Dodge - Dakota :: 1996 - Headlight Will Flash On And Off While On Low Beams After About 30 Minutes
Apr 8, 2013
So I own a 96 Dodge Dakota and its had a few problems since I first bought it, but its all fixed except for one really puzzling problem. My head light will flash on and off while on low beams after about 30 minutes (if on high beams its almost instantaneous). It all started out with my dash lights going out then the head lights would go out when driving. I checked the switch and plug, both were fried, so easy enough fix. That fixed the dash lights, but the head lights still go out. I replaced the bulbs and yet the problem still exists. I then took it to O'Reilleys and the put a volt meter to my negative battery post and to and auxiliary wire just 6 inches from the post. When the lights were on they produced around 46 ohms of resistance and when they shut off they produced 26 ohms. Which isnt good, so I replaced the negative battery cable to try and fix the problem. This still did not solve it. The only other suggestion I have been given is to replace the high/low beam switch on the steering whee. Could that solve the problem?
View 9 Replies
Advertisement
I have a 2000 Dakota quad cab with a 4.7 l when I turn on either turn signal itll flash 2-3 times or sometimes not even flash at all when it does it just stops u can hear the flasher working . What to check and how to check/ replace parts I need to get it working again is there a flasher inside the steering column. or is there just a relay on the side where the fuses are ?
View 1 Replies
I have a 89 dodge dakota and it starts sometimes and other times it don't start at all. When it does start and runs for a few min it will randomly die and when I try to start it after it dies it wont start back up. Me and my dad just fixed the starter relay yesterday and it started every time after that, now today it wont start. New coil, fuel pump, and fuel filter are new.
View 5 Replies
When cold the trans works fine for about 15 mins, then its like you put it in nuetral. No forward no reverse. A friend suggested changing filter/fluids so I did. Worked great for about 4 hrs then same thing. Leave it sit for a few hours and it works good for about 15 mins then nothing. Should I try another filter or something else?
View 1 Replies
I have had this truck in 3 different shops and none of them could figure it out. The codes say misfire in cyl 2 and 5 bank 1 too lean and primary and secondary circuits malfunctioning for ignition coil. I've replaced the ign coil cap, plugs,plug wires, rotor, pcv, fuel pump, pick up coil, cat, o2 sensors and all sensors under the hood. Switched out all vacuum lines, cleaned the IAC and checked the pulse ring. The truck loses all power and either dies or backfires and regains power randomly. If I drive at night, it will stall and keep cranking when trying to restart. Usually have to let it sit for ten minutes for it to turn back over. Last night it backfired and stalled every 50 ft for over a mile. During the day, it revs up and down at idle by about 100 rpms.
View 6 Replies
So my 96 Dodge Dakota's instrument lights went out a couple days ago, I thought it was just a fuse, so naturally I check all the fuses. Come to find out they're all fine, I replaced a few to see if maybe it was just an old fuse. Still nothing. Then last night I noticed that the instrument lights came on between off and on for the lights. So I assume its a wiring problem. Then as I drove down the road I hit a bump and all the lights went off then kicked back on. Needless to say I can't drive around with lights that won't stay on. Where should I check for the cause of this problem?
View 2 Replies
so my 96 dodge dakota has been acting up a lot lately. I can barely drive in town let alone on the highway. when I drive, keep in mind its random most of the time, my truck will start jumping and then lose power. when I try to power thru it my truck will backfire and then shut off. once I try to start again it floods the engine. most of the time it will do this going up a hill or when it has to get above 3000 rpm. I don't know what's causing it. I replaced the throttle body fuel injection sensor and tranny filter but I figure its a fuel problem.
View 9 Replies
We have a 1996 Dodge Dakota SLT that we purchased used. It starts and runs beautifully when the engine is cold; however, if you turn the vehicle off it is difficult to get it restarted and to keep it idling without keeping your foot on the accelerator. The funky thing is that after your "fight" with it a few minutes (i.e., foot constantly on the accelerator), the truck will then start to run correctly and idle correctly until the next time you turn off the engine. We have noticed that on each occasion when we have had this problem, the engine smells EXTREMELY flooded. We've been told its a temperature sensor, any other number of sensors, and now the IAC. If starting by process of elimination with least expensive fix first, what the heck do we replace first?
View 4 Replies
My '96 Dakota SLT 6-cylinder pickup backfired and blew a hole in my muffler ... I've had it in three different shops on six occasions since and the thing still hiccups, backfires, stalls ... most of the electrical switches and sensors have been replaced ... right before it back fires, it feels like it is going to stall, then "POW" ... sometimes it continues to run fine for a little while after that ... then it happens again ... When it stalls it feels like it is running out of gas ... it is almost impossible to restart right away, but if I wait a few minutes, the starts right up ...
View 1 Replies
i have a 96 slt v8 dakota im trying to fix myself. it wont start. put new batt. new starter motor. it just clicks engine wont turn everything in truck is working but when i turn the key to start its just clicks and my radio losses power. so i took out radio and still wont start...
View 2 Replies
The truck had a hard time starting, turn the key over hear that it wants to, but won't. Once getting it started, truck would drive fine, but after about 10 minutes just dies while driving. It then took 6-7 tries to get it started again, drove back like no issue. What it could be? I have come up with, potential battery, fuel pump/filter, spark plugs, EEC relay, PCM, or AIS motor, O2 sensor....
View 2 Replies
I have a code scanner which indicated that I should change the MAP sensor. I did that, and just for fun changed the idle air control valve and throttle position sensor. Now the idle is extremely smooth in park or neutral, but once I'm in a moving gear it's up to the same shenanigans, antics and tomfoolery I described in my original post: 96 Dakota SLT idles rough & stalls. So I have a 96 Dodge Dakota SLT 3.9 4WD. Anyway, it idles relatively smoothly at about 700 RPM in drive or neutral, but if I'm in a moving gear and need to stop, the idle is extremely rough. Usually, the RPM's will drop to near 0 within about 20 seconds of coming to a stop. It will typically recover and continue with rough idling and near stalling a few times, but within a minute or two it stalls. A few additional details: it starts right up again after falling, it doesn't make any difference if I start it cold and drive immediately or drive it for an hour before coming to a stop, the same thing happens. Anything that looked suspicious to me has been changed (drivebelt, spark plugs & wires, distributor cap & rotor, pcv valve, idle air control valve, and, of course, the air freshener).
View 1 Replies
My 2007 Dodge Caravan has only one working headlight, the passenger side does not work on high or low beams.
At this time I'm wondering if the problem is in the headlight plug itself, because there are no other complications other than the passenger side not working.
The light did work at first on high beams but now not at all. replacing bulbs makes no difference. There is some brown discoloring on the white strip on the plug face, nothing like this on the driver side.
Also hoping that the problem is not the relay or front control module.
View 3 Replies
So I have a 96 Dodge Dakota SLT 3.9 4WD. Anyway, it idles relatively smoothly at about 700 RPM in drive or neutral, but if I'm in a moving gear and need to stop, the idle is extremely rough. Usually, the RPM's will drop to near 0 within about 20 seconds of coming to a stop. It will typically recover and continue with rough idling and near stalling a few times, but within a minute or two it stalls. A few additional details: it starts right up again after falling, it doesn't make any difference if I start it cold and drive immediately or drive it for an hour before coming to a stop, the same thing happens. Anything that looked suspicious to me has been changed (drive belt, spark plugs & wires, distributor cap & rotor, pcv valve, idle air control valve, and, of course, the air freshener).
View 1 Replies
I have checked fuse 46 and 47, and installed new headlight bulbs. I have high beams, but no low beams. I have searched this topic but no one has the same prob it seems. My headlight switch has broken. Could it be the headlight switch?
In my manual, it says the 2002 has a fuse panel behind the glove box. I took glove box out but it doesn't look like a fuse panel.
View 5 Replies
I want to replace my headlight bulbs; I want to install 8000K in my low beams, and maybe 3000K in my hi beams. But all of the bulbs that I ever installed either; A the burnt out within few weeks (lost color), or B they stopped working.
Now, regular WHITE bulbs seem to work forever; but the color ones, burn out/break. Low quality?? I need a pair of very good 9006 8000K, and 9005 3000K. Again, but I don't want to change them in a week or two. I want them to last!!
P.S. 2005 Toyota Camry
View 7 Replies
I used to think when I flash it'll turn on the high beam only but that's wrong.
Today I changed the high bulbs 9005 to a brighter pair trying to get a better DRLs, but when I tested the high beam by flashing I realized it turns both low & high beams on at the same time.
I have HID for low beam so that's not a good thing for me to flash. And I think I did it only one time in the past but now I won't do it again. Is it normal?
View 1 Replies
92 Dakota 3.9L ... Starts and runs great. Engine shuts down, usually within first 30 minutes after starting. No shutter, just as if you turned off the key. It has not been an everyday occurrence.
I can wait 2 minutes or spray brake cleaner in the intake and it will restart. It will run the rest of the day and never happens again on the same day, even with multiple restarts and driving 100 miles.
I have installed a new ASD relay, new fuel pump relay, new fuel pump, new crank sensor and new air valve controller on the intake. They can't seem to catch it when it happens.
View 2 Replies
1996 dakota v8 automatic 4x4. tranny rebuilt 3 years ago got stuck in the mud and every since then it is stuck in first. wont shift no matter what i tried to adjust the tv cable and it didn't work at all. don't know much about dodge transmissions iv always worked on 4l60e in chevys. I don't know were to start. Where to start. iv been reading about the governor valve and shift selnoids are there any way to test any of this? first pulls strong and reverse works
View 1 Replies
97 Dodge Dakota Sport V8. Has spark, turns over, won't fire.
View 1 Replies
My dad has a 2001 Dodge Dakota extended cab with a 3.9L v6 (standard transmission). It will start and run for a while and it will die, if you turn the key it will start up again but will eventually die. He has changed the spark plugs & wires, the distributor cap & rotor, the MAP sensor, and the throttle valve sensor. It still does the same thing.
View 1 Replies
