I haven't owned a manual transmission in a while so I need to know if this is normal. When shifting into any gear I have to force the shifter into gear with quite a bit of force. Almost like it's hitting something and then going into gear. There's no screeching or grinding. It does the same thing when pulling out of gear.
View 19 RepliesI recently purchased a 1969 dodge dart, with the 225 inline 6. I have done the usual repairs (fluid changes, spark plugs and wires, fuel pump and line, thermostat, and even carburetor and distributor). The car starts and drives alright except when at idle such as red lights where it begins to tremble and shuts off. I have to start it again and begin to accelerate it while idling to keep it from giving out. I fixed the timing and switched to electrical distributor but the problem has persisted.
View 7 RepliesI have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 RepliesCould my brake issue be related to my transmission problem? Neither are constant. Brake problem= sometimes the brake pedal feels hard, like there's no power brakes (I drove a car once. ..looong time ago. .. that had no power brakes or steering) but it will kick in after a short distance. Transmission prob= seemingly unrelated, is a problem shifting from 1st to 2nd gear. This has happened maybe a 1/2 dozen times, the first time and mostly when in heavy commute traffic and when going between 1st and 2nd gear because of the slow commute speed, but also at other times when not in lengthy slow commutes. When it doesn't shift, the odometer doesn't work (shows only dashes) and an engine light comes on (the sprocket/gear looking one). Usually the transmission will eventually shift and the light goes off.
I read that the brake problem might be a vacuum hose problem? Something about a booster? Is this dangerous? or is it like having a car w/ no power brakes? Going to have my transmission looked at this week. Read on another site about dropping valve seats on this year car. If there's a major transmission problem, I'm wondering if it's worth fixing? I changed, timing belt, water pump, front and rears brakes, tires. 143,000 miles.
ok, i just became the proud owner of a 71 dodge dart.. fuel pump was not working, and am converting to an electric (airtex e8016s) and am told i need a relay. airtex doesn't seem to have one, is there another i can use? fairly new at this sort of thing, but have fixed a 72 honda motorbike, so not afraid of engines or whatnot.
View 19 RepliesBackground facts:
Tranny swapped from my 4 speed auto to a 1.8t o2j 5spd
13lb. Light flywheel
Powerflex dogbone mounts
Peloquin LSD
The problem: Very hard to get a smooth shift from gear to gear. Trust me, I know how to drive, but I can always feel the car shifting into a different gear if you know what I'm saying. On my friend's bone stock Jetta, I just let the clutch out without gas in between shifts and you don't feel a thing.
On my car, you feel EVERYTHING. People have told me the light flywheel will make the ride more uncomfortable in many ways, especially since the RPMs drop much quicker in between shifts than stock.
I've just got my 2015 GTI a few months. I'm driving manual with my GTI daily commute to work, getting along well. However sometimes I'll be struggling with the manual when approving a corner or a stop, and I'm not having a smooth up shift with 3rd and 4th gear (odd eh? most of the people will have difficulties starting up but since I've been taught so I'm fine...)
To be more specific:
1. Just want to know what REV usually will be done? e.g. 3rd gear with decent speed, would you maintain it until it revs up to 3k? or would you up shift when passing 2k+? Usually I'm doing the latter so I guess this is why I'm having a sluggish/jerky up shift with 3rd and 4th gear. And would you still put on a little bit gas when engaging with 3rd and 4th gear?
2. What to do when approaching stop? Assuming you don't have enough distance to down shift each gear. EITHER: Break with the current gear and clutch in until it reach 1k rev and complete stop; OR: down shift at least once to a lower gear and break until complete stop?
I have a 2006 Dodge Grand Caravan SXT with the 3.8 and 135,000 miles. Whenever it is hot out and the engine has been running it is hard to shift either from park or back into park. Today it completely froze on me and I had to wait for it to cool down before it would shift into park. Temp out is about 80 today.
View 2 RepliesI got new brakes put on a few months ago month (semi-metalic)... Any way anytime I drive and it is raining, when my car comes to a to a complete stop, and I hit the gas to shift into second gear my car sort of stutters like it doesn't want to shift but then it does.
I took it to two mechanics MULTIPLE times who even drove it in the rain and they couldn't find a single thing wrong. they hooked the transmission up to the computer and noticed nothing.
It has happened multiple times and its both been raining. Could it be the tires aren't gripping the road and that's why my cars shifting funny, like the tires aren't caught up?
My 2003 Dodge Dakota does not shift properly sometimes going into second gear and it only happens in second gear. I have to lift my foot off the accelerator for it to shift into third. If I don't it just screams at a high RPM and sounds as if it is about to blow. It has a hard time making it up a small incline such as an off ramp. Truck will not shift properly when going up grade. Engine will rev at 4500-5000 rpm but will not shift until I slightly release the gas pedal. Truck will also perform multiple hard up shifts whether in cruise control or not in cruise control, going upgrade. Took the truck to the dealer reprogrammed the computer with a "flash update" that was no luck. Not once has the ENGINE LIGHT ever come on.
So a lot of the comments that were presented to me I have done. Here is a list:
Changed govner senors and solenoid. Did not work.
Checked for exhaust leaks and other leaks. No leaks.
Checked all vaccuums. No problems there.
Had engine checked and dyno tested. No problems there.
Had transmission rebuilt. Same problem. (dealer did work)
Had new transmission put in. Same problem. (dealer did work)
Also, sometimes when I put the truck in reverse, it seems to about to stall, but it doesn't. It also does it sometimes when I put the truck in drive it seems that it wants to stall.
I just recently learned that my truck has a Transmission computer module, Transfer case computer module and of course the main computer. Is there a way to test those modules out?
This morning my 2006 Dodge Dakota v8 auto decided to become a large paperweight. I started it up fine and let it warm up a bit (about five-ten minutes), then shifted into reverse to leave my driveway and it won't move. It just rev's and rev's like it's in neutral. I tried Reverse, Drive, and both low gears, but no luck.
Since it got very cold, it has been making a buzzing/whirring sound that seems to be coming from the belts. But that sounds would go away when the car warmed up. I thought I needed a new power steering belt (and still may), but that wouldn't keep the car from moving at all, right?
Driving in normal mode and the transmission in auto. Once the car gets up to temp, (usually at a stop), move the gear selector to manual mode. If you punch it, I have not issues shifting from 1st to 2nd gear, but sometimes, the up shift paddle will need to be hit multiple times in 2nd before the car will shift to 3rd.
It seems to only happen the first time I go from auto mode to manual mode during a drive cycle. It happens on my car and another car I test drove.
I have a 04 grand caravan 3.8 liter. after filling up with gas & only after filling up i have a prob with the way the van runs. it will start and idle fine but once i shift in to gear and try to drive it starts to buck. if i take my foot off the gas it wants to stall. if i shift in to N or park the RPMs are around 400/500. if i rev the motor in N or park it will smooth out and idle fine and drive fine until the next fill up, then it starts all over again.
View 1 RepliesI get a hard shift into second gear, it jerks into 2nd but not all the time. I only notice it after driving on the freeway for several miles. It has 60,000 original miles. Service Engine Soon light come on after the hard shifts with a transmission fault code. I reset the Engine light and let it set 20 or so minutes and it shifts like new.
1997 CHEVROLET TRUCK S10 2WD
6 Cylinders 262 X 4.3L SFI
Automatic
I just finished the DG install yesterday. I am having a real problem with the first gear: it is really hard to shift into it (I mean hard!) - and several times I went into 3rd believing it was in 1st, while driving. I know that the DG is notchy and a little stiffer (which I like) but this does not feel right. I have to really push hard (moving slightly toward reverse) to shift into 1st. My wife would never be able to find it or shift into it (not that I let her drive my R that much...).
Note that all the other gears (2,3,4,5,6 and reverse) shift beautifully without any effort with that nice click. But not 1st.
What is it? Adjustment? I did it twice. I made sure that both cables were "all the way in" before tightening the first two bolts (and I made sure that the cables were not moving - a common problem with this install) with the engine lock on and pin in.
2015, F250 6.2L, 16,000km , so recently my transmission has seemingly lost its mind. When I start it up cold and drive it down my street I am greeted with a horrible slam of a 2nd to 3rd gear shift. Then while towing my TT this weekend a couple of times it held 2nd waaaay longer than it ever has before. Having issues with Torqueshift?
View 7 Replies2011 TDi 6 Speed (Sportwagon) with problems shifting into 2nd? Mine is currently in the shop under investigation for a balky shift when cold. The tech says it's not right, but then they find another vehicle in inventory with the same issue...currently waiting on a VW engineer.
View 16 Replies2000 ls v8 sport shifts normally exept while shifting into 2nd, it kind of pops out but then locks then shifts normally.
View 9 RepliesMy 97 Taurus shifts hard going into 2nd gear only. It started as just a cold problem but now does it all the time and there are no computer codes stored.
View 2 RepliesMy Santa Fe 2001 model V6 4X4 Automatic shift gears down hard from 3rd in to 2nd. I checked transmission oil and its light brown. Should I drain and refill or not worth it.
View 7 RepliesI have brand new ( 800KM ) Accent with Automatic transmission and I noticed that it shifts from 1st gear into 2nd kinda rough. By this I mean that I can feel shift pretty good, and I don't feel shifts from 2 to 3 to 4. I don't rev engine high, typically shifts occur when engine revs around 2000 rpm.
I am not sure if it is a transmission defect or this is the way it shifts? May be I need to breaking my car first and it will go away?