Crown Victoria :: 1995 Ford - Unintended Acceleration And Slow Start
Aug 3, 2013
My husband and I bought a 1995 Ford Crown Victoria not too long ago. We have already had to replace the brake lines 2 times (well, first the front and then a few weeks later the back). It has had nothing but problems. One thing is the air conditioner, but that probably just needs charged.
Now on to the bigger problems. All of a sudden we started having unintended acceleration. It is strong enough that if you don't have the brake pressed hard it will move your car forward every 5 seconds. The engine revs up on its own. This happens every time we stop anywhere. Including when I was pulling into a parking spot last night. I went very slow and as I was turning pressing on the brake it revved up and I thought for sure the way it jerked, it was going to go over the curb into the road. This scares the crap out of me.
Also, we have a problem with the slow (very slow) start. I know they had a recall on the cruise control, but I have not heard of any recalls on this. However, I did read somewhere about accidents happening due to this and something about it had to do with the way Ford build the car.
View 1 Replies
Advertisement
100,000 miles new fuel pump three months ago all filters changed, new spark plugs and coils. Parked car for the evening next morning would crank no start. It would start when the fuel pump primed, now the fuel pump does not prime, I get no check engine light in the on position and no check engine light when car is cranking.
View 1 Replies
I took my 2011 Lariat in for first service and reported that it sometimes tries to accelerate on its own during slowdown from high speed, eg when coming off a freeway ramp, rpms go up and vehicle wants to speed up rather than slow down. (sounds like something a Toyota would do!)
Dealer says its a known problem with 5.0L and performed a supposed fix per "TSB 11-8-9, 5.0L ENGINE BRAKING PERFORMANCE DURING LOW SPEED COAST DOWN," essentially a PCM reflash.
Happened once in a parking lot...thought the floormat was stuck on the accelerator but the pedal was clear.
View 4 Replies
I have a 2003 Crown Victoria. Within the last year, I changed blower fan resistor (or Blower fan control module) and repaired the Electronic Climate Control Module (the thing inside the cabin that controls A/C, heat, defrost and fan speed). Today, while I was driving, the blower fan came on high and would not stop. The weather was mild, so I did not have the A/C or heat on at the time. I tried pressing various buttons to make it stop, but it was running at high and wouldn't stop. The only way to make it stop was to turn off the engine. When I turn the engine back on, the blower fan was on high again.
What could possibly be wrong with the car? I recently changed the blower fan resistor, so that is unlikely to be the culprit. Even if it is, why wouldn't it shut off? Other people with a bad blower fan resistor say that the speed control is stuck on high, but the fan can be turned on and off.
Could it be the electronic climate control module inside the cabin? After all, it is the unit that tells the blower fan to go on. Air could be directed to defrost, vent and floor without any problem.
What do you think is making the fan stay on at HIGH and does not turn off?
View 16 Replies
It worked fine and then just stopped blowing on any speed. The #303 relay was swapped with another and made no difference. The #101 40 amp fuse checks good. The blower fuse under the dash checks good too. The actuator moves the flapper door as it should.I suppose it could be the switch, but that requires some dismantlement of the dash. When a blower relay goes bad, it will usually allow (in fact cause) the blower to go only on high If it doesn't blow at all, can that still be the cause?
View 19 Replies
I have a 2007 PI and recently lost heat and ac. All the controls do what they are supposed to do but both heat and ac blow room temp only. Fuses and relays are all good. Is this a blend door actuator problem? This is my guess and I'm basing the next question on a yes answer. Is it possible to access the actuator by making an eightXfour hole in the top of the dash above the radio. I would prefer not to have to pull the dash out of the way since everything else works good.
View 1 Replies
Ford crown vic, 1999, 125k miles, no engine work has been done, did flush cooling system in spring of 2013 and put in a 50/50 mix of coolant and distilled water (from a jug). No problems for the summer of 2013, have been using heater with no problems until around Tuesday of this week.
Car runs fine, no leaks, coolant checks out good. BUT now.. My temperature gauge hardly moves (up) and the heater blows warm air only. If I am driving the gauge will not move, if the car sits running for awhile it will move up some and the heat will get warmer inside of the car. My guess maybe a stuck thermostat?
View 3 Replies
I was driving home and i turned off my car as soon as i put it in park. Came back down two minutes later and it wont turn over or try to start. It makes a weird low clicking sound once the keys are taken out of the ignition.
View 1 Replies
I have a 1998 Crown Vic Lx with 66,000 miles on it. We bought the car about 2 years ago and at that time it had only 32,000 original miles and looked like it had just rolled off the showroom floor. The car was well maintained and we have kept it that way. Over the last few months we have started to have a problem with the engine surging at idle when the Heating/air controls are in use. It's like the engine tries to die and then comes back up and it happens about every 5 seconds. It stops when the control is cut off. The fan speed control has no effect,just the main control.
View 2 Replies
99 crown Vic windshield wipers only works on high. What could cause this?
View 4 Replies
I have a 96' Interceptor. Recently, it feels like the back tires are sticking/skipping when I take off. I haven't noticed it doing that when I have it in reverse though. Sometimes it's hardly noticeable and other times it's fairly violent. I think it gets worse the more stops I make but I've parked it for now so there is no way to test that theory.
View 2 Replies
When I was a mechanic in the 1980's it was easy to disable a car's ignition to do starter crank or compression tests, just pull the distributor lead wire in the center of the dist. cap.
I have a 2000 vintage 4.6 engine and was wondering the easy way to knock out the ignition to do crank tests, etc. This engine has all the modules resting independently on each spark plug, so no central distributor cap to get to. Is there an easy way, and does it work for Chrysler and GM cars too?
View 3 Replies
I have 95 Crown Victoria and every time it rains water leaks into the back seat so I checked the condencer drain and it was not clogged ...
View 2 Replies
I have just purchased a 2009 Ford Crown Vic Interceptor a few weeks ago. One of the few things I would like to fix is the rear doors. I want to have people in the back have the ability to roll down their own windows and open their own doors. I have plugged the wires, that were in the armrest back into the button but still doesn't work. I am assuming the fuse might also be missing from the fuse box but I have not looked yet and when looking through the owners manual I could figure out which fuse it would have been or its place.
The other issue with the doors is people getting out on their own rather than me feeling like their limo driver or something... Iss there a kit I can buy to get the doors in full working order? If I take it into a ford dealership will/can they fix it?
View 7 Replies
I have a 2003 Ford crown Victoria with 137,000km (85,000 miles) which is in good condition overall. It runs well in the city and highway with few problems. I have noticed 1 issue with this car that is consistent. When it is snowing and below freezing it will hesitate occasionally on the highway at speeds over 45 mph. It does not put out any codes. I have sprayed the ignition wires with no change. I have not changed any ignition parts. I did over 500 miles on the highway this weekend in moderate rain with no trouble at all at temperatures around freezing. Today was snowing and below freezing with same problem on highway with occasional hesitation. In the city today with traction problems and tires spinning the ABS and Brake light came on. They were out when I drove it home.
View 3 Replies
The owner of the car claims that there was sudden unintended acceleration, and it was 09' Sonata.
Video .....
I thought this should be very concerned to us, since we all drive 11' sonata & up. I heard Hyundai installs some kinds of system to prevent this incident to all cars manufactured after May of 2012.
View 37 Replies
I've read quite a few instances in this forum of unintended acceleration in the Toyota Sienna. Well it happened to me this morning. I was pulling into my parking spot at work with my foot lightly on the brake, going about 5 or 10 mph when the vehicle suddenly accelerated as if someone had floored the accelerator. The vehicle went up over the curb and into the side of the building. When I told the policeman what had happened, he said that isn't possible. I told him it was possible because it just happened to me. I had it towed to the dealership, called my insurance company and Toyota to make a report of the incident. They will be sending someone out to check out the car, but I'm sure they won't say there is anything wrong with it. I'm sure it won't be impartial since they don't want to be held liable. I also made a complaint with the NHTSA. I am afraid to drive the car and will never buy a Toyota again.
View 2 Replies
My 2005 4.2L w/ 139,000mi , giving the above warning. Thinking it was a gremlin, I raised the vehicle height and all seemed well until I got onto the 101 fwy here in SoCal and hit the threshold speed to lower the height.
That's when the engine rev'd to 7k RPM's. Initially it quieted in neutral and I drifted to the shoulder with one shift back into D and 7k RPMs for a bit of power. After that, any start and it revs immediately to 7K upon start.
Flat bedded to Santa Monica VW and await Ivan, their Phaeton mechanic to return tomorrow. Service writer Jeff wondered about front suspension but connection to acceleration is a mystery.
View 21 Replies
My 2013 goes 7mph with the foot off the gas. Why is it doing this and is there any way to correct this?
Is this normal? I have to keep my foot jammed on the brake to stop the car from lurching forward.
View 19 Replies
I have a scary problem with my 2005 Civic Coupe HX CVT that the dealer can't resolve - my car drives forward and even accelerates when my foot's not on the gas! This is a recipe for disaster, especially since I live in a cold climate and there's so much ice and snow in winter.
I thought at first I must be crazy. So I've tested it by taking my foot off the gas going up a small incline, and Voila! It drives up the hill! It also can drive around the block by itself! It's like the energizer bunny, and I'm scared to drive it anymore.
The dealer has no clue why this is happening and can't seem to replicate the problem. I've brought it in more than once, too.
It happens most often when my car's been parked for awhile, say 6 hours or more, and if it's really cold outside, say less than 32 degrees outside. Also the heater's usually on when it happens, but that may be incidental since it's usually cold when the problem occurs...
Also, There's a whine that sounds like a belt that gets loud when the air conditioner runs and also if it's really rainy. I've taken it in to the dealer a couple different times and they fix it, but then the sound comes back again. Could this be related?
View 4 Replies
I have 2001 F250 7.3L 261k miles.
Over the last few months, I have noticed that my truck is taking longer & longer to start after sitting for a long time (i.e. every morning, after work, etc.) When the problem first started (3-4 months ago) it would crank for 2 seconds & nothing so I would turn it off, let the "wait to start" light go off again (depending on outside temp 10-20 seconds) & then it would crank & usually fire right over like it was new. That seemed to happen only in the morning when it was 70 degrees or colder outside but no problem after work when it was 80+ degrees.
As the weather has gotten colder, it has gotten progressively worse. A couple of weeks ago, it was in the 40s in the morning & it took a solid 8 or 9 minutes of cranking for a few seconds, then trying again before it started. Once it started it did "chuga chug" a couple of times before it smoothed out. Last week when it was 16 degrees in the morning, it wouldn't start at all. I tried for a solid 15 minutes before I gave up.
I will say that as it has gotten worse over the last couple of months, I have noticed that it's cranking w/o firing but I will hear it fire once or twice per crank before it will fire up & run. Once it starts, it runs like a champ. No studders, stalls, slow acceleration, etc. Pulls like it always has. The weirdest part about it is that once it starts & runs for 30-60 seconds, I can shut it off & it'll fire right up every time. If I get it up to full operating temperature, I can go back & start it right up 2 or 3 hours later w/o a problem.
I did notice my oil cooler is leaking pretty badly (that will be fixed this weekend) & my valley has fluid in it but it's hard to tell if it's diesel, oil or a combination of the two because my truck is setup to run on WMO (waste motor oil). I have dual tanks so the OEM tank is diesel & the auxillary tank is WMO. I have 2 mechanical fuel pressure gauges on my fuel bowl, 1 pre & 1 post fuel filter as well as an aftermarket Walbro fuel pump. The fuel pressure when running on WMO has always bounced a little bit between (65-75 psi) but the fuel pressure on diesel has always held solid at 75 psi until recently when I have noticed that it flutters a very small amount between 73-75 psi.
I have verified that the GP Relay works & was leaning towards a glow plug problem but considering it was having troubles at 70 degrees ambient temperature, I'm hesitant to think that's the true problem. I think that might just be adding to the problem. I live in the south so my truck doesn't have a block heater but I'm going to add one this weekend when I replace the oil cooler gaskets & o-rings.
I'm also going to pick up a new Android tablet today (replace my broken one) so I can use the Torque Pro app to monitor ICP, HPOP & InjPW. Finally, I had a DP Tuner chip on it & to remove that as the possible cause, I removed it & the same symptoms continued.
View 14 Replies
