Elantra MD (2010-15) :: Brake Pedal Is Spongy
Oct 11, 2016
I have a question about the bleeding the brake? When I washed my E, I usually spray the wheel and the brake part. I don't know it is a good idea or not. Recently, I felt like I have to step further on the brake pedal to apply the brake.
The force is there and Brake assist is still in effect if I step fast enough. I just felt like the brake pedal is spongy. My E is on 36k right now. Do you think wash the wheel often will cause the problem to brake line?
I have confirmed that my Gf's Elantra is easy and ease to brake than mine. At the mean time, her brake fluid is darker than mine. My brake fluid is full and clear. Maybe I should not wash the wheel more often. Or maybe I get OCD too much?
View 22 Replies
Advertisement
My dad drives an '06 Sonata. And he recently broke a brake line and had gotten it fixed. His current problem is that his brake pedal hasn't returned after getting the line fixed. What can he do to fix that? The pedal is really low and is spongy. And his ABS and ESC lights are also on.
View 4 Replies
I have a 2000 Silverado 1500 replaced calipers, master cylinder, and ABS Pump/Modulator. Bled all four calipers. Brake pedal spongy and has very little pressure and travels all the way to the floor. What am I missing here?
View 8 Replies
I just finished replacing pads, calipers, rotors, wheel cylinders & brake drum hardware on my truck along with flushing the brake fluid. The brakes work but the pedal goes almost to the floor. While bleeding them some air did come out as expected. But a couple times the master cylinder reservoir got very low on fluid. The workshop manual talks about bleeding the MC but are special fittings needed for that?
View 10 Replies
Drove the lady's car out on some errands today and ran into a problem on our drive home. Car was pinging really bad (low rpms in 1st and second) and car seemed as if it couldn't get out of its own way. Was driving for some time on the freeway (after a blistering 0-60 time of 20 seconds ), and noticed that the brake pedal was really spongy (felt like a mk1 when you try to brake with the car off). Found that the e-brake handle was up (negligibly up (perhaps 1mm raised)). Didn't have power brakes at all and had to use a lot of engine braking to slow the car off of the freeway.
Rear of the car smells like copper (wet pennies) and found that the brake reservoir is cracked (but fluid still at max level). Also noticed that as of late, when the car is at a stop (sometimes in gear, and sometimes in neutral) the car will rock/bump a little almost as if someone were giving it a bumper kiss with their car.
View 2 Replies
My Gen I Prius is screeching at me with the BRAKE and ABS lights on, and I hear the electrically actuated pump pulsing as it tries to get pressure into the system. The pedal is spongy and will go all the way down, with the right amount of exerted pressure from my foot.
View 6 Replies
After my local brake shop changed the front rotors and brake pads on my 99 grand cherokee the brake pedal is spongy and long, almost reaching the floor. They don't know why. Apparently they had a problem with fitting the new pads. I took it to the jeep dealer and they told me the master brake cylinder was leaking and needed to be replaced. many hundreds of dollars later the brakes are still spongy and long and does not correct with repeated pumping. The dealer was also stumped and I complained that nothing changed with the new master cylinder. what might be the problem?
View 4 Replies
I have a 2008 Ranger Sport 4x4. I noticed yesterday that when I stepped on the brake pedal it felt like nothing was there until I step a little harder then it was like full brake application. The truck only has 63000 on it. Then every once in awhile it would be normal ie very light brake application and slows like it should. Then back to same issue... Any thoughts about this??
View 8 Replies
2009 XRS ABS brakes .... I changed all four brake pads and flushed out most of the old brake fluid. Bled all four sides. But now while I am in idle (like waiting for a light to turn) my brake pedal is spongy and is making a hissing sound. All was good before I did this job.
View 3 Replies
I replaced all the brake pads on all 4 wheels. Pretty standard procedure. I now have a very spongy brake pedal. It stops but the pedal will be almost to the floor. I did not break any of the lines open during the procedure just used c-clamp to spread the calipers. No ABS light. Have a Snap-On power bleeder and bled the system several times with no change. Checked the power steering fluid level and inspected entire system for leaks.
2002 F-550 V10
View 8 Replies
I noticed last week that my brake pedal seemed more spongy than usual. The next day the pedal would go down about half way to the floor before I had pressure. And then the next day the pedal would go straight to the floor. Pedal comes back up once released. I still have brakes pressure about an inch before the pedal bottoms out. Its been like this a couple days now. The vaccum pump works fine. I'm gunna try bleeding the brakes on it tomorrow.
View 5 Replies
About 9/10 times when I step on my brake pedal (speed has not made a difference) I can hear and feel a hard knock under my car by my resting left foot. Started a few weeks ago. Haven't had work done to my brakes since May 2015 so I am thinking it is unrelated. What the issue might be?
View 2 Replies
My friend got her front brakes and rotors replaced a few days ago and now the brake pedal is vibrating at various times. It happens when slowing down and at a complete stop. Sounds like the ABS is kicking in to me, BUT is also does it sometimes when driving at low speeds (under 40mph) without pressing the brake pedal. No loud clicking noises, just a quick steady vibration felt at the brake pedal/flooboard.
The service was not done at Hyundai dealership. She is out of town at the moment so we haven't had a chance to take it to the shop yet. She called, they played dumb apparently. I don't know enough about Hyundais to diagnose.
View 16 Replies
I purchased a new 2016 Elantra about a month ago. I like the car although the driving position took a little bit of getting used too. Anyways, after 2000 miles my ankle has begun to hurt due to the height difference between the gas and brake. Is there any way to lower the brake closer to the floor to make them a bit more even?
View 5 Replies
I have replaced booster, master cylinder, all four callipers, and bled the brake system a number of times on my 2000 F-150 4x4. and still the pedal is wicked spongy, is there some other problem?
View 6 Replies
I have the limited with the push start. In order to start the car, you have to push the brake in so far and then push the push button. Lately the brake pedal is really hard to push down after its been sitting for an extended period. Once its started, all is fine. Its almost like I've pumped it a few times first, but its not the case.
View 11 Replies
I've noticed, lately on my girlfriend's 2013 with auto trans, when the brake pedal is down, and then pumped, I can hear and feel a click coming through the shifter. It happens in all gears.
View 12 Replies
I have 2013 Elantra ( 20,000 miles) and when I put the brake lights on without the headlights on everything works ok but when the headlights are on the driver's side brake light does not come on when the brake pedal is pressed. I thought it was a bulb problem so I replaced it but I am still having the same issue. What is going on? I know it is still under warranty but I figured I could handle a burnt bulb issue but that was not it. I noticed that the drivers side bulb is not as bright either when brake is pressed without headlights
View 11 Replies
I bought a new 2012 Elantra in March. Every so often I get a strange vibration through the brake pedal when I'm at a complete stop (red light/stop sign). It happens intermittently and I can't narrow down any exact cause. It happens when the engine is cold, fully warmed up, A/C on, A/C off, only been driving for a few minutes or driving for a few hours. No system lights come on. I've taken the car to the dealer twice and discussed this with them. They've not hooked it up for any diagnostics as yet. I don't think it's a vacuum line, engine or transmission issue because it is intermittent. I also don't think it's a defective engine/transmission mount. Could it possibly be the ABS module?
View 7 Replies
New 2013 Elantra owner here.. When initially depressing the brake pedal lightly (before the brake pads engage, usually in stop-and-go traffic), I can feel a rubbing sensation coming from somewhere in the pedal assembly. If it's quiet, I can also hear a groaning sound. This definitely isn't a pad/rotor issue, rather something closer to the pedal itself and inside or near the cabin.
Took it to the dealership and after some coaxing and insistence that it wasn't "normal," they finally said it was the brake switch and replaced it. Seemed to alleviate the problem for a week or so, but now it's back!
View 3 Replies
It could be the ECS kicking in or something but here's what I feel..... when hitting a rough patch of road at I'd say 25 miles an hour or greater and applying the brake over that rough patch of road for what ever reason, my foot is on brake pedal normal and it feels like the pedal gets ultra firm (opposite of pedal diving to floor if you lost brakes) or the feeling is like the brake pedal is pushing back against me, like the car is taking the brakes off on me for a brief second.....its a weird feeling and only happens on rough road when I'm at speed and have to hit brakes, all other braking times it doesn't do this
Good example is coming to a stop at a certain stop light that's got choppy asphalt right at the stop light line.....light turns yellow and I'm at speed and have to brake to stop for the light, it hit the rumbly road and feels like the pedal doesn't want me to brake and gets really firm, I stop and all, but then again makes me worry, because if I had to really stop fast and hard......would I ???
No alarm or alert lights come on, so I don't know ....
Car's got 8,000 miles on the clock ....
View 15 Replies
