Dodge - Intrepid :: 2000 - AC Clutch Always On Even In Heat Mode (no Defrost Mode)
Aug 21, 2015
I have a 2000 Intrepid with ATC (automatic temperature control).I noticed my A/C clutch is always is on even in heat mode (no defrost mode) Is this normal in automatic mode even if I set temp at 90° without defrost mode? Been looking on forums and some say it is normal for newer cars and some say no. What is correct.Doesn't seem normal to me when I set temp at 90° and the A/C is still running. The heat does work though.I did check for voltage at the clutch and it has power so something is telling it to run, (not a bad clutch,stuck clutch etc).
I never seen or heard it cycle when watching it. (hard to tell when driving) because the cooling fans go from low to high sometimes even without the A/C cycling.
In manual mode I can physically turn on or off the A/C but if it is on, I never seen it cycle yet when set at a normal temp 72-75° is this normal?I know it depends on outside temp,humidity, inside temp etc but if it feels comfortable in the cabin shouldn't the A/C cycle on and off every few minuts-10 minutes etc or is it normal to go 30 minutes or more without cycling? I don't have it on max Cool or recirculate mode either.
View 5 Replies
Advertisement
I have a 2003 Dodge Intrepid SE 2.7L with 170,xxx miles.... My check engine light came on and is showing the codes P0562, P1776, P0871, P0441, P0700, and P0440. While driving, the car jerks and then i only have 2nd gear. If i shut the car off and turn it back on everything runs normal again for a little while. i had my battery and alternator checked and both tested good. What could be causing these codes and why only 2nd gear (Limp Mode)?
View 1 Replies
Last Oct. I noticed that my ac/heater started to intermittently stop blowing from AC fresh air/recir/vent/etc. mode and stick to defrost only. Do I have a bad switch and or a vacuum issue here? It's a '01 F350 CC 7.3 .....
View 6 Replies
I recently purchased a 2005 Monte Carlo, it has the 3.4l V6. I live in Pa. and like others our winter has been real cold, I was waiting to pick up my wife from work the other day, while sitting in the car i was changing the heat selections from defrost to floor to bi-level and realized that the A/C compressor clutch is engaging when the selector is on defrost and floor, it disengages on bi-level. I know that it is supposed to engage on defrost. Is it normal for this car to activate the A/C on floor? if so it is a first for me.
View 4 Replies
My 99 Monte Carlo LS has a problem with the ac and the heater being stuck in the defrost mode. The heater and the ac work fine but it won't switch to anything else. I heard this could be a vacuum prob. I found a hose that runs from the top of the upper intake manifold. It goes to a T then one end to the firewall and the broken end is by the battery. I don't know where the broken end goes.
View 5 Replies
2014 Grand Cherokee Laredo. Wondering why the hvac acts like it is in recirculate mode with the A/C button pushed in manual mode. Have window cracked to force smoke and odors out of cabin. On vent mode it pushes air right out, in A/C mode it acts like recirculate is partially on and in recirculate mode it draws outside air in like you would expect recirculate to do. Trying to decide if I have something wrong or the nature of the beast. My GM vehicles do not act like this.
View 1 Replies
I have noticed that when driving in EV mode when the car switches over to HV mode the Eco icon always lights up! Of course you can select Eco, or Power mode manually, but when it does this automatically, after the EV battery charge is used up, it keeps showing the Eco icon being lite not HV.
View 1 Replies
My 2005 Ford F250 6.0 diesel CLIMATE CONTROL DEFAULTS TO DEFROST mode all the time now. For some reason I'll turn on the AC and it is either already in defrost or changes to it no matter what I do. Is the head unit in the dash the problem or is it a vacuum leak or an electrical issue?
View 2 Replies
My AC always defaults to Recirculation mode the first time I use it after starting the car even though Auto mode is off.
Can I change this to default to fresh air mode?
View 10 Replies
I have a 2008 F350 with a 6.4 Powerstroke diesel engine that just experienced total engine failure. It has around 65K miles.
There is a heavy burn star pattern on all 8 pistons, a few pistons are cracked, a few cylinder walls are scored, glow plugs are melted, both heads are cracked with multiple stress fractures in each head.
About 1 month previously, the transmission would not work in tow mode and caused the engine to go into limp home mode. The dealership just replaced the entire tranny as a warranty item. About 1 week before the engine failure, I put in a 5.25 oz bottle of Lucas injector cleaner with a full tank of gas.
The Ford dealership is saying that the star pattern on all 8 pistons is due to high pressure fuel overspray and is evidence that I had a tuner on this engine and that the warranty is invalid. I did not have a tuner. What might have caused this engine failure?
Also, they only ripped down the top half of the motor, not the bottom half. I heard this might have been caused by a cracked crank shaft, but Ford refuses to investigate this possibility.
View 14 Replies
So i noticed, when in auto mode, whether sport mode is on or off, it does the same thing. If i floor it from a stand still, the transmission takes noticeably longer to go from 1st into 2nd then from 2nd to 3rd, 3rd to 4th, etc. 1st to 2nd takes like a good second, kinda like this:
1st VROOOOM.....................2nd VROOOM..3rd VROOOM..4th.....etc..
If I drive it in manual mode, then it shifts just as fast. So this only happens in auto.
View 14 Replies
I have a concern about my 2010 Prius V(five). I've noticed some issues lately that may all tie in to one big problem.
1. My ev mode will not work at all. My battery will be fully charged and not in "B" mode. Turning car off and on will not work.
2. Engine will not turn off when coming to stops. Mind you when the battery is above 3 lines.
3. Throttle response feels like it's in PWR mode(super sensitive) but the engine is leggy. If I floor it for a sec the RPMS are super slow to come down.
4. The Eco line is quick to go in PWR portion and I'm not pushing it any harder than I was before all of this started. It seems like when I push the gas it skips the electric and automatically pulls from the engine.
View 15 Replies
Here in the Midwest its starting to get cold, very cold.... so the heat is getting cranked. Why doesn't Auto mode leave it on the heat setting when I leave and come back? It reverts it back to A/C.
View 19 Replies
I have a 2000 Dodge Intrepid with 92000 miles. Several times a day I get a vibration or shaking coming from the right side front tire. It comes and goes. It only happens between say 30 and 50 miles an hour. It stops whenever you hit the gas or turn the wheel to the right. Seems to start mostly after hitting a bump or rough road.
View 2 Replies
I've had this 2012 SE I4 for about 6 months, but since it has been cold, I've noticed that when switching heat to floor vents only mode, that most of the air still flows through the upper vents (I'd estimate about 50% still flows through the upper vents).
I've taken a thermometer and read 80F coming out of top vent and about 60F coming out of the bottom.
When driving my face/body feel like they are on fire but feet still remain cold. Took to the dealer and they said there is a temp/and airflow difference but appears normal.
If this is normal, it is totally different than any other car I've owned. Does most of the air still come out of the upper vents when on floor vent only?
View 14 Replies
I have had my 2005 Dodge Sprinter, 2500, with 214,000 miles, for one month. When I bought it the seller told me that after I drove it for a while it would become sluggish and not keep up to 70MPH. I have found that when this happens it may slow down to 50MPH going up a hill and takes a while to get back up to 65+ on the flat. Sometimes it goes into slug mode when I cannot accelerate normally in heavy city traffic. Slug mode happens at all speeds. When it happens I can get back to peppy mode by shifting into neutral, turning the engine off, coasting and turning the engine on. I tried this because I noticed when I stopped to go in a store and shut the engine off, it was peppy even if if the stop is only a few minutes.
View 3 Replies
My Neon tranny has been acting up lately with the cold weather. When I first put it in gear, if I do not keep it at a near idle sometimes the transmission will go into a total neutral mode. You have to just stop, wait a minute or two, and then begin to take off very slowly.
Once I get couple blocks it works fine. The temps have been in the 30's lately. Will get colder. I have been letting it warm up for about 5 mins before I drive it. I think it may work more if I leave it run longer, maybe 10 mins. The fluid level is full.
Could it have something to do with the fluid being cold? If so, would letting it idle for a very long time, 10 - 15 mins solve this problem? What is causing this? What can be done?
View 19 Replies
I have a 2001 F-350 S/D w/7.3. Question is... Is it possible for the mode switch ( one controls floor/ defrost and A/c ) to not function or should I say leave the a/c on even if it is not in a/c position? What I have noticed was that when it is in the floor mode or the vent mode (not the floor/vent) the compressor does not come on. When it is in vent/floor or either a/c modes it does. Is this normal... I don't think so though I do know anytime the a/c is switched on compressor should come on but no time without a/c being on.. Maybe I'm wrong
View 9 Replies
I read another blog on here about stratus not shifting and decided to ask someone about my limp mode problem. A few months ago I was driving uphill when it jerked before it got into limp mode. I thought maybe the hot weather caused it(it was 95 deg). I let it sit overnight. and the next day car was fine. for about 3-4 months. Now it got into limp mode only after it goes through all the gears once only. When i come to a stop it will go into limp again. Got a 0700 and 0760 codes. My speedometer works. tach works. Basically everything works as it should.
I decided to change the ATF and filter, both speed sensors and i get the same old codes after a drive around the block. I then decided to remove the neg terminal overnight. Next day I would have no signal at the data link port. When i removed the key from the ignition my dash lights for the mileage will stay on for another 3-4 seconds before disappearing. I checked the ground wires to the PCM and TCM which are good. Fuses and relays are also good. I even swapped some of them. Still no change. 1997 stratus 2.4 auto...
View 4 Replies
Problem 1: Headlight switch occasionally needs to be jiggled to get headlights on.
Problem 2: Wipers only work in the "spray and wipe" mode.
My Solution: Removed dash, installed new switches, replaced dash.Result: Now the right headlight does not come on at all. Wipers STILL only work in the "Spray and wipe" mode.
Question: Where do I go from here?
View 6 Replies
My tranny is stuck in limp mode. I can manually shift it, but it won't shift on it's own. The 'automatic' part of the automatic transimission is definitely not working right.
I searched and checked for the usual suspects, low battery or alternator output (measured over 14v at batt. when on), and the range selector switch. I removed the switch, took it apart, cleaned it up, and reinstalled it. It looked like it was in decent shape inside, although it appeared to have had a bit of oil of some sort that had leaked into it. There was a bit of oil on that side of the tranny, around the gear selector and switch, but not enough to actually drip as I don't have any stains on my driveway where I always park. The only thing I haven't checked is the atf fluid level, as I can't seem to find the my wrench that will take off the fill nut. I'll get that figured out tonight.
The tranny hasn't been taken care of like it should, I've had the fluid replaced two or three times over 100k of ownership, but I'm not sure about the filter. Would the need for a filter and fluid change cause it to go into limp mode? Also, it's not throwing any CEL codes either.
View 14 Replies
