Elantra MD (2010-15) :: 2013 - How To Remove Shift Knob
Feb 16, 2013
How do you remove the shift knob in a 2013 Elantra GLS? I didn't see a pin or anything.
View 3 Replies
Feb 16, 2013
Advertisement
Elantra MD (2010-15) :: How To Remove Manual Shift Knob
I have a 2011 elantra a 6 speed manual and im trying to take off the shift knob and can't seem to do it....
View 33 RepliesElantra MD (2010-15) :: 2014 How To Remove Gear Knob
This car is an Australian 2014 Elantra SE
The existing manuals do not work, they show a knob previous to this one and don't apply.
Hyundai Elantra: Console. Repair procedures - Interior - Body (Interior and Exterior) - Hyundai Elantra MD 2010-2016 Service manual
Shows an earlier one and I can't find any other info.
Azera TG (2006-11) :: How To Remove Gear Shift Knob
How Do You Remove Gear Shift Knob For Replacement ?? On My 07 Azera
View 2 RepliesPassat (B5) :: 2004 - How To Remove Shift Boot From Knob
I'm trying to swap out the shift boot of my 2004 (B5.5) Passat 1.8T 4Motion and running into trouble. According to the instructions from the new Red Line shift boot, I should be able to separate the two collars that hold the boot to the knob. However, the white post that's part of the knob assembly has a piece that's bigger than the lower black collar, preventing it from being removed. Is there something I'm missing? How can I remove the boot without damaging the existing knob assembly?
View 7 RepliesPassat (B5) :: 1999 - How To Remove The Stick Shift Knob
How to remove the stick shift knob on a 5 speed 99 passat .
View 3 RepliesElantra MD (2010-15) :: 2013 GLS Won't Shift Out Of Park
My 2013 Elantra won't shift out of park. I know that I should check fuses, but what fuses might be associated with this. (The brake lights are not affected)...
View 1 RepliesElantra MD (2010-15) :: 2013 GL - Notchy Shift Clunk From 1st To 2nd Gear
I got a new '13 Elantra GL sedan with standard transmission a month ago, and I've noticed that 1st gear is very "torquey" (always jumps when mildly applying or releasing gas pedal), and there is a very notchy shift clunk from 1st to 2nd, so loud you can audibly hear the gearshift change quite significantly. The torquiness occurs for about 1st-4th gears (It's a 6-speed), but the notchy clunk doesn't occur for any other gears except 1st, and I took my friend's 2013 Veloster stickshift for a drive the other day, and his 1st gear is MUCH smoother and less jumpy.
Also, taking off in 1st is a very delicate balance and I still stall it now and then, no matter how much I focus and practice. It also feels like it's sputtering on takeoff every time, unless I really slip the clutch (which isn't a good habit to take up). Slipping the clutch for reverse is necessary unless I want a very jumpy, very grindy and clankery (is that a word? lol) reverse.
Is this an issue with Elantra sedans in general for stickshift models, or is it a problem with my specific car? Should I bring it into the dealer?
Elantra MD (2010-15) :: 2013 - Turn Off Manual Tranny Shift Indicator
Is there a way to shut this feature off. I don't need to be told when I have to shift or down shift. I thought the manual tranny E's had the ECO button which would turn this feature off, but there's no button.
View 5 RepliesPrius (2010-12) :: Mod The Stock Shift Knob
Do the cover on the stock knob can be taken apart, smoked, and put back together?
View 6 RepliesElantra MD (2010-15) :: Fan Control Knob Removal?
My car is 2012 Elantra. I want to remove the fan control knob. It was easy to pull Mode and Dual buttons straight out. But I don't know how to get the fan control knob off.
View 3 RepliesElantra MD (2010-15) :: How To Remove CV Axle
I need to remove the cv axle from the hub so I can replace the washer (I have the clicking noise). Its a 2013 Elantra. Wondering the steps so I don't remove anything I don't need to. Also I am guessing the washer goes on the inside of the bearing as opposed to between the bearing and nut?
View 8 RepliesElantra MD (2010-15) :: How To Remove Rear Deck
So I tried removing my rear deck but was unsuccessful. I removed 4 "screws" when folding the seats then the ones inside the trunk but it didn't come off. Did I miss anything that is holding it down?
View 4 RepliesLexus RX 2010-15 :: 2013 - How To Remove Former Bluetooth Settings
We just picked up a 2013 RX350 from a non Lexus dealer and the audio system still has all of the former owners Bluetooth settings destination histories, etc.
View 2 RepliesElantra MD (2010-15) :: How To Remove Rear Seat Bottom
Is there any trick to removing the rear seat bottom, or do I just need to pull each side up with enough force until it pops out? If I get my hand under the edge of the seat there seems to be a decent amount of give to it, but I don't want to break anything...
View 8 RepliesElantra GD (2013+) :: RPMs Too High - Cannot Shift Into 1st Gear
Purchased my 2013 Elantra GT a few months ago and have been having a problem that had stumped everyone at the dealership. Thought I'd see who else is having it and what the thoughts are. To start, this is a 6SPD Manual Transmission.
Problem: Say you're at a stop and begin accelerating in 1st gear and then shift into neutral because you have to come to a stop again. When operating normally, the RPMs immediately wind down to idle. Well for me, about 15% of the time or more, the RPMs will take up to 10-15 seconds to wind down to idle. During this time, you cannot really shift into 1st gear because the RPM are too high.
The dealership has been working on this issue since last month. They replaced some parts and it is still doing it. They got diagnostic data and told me the throttle was sticking. No one could figure it out. Engineers got involved from regional, and it got pretty heavy as far as time. After several attempts at figuring out the problem and replacing things (which didn't resolve the issue), the engineers drove another new GT and found it was also doing it. So all of a sudden they said "it's normal" and closed the case.
Chances are, if other new ones are doing it, so is yours. I got second opinions from other auto shops who said it is not at all normal and that there may be a defect in the design. I've owned 4 Manual Transmission cars and I have never seen this before. If you're curious and have the 6spd manual version of this car, the easiest and quickest way to see this happen is accelerate in 1st gear to about 4000RPM and shift into neutral. Eventually, it'll get stuck and take a significantly longer time for the RPMs to return to idle. Usually when it finally happens, it'll keep doing it for several subsequent acceleration cycles.
Prius (2010-12) :: 2013 - Can't Remove Rear Seat Belt?
I just got my clazzio seat cover yesterday, spent the whole day installing it. I'm up to the last seat (rear passenger side) where i need to remove the seat belt.
I'm having problem removing the seat belt. Tried with several different tools, including variable speed tool, and even tried turning it to the right in case it has different direction to unbolt, but it just wouldn't turn at all.
I called the dealership, but no luck. So i'm now stucked with all but 1 seat being covered. I went to some shops today, most wouldn't touch it because it's liability issue.
Elantra MD (2010-15) :: How To Remove Plastic Panel Under The Steering Wheel
i need to get to the wires but cant do it looking through the small hole for the fuse box.
View 14 RepliesElantra MD (2010-15) :: 2012 - How To Remove Rear Bumper Reflectors
I have a '12 Elantra Limited and I'm planning to smoke the rear bumper reflectors. How to remove them?
View 20 RepliesElantra GD (2013+) :: Auto Shift Noise At Higher RPMs
2013 Elantra GT ... Odd sound when shifts at higher RPMs. Like a chirp, or a tiny blow off valve from an old home turboed civic. Some sort of leak? When the engine is under load, it sounds like I may have some sort of minor exhaust leak, though that is nowhere near audible in the video. Very curious as to what this is.
[URL] ...
Listen right at 0:14 when it shifts.
Ford F-150 - 1997-2003 :: 1998 - Way To Remove Lumbar Support Knob?
I have a '98 F150 front 60/40 seat going into a '77 shortbox F100. I've searched and found a lot of info on repairing a lumbar support but nobody seems to mention how to get the stupid off. I don't want to break anything but I can't see any screws or clips. Does it just pull off with force?
View 1 Replies