Dakota :: 2000 V8 - Check Gauges Light Comes On Intermittently / Engine Dies
Apr 12, 2013
2000 Dakota, 4.7 V8 ... The 'CHECK GAUGES' light comes on intermittently. As soon as it comes on, the voltmeter gauge drops to zero (it is a brand new battery); the temperature gauge does flip flops; the truck dies right now. Walk home and come back later, and it starts up again. When you get home, you sure don't feel secure in taking it on the road again. The shop checked it and of course there was nothing wrong when they had it Where do I start the troubleshoot? Is it computer or?
View 1 Replies
Advertisement
Cold start. engine starts but wont idle, just dies. rpms drop. Restart same. Must neutral drop to get going keep rpms up until engines shifts then things are fine until next cold start. Cleaned throttle, changed air filter, dry gas, injector cleaner, no warning signal, scans clean. 180k miles.
View 6 Replies
I have a 2004 Accent GS. It is an automatic. I have had it for almost a year.
In early November, the check engine light came on when the temperature dropped drastically and it went off when it warmed up a bit about 3 days later. Since then it seems to come on randomly and stay on for a few days then go off (usually around once-twice a month). Then in late December I noticed that the car had trouble starting after I refueled it, the first two times I though it was because I had let the fuel get down too much. Now every time I fuel up it does this. But just the first time turning on the car and no other time after that.
The check engine light had not come on again for almost a month, and then about a week ago it came on again. I double checked all the fluids and the gas cap but that's about as far as my knowledge of cars goes. When the light has come on I have not really noticed any handling differences. However since I need to put the car through an inspection very soon it is now concerning me a bit more. What could be causing the check engine light to go on and off?
View 3 Replies
On empty a week ago, filled 1/2 a tank, drove home no issue. Didn't drive truck for a week. Turned it on this morning (didn't warm it up) about 10 minutes into the drive anytime you tried to accelerate, the truck would buck. If you were idling or just had your foot slightly on the pedal driving at the same speed it was fine, it only bucked when I really pushed on the pedal to accelerate. The check engine light started flashing as well.
View 3 Replies
My 2005 Dodge Dokota 4.7L V8 152,000 miles has an intermittent check engine light (CEL) code P0420 ('catalylst efficiency') that turns itself off.
1) 151,000 CEL on, code P0420, checked, cleared at dealer.
2) 151,948 CEL on, code P0420, checked, cleared at dealer (Cat Conv).
3) 152,200 CEL on, code P0420, checked, cleared at local auto parts store.
4) 152,597 CEL on. No checks.
5) 152,815 CEL turned off on its own
6) 152,849 CEL on. No checks.
7) 153,137 CEL turned off on its own.
Twice in this time CEL has came on soon after a fill up from near empty.
Engine runs fine, 18-19 mpg highway.
Have seen numerous on-line reports of other possible causes:
a) base engine problems (coolant or oil) -- coolant temp sensor
b) Air inleakage -- air systems or manifold
c) Lazy front O2 sensor
d) fuel pumps
e) timing or misfire
f) what else? - (gas cap, other...)
What to check first or categories to eliminate?
View 4 Replies
I just replaced fuel pump and tps on my 1989 Dodge Dakota 4 cyl truck. Now it idles rough and the check engine light came on. I have removed battery cable to reset computer but did no good. What could be the problem now? I have since replaced the plug wires and distrib cap and it is flashing 3 5 5 twice now?
View 10 Replies
So, last December, I was sitting at a stop light, when my engine suddenly started rattling. "Check Gauges" light on, ZERO oil Pressure..
Took car to mechanic, he removed the valve covers, and scoped out the timing chains with a camera, and found everything intack, and no chips out of the timing guides (125K miles on the engine). no sludge, nothing.
Engine runs fine (for 5 seconds at a time) no issues. Removed Intake to check the Oil Pump Drive Gear, all is well.
Removed Oil Pan Inspection Plate, All is well. ZERO plastic chips in the oil pan from timing guides, ZERO sludge, all is clean.
Back up to top of engine, pull the Oil Pump Drive Shaft using needle nose pliers from the top of the engine. BUT!!!
Only the top 8 inches of the Oil Pump Drive Shaft comes out! The bottom gear is not present! Is it still in the oil pump?
OK, so I need a new oil pump drive shaft. no Problem.. BUT: how do I get the broken oil shaft out of the engine before I put a new one in? Use a magnet? Rubber hose?
View 5 Replies
'97 dodge dakota engine starts and vehicle will move and then engine dies. Just bought it and it ran fine. Coil was replaced by previous owner four months ago. At times it will run fine but is not reliable and wife will not drive in it. Had it towed to dodge dealer and they said it needed a new coil which they installed and still have the same problem and now think it might be the ecm which is mine even if it does not cure problem. Truck has 145k miles and otherwise is in good shape. When it does run, engine is strong, automatic shifts good and all accessories work. But, it won't keep running.
View 14 Replies
Dad's 2000 F150 5.4 ltr will start intermittently, when it does fire it runs fine, but right after start up all the dash gauges "spike" to the max levels for a sec and then go back down to normal....
Put the Cen-Tec 98614 code reader on and it continues to say "Link error" and I can't communicate to the interface. P.S., I confirmed the Code reader is good by pulling a 420 O2 sensor code from my Toyota in just a few seconds....
I can hear the fuel pump kick in so I doubt that is the culprit. Because of the gauge spike at start up (every time) this problem screams grounding problem, but I don't know where to start. Could it be a faulty relay?
View 5 Replies
I have a 2005 Nissan Frontier that recently had a new transmission and radiator installed due to a defect where coolant leaks into the transmission and destroys Nissan transmissions. After I got my truck back it ran fine for about 2 days, then on the third day I started it and the gauges all started going up and down at a speed of about 72 bpm. I shut it off let sit for a few minutes started it and it did this again. I repeated that about 4 times. I let it sit for about 4 hours started it and it was fine for a very short drive (1/2 mile). After about another 2 hours of sitting I tried to start and the battery was dead, my friend jumped it and it drove fine. So it sat for a few days until I had my brother jump it so I could drive to get a new battery. Once it was jumped the moving of the gauges started again.
As I was driving, the gauges kept coming on the going off. I got it to advanced auto and they replaced the battery, it started up drove it for a matter of minutes, then the gauges died and it wouldn’t drive faster than 1 MPH, then engine would rev when I hit the gas. I got it to a parking lot shut it off tried starting it the gauges would come on but as soon as I hit the gas pedal it would rev up but instantly the gauges would shut off and the engine would rev anymore. So I was stuck, got it towed to where the transmission was put in. They couldn't fix it but had to jump it to start it, so the new battery was dead. They towed it to a Nissan dealer and the mechanics are now saying it’s just a bad battery, but this just doesn't make any sense to me.
View 4 Replies
My check engine light comes on intermittently, fuel consumption normal. I have not had any noticeable performance issues. I took it to O'Rielly's for a scan but they could not establish a connection to get a readout. Is there a special scan tool needed? The on board Lan Monitor shows EMV codes below, are they meaningful in any way?
Code Sub-code
01-DC 190-38-5
01-D5 190-52-F
01-D8 190-35-1
01-DB 190-11-F
01-DB 110-21-2
View 5 Replies
Purchased certified pre owned 2009 f150 may/2010 24,000 mile. The check engine light intermittently comes and goes. It seems that its either cold temperature or related to filling the gas tank. The first time it appeared I drove 100 mile then the truck sat over the weekend and went back off when started. The second time had serviced for the check light and the dealer diagnostic pin pointed P0304, P0305, P0300 and P0316 and replaced cyl 4&5 coils.
Prior to the replacement of the coils the truck averaged 18.2 mpg since the repair the mpg dropped to 17.6 and now at 17.2mpg. Had the truck in again and the light was on when I made the appointment but went back off when I went to the dealer. They said the reset the computer. The light twice has since went on and then back off after a couple days. The only observation is that the outside temperature on both occurrences has been below freezing and that I had filled up the tank.
View 10 Replies
Intermittently blinking check engine light in a 2003(?) Ford Escape. I received a call from my fiance, who's about 45 minutes into a two hour drive. On the interstate, her check engine light started blinking, so she pulls off the interstate to a gas station (the light was blinking for maybe five minutes before she could stop, according to her). After she was off the interstate, but before she had turned the engine off, the blinking stopped.
She called me, and I looked up and directed her to an AutoZone about a half mile from where she was. Told her to drive there, and have them to try to read any codes from the engine. She drives over, engine light stays off the entire time. They hook up the reader, and there aren't any codes. My question is, if the check engine light stops blinking, and there aren't any codes for the reader, is the car safe to drive, or will she destroy the cat if she keeps going? Also, it's raining, if that matters for any reason.
View 4 Replies
Have 1994 F150 with 5.0L engine. Check engine light, intermittent on due to overheated O2 sensor. Replace sensor, light goes off. The sensor will last longer in cold weather but will fail with same code. Is the overheating due to an electrical problem from the ECU or ambient tempreture. Would like to sell truck but don't want to hand the buyer a dozen O2 sensors.
View 3 Replies
When I had a new battery installed, the check engine light came on; initially, testing showed 2 valves performing "intermittently". Have done a full tune-up with new spark plugs & rotor, which briefly fixed it. Anything that can be done other than a full valve job?
View 7 Replies
I have a 2004 Audi A6 wagon that has an intermittently flashing check engine light. I took it to the dealership to have the codes read and they told me that they got codes for Cylinder 2 and Cylinder 5 misfires. Additionally they got a code saying the Engine Coolant Temperature Sender was electronically faulty. What is this part and what does it do? Is it essential to fix it immediately?
The dealership recommended changing the spark plugs and the air filters for the cylinder misfire issue. We are also talking about replacing the timing belt since the car has 105k miles on it. I know there are several other parts that are replaced during the timing belt replacement (like the water pump, thermostat, oil seals, etc). Is it essential to replace these items if there is no immediate need to do so?
View 5 Replies
When I turn the key all the way over, I hear only one click, and no engine sound. Playing with park or neutral positions do nothing. Battery and connections are good. I am getting a raw fuel smell out of the tail pipe after it finally starts. The check engine light intermittently comes on, by now it is mostly on.
My guesses are: fuel pump/relay problems, starter/connection problems.
View 7 Replies
I have a 98 Dodge Dakota with 5.2 V8. On the way home today all my gauges and warning lights started going on and off and then gauges stopped working all together and all the warning lights stayed on. The engine was running fine and after pulling over and checking things out, I made the last mile or so home OK. Checked fuses and battery connection and everything looked Ok. Relay or Computer?
View 4 Replies
i have a 1988 2.4L 185,000+ miles chevy s10 pu. the check gauges light has been coming on for some time. the gauge bounces up and down a lot. but settles to 20psi at driving speeds. there is no tapping or noises from the engine and has good power and oil. what should i have check
View 4 Replies
I have a 2000 Cherokee Sport and the Check Gauges Light has come on, it usually happens after during my commute and I have been on the freeway for about 10 minutes, I exit and at the first stoplight it comes on. Doesn't come on in normal around town driving, just in that situation each day. I took it in to my mechanic and twice and it still comes on, they said they replaced the oil pump. Anyway, could it be that the gauge light has to be reset? I don't see any leak after two days on the street now. I am at my wits end, before I take it to different mechanic, I'd like to see what the boards say.
View 3 Replies
So my band mates and I own a 2002 Dodge Ram Wagon (15 passenger) with ~130k miles on it. Bought it 2 years ago with 106k. We've had a slew of problems with it ranging fro brakes to radiator to electrical problems. We are often on the road for 4-6 hours straight (sometimes more) and we typically drive it above the speed limit on the freeway because we need to be somewhere. So lately while driving the check gauges light will come on suddenly and the alternator/battery gauge is maxed out, which lasts a few minutes and then returns to normal. Im wondering if this is something indicative of a potential alternator issue or merely just the van working hard and having some sort of power fluctuation momentarily. There's typically no issue in starting the engine or anything like that, and we actually had the alternator belt blow out about 6 months ago and we replaced the battery probably a year or so ago, so the whole system should be pretty new and in good shape.
View 3 Replies
