Elantra HD (2006-10) :: 2008 - Slight Vibration During Idle
Jul 30, 2010
I just bought a 2008 Elantra SE with 26K miles. So far, I've really enjoyed it, except for, at times, it does vibrate somewhat during idle.
I took it to the nearest Hyundai dealer, and they clipped the throttle cables to the inside of the firewall. This did make some improvement, but I still feel vibration during idle when the engine is warm (doesn't seem to as long as RPMs are up). It's almost as if the idle is set a little too low.
Maybe this is just normal vibration? It's not too bad, just noticeable. Can idle in these cars be adjusted? It seems the car is too new to have clogged fuel injectors. Everything else about driving it feels great, acceleration, etc. Do you think using a higher octane gas would work?
View 2 Replies
Advertisement
I have a 2008 focus and at about 15000 miles started having a slight vibration at idle. Its idling at about 700rpm is that normal? It more annoying than anything. Took it to Ford and they just say its normal. What the problem could be? Should I replace the plugs?
View 4 Replies
Experienced slight vibration at idle with the ac on ranging from 780-825rpm n causes shaking. Don't remember it ever doing it before. Also once I off the ac it goes away. Also the car started dropping rpm a little when slowing down.
View 9 Replies
I posted a while back about my 04 5.4 having an issue at idle. I did all the normal things like replace coil, spark plug, etc etc. No change to the issue. It still acts as though it's misfiring on a cylinder and I get codes P0306 and P0316. Finally took it to ford and had a diagnostic check ran. Everything on the top end was in working order. The tech even put a known working coil on 6 and nothing changed. I was told that it's either an intake or valve issue on that cylinder. But no definite answer to problem.
Fast forward to yesterday. I got a wild hair at lunch and went out and started truck. Pulled injector plug off of 6. No change to the way it was running. I did the same for 5, 7, 8, 1, and 2. All of which made a big difference in the way it ran. It was obviously misfiring with no fuel to cylinder. This gave me the idea to swap 5 and 6 when I got home to see if the issue followed the injector from 6. I did NOT. I pulled the plug on 5 and got the obvious change in the way it ran. So there is definitely something going on at cylinder 6 that I cannot figure out.
PCM, bad intake, bad valve? I'm not rich so a trip to ford for repair is gonna have to wait. Truck seems to run fine when driving except for slight hesitation during acceleration.
View 3 Replies
My moms has a 2010 Elantra with 30,000kms on the clock, and we have noticed since new when the vehicle is started cold in the morning it seems to run rough for about 30-60 seconds then stabilizes.
It's almost like it has a slight misfire, or slight fuel flooded from sitting overnight. Now if course we have taken it to the dealership twice for this issue and dropped it off overnight for a cold start, and both times they cannot re-produce the problem.......surprise.
View 6 Replies
My truck had a slight vibration at idle today and what i noticed the most was i was looking at the top of the motor and i noticed that the fluid in the power steering reservoir was shaking back and forth like i was shaking the container. Is this from the vibration or is the power steering system vibrating. I have had this truck for two weeks and it has 135k on it. It is the 5.4 motor...
View 1 Replies
I drive a 2008 Elantra automatic,and have a constant engine shudder/vibration whenever the rpms are between 1000 and1500. The engine shudder stops as soon as I accelerate above 1500 rpms,or take my foot off the gas completely.
The dealer recommended cleaning of the fuel injector system,not sure if thats the course to take.I do know my model has had fuel pump issues,but the dealer has told me all recalls on the car have been processed.
View 3 Replies
2015 GTI have a slight vibration at Idle speed is this normal I have a 2008 a3 that car doesn't do it, it's almost like it's misfiring I know the car switches between direct injection and port injection?
View 6 Replies
Noticed a slight vibration from my engine at idle. Nothing too overbearing but just had a concern. How much should I expect if the engine mounts need replacement? Parts? Labor?
View 11 Replies
1.8T Car only has 73k on it.? When I am sitting at a stop I can hear a vibration sound coming from the engine bay. It goes away as soon as RPMs hit about 2000. My best guess is old, worn out engine mounts.
View 6 Replies
I have just purchased a 2005 elantra fx and noticed a vibration all the time in the steering and you can feel it in the seat on the floor and peddles, not severe but enough to be annoying. I had the same vibration in my last car a 2001 elantra. Is this normal with these cars, or could it be something like engine mounts as there is a very very slight clunk on acceleration ?
View 2 Replies
I've had my 2013 Hyundai for about a week now and I feel a slight vibration/shaking when the car is stopped and I have my foot on the brake. When I was in the finance office signing all the papers, etc. The finance manager was trying to sell me the free oil changes for 3 years/tire rotations/filter change for $600. He was adamant that if I do not get all my service done by Hyundai dealer all the warranties are voided. I asked him specifically this question at least 3 times as I was appalled at the notion, and time and time again he would say the second you bring it somewhere else for an oil change the warranty is voided. 5 days later I brought the vehicle back to get my sticker, and I asked the guy at service, he said absolutely not. He said it doesn't matter as long as you have the proof/receipts.
View 18 Replies
I'm not sure if this is normal, but I have noticed a slight vibration in the steering wheel. This happens when the engine is completely warmed up and If I'm sitting at a complete stop in drive (no air conditioning, seat warmers, or headlights on) it happens. It is not a vibration where the idle goes up and down. The rpm gauge shows that it is between a consistent 550-600 rpms. When the headlights or air is on, the idle goes to around 700-750 and the steering wheel vibrations go away. I do not have any cel on and I know the car is not miss firing. I think it's just because the low idle.
View 9 Replies
I recently bought a 2004 Hyundai santa fe 2.4l with 94k miles. when sitting at a idle it has a slight vibration in the cabin, feels like a slightly rough idle, when you drive the vibration is gone. I also had it throw misfire codes for cyl 2 and 4. I put in new plugs and changed the wires, coils are on the way. When the car is in drive and I put the parking brake on and walk up to the motor it sounds like it has a exhaust manifold leak, but I only hear it when in drive. I guess my question is, could this exhaust leak be causing the rough idle or will this be fixed once the new coils are on?
View 18 Replies
Is this a normal thing? I notice that my 2013 Elantra has a slight shudder when stopped in drive, most noticeable when the Air is on. It's not always there, but I would associate this with a low RPM idle.
Is this normal for these cars? It goes away when in park/N, and sometimes if I turn the air off completely.
View 14 Replies
I'm looking at a 2001 Excursion with 242k miles. Truck is all stock, and everything checks out well. The only thing is there is a slight vibration at idle, that increases quite a bit when the engine is revved to about 12-1500rpm. Ran a CCT, and #8 was flagged. I know that can be somewhat normal depending on the CPS, right? Otherwise the truck is smooth, and in great shape. Should I be concerned about what feels like a slight miss on #8?
View 3 Replies
5.0L ... I'm having one of those moments, you know after you do a mod to your truck and all of a sudden you notice something about your truck that could have been there all along but now you notice it as something new? Ok earlier in the week I had my exhaust resonator removed and replaced with a straight-pipe by a reputable exhaust shop. IMO the work looks to be pretty good for what it is.
That said I have always been nervous about getting exhaust work on any vehicle because it always seems like tampering with or removing the OEM plumbing for aftermarket or custom work tends to develop a vibration at some point.
So here is what I've noticed over the last couple days, when driving my truck it is extremely smooth, almost like glass. When I come to a complete stop say at a traffic light about 1-2 seconds after making the complete stop I feel this slight harmonic vibration in the steering wheel. For those of you that have an iphone it would be like having your phone bolted to the steering shaft somewhere and it on constant vibration if that makes sense.
Just to prove it only happens when I'm sitting still and idling in (D)rive I sat in my driveway with the truck idling, set the park brake and released the brake pedal holding the truck in place in (D)rive with the parking brake. No vibration, smooth as glass engine idle, as soon as I put my foot back on the brake pedal the vibration comes back. It's as if the extra draw of applying the brakes puts an extra load on some sort of accesory drive or componant under the hood and the result is this harmonic vibration.
Just so everyone knows, the vibration is very noticeable to me because I drive the truck daily, most people wouldn't pick it out if I didn't tell them first. Case in point if my wife drives the truck she can't feel it unless I tell her what to look for. There are going to be some of you that just say my truck doesn't do this and has had a smooth idle for XX,XXX miles I believe you but let me know now that I have explained exactly what to look for. Like I said for all I know it's done this since day one.
I have a feeling that the straight pipe might have been welded in slightly longer than the oem section that was removed thus putting more tention on the exhaust and engine if that makes sense, the end result being a slight vibration?? I know that manufactures put these little rubber bushings along the exhaust system on cars/ truck to absorb harmonic vibrations and for all I know my resonator might have been designed to balance out harmonic vibes in the exhaust system as well as quiet down the exhaust.
View 2 Replies
It feels like I am having a front bearing issue, when turning the steering wheel to the right I feel a slight vibration in the steering, need to know which one is going out,??? I have already replaced the passenger side twice It just seems to not tighten completely as I can still move the tire slightly while up on a jack...
View 12 Replies
i have a 04 f150 2WD I've been noticing a slight vibration on initial takeoff, it only lasts for a couple of seconds then it goes away. I have the "non serviceable drive shaft" the u joints are staked into the yoke. there is some up and down play where the drive shaft goes into the transmission extension housing. Does that play is normal or what may be causing the vibration?
View 3 Replies
I've noticed that when I am driving my car in the morning there is a slight vibration in the car, it feels like the rear, but it could be the whole car. After I drive it for a while this vibration goes away. The vibration never comes back again until the next morning, even when the car sits at work for 8 hours the vibration doesn't appear.
It's not a violent vibration, it's very subtle but it is noticeable. I'm thinking that most likely it is my struts and shocks, I know that they probably need to be replaced soon (with our shocks being crap).
I don't think my wheels are out of alignment as the car doesn't pull to any side at all and my brakes are also good and not sticking. The car has 86K on it. What is going on and if I should be more concerned than I am or is it just worn shocks and or struts?
View 1 Replies
I have a 2007 Accent that I love but have a strange issue. I had both front wheel bearings replaced about four months ago. Recently (about the past three weeks) there has been a slight vibration at speed once I hit over 50 kph, which sounds/feels like an alignment/axle issue (almost like there is a flat tire type of sound) but there isn't any sway when I let go of the wheel and I had the front end inspected and they told me there are no loose parts.
I took it to a shop, and they said a wheel bearing needs to be replaced. So of course I took it back to the original shop and had them check it again for free - they said it isn't a wheel bearing but what it could be.
View 5 Replies
