Crown Victoria :: 1999 Ford - Temp Gauge Hardly Moves (up) And Heater Blows Warm Air Only
Jan 24, 2014
Ford crown vic, 1999, 125k miles, no engine work has been done, did flush cooling system in spring of 2013 and put in a 50/50 mix of coolant and distilled water (from a jug). No problems for the summer of 2013, have been using heater with no problems until around Tuesday of this week.
Car runs fine, no leaks, coolant checks out good. BUT now.. My temperature gauge hardly moves (up) and the heater blows warm air only. If I am driving the gauge will not move, if the car sits running for awhile it will move up some and the heat will get warmer inside of the car. My guess maybe a stuck thermostat?
View 3 Replies
Advertisement
I have a 2007 PI and recently lost heat and ac. All the controls do what they are supposed to do but both heat and ac blow room temp only. Fuses and relays are all good. Is this a blend door actuator problem? This is my guess and I'm basing the next question on a yes answer. Is it possible to access the actuator by making an eightXfour hole in the top of the dash above the radio. I would prefer not to have to pull the dash out of the way since everything else works good.
View 1 Replies
It worked fine and then just stopped blowing on any speed. The #303 relay was swapped with another and made no difference. The #101 40 amp fuse checks good. The blower fuse under the dash checks good too. The actuator moves the flapper door as it should.I suppose it could be the switch, but that requires some dismantlement of the dash. When a blower relay goes bad, it will usually allow (in fact cause) the blower to go only on high If it doesn't blow at all, can that still be the cause?
View 19 Replies
I have a 2003 Ford crown Victoria with 137,000km (85,000 miles) which is in good condition overall. It runs well in the city and highway with few problems. I have noticed 1 issue with this car that is consistent. When it is snowing and below freezing it will hesitate occasionally on the highway at speeds over 45 mph. It does not put out any codes. I have sprayed the ignition wires with no change. I have not changed any ignition parts. I did over 500 miles on the highway this weekend in moderate rain with no trouble at all at temperatures around freezing. Today was snowing and below freezing with same problem on highway with occasional hesitation. In the city today with traction problems and tires spinning the ABS and Brake light came on. They were out when I drove it home.
View 3 Replies
100,000 miles new fuel pump three months ago all filters changed, new spark plugs and coils. Parked car for the evening next morning would crank no start. It would start when the fuel pump primed, now the fuel pump does not prime, I get no check engine light in the on position and no check engine light when car is cranking.
View 1 Replies
99 crown Vic windshield wipers only works on high. What could cause this?
View 4 Replies
I have a 2003 Crown Victoria. Within the last year, I changed blower fan resistor (or Blower fan control module) and repaired the Electronic Climate Control Module (the thing inside the cabin that controls A/C, heat, defrost and fan speed). Today, while I was driving, the blower fan came on high and would not stop. The weather was mild, so I did not have the A/C or heat on at the time. I tried pressing various buttons to make it stop, but it was running at high and wouldn't stop. The only way to make it stop was to turn off the engine. When I turn the engine back on, the blower fan was on high again.
What could possibly be wrong with the car? I recently changed the blower fan resistor, so that is unlikely to be the culprit. Even if it is, why wouldn't it shut off? Other people with a bad blower fan resistor say that the speed control is stuck on high, but the fan can be turned on and off.
Could it be the electronic climate control module inside the cabin? After all, it is the unit that tells the blower fan to go on. Air could be directed to defrost, vent and floor without any problem.
What do you think is making the fan stay on at HIGH and does not turn off?
View 16 Replies
My husband and I bought a 1995 Ford Crown Victoria not too long ago. We have already had to replace the brake lines 2 times (well, first the front and then a few weeks later the back). It has had nothing but problems. One thing is the air conditioner, but that probably just needs charged.
Now on to the bigger problems. All of a sudden we started having unintended acceleration. It is strong enough that if you don't have the brake pressed hard it will move your car forward every 5 seconds. The engine revs up on its own. This happens every time we stop anywhere. Including when I was pulling into a parking spot last night. I went very slow and as I was turning pressing on the brake it revved up and I thought for sure the way it jerked, it was going to go over the curb into the road. This scares the crap out of me.
Also, we have a problem with the slow (very slow) start. I know they had a recall on the cruise control, but I have not heard of any recalls on this. However, I did read somewhere about accidents happening due to this and something about it had to do with the way Ford build the car.
View 1 Replies
I have a 94 Ford Ranger, 2WD, 5-Speed, with 2.3 engine. My temp gauge hardly moves at all... It actually appears as if it doesn't move it you don't pay close attention and were to just glance at it. I'm thinking it is most likely the temp sensor that is on the engine block as I understand there is also one that is in the line that controls the fans for the radiator. Am I approaching this in the right direction or is there something else I might need to do?
View 3 Replies
I was driving home and i turned off my car as soon as i put it in park. Came back down two minutes later and it wont turn over or try to start. It makes a weird low clicking sound once the keys are taken out of the ignition.
View 1 Replies
I have a 1998 Crown Vic Lx with 66,000 miles on it. We bought the car about 2 years ago and at that time it had only 32,000 original miles and looked like it had just rolled off the showroom floor. The car was well maintained and we have kept it that way. Over the last few months we have started to have a problem with the engine surging at idle when the Heating/air controls are in use. It's like the engine tries to die and then comes back up and it happens about every 5 seconds. It stops when the control is cut off. The fan speed control has no effect,just the main control.
View 2 Replies
I have a 96' Interceptor. Recently, it feels like the back tires are sticking/skipping when I take off. I haven't noticed it doing that when I have it in reverse though. Sometimes it's hardly noticeable and other times it's fairly violent. I think it gets worse the more stops I make but I've parked it for now so there is no way to test that theory.
View 2 Replies
When I was a mechanic in the 1980's it was easy to disable a car's ignition to do starter crank or compression tests, just pull the distributor lead wire in the center of the dist. cap.
I have a 2000 vintage 4.6 engine and was wondering the easy way to knock out the ignition to do crank tests, etc. This engine has all the modules resting independently on each spark plug, so no central distributor cap to get to. Is there an easy way, and does it work for Chrysler and GM cars too?
View 3 Replies
I have 95 Crown Victoria and every time it rains water leaks into the back seat so I checked the condencer drain and it was not clogged ...
View 2 Replies
I've noticed that my X in the winter does not seem to warm up as it should. I watch the temperature gauge and notice that it barely gets to the first mark in the operating zone of the gauge. The heater blows warm air but not hot. I think its the thermostat that needs replaced because in other vehicles I would see the temp gauge rise and then drop when the thermostat opened. I've flushed the radiator and changed the fluid and not difference. I did find the heater valve on the right side was unhooked from the vacuum line and plugged it back in but no change from that being connected. Anything else I should check?
View 5 Replies
I own a 1997 ford f150 V6 engine and I have problems with the electrics. I turn the key on and the engine starts up runs great but I then look at the gauges and not one moves at all the. No fuel when i have just filled up,no tep,no oil,no battery all read nil. I went a drive and the speedo reads 0 it does not move but the truck drives great. Could it be a fuse, does a fuse control the gauges, which one it could be. I have lifted the hood and under the hood on the drivers side there is a box with small and larger fuses.There is one that is very small and the colour is white that's blown. Would you no what that fuse is for.
View 1 Replies
I have just purchased a 2009 Ford Crown Vic Interceptor a few weeks ago. One of the few things I would like to fix is the rear doors. I want to have people in the back have the ability to roll down their own windows and open their own doors. I have plugged the wires, that were in the armrest back into the button but still doesn't work. I am assuming the fuse might also be missing from the fuse box but I have not looked yet and when looking through the owners manual I could figure out which fuse it would have been or its place.
The other issue with the doors is people getting out on their own rather than me feeling like their limo driver or something... Iss there a kit I can buy to get the doors in full working order? If I take it into a ford dealership will/can they fix it?
View 7 Replies
I have a 1997 ford f 150 lariat with the 4.6 v8 and my engine had a piston slap so I replaced the engine with a used one and I put a new water pump on the engine. My problem is the heater does not get hot and it only gets warm when I get on the freeway and the rpms stay steady for a bit. but when i idle it just blows cool air. the heat door works cause I can turn it to cold air when I'm on the freeway and i just replaced the thermostat so I don't believe its that. It weird because the heater worked fine before I changed out the engine so i cant figure it out. the only thing i can think of is the water pump is bad out of the box. Could it be the belt or does spacing on the water pump have something to do with it. nothing is leaking.
View 7 Replies
I rebuilt the engine on my toyota celica. After putting everything back together there are a few bizarre symptoms I am hoping to get sorted out.
1) It only starts with starting fluid, but once it starts it will run continuously without dying.
2) The temperature gauge goes up relatively quickly, and also moves with the throttle. For example if it is as the 1/3 level and I apply throttle it will bump up. It continues to jump along with throttle play.
3) When I remove the coolant sender and/or sensor plugs, the gauge still reads the same (is this normal).
4) The fans don't turn on unless I remove the sender cable (the one with one wire and not two)
If I understand correctly the sensor with one wire is the sender and the sensor with two wires is the temp sensor. I am having a hell of a time determining the difference. The one with a single wire contact is plugged into the thermostate cover/pipe. The one with two wires is in the thermostat housing.
Did I fry the ECU somehow? What is going on?
View 14 Replies
So the other morning I drive the 140 miles out of town to work for the week. when I pull up to the job site the cooling fans were revving really really high! never heard this before. then it went back to normal after I opened the gate and parked my truck and shut it off. I'm driving maybe 5 miles tops to the job and back to the motel every day. however that is far enough that my heater should be warming up and it's not even coming close to warm. it blows cold air. and to compound that I'm not sure the cooling fans are even working. they don't appear to be. Is there a connection here?
2011 xlt 4x4 super crew.....
View 12 Replies
I have a 2007 Dodge Charger. The heat blows out warm air. I have replaced the water pump and thermostat. When accelerating the vehicle, the heat turns to hot. Is this normal, perhaps a speical feature? I have 66,000 miles.
View 9 Replies
