Elantra HD (2006-10) :: 2009 - Hazards Don't Work
Aug 30, 2016
I recently purchased a 2009 elantra and the hazards dont work but both blinkers do I need to get it inspected but it won't pass without hazard lights.
View 14 Replies
Aug 30, 2016
Advertisement
Elantra HD (2006-10) :: Turn Signals Work But Hazards Do Not
Today, I replaced the flexible coupling in my steering column. All went well and seemed great until I realized my turn signals were not working. I tried the hazards and promptly heard the 10amp fuse blow. I took the paneling back off and realized that the wire bundle to the turn signal was being pinched above the steering column.
After lowering the front of the column down and removing the wires, I noticed that there was some damage. One wire (blue) was cut and a few others had damage to the sleeves. I repaired the sleeves and fixed the broken wire. The turn signals now work perfectly fine, but when I activate the hazards all the signals go dark. I cannot find any blown fuses and the relay appears to be working just fine for the turn signals.
Ford Escape / Hybrid :: 2009 - Driver Side Brake Light And Hazards Do Not Work
Drivers side turn signal does not work, and blinks fast when turned on. The brake light on that side and hazards do not work. when I unlock the car with the remote, it lights up fine.
View 5 RepliesSonata NF (2006-10) :: 2008 - Turn Signals / Hazards Won't Work
I recently bought an 08 Sonata from a used car dealer which has 65,xxx miles. Last week my turn signals would work intermittently, and now neither the turn signals or the hazards work. I put in a new relay and a new turn signal switch, to no avail. When I turn the hazards on, the relay clicks once then nothing. When I do the turn signals, nothing clicks. Is there another relay I'm missing somewhere?
View 14 RepliesChrysler - Ptcruiser :: Horn / Turn Signals / Hazards / Door Ding Doesn't Work?
I have had this problem for a while now, but can't seem to figure it out. I'm sure it's an electrical issue, but I'm not that great with electrical. My turn signals don't click when I push the handle in either direction. The turn signals come on and stay on but don't blink like they should. I checked the lights in the front and back and they just stay on but don't blink. Also my hazards don't blink. They just stay on and don't make clicking noise either. My horn doesn't work and my door doesn't ding with the key still in the ignition but in the off position. I don't know of it's all related or different issues.
View 10 RepliesFord F-150 (2004-2008) :: Tail Light Does Work For Hazards / Turn Signal Or When Braking
I have a 2004 F150 XLT and the passenger side tail light doesn't work whatsoever. The light does work for hazards, turn signal, or when braking. The passenger front turn signal works, so does the front and the driver sides tail light. Only the 1 tail light doesn't work. I bought a new brake light bulb and it didnt't fix it, so i swapped the drivers and passengers bulbs out, and it still didn't work. I replaced the 10 amp fuse (#36) in the fuse box. What is causing the problem.
View 2 RepliesFord Excursion :: No Turn Signals / Hazards Work But When Press Brake Tail Lights Just Blink
I have checked all fuses, checked wires on top of steering column all checked out ok. Hazards work but when I press brake tail lights just blink with no brake light but the 3rd brake light works??? Signal switch maybe??
View 14 RepliesFord Super Duty (1999-2016) :: 2000 F250 V10 - Hazards Not Turning Off / Turn Signals Don't Work
2000 V10 F250 - daughter is using my truck and called to tell me the turn signals weren't working. She called me shortly after and said she adjusted the tilt and hazard lights came on and now she can't turn them off. I had her pull the hazard fuse to stop them. She then noticed the brake light weren't working. I don't know if the brake lights were because she pulled the fuse or she just noticed they weren't working.
A week or two ago, she said she parked the truck, turned it off and took the keys. When she came back out, the truck had rolled across the street. Periodically, over the years, I would go to start the truck and nothing happened. I would shift the gear selector in and out of drive. Then the truck started.
Finally, since I've owned the truck, the when I activated the left turn signal, the selector frequently wouldn't stay "locked" till I turned. So, are these related? Do I have multiple issues going on in the steering column. Where to start looking when she gets the truck home?
Ford Super Duty (1999-2016) :: Fuse 13 Keeps Blowing - Brake Lights / Turn Signals And Hazards Don't Work
Every time I step on the brakes, there is a bright spark in fuse #13. My brake lights, turn signals and hazards don't work. At this point my truck isn't drivable.
According to the owner's manual in my truck, says circuit #13 is for "stop lamps, CHMSL/hazard, trailer tow stop lamp, and speed control."
I'm assuming that the hazard part covers the turn signals as well, but I know the cruise control works even when the fuse is blown. I used it last night on the way home (this was before I realized I didn't have brake lights).
So I know I have a short somewhere. The only mods I've done to the lights are aftermarket headlights, but if the fuse only gets blown when I step on the brakes, I don't see what that would have to do with it. Also, the lights have been installed and working for about a month before this started. The only thing that I did around the same time was install the gauges. I ran the power to them from #5, the customer access circuit.
Are there any other "common" areas for this to happen? I already removed the rear brake lights and it didn't work. I am quickly running out of 20A mini fuses.
Hyundai - Elantra :: 2009 - Cruise Control Does Not Work At All From Driver Controls
Hyundai Elantra SE ("sedan"?), 2009, manual - after the dealer replaced the brake light switch (or some such) as a recall service, soon after - but perhaps unrelated - the cruise control doesn't work at all from the driver controls. No nothing. All of a sudden. I read about the relays, fuses, however didn't make much of it - overlooked perhaps....
View 7 RepliesElantra HD (2006-10) :: Dome Light Doesn't Work
Just picked up an '07 5spd & noticed that the dome light doesn't work. no biggie, but then found that the dash lights don't work at all. When I turn the lights on the backlighting for the window switches comes on, as do all the running lights. The odometer & clock backlight properly dim out, but the dash & heat/fan control lights are dead. dimmer dial on the left panel has no effect. dash cluster fuse is good. If I can't get the dealer to fix it (only had it two days).
View 1 RepliesElantra HD (2006-10) :: Cruise Control Does Not Work After Changed Brake Light Switch
I just discovered my cruise won't "SET" (light goes out after 1/2 second) anymore after having the brake light switch done yesterday.
View 2 RepliesSonata NF (2006-10) :: 2009 - Boot Release Button And Fuel Lid On Door Won't Work
Its a 2009 sonata 2.4L auto. The button on the remote for boot works & I can open the fuel lid from the boot manually.
I am in perth.
Elantra HD (2006-10) :: 2009 - AC Not Working / Just Blows Hot Air
My 2009 elantra (160 k) ac is not working. The centre of the compressor doesn't turn when the ac is turned on and I don't hear any difference in the engine when turning it on (no extra load). I don't hear any clicks or anything for that matter. It just blows hot air.
From the research i have done it seems it doesn't necessarily mean the compressor is shot. It may just mean there is a leak in the evaporator core.
Is there a way to tell if the compressor is shot? I'm hearing that replacing the compressor is at least as twice as much as the evaporator core so I would like to go into a shop knowing one way or another.
Elantra HD (2006-10) :: 2009 - No Crank / Start
I have a 2009 Entrant, lately I've started experiencing no crank starts, I try a couple of times and then it starts normally. The car has new battery and terminals so am thinking it might the starter. I've looked online on a how to change starter for a 2009 starter video but no dice. I've found every other Hyundai but not the 2007 to 2010.
View 2 RepliesElantra HD (2006-10) :: 2009 Engine Rough Idle After A Run
Have a 2009 Elantra 4 door, manual. It is at 52000 kilometers and recently in the spring changed the oil, I run Full synthetic.
Lately its been really hot and the following problem occurs, no engine light or anything. But if I start the car cold it idles no problem, nice an smooth, If I go out for a 30min drive, come back and let it idle its rough. Not crazy rough but its rougher than it should be. I have no power issues, it pulls well, never stalls. If I shut it down and wait a few hours, engine still hot, but not super hot, start her up and runs well, no rough idle.
Go out for a 15-20 min drive and park it, idles rough. I checked the usual, wires, plugs, pvc valve seems good. Engine temp is normal also. I did some searches on the site but come up mostly with cold idle issues, not great when cold not so when hot.
Elantra HD (2006-10) :: 2009 - EPS Has Been Randomly Turn Off While Driving
I have a 2009 Elantra with a hair over 107 000 km. Recently I have been having an issue whee the EPS (Electronic Power Steering) has been randomly turn off while driving. This has occurred anywhere from once a week two twice in 10 min. It has happened immediately after starting the car or after driving for half an hour. There is no visible or audible sign when the EPS shuts off other than a small warning light on the instrument panel.
I am very worried about the safety risk this poses to me and the vehicles around me as when the EPS turns off the car is very difficult to steer, so I would like to get this fixed ASAP. What I should be looking at? Is this something I can fix myself (I'm not very car savy) or should I be taking it to a mechanic/dealership?
Elantra HD (2006-10) :: 2009 - Code P0441 Won't Reset
Got a cel on a 2009 Elantra the other day. Put my cheapie code reader on it and got a double hit on P0441. It showed two codes, both P0441. This is the first time I got this code. I had gotten gas the day before and thought it might be from over filling or a loose gas cap like my S10. I made sure the gas cap was tight and went to reset the code. It would not reset even though the code reader said "Done". Checked today and there is only 1 P0441 code showing. Tried to reset, but the same thing. Code reader says "Done" and the code remains.
Car starts and runs fine. I see no loose wires or anything amiss. I did hit a curb a few days ago. What could I have knocked loose? Do I need to go to someone with a better code reader? Is this a drive cycle thing?
Elantra HD (2006-10) :: 2009 - Clicking Sound When Backing Up
My wife just noticed a weird sound when coming home from work this morning. When backing up, you can hear what sounds like a clicking sound coming the car. The noise doesn't happen if the car is stopped and in reverse. It starts when you start to move and the faster you go, the louder and faster the clicking is. After this, I now found out my sister's boyfriend backed into the car last night pushing it down the driveway while it was in park. From my understanding, the car moved about 6 or maybe a little more inches. There is no damage to the bumper except the part that came unclipped which I just pushed back together with my hand and it's fine. The license plate is a bit bent though. It's an 09 auto and the park break was not engaged during last night's incident. What it could be? It sounds like it's coming from the front somewhere but I can't pinpoint where. I looked at the front under the hood close to the bumper but see no physical damage. I'm thinking CV or axle.
View 11 RepliesElantra HD (2006-10) :: 2009 - Throttle Goes From Idle 650 - 700 Right To About 2000 RPM
When sitting in Neutral or Park with the engine warm, my throttle goes from idle 650-700 right to about 2000 RPM. I have 14,000kms on it now. The fast idle works OK at RPMS between that OK when the engine is cold so it doesn't look like a ECU Problem.
There is no way that the RPM can be set lower, when attempting to go lower it drops right to idle. The dealer says the TPS is testing OK, but it never did this when new. It used to go gradually right up the scale.
What the dealer TPS testing actually measures? I suspect that it only measures the output voltage to be within requirements of 5 to .2vdc, but doesn't have anyway to measure a linear change in voltage that should be taking place when the throttle is depressed. And since the engine never tries to speed up unexpectedly except under no load conditions like this, they say it is normal and won't change the TPS.
My guess is that the TPS resistor is not working linearly and that the first part of the throttle movement doesn't change the output voltage to allow throttle setting for a lower RPM than 2000 under a no load condition only.
Remember you can only test this in park or neutral with no load and the engine warm.
Further investigation has shown that the TPS output is linear and the ECU just doesn't react to changes in voltage that will allow the engine to run at less than approx. 2000RPM under a no load condition. Apparently all the 2.0 litre engines perform the same way by design.
It would seem to indicate that safely controlling your vehicle with precise fuel adjustment in tight places is not necessary by someones standards.
Elantra HD (2006-10) :: 2009 - Intermittent Start / No Spark
One morning my 09' Elantra didn't start. It sounded like it was only the starter running. I checked the spark and there wasn't any. I checked the fuel injector pulse and got nothing. Occasionally I could get it to start just by trying a bunch of times but never more then once in a row (or day for that matter).
I decided to replace the Crankshaft Positioning Sensor. The first time it took a bit but started up and ran nicely, till i turned it off. Now I'm back to a no start car and again with no spark or fuel injector pulse. It does feel like it's trying to turn over just a little bit now that i replaced the sensor.