Corolla / Matrix 2009-13 :: Rear Brakes Pads Sticking / Wearing Quickly?
Mar 20, 2013
At about 25,000 miles I had one of my rear brake pads sticking so had to change the rear brakes. The non-stuck pads on the other side looked decent still, so I'm assuming I'd have gotten quite a few more miles out of them if the one hadn't been sticking. Changed the front pads at about the same time, although they were in pretty good shape still (but it was taken apart already, so did them while it was apart and the chance was there). At about 50,000 miles later the rear pads are again unevenly (and I feel perhaps prematurely?) worn, and the fronts look fine. Is it something with the screw-type e-brake mechanism on the rear disc brake that lends itself to sticking? Or am I just especially unfortunate?
View 10 Replies
Advertisement
My car has about 37k on it; and while the front pads look to be about 50% worn; the rears look like they are closer to 90%. Is this normal? The car is also sluggish while braking especially when the engine is being auto-revved to keep the system voltage up (a known problem). It also seems that the car will step into ABS lock-up mode too soon in a panic stop situation; which might also indicate that the brake system is biasing too much power to the rears; too little to the fronts.
I've never had a car wear the rear brakes more rapidly than the fronts; usually the rears are much more lightly utilized to reduce the tendency to skid. Is there any way to adjust brake bias? I'm getting ready to change rear pads and flush brake fluid.
View 8 Replies
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
View 4 Replies
I performed brake maintenance today with my brother on my 2010 corolla CE, my front rotors were warped and my pads were used ( and also uneven) and I replaced both front rotors and pads.
The install went smoothly, my brother changed a couple of brakes sets and knew what he was doing and showed me up.
Took it for a spin, the brakes work very nicely ( i bought the ceramic wagner bundle ) but theres a slight grinding noise when driving, like the pads are touching and rubbing a bit too much on the rotor, but the driving is unnafected. Also, there's a sqealing noise coming from either side when you turn only.
Braking itself produces no noise whatsoever, only when you turn that it squeals.
View 4 Replies
It was about 7 degrees Fahrenheit and I started my car and it took a few seconds longer to start then normal but I kind of expected that as it was pretty cold.
Then after letting the engine warm up a little bit I went to leave and the clutch pedal was sticking for a second or two between shifts and I still kind of ignored it and drove home, well after a 45 minute drive by my house it was still doing it.
The next day I drove it to the store and after sitting in my garage for a while it was fine. A few days later, (well last night) I went on a break to get some food and it did the same thing when I left to do that but after it was warmed up to normal operating temperatures it was fine again. When I first started it, the temp was 13 degrees.
I am trying to figure out if there is something wrong with my car or if all of them do that. I am going to stop by the local dealership on my way home today but if it is normal I don't want to waste my time. I just don't like the fact that I live in Minnesota and the temperature is going to get colder then that. I mean what is it going to do then?
View 1 Replies
i have a 2010 Corolla XRS and was wondering the following:
-How good are ceramic brake pads?
-Do they last longer than normal OEM pads?....under normal driving.
I was considering buying a complete set of drilled rotors and ceramic pads for my car.
View 14 Replies
I am very happy with my 2010 corolla, except for the annoying beeping. I live in a very quiet townhouse row and the cars are parked right in front of the houses. So, when I get up in the morning to get in the car, it beeps when I unlock it and on good weather days when the windows are open, there are at least 20 units that can hear it. It is very embarrassing. What is worse, randomly in the middle of the night, at 230 or 3am, it will beep five times quickly. My neighbors want to kill me! The engine light has been on for a few weeks because I am due for an oil change. Could it be related to that? And how do I turn this thing off?
View 4 Replies
I changed out the brake pads, now it is making a hissing noise. I bled all the brakes starting from the back. Here is the video : [URL] .....
View 2 Replies
Took my Prius to the local dealer for 50,000 mile service and got a call that both of my front brake pads were worn below the limit and needed replacing. This surprised me as I have read here and elsewhere that some go 100,00+ miles before needed replacement. So I had them replaced and when I went to pick it up, asked them how much was left on the front brakes the last time I was in, which was for my 45,000 service. After looking it up, guy told me they measured 8mm in February, meaning I went from 8mm down to needing to be replaced in the span of like 9 months after driving 5,000 miles. Even the guy at the dealership seemed surprised when we looked it up. Could there be some underlying issue causing abnormally fast break wear? I vaguely remember getting the brakes adjusted related to some TSB in the spring.
View 19 Replies
I bought my 2010 Corolla 5 years ago with 17,000 miles on it. Since then I've put on about another 46,000. With 63,000 miles it needs it's 4th set of rotors due to brake pulse and shudder. We live in the prairie and I'm not hard on brakes. The brakes have never felt like my 05 Corolla.
Can this be caused by too aggressive of brake pads?
View 3 Replies
Today I decided to change my rotors and pads out.. Got everything back together and i believe car is in limp mode.. It wont shift out of 3rd.. Abs light on ,check engine light, traction control and stability control light on.. Also my speedometer doesn't work but my rpm"s do...hooked up scan tool and comes back as wheel speed sensors.. I never touched them or removed them....
View 3 Replies
What's with the rear brake pads wearing out before the front brake pads. Took my '03 Passat in last week to the dealer for the recall and the service dept. guy said my brake pads were worn out. I took the car to my local mechanic who specializes in VW's. Sure enough, rears were almost gone but fronts still had plenty of meat left on them. Of course I had him replace the rears. But I always thought the fronts wore out first. Could this anomaly be due to ABS?
View 11 Replies
Don't the stock brake pads go for more than 12k miles? The brakes are squeaking when I first pull out of my driveway and after a while it goes away, but at lower speeds (stop and go traffic) they still squeal a little bit, but when I am braking at higher speeds I don't hear anything. about a year ago my friend drove my car with the E-Brake up for about a mile. Could it be that because my rear drums are worn that my front brakes are getting worked more? But when I pull my E-brake up it still works fine without going up too much.
View 7 Replies
I bought my 06 Corolla LE last week and just started hearing a nasty squeaking sound whenever I applied the brakes. I took it to the dealer today and 4 hours later he calls me and tells me that he had to readjust my back brakes and lube them up and it should be fine..About a half hour into driving the car around town I start hearing this noise again. Now he's telling me to bring back in the morning to see what the issue is.
My question is besides the brake pads and rotors which were checked by another mechanic that said they were good what the hell could be the issue?
View 3 Replies
I bought a 2012 Corolla S and I feel that the rear brakes are a little cheap. Has swapping brakes but how?
View 3 Replies
2010 LE is having a brake squealing issue. The car only has 35,000 miles and the pads are at about 50% life left. I cleaned everything and lubed everything and they are still squealing. I would hate to have to replace the front brakes this early especially when the pads are only half worn. They are the factory pads and rotors btw.
View 5 Replies
Is it possible for the brakes to make some kind of noise when it's cold outside?
I've been noticing some kind of noise after a cold start, I'd drive the car a little bit then apply the brakes and it would just make this random noise coming from the front-right side of the car. It sounds like a grinding noise, but I can't really tell. It doesn't create an issue either, I'll let go of the steering wheel and the car doesn't drift in any direction at all, the noise appears but the car is slowing down properly.
The noise disappears though after the 1st time it happens, and would only reappear after you've turned the car off, parked it where it's cold and it would only appear after not using it for at least 2 hours. My dad already took it to the dealership and they said the brakes are perfectly fine.
View 14 Replies
I have problem with left front brakes corolla. When I changed the router it was fine, but after few month, during down hill when I apply brake, right side make lot of noise. I cleaned pads and pin are good. It happens only on right side, down hill is problem.
View 2 Replies
My son just bought a 09 Corolla LE and he gets this clicking noise every time the brakes are applied. The clicking noise comes from the Shifter.
I know that about the Shift Lock Solenoid, but this clicking sound is loud. I have been told that this is normal. So, I thought if this is what 10th Gen owners here is experiencing the same.
View 1 Replies
I have a 2010 Model S that has 38,000 miles on it. I am hearing a rattling in the front brakes when cruising along at almost all speeds. If i hold a little peddle pressure it goes away. Sounds like the pads are rattling to me. I am running the stock pads with about 45 to 50% remaining on them.
View 6 Replies
I have a 2009 Corolla S and the symptoms are as follows:
1. Normal forward driving, brakes work fine (and as expected without sound).
2. In reverse, when I apply the brakes I hear a click (clunk) sound from the front brakes. It only makes the sound when I'm going from moving to stopping (IE: I cant just keep pressing the brake once stopped to generate the noise). But if I let myself continue in reverse and press pedal again, it will make the same sound (very repeatable). I don't need to go forward to replicate the sound, I can just stay in reverse, stop (CLICK), continue in reverse, stop (CLICK), etc.
3. The it's noticable in the pedal. I can feel it on the brake with my foot when the noise happens.
4. It happens when I depress the brake pedal about 1/4 down, a gentle stop. And usually happens every time when I back out of my driveway or parking spot.
5. GF's sister's 2009 corolla CE does NOT make this noise in reverse.
6. 20,000 miles, Orig tires/brakes, didn't happen 4ish months ago.
I plan on putting winter tires on next month. Perhaps I'll take a look at the pads to make sure they aren't moving around, but wouldn't I also hear the noise in forward motion? Or when I switch from forward to reverse?
View 13 Replies
