I was driving home and i turned off my car as soon as i put it in park. Came back down two minutes later and it wont turn over or try to start. It makes a weird low clicking sound once the keys are taken out of the ignition.
View 1 RepliesWhen I was a mechanic in the 1980's it was easy to disable a car's ignition to do starter crank or compression tests, just pull the distributor lead wire in the center of the dist. cap.
I have a 2000 vintage 4.6 engine and was wondering the easy way to knock out the ignition to do crank tests, etc. This engine has all the modules resting independently on each spark plug, so no central distributor cap to get to. Is there an easy way, and does it work for Chrysler and GM cars too?
100,000 miles new fuel pump three months ago all filters changed, new spark plugs and coils. Parked car for the evening next morning would crank no start. It would start when the fuel pump primed, now the fuel pump does not prime, I get no check engine light in the on position and no check engine light when car is cranking.
View 1 RepliesI have a 1998 Crown Vic Lx with 66,000 miles on it. We bought the car about 2 years ago and at that time it had only 32,000 original miles and looked like it had just rolled off the showroom floor. The car was well maintained and we have kept it that way. Over the last few months we have started to have a problem with the engine surging at idle when the Heating/air controls are in use. It's like the engine tries to die and then comes back up and it happens about every 5 seconds. It stops when the control is cut off. The fan speed control has no effect,just the main control.
View 2 Replies99 crown Vic windshield wipers only works on high. What could cause this?
View 4 RepliesI have a 96' Interceptor. Recently, it feels like the back tires are sticking/skipping when I take off. I haven't noticed it doing that when I have it in reverse though. Sometimes it's hardly noticeable and other times it's fairly violent. I think it gets worse the more stops I make but I've parked it for now so there is no way to test that theory.
View 2 RepliesI have a 2003 Crown Victoria. Within the last year, I changed blower fan resistor (or Blower fan control module) and repaired the Electronic Climate Control Module (the thing inside the cabin that controls A/C, heat, defrost and fan speed). Today, while I was driving, the blower fan came on high and would not stop. The weather was mild, so I did not have the A/C or heat on at the time. I tried pressing various buttons to make it stop, but it was running at high and wouldn't stop. The only way to make it stop was to turn off the engine. When I turn the engine back on, the blower fan was on high again.
What could possibly be wrong with the car? I recently changed the blower fan resistor, so that is unlikely to be the culprit. Even if it is, why wouldn't it shut off? Other people with a bad blower fan resistor say that the speed control is stuck on high, but the fan can be turned on and off.
Could it be the electronic climate control module inside the cabin? After all, it is the unit that tells the blower fan to go on. Air could be directed to defrost, vent and floor without any problem.
What do you think is making the fan stay on at HIGH and does not turn off?
It worked fine and then just stopped blowing on any speed. The #303 relay was swapped with another and made no difference. The #101 40 amp fuse checks good. The blower fuse under the dash checks good too. The actuator moves the flapper door as it should.I suppose it could be the switch, but that requires some dismantlement of the dash. When a blower relay goes bad, it will usually allow (in fact cause) the blower to go only on high If it doesn't blow at all, can that still be the cause?
View 19 RepliesI have a 2007 PI and recently lost heat and ac. All the controls do what they are supposed to do but both heat and ac blow room temp only. Fuses and relays are all good. Is this a blend door actuator problem? This is my guess and I'm basing the next question on a yes answer. Is it possible to access the actuator by making an eightXfour hole in the top of the dash above the radio. I would prefer not to have to pull the dash out of the way since everything else works good.
View 1 RepliesI have 95 Crown Victoria and every time it rains water leaks into the back seat so I checked the condencer drain and it was not clogged ...
View 2 RepliesMy husband and I bought a 1995 Ford Crown Victoria not too long ago. We have already had to replace the brake lines 2 times (well, first the front and then a few weeks later the back). It has had nothing but problems. One thing is the air conditioner, but that probably just needs charged.
Now on to the bigger problems. All of a sudden we started having unintended acceleration. It is strong enough that if you don't have the brake pressed hard it will move your car forward every 5 seconds. The engine revs up on its own. This happens every time we stop anywhere. Including when I was pulling into a parking spot last night. I went very slow and as I was turning pressing on the brake it revved up and I thought for sure the way it jerked, it was going to go over the curb into the road. This scares the crap out of me.
Also, we have a problem with the slow (very slow) start. I know they had a recall on the cruise control, but I have not heard of any recalls on this. However, I did read somewhere about accidents happening due to this and something about it had to do with the way Ford build the car.
I have just purchased a 2009 Ford Crown Vic Interceptor a few weeks ago. One of the few things I would like to fix is the rear doors. I want to have people in the back have the ability to roll down their own windows and open their own doors. I have plugged the wires, that were in the armrest back into the button but still doesn't work. I am assuming the fuse might also be missing from the fuse box but I have not looked yet and when looking through the owners manual I could figure out which fuse it would have been or its place.
The other issue with the doors is people getting out on their own rather than me feeling like their limo driver or something... Iss there a kit I can buy to get the doors in full working order? If I take it into a ford dealership will/can they fix it?
I have a 2003 Ford crown Victoria with 137,000km (85,000 miles) which is in good condition overall. It runs well in the city and highway with few problems. I have noticed 1 issue with this car that is consistent. When it is snowing and below freezing it will hesitate occasionally on the highway at speeds over 45 mph. It does not put out any codes. I have sprayed the ignition wires with no change. I have not changed any ignition parts. I did over 500 miles on the highway this weekend in moderate rain with no trouble at all at temperatures around freezing. Today was snowing and below freezing with same problem on highway with occasional hesitation. In the city today with traction problems and tires spinning the ABS and Brake light came on. They were out when I drove it home.
View 3 RepliesFord crown vic, 1999, 125k miles, no engine work has been done, did flush cooling system in spring of 2013 and put in a 50/50 mix of coolant and distilled water (from a jug). No problems for the summer of 2013, have been using heater with no problems until around Tuesday of this week.
Car runs fine, no leaks, coolant checks out good. BUT now.. My temperature gauge hardly moves (up) and the heater blows warm air only. If I am driving the gauge will not move, if the car sits running for awhile it will move up some and the heat will get warmer inside of the car. My guess maybe a stuck thermostat?
I drive a 2006 Acura MDX with about 30000 miles on it. Today when I put the key in my ignition and attempted to start it I hear a clicking sound and the car wont start. The first time I attempted to turn on my headlights they did turn on. But then when I tried a few seconds later they would not. And I am seeing lights flickering on my dashboard as well. Do I have a dead battery or possibly something worse?
View 4 RepliesI have a 2002 Passat GLS and when I tried to start my car this morning, it would not start. When I turn on the ignition, the car gives off a loud clicking sound. The interior and exterior light works, the panel light works, and the radio works as well. What might be the problem?
View 4 RepliesI went to get into my car this morning & my key fob didn't work. I Manually entered the car by using my key in the door (expecting the alarm to go off). I put the keys into the ignition & twist to start my car &.... NOTHING. I'm getting no display on my monitors (almost like there is no power to the car) & to make matters worse. I can't get the key out of the ignition. A couple things of note.
1. I had both batteries replaced in December (as a precaution since both were originals)
2. I've noticed that there may be a water seepage issue (noticed some water collected in the driver side floor of my car which may have gone unnoticed because I'd attributed it to water from my feet when it was raining) I've never seen any water accumulation on the floor during a dry day until this morning.
How I can get the key out of the ignition w/o power (i.e is there a manual release switch?) Is there a way to get the car into neutral w/o power etc.? The last time w/ the steering wheel issue. I had a devil of a time w/ the tow company because the wheels were locked etc.
I drive a 99 s/w 2 and this mourning when I arrived at work I got out of the vehicle and the bell that chimes when you leave the headlights on or the key in the ignition the warning chime would not turn off even though the keys were out of the ignition and the headlights were off, however it stops chiming when you shut the door.
View 2 RepliesKeys get stuck in ignition lose all power have replaced ignition and shifter?
View 1 RepliesI have a 2006 Dodge Stratus and recently lost my transponder key for my ignition. I do have a spare key cut but it doesn't have a chip in it, I can only use it to unlock the doors and open the trunk.
What I want to know... is there:
➣ A way to disable/bypass the theft prevention system so I can use the non-chipped key in my ignition?
➣ a way I can modify my key to trick the theft prevention system into thinking it is a real key?
So I bought a 2005 Honda Pilot which came with 2 keys. The main key has a remote battery (which is dead) and a spare key. Because the battery is dead, we must manually unlock the car door each time we get in. A month ago or so I noticed that the main key was having trouble going in the driver's side door. It would go about half way in and jam. I would try 5-10 times and then eventually it'd go in and turn fine. Sometimes I'd go to the passenger door where it would open with no problem.
We started having the same problem with the key in the ignition, where it would take several times to get the key in the ignition, once in, it would turn fine. At this point, we switched to the passenger key, as we are really tight in the money dept (aren't we all?), and didn't want to pay much money for a slight inconvenience.
Unfortunately we're not having the same trouble with the spare key in the ignition. 5-10 times before it will go in, once in, it starts fine. The main key is still tough on the driver door. The only thing I can think of is it's the keys and the ignition, as it doesn't make sense that it's limited to one or the other since we have problems with both keys..