I just recently had a new pressure hose (had a leak) replaced on the power steering pump but there is a slight squeaking noise when I turn the wheel. the mechanic says it'll go away after a week or so because of the new fluid that was put in? Is this correct?
View 4 RepliesI have an 07 Camry with a hard to turn steering wheel. I had to replace the high pressure hose from the rack due to a leak. After that I basically bled the system as one would do under normal circumstances. With the cars front wheels off the ground I turned the wheel hard left and right. The wheel did give a bit but not to the point of perfection. After many turns I put the vehicle on the ground and repeated the process. The fluid no longer leaked but the stiffness was still there.
The hose was replaced at 110,000 miles. It's currently at 112,000 miles
I started to notice a slight whine when I turn the wheel. My fluid is at low but it's pretty dark and I'm not sure if it was ever changed or when. I have 100k miles. What fluid should I use?
View 10 RepliesI just got a 2013 Corolla Saturday (manual transmission). So far, I love the car, but I think I'm having a problem with the steering column. When I turn the steering wheel in a parked position, I can hear an audible "rubbing" noise coming from the column. I called the dealership, and spoke not only to the service department, but also to my salesman, who has one too. He says he's never heard that, and the service department assures me it's normal and is because it's an electric motor now instead of a fluid power steering system.
So, do I have reason to be concerned? Experienced this after only 300 or so miles on a new car? We traded a Scion IQ for this Corolla (didn't like the CVT whine in the IQ), and never heard anything like this.
2000 Corolla - "growling" noise on the passenger side of the engine / stops when I turn the steering wheel - no loss of PS fluid (I also flushed the system) - which bearing(s) might be bad...?
View 2 RepliesJust replaced power steering pressure hose while engine out as PM. New hose wasn't correct shape so I bent the tubing to fit. I later realized that I bought a hose for power steering without variable assist and the hose for variable assist looks correct.
Is there any harm in leaving the "w/o variable assist" hose in now?
The Power Steering Reservoir has a small leak that makes the area under it looks oily and messy, so i followed a member's DIY PS flush, I used Walmart Supertech ATF Dexll/lll fluid but now I am thinking about using Mobil1 Synthetic ATF once I get the reservoir out.
The new red color shoes the leak is coming from the edge of the connection between the top and bottom plastic parts of the reservoir.
so my questions are:
1- How do i remove/pry or pop the reservoir out of its bracket?
2- Can i use JB Weld epoxy to glue/reinforce them parts together or just pick a used one from junkyard?
and last question: What size ID/OD is the PS fluid low pressure hose?
I have a 1989 Honda Accord DX with less than 120k miles. I have two problems.
1) the low pressure hose for the power steering has worn out and is leaking by the fittings (badly) and I can't find the parts to fix it. The high pressure hose was also leaking but we found and replaced that part, and
2) I accidentally topped off the power steering reservoir with brake fluid (this was after I already knew the leaks existed).
So, I have a 1995 Jeep Grand Cherokee (Orvis edition) with about 270,000 miles. It still runs great and has been really useful in the snow this winter. A couple days ago the power steering pressure hose blew. My mechanic wants to replace it, but I can get a replacement hose locally. Is there any reason I shouldn't just do this myself. Do I need to worry about the fluid sprayed around the engine? The serpentine belt is only a few months old and squeaked only a little on the three mile drive to get it home.
View 8 RepliesMy high pressure power steering hose just blew at the "B" nut at the pump. Meaning, the fitting is still in the pump but the line is out. Do I need to replace the whole line or is there a retainer I can swap out?
View 14 RepliesHow to remove the "high pressure" power steering hose. I have drained the fluid, disconnected from the pump, and also from the rack. Removed the center clamp, and got it all "loose". However, I cannot seem to figure out how to "fish" the hose out. There is a long piece of metal tubing that connects into the rack, and it seems to be resting above some cross member that is not removable. Went to the library, and searched the AllData Online manuals. On the "How to replace the High Pressure Hose" page, it only showed a diagram of the power steering system, with no written description on how to remove the hose. I am not on a lift, but jacked up and supported and on my back under the car with the right wheel removed. I am stumped, and the new hose is due to arrive soon.
View 2 RepliesJust had dealer repair shop complete power steering fluid flush in Jan 2013. Vehicle now has lost all power steering fluid (April 2013) and dealer repair shop has told me it is due to high pressure hose failure - need to replace & then verify pump condition (dealer repair shop not sure if pump bad until hose replaced to test) for repair bill.. I was told this was not related to repair shop power steering flush because this hose not removed for flush or part of that procedure (at which time a transmission flush & spark plugs replaced (minor tune-up) . Just wondering if any pro mechanic can respond with advice about the relative close time frame these two events & if there may be a probable related reason?
View 4 RepliesI have a really small leak coming from the lower end of my power steering hose, it's super small, I was wondering if I could fix this by wiping it down really well and dry, and then layering it with plasti-dip. I think the leak is small/slow enough for me to get in a few good layers. Would this be an okay fix, or would the plasti-dip separate fast?
View 2 Replies2001 F150 Supercrew 5.4L ... Dealership unable to locate replacement pressure hose for power steering . I've returned 3 wrong parts. The hose in pic goes all the way up to the reservoir.
View 13 RepliesI have a 2004 with the 4.6l. The high pressure hose is leaking from rust. From other posts I have read, it looks like I should rent a puller and remove the pulley first, and then I'll have access to where the hose connects to the pump.
Question: The leak occurred while driving home from vacation today. Went we stopped for gas, we noticed a shutter in the steering. I added about a 1/2 quart to the reservoir - there was still some fluid but foamy. I made it home, and I when I checked again the reservoir was empty.
Should I go ahead and replace the pump while I am at it? I wondering it if could have gotten damaged from low fluid. The truck has 190k so it's not like the pump owes me anything. Will it make any of the repair easier to toss out the pump too?
For those with a sunroof do you have the same issue as me?
On the passenger side when I apply slight pressure to the headliner, I get the following noise. In person it sounds like plastic tubes knocking around. The driver's side does not do this.
I've got about 27k on my GTI, and have just noticed some faint, but odd steering / power assist issues.
Relevant mods - koni coils. Have had these for about 15k, recently raised for winter travel, then lowered back to 24.25 ftg. Conti DWS with about 3k on them.
Anyway, other day (while in brief winter height) at parking lot speed, slight turn, I noticed a very faint pulsing through steering wheel. Was not there minutes later.
Lowered car back, drove for a few days, nothing unusual.
Drove from SF > LA yesterday and had an odd feeling at speed on freeway. It was like a bit of resistance turning the wheel off center. Almost like there is a center detent, which i have never noticed before. Once off center, all feels normal. It was super windy out and thought that was causing this, but continued throughout drive.
I don't think that this is the tires, it's more mechanical than that.
I own a 2009 Scion tC, has about 70k miles on the car. I am experiencing a squeaky noise when turning the steering wheel left or right, as well as accelerate and braking. A friend and I jacked up the car, listen to the noise while the engine was running. We were able to duplicate the noise and it seems like its coming from the tie rod area, inner tie rod that is connected to the rack and pinion. Do it needs to be greased? keep in mind that for my car, i will have to replace the whole tie rod, can't grease it because it doesn't have a Zerk fitting. Also, when i push down on the passenger side fender, the squeaky noise reappear. noise is coming from passenger side. This has been going on for about 2 months now.
View 2 RepliesI have a 98 passat sedan... I notice whenever I turn the wheel left I get a squeaking noise, like plastic against plastic. I saw somewhere else someone mentioned the power steering fluid, but I checked that and it was fine.
View 1 RepliesI had the front right wheel bearing replaced on my Toyota Corolla (60,000 miles) replaced a couple days ago. One day after the repair, I heard a high pitched clicking noise which was noticeable around 20-30 mph. Yesterday, I still noticed the high-pitched sound but also a grinding/popping sound in front left side when coming to a stop upon every rotation of the tire. Took the car back to the shop to let them listen to the noise, but really weren't very compliant since it doesn't sound like a wheel bearing problem.
Here is YouTube link to noise car is making : [URL] .....
I recently bought a 2014 Santa Fe Sport 2.0T about a 3 months ago, and have since noticed a couple issues that have come up with it. First was with a squeaking front suspension, but that was fixed by simply lubricating the sway bar bushings.
The second is that the steering wheel seems louder than normal when turning left/right at low speeds, mainly when parking, it sounds like two pieces of paper rubbing against each other right behind the steering wheel like a dry noise.
I test drove another Santa Fe before getting mine for about a week and didn't notice this issue. Is this a normal sound that eventually develops after having the Santa Fe for a while? I'm like at 3,600 miles.