Dodge :: 1950 - Engine Won't Start Only Turn Over?


Jul 6, 2014

i have been restoring a 1950 dodge b2b pickup. engine was rebuilt. electrical redone. brakes redone. was starting before i began electrical replacement. all wiring replaced and everything working. But now the engine just turns over and over but won't start. I've checked starter, battery, spark, fuel pump and carburetor. Timing may be off because bolt holding distributer was loose without me knowing it. What do i do next?

View 19 Replies

Advertisement

Dodge - Neon :: 1999 - Engine Light Goes On When Turn Right / Goes Off If Turn Left

My sons commuter car is having an intermittent engine light. If you turn left while driving it goes off, turn right it goes on, move the wheel left and right you can make it a disco light on and off. I have had two code readers on this car and there are no engine codes. Im in California so it cant pass emissions test with any engine light despite the fact there are not codes.

View 4 Replies

Dodge - Dakota :: 1996 V8 Not Starting / Click When Turn The Key To Start

i have a 96 slt v8 dakota im trying to fix myself. it wont start. put new batt. new starter motor. it just clicks engine wont turn everything in truck is working but when i turn the key to start its just clicks and my radio losses power. so i took out radio and still wont start...

View 2 Replies

Dodge - Neon :: 2005 - Engine Won't Turn Over Sometimes

My stepson's 2005 Dodge Neon sometimes won't start. Turn the key, the dash lights and radio and electric stuff respond, but other than a click there is nothing of an engine start up going on. He'll turn the key a few times, he pumps the gas pedal, does what he thinks might wake it up. Usually it will start after a few tries. He thinks it gets worse in the cold weather, but not much worse.

He also notes that if he does a lot of short trips, like running errands, this problem comes up more often. The car may run fine for weeks, and then the problem hits. Of course, it never does this when the mechanic has it. The mechanic has no idea what to do, since the car works when they test it. I was wondering if I used a voltmeter could I check some key nodes when the problem comes up. Also, if it really does get worse at cold, can I spray some suspicious locations with freeze spray to try and instigate the problem?

View 4 Replies

Dodge - Grandcaravan :: 2002 - When Left Signal Turn On Then Right Side Start To Flash?

My 2002 Dodge Grand Caravan's most recent problem has baffled 2 garages so far. It is now in a 3rd one that specializes in auto electric issues. When I turn on the left signal it flashes a few times then the RIGHT side starts to flash. When I turn the right signal on you got it the LEFT side flashes! I installed a new multi function switch and NO CHANGE!

View 6 Replies

Dodge - Ram :: 1996 - Intermittent Fuel Pump Malfunction - Have To Turn Ignition Several Times To Start

Intermittent fuel pump problems in '96 Dodge ram resulted in new fuel pump 50,000 miles ago. Happened again 100 miles ago, so another new fuel pump. Now to start car must turn the ignition on several times before going to the start position. It appears the latest new pump may have defective one way check valve, so the pressure is depleting after turn off. Any favorite brand of fuel pump for the Dodge "pump in the gas tank" arrangement? Or solutions such as installing an external pump to do the work of pumping the fuel?

View 1 Replies

Dodge - Neon :: Engine Won't Turn - Makes Chugging / Rattling Noise

Went out to my car a moment ago, Dodge Neon 2000, couldn't get the engine to start. The lights all come on, battery seems fine. It sounds like the engine isn't even trying to turn over. Instead, the car makes a weird chugging noise. I've got a recording here, is someone still awake that could give me a clue as to what this is?

[URL] .... -- I turn the key twice here and let it chug. You can hear the noise at about the 2-second mark. I don't think I had any advance warning that anything was wrong, though I did have the car in the shop a few days ago to replace a water pump and timing belt.

View 6 Replies

Dodge - Neon :: 1998 - When Key Is Turned Starter Tries To Turn But Engine Does Not Spark

My Neon needed a water pump. At 204K miles the timing belt should be replaced also. The pump and belt were replaced. The motor started and the car drove about 1000ft. and stopped. There was no more spark. The car was checked to make sure that the timing belt is on correctly. The cam points to top dead center when the #1 cylinder is at peak and the crankshaft is at top dead center. Both marks align. When the key is turned the starter tries to turn but the engine does not spark. Electricity goes to the coil pack. 1998 Dodge Neon 2.0L SOHC 4 cylinder....

View 2 Replies

Ford F-150 - 1997-2003 :: 2002 - When Turn The Ignition On Engine Will Turn Over But Not Start

My 2002 F150 Screw has been giving me issues when trying to start it for the last month. Sometimes it will start sometimes it won't. When I turn the ignition on the gauges all seem normal, the theft light turns solid then goes out, but engine will turn over but not start. Sometimes it will start if I leave the ignition on for 20 seconds then pull the key and try again. (this doesn't always work). I have disconnected the battery for about 2 minutes this usually works but not always.

Sometimes it will start first time with no issues. Once the the engine fires it runs fine. Another symptom is when I shut the engine off, pull the key and open the door, the chime telling me that the key is still in the ignition sounds. (but the key is in my hand)

I put a new battery in yesterday to rule that out and because the old one seemed to be getting weak. (starting issues didn't go away). I don't want to put 300+ into a fuel pump without being sure that's the problem.

View 1 Replies

GMC :: 1950 - Distributor Module Not Working?

I have a 1950 GMC truck that I restored with a 350 small block v8 with a stock set-up. I now have 30K on the motor and it runs great except for one problem: The module in the HEI distributor keeps failing. The mileage between failures is random: 3k, 5K, 8K. I have now put in 8! I pull the module out and test it: Yep, cooked. I have replaced the cap, coil, and alternator. I think the distributor is not grounded properly. There is no tach attached to it. What is the source of problem? Should I just replace the whole distributor and hope for the best?

View 18 Replies

Dodge - Dynasty :: 1992 Won't Start Once Engine Gets Warmed Up

'92 Dynasty is a good runner, but, once the engine gets warmed up, I shut off the engine at my own risk. If the car sits for a while with the hood open, it will start again, but attempting to start immediately after shutting off will result in the engine spinning over but no sounds of attempted ignition. It seems that once the coil is cooled down to slightly more than body temp the engine will start like nothing was wrong.

View 3 Replies

Cadillac :: 1950 - Moisture Repellent For Distributor?

I'm going to be freshening up my distributor for my 1950 Cadillac, and I think because of bad weather stripping and other leaks, when it rains heavy, moisture might be getting on the distributor. Is there something I can spray on it that will repel moisture or would just a healthy dose of dielectric grease do the trick?

View 12 Replies

Dodge - Ram :: 2002 - Engine Start Shaking / Stalling On Highway

I have recently picked up this 2002 Ram 1500 quad cab and had the engine rebuilt because it was running rough. 2 weeks later After I'm driving for a bit, the engine starts shaking and feels like it losses compression and dies. It will not start for about 30 minutes and then it starts back up and I can drive for a few miles and it dies again. the longer it sits, the further I can drive. The head shop checked their work on the engine and could find nothing wrong with block or heads. they said the O2 sensors were clogged and replaced those for me. they also looked at the fuel filter and didn't see anything wrong with it.

I needed to know what direction to go from here.. Catalytic converter? Battery? Fuel Pump? I took the truck to the Service Dept at a Dodge Dealership... They checked it out and replaced the after-market O2 sensors with Factory O2 sensors and said it was running fine... As soon as We picked it up, it shut off again not 5 miles from the shop.. The service advisor tells me that his techs are scratching their heads on what could be the cause of this problem. I'm feeling that the problem lies in the fuel system somewhere, but not feeling confident in the dealer service to find my problem...

View 9 Replies

Dodge - Ram :: Engine Will Crank But Won't Start Unless Spray Starter Fluid In It

Okay so I have a 2004 Dodge Ram Hemi, the truck was running fine all this weekend and was fine this morning. Went out at lunch and used the automatic starter button while walking to it and wouldn't start. It turn over and wants to start you can hear it trying to catch but it won't catch unless you put some starter fluid in. Just changed all 16 spark plugs, all 8 coil packs, wires and 2 valve springs about 2 weeks ago have been running fine since and now this. What it could be?

View 15 Replies

Dodge - Grandcaravan :: 1997 - When Turning The Key To Start No Engine Turnover

This question concerns starting our 1997 Dodge Grand Caravan with 170K. The problem started about a week ago. When turning the key to start the engine, nothing would happen. No click, no noise, no engine turnover. By turning the key to off and then back on several times, the starter would kick in normally. The starter has never been replaced and I don't recall any electrical work ever being done on the car. I take it to our mechanic about every 2 years for a tune up and replacement of belts and hoses as needed.I have a friend that is a good shade tree mechanic and he is willing to replace the starter.My question is: Is the problem most likely a bad starter and if so, is replacement by my friend a reasonably easy task.

View 2 Replies

Caravan/Voyager :: 97 Dodge Engine Fuse Blown When Start To Accelerate

I have a 97 dodge caravan engine 3.0. When I start to accelerate my engine fuse 20amp blows. I does not occur every time but yesterday, it did it 6 times and is now getting looked at. I am just curious on what causes this. I did recently have my spark plugs changed so I am thinking something may be arching.

I do have codes that previously came up for my fuel injectors (P0203, p0206). Another code I have is p1294 idle speed performance.

View 4 Replies

Dodge - Grandcaravan :: Power Steering Is Noisy When Engine First Start And Run Few Blocks

I had my car power steering lush at a repair shop! Unfortunately, power steering is too noisy (lot of air trapped). The mechanic fixed right away at the time I picked up my vehicle but still had some noisy, he suggested I drove for few days to get the air out. After a week driving and the air still trapped. I brought my vehicle back to the shop and had the mechanic fixed again! and this time I got power steering leak when I drove home! I returned to the shop and he said he replaced both bad power steering hoses. Noise was gone (engine was at operating temperature).

My power steering is still noisy at a touch of turning steering wheel (not even turn the vehicle), it's noisy when engine first started regardless the temperature outside. I drive my car for few blocks and the noise goes away. I won't bring my car back to the shop anymore, they may make it worse. Logical thinking, I think either the air still trapped deep inside the steering system or the O-rings at hose ends are defective. When engine is cold O-ring is cold and shrink, it does not seal properly and when it reaches operating temperature, O-ring expands and seals properly. That's my thinking, of course, I can be easily wrong. There's no power steering leak to the floor!

Will those after market power steering seal additives like Lucas 10008 and other fix my vehicle power steering issue? is there something I can do at home to fix this?

View 7 Replies

Starting - Dodge - Intrepid :: Engine Sludge / Car Wouldn't Start Without Being Jumped Off

We have a poorly maintained 2001 Dodge Intrepid 2.7L with 155,000 miles on it. Over the Christmas break, we left it untouched in the driveway for a month. After that it wouldn't start without being jumped off, and the oil light flickered when the car idled. We had the battery, alternator, and starter checked at a local shop; all of them checked out fine. Nevertheless, the car wouldn't start without being jumped off. It would click once, and then nothing. We also noticed it was overdue by 2,000 miles for an oil change, and thought this may be causing the oil light issue. Since the 2.7L Intrepids are notorious for engine sludge, we added a couple of ounces of Seafoam, drove about 15 miles, and then took it in for an oil change. Now it starts without a jump. So my question is Is there any way that oil sludge (and perhaps a weak starter?) is the issue?

View 6 Replies

Cadillac :: 1950 - Safe To Remove Rust From Cooling System

Is there a safe way to remove rust from a cooling system? It's on a 1950 cadillac that's all cast iron with a copper radiator. I'm pretty certain the coolant passages in the engine are plugged up from rust. I took off the rad hoses and rinsed everything out until it ran clear, but I've done this before and the car still runs hot.

View 1 Replies

Neon :: 2003 Dodge Keep Cranking In Order To Start Up - Engine Code P0440

I have a engine code for evap sensor sometimes this can be ignored but this is causing me to keep cranking my car in order to start up what should I look for I know there's solenoid and charcoal canister and gas cap which one could be keeping my car from starting the first time.

View 1 Replies

Toyota - Corolla :: Loud Rattle At 1950 Rpm From Drive Belt Area

I have a 2002 Corolla with a 1.8Liter 1zzfe engine.

I can hear a loud "rattle" at 1950 rpm from the drive belt area whether I'm driving down the street or if I rev it up while parked in neutral. It's not a tapping sound, more like a sheet metal rattle but I can't locate an loose sheet metal.

I thought it might have been the drivebelt tensioner. The plastic bushing on the small bolt cracked to pieces and I simply replaced it with a stack of washers. That's the bolt at the top of the piston that screws into the valve cover. I replaced the tension but still hear that rattle. I tried to locate it with a stethoscope but no luck.

View 7 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved