Elantra MD (2010-15) :: 2013 - Blinking Check Engine Light
Dec 27, 2015
I have a 2013 Elantra GLS with almost 200k on it. I am the original owner. I have only had a few small problems with it just replacing lights and had to replace the passengers side wheel bearing twice. the rest has just m=been replacing wear and tear parts. the check engine light is on because it needs 02 sensors. They are back ordered. The car started idling roughly and driving horribly on the way from Rhode Island to New York on Christmas day. A friend had a diagnostic machine and the code read misfire cylinder 3 p0303..I am assuming it damaged the catalytic converter and that I now need both the sensors and the convertor. I live about 7 miles from my garage. should I tow it ? or drive a t a low speed? Have to bring it in first thing in the morning. What else could be wrong?
View 3 Replies
Advertisement
I have a 2011 Elantra that I purchased brand new. Has over 60,000 miles on it. Had a check engine light come about year or so ago which was fixed with a software update at the dealer.
Check engine light is back on now. Steady light; it's not blinking. Brought it to my mechanic. Ran diagnostic and said the oxygen sensor needed to be replaced. P codes were P2096 and P2196. He ordered the sensor from the dealership and installed it. Reset my cars computer. I drove the car 26 miles and the engine light came on again.
Here are my questions:
1. Wouldn't my mechanic's diagnostic equipment tell him what the problem or all the problems were? Why would it tell him the oxygen sensor needed to be replaced when there seems to be another problem causing the engine light to come on?
2. Would the dealership have more insight into a check engine light system problem than a mechanic shop may have?
View 45 Replies
So as my first post was about all the upgrades/mods I wanted to get recommendations on, it saddens me that my second is about my check engine light.
I've noticed for the past week a little bit more of a "bump" when accelerating into gear. This Friday, coming home from work the check engine light came on. Checked the oil and gas cap, everything seems ok. I'm taking it into the dealership tomorrow and will update with their findings.
I'm worried cause I would never imagine the light to come on so soon. The car is barely two months old!
View 21 Replies
My Girlfriend just got a 2003 Hyundai Elantra and everything was running great on it the first month she had it BUT the check engine light was on.. After about a month she called me up while driving and said that the check engine light was blinking and the car would hardly move. So I got to the car and looked at it and I noticed the oil filter was a little loose so I tightened it good this time and added a little bit of oil. It actually moved but it would hesitate. So we had it towed to a shop and they read the codes from the check engine light and told us it was leaking oil from the motor some where (not specific) and it also needed a new O2 sensor.
So I replaced the catalytic converter underneath the car and also a new sensor along with a new set of spark plugs. It ran alot better and I left it at that. Now about a week later she was coming home and noticed that when she turned left or right that the battery light and brake light on the dash came on. She drove it home and when she turned in the driveway the car went dead. It started right back up and we got it to the house and left it over night. I went out this morning and again it started right up. but when I lifted the hood I noticed the belts on the pulleys were all spinning very slowly. I'm not sure if it could be a timing chain or if it just needs new pulleys.
View 6 Replies
I just purchased a 2013 Elantra GT, 3 days ago. I was driving down the highway and my check engine light came on. There is only 480 miles on my car! I know it's not a gas cap. I haven't even put gas in it since I drove it off the lot. Is there a way to check for the code thrown without a scanner? I use to have a jeep liberty and I could click the key over 3 times an the code would pop up.
View 24 Replies
I'm due to leave at 6am sharp on Friday morning for that pre-planned surprise 50th Bday celebration I've been talking about for my wife. This evening I get in the Elantra to pick her up and when I started the car it began to shake VIOLENTLY, like I was in a commercial dough mixer. WTF!?? I saw the check engine light was on so I shut it off immediately. Curiously, I had the car out earlier without incident.
I restarted the car and it ran smoothly this time, but the check engine light remained. Calling the dealer, I was able to get a 9am appointment for tomorrow morning. I don't have an OBD-II scan tool to check the codes, but based on the symptoms, and recent poor gas mileage.
View 31 Replies
So the check engine light on my '12 with 5K miles came on 2 days ago. Called to make an appointment at the dealer for tomorrow...and today it goes off. Is it relatively safe to fore go the appointment and see what happens? I don't think it was related to the gas cap.
View 2 Replies
I just bought a used 2011 Elantra GLS and am having some issues that the dealer cant resolve. What is happening is the the Check Engine light comes on and off. It will be on for a day or so, then go off for a day or so, so I am thinking its the gas cap. So I tighten that thing up as good as I can and pulled the negative battery terminal and problem solved. About 2 days later, and about 200 miles later on the same tank of gas, the light pops back on. So I call the dealer and took it there the next day.
On my way to the dealer, the light goes out. They try and pull the code, but the ECU is showing nothing. I asked if the ECU stores codes and I was told that when the light goes out on its own it clears the ECU of the code. Not sure if that is true, but that is what I was told. So I drive the car home. I fill the car with gas, drive about 100 miles and the light comes on. I call the dealer the same day, take it over, and on the way like the car knows it goes off and guess what? Dealer cant do nothing.
Now to make a long story longer, this is what I know. The car is not a CA car. It was sold in GA and was a prior rental. It ended up in CA and was sold as a certified pre owned from a Hyundai Dealer, I actually bought the car from a Mitsubishi Dealer and they dealer traded for this car (thats another long story) the carfax does show that it failed emissions but passed after several attempts. Which I thought was odd on a ULEV vehicle. Since I liked the car so much and the price was good, I bought it since it did pass smog eventually.
Once I get the car home, I do my usual thorough look. I clean everything to my standards. I am cleaning the engine compartment and took the engine cover off. 1st thing I noticed was the Spark Plug Coil Packs all the 10mm bolts that hold them in were loose and 2 of them were completely off!! So I decided thats odd, so I pulled the plugs out and they were the NGK's so just in case I put a brand new set of the NGK laser Iridiums back in and tighten everything up. Then I notice where the PCV valve is on the valve cover, the hose that goes to that to the intake tube does not look stock. The hose looks like fuel line hose that someone put on it and the clamps are not stock. So I am canvasing for OEM replacements of those parts now. Then when I was installing the mud guards, on the drivers side rear tire where the gas filler tube is I notice another non OEM clamp. So someone was messing with this area of the car too.
The car is averaging 26-28mpg's in the city and I have been getting 35-37mpg's highway so I don't think there is anything major wrong here. I believe that either the PCV valve hose is kinked and may be causing a fault, or that since it was a prior rental that people were over filling the gas tank and maybe blew the expansion valve in the gas tank, causing the fault. I have no way to prove this since the light goes on and off and clears the ECU every time I take it in.
View 7 Replies
I have a 2015 Hyundai Elantra Limited. Lately, the check Engine light comes on when I accelerate from a full stop and stays on for 3-5 seconds. It has also happened when I accelerate to get on the interstate (that just started today). There is no issue with the car accelerating. Everything else seems to be fine. It's just the Check Engine light that is freaking me out a bit. I've had the car since June so I'm not ready for any major issues. It started two days ago. I took the gas cap off and put it back on last night to see if that was the cause but it's still happening today.
View 2 Replies
So I got gas 4 days ago and today the check engine light came on afterwards. Went to auto zone to read code and it had to do with the gas pressure being slightly low (gas cap). So I got gas and resealed the gas cap. Well, it's been about 2 days since then and it hasn't gone off. Does it need to be reset or does it take more time?
View 1 Replies
Check engine light came on about 2 weeks ago on my 2013 elantra gls. I went to auto zone to get it checked and they ran a p2096, which is what I had almost a year ago. That was fixed by dealer software update. So, I thought that was what needed to be done, headed to the closest Hyundai and they found p2096 and p2196. They replaced the o2 sensor bank 1, under warranty.
However, the next day the check engine light came on, less than 24 hours. Brought it back to the dealer, they said everything was within the correct "parameters" and said the light shouldn't come back on. On the way to work this morning, the check engine light came on, when the car was in the exact same spot it was yesterday.
I'm thinking the computer doesn't recognize the repair and needs to cycle a few times but I don't know. I'm so tired of going to the dealership because they are obviously missing something if the light is still on.
View 31 Replies
In the last month, my car has had an awful time starting on 2 different occasions. The first time it ran really rough for about 1 minute then was ok. The second time was the same but the engine light came on. Took it to an out of town dealer and he said it showed a misfire code but could never find anything else and all looked OK. Spark plugs?
View 4 Replies
Hyundai Elantra 2011... My issue occurred just yesterday on a highway at speeds above 65 mph. I initially noticed my traction control light blinking upon light acceleration but with no noticeable loss in traction.
I continued with caution. About 5 minutes later, the light now was blinking regardless of the amount of acceleration. I found I could push the accelerator to the floor with no added power and my speedometer was dropping below 55 mph.
Being a busy highway, I had to very quickly get to the side of the road as my car dropped to dangerous speeds in the middle of the highway. Had I no shoulder or outlet, I could've been in serious trouble.
The situation resolved itself with a simple shut down, restart of the vehicle. But it makes me very concerned why the error in the computer occurred in the first.
View 15 Replies
I changed my plugs a few days ago on my 96' Taurus GL 3.0LI checked under my hood to check the recommended gap size and it said .42 to .46.. I went with .46. after putting them in i started the car up just fine, but later in the day i noticed when I came to a stop at a red light my car would sputter and my check engine light would start blinking. When I'd accelerate and drive it again everything would clear up and the light would stop blinking. I didn't change the wires, just the plugs in case you were wondering but I am unsure of how much that would influence my problem. Today after work i had a little trouble starting my car. After a few tries it started and my exhaust smelt rich in gasoline. Did i gap them too much? Should i get new plugs again and regap them? should i buy new wires also?Is my ignition coil going bad?
View 19 Replies
It's a 2010 vw jetta. Check engine light is blinking and the epc light is on the car is not paid off yet have no.
View 19 Replies
When I was driving to school this morning my check engine light went on and I noticed that my car is running very rough (suddenly). I also noticed that the check engine light would blink when accelerating at a stop light then go solid again when driving. I drive long distances between school and work and I think I won't be making it to work later due to this issue. This is a Saturn Ion II 2005 and gets regular maintenance on time.
View 15 Replies
So I am on my way to the store this morning and the check engine light starts blinking. After I get out of the store I try to start the car so I can drive the mile back home and then have it towed to the dealer. The car is only able to drive at like 1-3mph. I changed the cam follower 6k ago and the car only has 43k.
I'm thinking this seems like a fuel delivery/cam follower type of issue. At the moment my plan is to have AAA tow the car home so I can see if its a follower issue. If it is I think I'm going to have to take off my downpipe and put the stock one back on. When I put the car in neutral and step on the throttle I get no revs at all.
View 4 Replies
My check engine lights been on forever, like every VW, but now it's blinking fast, and the car isn't running right. It's messed up AGAIN, it's running really bad, like misfiring and not making power. It's shaky feeling in the throttle and power, almost like it's going to stall but it doesn't. What the problem is?
View 5 Replies
'99 Passat GLS - 79,000 miles - no mods ... Solid Check Engine Light was on for about 2 weeks...last time it was on, it was a fuel cap issue so I took my time with it. Well, all of the sudden on 4/14/03, on my way to work, (less than 5 minutes after starting the car) the car starts to ride hard (like going over grated pavement)...check engine light starts to blink! I pulled over. Eventually the light went back to solid.
Tonight (on 4th ignition sequence since picking up the car this AM) - the solid Check Engine Light came on again.
I had a friend who went through this with a 2000 Passat GLS - different dealer claimed it was the MAF, then the O2 sensors, then....she eventually took it to carmax to unload it.
View 13 Replies
This morning on my drive to work my car would choke whenever I hit 3000 rpm right when the car is sucking the most air from my intake, and especially on 3rd gear and up. After being on the road for quite some time my check engine light came on blinking but went away right after I stop pushing the car to 3000 rpm to switch gears.
The car is on APR Stage 1 with AEM Filter + Nuespeed Intake + BSH Inlet Pipe.
Recently added was a VW Diverter Valve D Version due to an oil leaking from my Old Diverter Valvue G version.
View 5 Replies
Our R32 has 2428 miles- and today the check engine light came on and it started to run pretty rough, babied it home and the the light was blinking when I turned into the driveway.. I know that booklet 3.2 in the owners manual is diagnosing catalytic converter issues...I have always used super unleaded, it hasn't even reached the halfway point of the first service.
View 10 Replies
