This car is an Australian 2014 Elantra SE
The existing manuals do not work, they show a knob previous to this one and don't apply.
Hyundai Elantra: Console. Repair procedures - Interior - Body (Interior and Exterior) - Hyundai Elantra MD 2010-2016 Service manual
Shows an earlier one and I can't find any other info.
I have a 2011 elantra a 6 speed manual and im trying to take off the shift knob and can't seem to do it....
View 33 RepliesHow do you remove the shift knob in a 2013 Elantra GLS? I didn't see a pin or anything.
View 3 RepliesHow Do You Remove Gear Shift Knob For Replacement ?? On My 07 Azera
View 2 RepliesMy car is 2012 Elantra. I want to remove the fan control knob. It was easy to pull Mode and Dual buttons straight out. But I don't know how to get the fan control knob off.
View 3 RepliesI need to remove the cv axle from the hub so I can replace the washer (I have the clicking noise). Its a 2013 Elantra. Wondering the steps so I don't remove anything I don't need to. Also I am guessing the washer goes on the inside of the bearing as opposed to between the bearing and nut?
View 8 RepliesSo I tried removing my rear deck but was unsuccessful. I removed 4 "screws" when folding the seats then the ones inside the trunk but it didn't come off. Did I miss anything that is holding it down?
View 4 RepliesI'm trying to swap out the shift boot of my 2004 (B5.5) Passat 1.8T 4Motion and running into trouble. According to the instructions from the new Red Line shift boot, I should be able to separate the two collars that hold the boot to the knob. However, the white post that's part of the knob assembly has a piece that's bigger than the lower black collar, preventing it from being removed. Is there something I'm missing? How can I remove the boot without damaging the existing knob assembly?
View 7 RepliesHow to remove the stick shift knob on a 5 speed 99 passat .
View 3 RepliesIs there any trick to removing the rear seat bottom, or do I just need to pull each side up with enough force until it pops out? If I get my hand under the edge of the seat there seems to be a decent amount of give to it, but I don't want to break anything...
View 8 Repliesi need to get to the wires but cant do it looking through the small hole for the fuse box.
View 14 RepliesI have a '12 Elantra Limited and I'm planning to smoke the rear bumper reflectors. How to remove them?
View 20 RepliesI have a '98 F150 front 60/40 seat going into a '77 shortbox F100. I've searched and found a lot of info on repairing a lumbar support but nobody seems to mention how to get the stupid off. I don't want to break anything but I can't see any screws or clips. Does it just pull off with force?
View 1 Replies2010 F-150 with 38 gallon tank. Original thought was great way of having some spare fuel available for use during an emergency. How to easily remove gas from these new vehicles?
View 10 RepliesHow to remove the drivers side airbag on a 2010 f-150, a deer jumped out at my truck and set off the airbag which now needs replacing besides the body work
View 3 RepliesOur current gear knob is worn badly, so I bought a new one with the shifter boot/gear gaiter.
I was just wondering, how to take the old one off and put the new one on/or any guides that are about? (they're exactly the same) As it doesn't seem like it screws on as I can't see any thread in the knob.
It the manual 6 speed ....
Swap DSG knob in mk7 for that of an A3 or S3 knob. I have searched but could not find anything about swapping DSG gear knobs. I don't know if it's something easy to do but I would like to swap mine for something that you would see more in the Audi as I would like something that is more round.
View 2 RepliesI have a 2013 Hyundai Elantra with an automatic with the Tiptronic transmission. last week I went to put the transmission into Tiptronic mode and it would not go in. it like crunch to the right and would not shift gear up or down nor would the gear number appear on the digital dash.
View 1 RepliesThe downshifting while braking is very obvious during braking, I can literally feel the gearshifts going down from 5th Gear to 1st as I brake. I have driven a wide range of cars but haven't experienced this earlier. Is there any modification that can be done or added to change this and make it smoother like usual cars?
View 28 RepliesI've hyundai elantra2013 while changing gear by car jerk and sometime it doesn't jerk. What is issue causing car to jerk when changing gear. It happens not every time, sometime it don't jerk while changing gear.
View 5 RepliesThe lights on the knob which selects the where to push the blower air have gone out. I took the dash fucia out and took the that piece that controls the heat and fan speed out. But I don't understand how to open it up to replace the bulb. There are little tabs around the piece which I tried to open but the knobs are connected to something inside so I didn't want to pull too hard and risk breaking something.
How I can change the light bulb? I attached a picture to the post and circled in red the area I'm referring to where the light bulb has gone out.