats wrong?) but I can't imagine this can carry on much longer without something breaking.
View 2 RepliesI have noticed on our 2009 F-150 there is an audible "click" (and you can feel it in the steering wheel) in left hand turns at about 1/4 revolution. You can also hear/feel the same thing coming out of right hand turns. It doesn't happen EVERY time, but pretty often. My wife had the service guy drive it when it was in for an oil change, and of course he didn't experience the same thing. What it might be or where to start?
View 8 RepliesMy passenger side has been making thud noises on a number of occasions on my 01 Jetta 1.8t:
1. When I go over bumps, the front passenger side will make a loud thud noise.
2. When I take my foot off the brake, there will be a loud thud from the front passenger side as well.
3. When making left hand turns and I begin to turn the wheel back to return it to its original position, there is a thud coming from the front passenger side as well.
It does not continuously click like a bad CV joint would. All these symptoms came at the same time period.
What the heck could it be? It gets a little louder on left-hand curves of the road, but pretty much constant. Its not the tires, they are new as of a few months ago.
View 12 RepliesMy Neon has this strange problem and I can't figure it out neither can my mechanic. Mainly when I'm making a left hand turn there is a knock sound underneath the car, like I can almost feel something jerking up underneath my pedals. And then after making the left hand turn and then accelerating... my car would almost feel like it was stuck to the left and jerk itself straight again.
NOTE: I have replaced/checked the Lateral and Radius Bushings, Control Arm Bushings, Sway Bar and I also recently got new rims and tires which at that point I got an alignment. But nothing has worked so far and I'm at a loss.
What is the cause for a clicking sound coming from Left hand side wheelwell area when I make semi tight Left hand turns from a parked/stationary position?
View 4 RepliesMy 2005 Dodge Ram (53,000 miles) will sometimes die while I'm making a left turn, or when I'm moving slowly in a parking lot.I get the oil change regularly and asked my mechanic to checkinto it. He. thought it has something to do with using cheaper gas, so I started buying the more expensive gas but it is still doing it. This is scary when it happens because not only do I suddenly slow down, but the power steering goes out and I have to muscle it around the turn.
View 1 RepliesI have a 2002 Saturn SL with about 160k miles. She's been a great car but recently she starts to oversteer when making moderate left turns over 35 mph. It always happens when the car's weight shifts to the right side. It is predictable but it still feels unsafe to drive. Unfortunately My mechanic couldn't find anything wrong with it.
View 6 RepliesI recently starting noticing a very high pitched,annoying squeak on my 2004 Century.. It's most noticeable when making left turns but can sometimes be heard when going straight or making right turns.. I'm thinking it might be the metal tab/wear sensor on the brake pads rubbing on the brake rotor but not sure, haven't looked at it yet? It doesn't turn out to be the wear sensor?
View 1 RepliesHave a 05 GLI tiptronic. Every time while making a left turn there is a LOUD vibrating/rattling sound coming from underneath my shifter. Dealership told me it was my exhaust rattling since it was larger than OEM. That doesn't sound right at all.....
View 1 RepliesI'm getting a clunk sound from my Passat's front left suspension when making turns. I've found info on how to diagnose control arms and I plan to jack the car up tomorrow and check it out. But how would I diagnose a tie rod end problem?
My Passat has 53,000 miles on it.
My car has the wavy acceleration feel and sometimes hesitates a bit. It is way worse when the a/c is on. I wonder if this is a octane or sparkplug issue. On my old cruze 1.4t the gap was wrong from the factory. It came with all four gapped under .022 but the manual called for .028. Everyone gapped to .035 with great results. Not checked the sparkplugs yet?
View 12 RepliesWhen I fill my tank with gas I get a very strong odor of gas throughout the vehicle, what do I need to check to fix this?
Also this one is weird, but everytime I make left turns ONLY, my Jeep does a down shift but stays in Neutral longer than it should but then kicks into gear by me taking my foot off the gas pedal and reapplying. What this could be? I have made sure that my Transmission levels were fine but I am baffled what the problem is?
This is the second time I notice a problem with my 2014 elantra base model. The car only has 13000kms and today the car acted with a weird behaviour. This car has a manual 6 speed transmission.
Out of the blue the car jerked like it had a problem with the transmission switching gears which is weird as this is a manual.
The second time this happened the wife was driving and she said that she was in is third gear and she pressed the clutch and the brake at the same time and she felt a small jerking feel in the clutch like it didn't engage.
The problem is that I cant reproduce the problem. The car is still under warranty and I don't want to go to the dealer with a problem that I cant exhibit.