Corolla / Matrix 2009-13 :: XLE - Engine Rattles At 2000rpm During Light Acceleration
Oct 14, 2008
Just bought a XLE (currently have had the car for 2 weeks and a total of 275miles) and am experiencing a very strange rattle coming from the engine compartment when accelerating very lightly and engine being fully warm (being ran for atleast 15min). The rattle is coming during 2000-2300rpm. Below and above that range, the problem does not occur. The rattling noise sounds as if some metal is grinding on one another. I understand that the Dual VVT-i is notoriously known for it's noise (ticking/tapping of valves, naturally being a 4cyl, and a small amount of "roar" when applying large amount of throttle) but I think this problem I am exhibiting is by far, not normal.
Symptoms/Conditions:
1. Car must be hot/warm (must be driven for atleast 15 minutes)
2. Must be in a drive or reverse direction. Problem does not occur in park or neutral.
3. You have to be acclerating lightly, the engine rattle occurs from 2000rpm - 2300rpm. It's not a tapping or ticking sound but rather a "buzzing" metal to metal grinding.
4. Sounds like the sound is coming from the intake or exhaust systems and the rpm's is causing a natural vibration frequency that is causing a metal part to vibrate (or resonate). Could explain
5. The car doesn't seem to be power limited or anything abnormal. Drives just fine - just a rattling sound that I hate to believe is normal!
I'm under assumption that this is an engineering design flaw! I would encourage you as Toyota Corolla 2009 owners (1.8L, 4spd autos, manuals) to see if you can replicate this issue. Warm your car up, turn off heat/ac & radio (so you can clearly hear the engine), put it in drive, slowly excelerate, and listen as your rpm's increase (noise will only occur at 2000-2300rpm).
View 14 Replies
Advertisement
So basically I woke up one morning, was gonna go to work when I tried to start my corolla nothing happened...tried that couple of times and still nothing ....then couple tries later, you could hear the car try to start but then nothing happens. The check Engine light is on when I try to turn on car
The battery and such seems fine. And I don't recall having any problems before, now even the remote control for the key wont work for the car...
View 10 Replies
I have a 2010 Corolla. The car is flashing the infamous VSC Off, trac, engine light! The car is still has the powertrain warranty. I was wondering if I should take it to a Toyota dealership.
But I read just getting the diagnostic itself is around $100. I don't want to end up paying for that if the repairs end up being something that's not even covered under the warranty.
View 4 Replies
I have a 2009 Corolla S w/ 79K miles on it and recently my check engine light came on with the trouble code P0352. The engine would misfire while accelerating and then was extremely rough when at a stop light. This issue and check engine light have been happening intermittently over the last few days. I don't really know anything about engines/cars but doing some research came back with the following...
Possible causes
- Faulty Ignition Coil 2
- Ignition Coil 2 harness is open or shorted
- Ignition Coil 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
Basically my question is how do I troubleshoot and figure out what the real problem is? I would rather not buy and replace the Ignition Coil if it is something else. From everything I have seen it seems the simplest method to test the coil is to switch out the ignition coil and spark plug on coil 2 with one of the other 3 ignition coils and see if the the trouble code follows it or stays on 2.
View 3 Replies
I own a 2012 Toyota Corolla S w/ 8700 miles on it I am the first owner. Check engine light blinks on and off 8 times. I cleaned the gas cap threads and neck, then I reset the computer by removing the positive terminal for 1 minute. I also checked the oil it's fine. Light still blinks? I have many years of mechanical back ground, without running codes I don't know this one
View 4 Replies
My friend was told by Toyota that the Air Fuel Sensor code was the reason why her 2010 Corolla VSC and engine lights were on. This was after she visited her mechanic who changed the O2 sensor.
Is there a way to change the Air fuel sensor herself without having to pay Toyota...
View 2 Replies
The fuel line is fine.
Today after work I started the car in a sheltered car garage and as soon as I started the car the after the initial start up sequence the check engine light stayed on and the traction control light stayed on and right next to it on the left side the "VSC Off" light kept blinking and flashing. I turned off the car and started it several times to see if that did anything and to no avail nothing happened.
While I was driving those lights stayed on and the VSC off light kept on blinking. I also checked the brakes and the brake fluid and they all seem to be fine, I even checked the fuel door as well.
I am not sure what is wrong. I was looking at some of the complaint sites and most people say it happens when you drive through a deep puddle or if it is cold and wet outside. But that didn't make sense because I drove in the snow and those lights never turned on. The only time I used the ETS button is during the snow storms and I drive at low speeds.
I need to know why this VSC off light is blinking? Is it a bad sensor or is the ABS/ETS brake system broken or is it an ECU issue or is it because of an alignment. Since I was told to get an alignment soon.
View 14 Replies
After taking my 2009 Corolla S to the dealer on 4/07 for an oil change, about 4 or 5 days later the check engine light, the traction control light, and the VSC light come on (VSC off blinks). The first day it came on, I took it to autozone to look the code up and they said it was P0353 (issue with ignition coil c I think). I immediately afterwards drove to the dealer to see what they would say. But after parking in their garage speaking with the greeters, they said the light wasnt on, and asked if I wanted to wait the 2 hours to see a tech. So I took it home.
The code came back about 3 days later, and this time there was a slight stall/jolt for about 4 or 5 seconds. This occured on startup and not during driving. After the 4 or 5 seconds of the mild jolting it felt like it was running smooth. I took it home and after leaving it off for about 20 minutes, the light went out again. A couple days later it came back and stayed on over night and was still present when I started it the next day. It went off again later that day.
My question is what could be causing this that might be a simple fix. Do toyota techs check anything with the spark plugs during normal Oil Changes? I know they checked my brakes but Im not a car guy and am not really sure all that they do. Could it be a loose spark plug? Code P0353 coming up sporadically after dealer Oil change. Is there any steps they normally do during the oil change that could be causing this, like leaving a spark plug loose after checking them or something? Would the coil / wiring harness fall under an engine warranty?
View 10 Replies
I am far from home. Taking a road trip. Day 2 out of 6. My check engine light came on, so I just pulled over. All fluids were fine. Found some place to read the code:
P2757 TCC pressure control Sol Ckt Perf / Stuck off
The guy said it was something to do with trans.
View 3 Replies
I just got my bc extreme drop kit installed, after taking out struts i imagined my corolla would be lighter and faster cuz the struts weigh way more than the coilovers, but when i drove it for first time after install, i noticed the acceleration is weaker and not as responsive, why this is? is it supposed to be like that, whats happening?
View 5 Replies
Check engine light came on. Codes are P0300, P0302, P0304. Plugs were previously changed. Plugs look good. Changed both coils. Light still one. Injectors also previously cleaned. What else should we check for? Valves hanging? Anything else to check for?
View 5 Replies
I currently own a Toyota Corolla VVTI 1.8 2009 GLI. I have been racing this car here at our auto drome for over a year. Last race it starting giving me real bad issues with shifting on the track. I can be a 5,900 RPM and shift to a higher gear and the car will choke and drown and it takes forever to recognize I'm accelerating. I know this is because of the computer and the electronic accelerator it comes with ( I can't remember it's name in English). My gas pedal is Denso and I understand there is an adaption that can be done to the cable to trick the computer.
View 14 Replies
I just recently bought 2012 CorollaS. Great car inside and out with about 20k miles. I've noticed under acceleration and sudden braking a pop is coming from the passenger fender area. I've replaced the motor mount on that side thinking that might have been the issue, but it's still there. What are the torque specs for the motor mount. Maybe it's simply not torqued correctly.
View 2 Replies
What the problem is? still drive-able?
View 14 Replies
2010 Corolla LE ... This started today, on the ride home from work. Mid 50 degrees, light rain, driving down straight road it started. Engine light also on. No mods in car. is this something the dealer has to se, or can I bring it to my own mechanic?
View 1 Replies
I have a 2011 corolla. the engine just dont have any pep. is there a way to swap 1.8 for a 2.4 . is it worth the effort. or how can i get more pep without sinking lots into it.
View 14 Replies
One of my light bulbs for the rear license plate light is out.
what kind of light bulb I need to get?
View 8 Replies
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 Replies
So I bought and installed bc coilovers and my abs light and 2 other lights came on. I did accidently mess up one of the wires on the front left strut but it is not torn in half or anything just sliced into a little. I electrical taped it back together.
View 4 Replies
This morning I started my car, which was parked on an incline, with the car in gear (manual tranny) without remembering that I had left the car in gear. So, when I started the car, it lurched forward when I took my foot off of the clutch pedal. No big deal. I started the car again, but now the check engine light and abs lights are on steady, and the VCS is blinking. The car drove normal all the way to work. When I got to work, I shut the car off and started it up again, but the 3 warning lights are still on.
Is there a re-set procedure for the lights that happens automatically, or do I have to have someone with a scan tool reset it?
Could there actually be something wrong with the car?
View 7 Replies
I noticed my tail light isnt working, so I decided to change the bulb. And bought a 7443LL Sylvania bulb from Oreilly. Fits perfectly but noob that hasnt opened a car before. Old bulb is greyish, I guess its blown out or something. I change both bulb because you buy them in pairs. Anyhow, I thought its the bulb is the problem but now its not. Since both break light and tail are of the same bulb but tail light isnt working. So I figured the bulb isn't the culprit. I called a friend and he says its the fuse. Found the fuse, bought and replace the fuse. I turn on the car, tail light is still not working. Check the new fuse, its blown, put another one, the same thing happen. It keeps blowing my tail light fuse everytime I start the car. Im quite sure I got the right 7443, its dual filament bulb (I can see 4 wires at the base and 2 string that would light up for tail and break.
Is there 2 fuse for the tail light, I only found one by the break pedal, its just below the turn signal/hazard relay.
View 4 Replies
