Corolla / Matrix 2009-13 :: P0500 Code - Vehicle Speed Sensor Malfunction
Jun 29, 2015
My car is now 24/7 with this error which is Vehicle Speed Sensor malfunction an there seems to be no way of solving it, symptoms are:
*Speedometer not working, needle always in 0
*Power steering not working
*Car wont past 3rd gear
*Check engine light and power steering light on
I checked all 4 speed sensors and the wiring looks good and they look good. Also if i hit a bump, issue goes away for a couple of minutes, until i hit another, etc, so looks like a wire or short circuit, cant tell. Is there a speed sensor on the transmission as well? where is located?
View 1 Replies
Advertisement
Recently, my I4 XLE camry with abs came up with a cel P0500 - Vehicle Speed Sensor A Malfunction. Where the vehicle speed sensor is located? i doubt this thing's hard to service, but so far i have no luck finding it.
View 13 Replies
Where the vehicle speed sensor is located on the 2007 es350. Reomoved battery and air filter box but just can't find it.
View 1 Replies
Vehicle is a 1996 Aero* XLT, 4.0 engine with 155000+ miles. I'm getting the P0500 code with the OD light blinking. Tranny is not shifting properly. Did not look at the speedo or check the cruise due to worry about making it to my driveway. I have had ocasion to set the cruise to 45MPH and at times it will drop out. I don't know the lower limit on the cruise. Is this speed sensor the same as the VSS...
View 9 Replies
I have the code P0500 on my 2009 Matrix. The odometer doesn't function, all error lights are on, the power steering is not completely out but it's reduced. Also, the rear windshield wiper is constantly on. I replaced the vehicle transmission sensor today because I thought that would fix it all. It had absolutely no effect.
View 5 Replies
I have a 2010 Toyota Corolla 1.8L, the base model.
I recently had a check engine light, VSC off light (blinking) and traction control light come on. I took it to Autozone and had a p0037 code ring up for a new Bank 1 Sensor 2 oxygen sensor (downstream). I believe I have found the correct sensor (located under car, approximately near drivers seat) and it looks simple to replace, aside from the fact that the wires go through the car body.
Can confirm that I have located the correct sensor? And if so, what is the best way to get to where the wires connect?
Is it located under the drivers seat? What should I do about the rubber grommet located under the car where the wires appear to pass through?
View 2 Replies
2010 RX350 check engine light is on code P0500 came up it said speed sensor A...
View 1 Replies
My friend was told by Toyota that the Air Fuel Sensor code was the reason why her 2010 Corolla VSC and engine lights were on. This was after she visited her mechanic who changed the O2 sensor.
Is there a way to change the Air fuel sensor herself without having to pay Toyota...
View 2 Replies
I have an 08 avalon w/ 281k miles. NEED to replace the transmission speed sensor (P0500 code thrown). Where is it located on the trans and what is the part #? I'm thinking about servicing the trans while I'm there but looks like a lot of "comments" regarding this transmission and the problems with servicing it!?
View 9 Replies
So I'm getting code p0500 the question I have is will the speed sensor on the tail on my transmission cause this code on my 99 f150 4x4 . the reason I ask is because this sensor has been broken off . I'm hopeful it only control's my speedometer and is not related to the code . I've tried to remove what is left however in fear if I get it loose it may fall into the transmission. I will be replacing the speed sensor on the pumpkin this weekend . but the transmission it's the upper one is broke off below the surface of the transmission this is a manual transmission....
View 2 Replies
I was looking to lower my 2012 Corolla after seeing torres 16 running 18x10 all around on his car. I fell in love with his Corolla and have been craving to do something similar. Now here's the flip side. I am absolutely clueless about the in-and-outs of stance work or being "slammed". I was thinking running 18x10 all around is a bit too much and was looking to run 18x9.5 Grids - if I could find them new. I'd like to sit "flush." What offset would be recommended? From what I saw on wheeldude, they only come in +20 or +38. Would this be possible on BC coilovers? I'd like to achieve a look similar to Jzen 16 or torres 16. Would I be better off running an air suspension setup? The downfall is they get ridiculously costly.
View 14 Replies
I have a 2009 Corolla LE. I've had these issues since buying the car last year. Issue #1 : when initially accelerating from a stop through 1st and 2nd gears, there's a slight vibration felt through the steering wheel and vehicle. If it's just a gentle acceleration it typically doesn't aggravate the issue as much as a quicker acceleration. Issue #2 : This car is very sensitive to varying types of road conditions. One patch of road can seem smooth as silk. Then another patch will feel rough and bumpy. The road appears to have no bumps or imperfections. I just put brand new tires on the other day, and its still doing this. And I feel all of the road imperfections the most through the steering wheel. I'll briefly take my hands off the steering wheel to see if I feel it in the cabin, and its not as bad as it is through the steering wheel.
View 9 Replies
So I am getting a CEL and p0501 (Vehicle Speed Sensor) code and don't quite know how to approach it.
Other forums/posts suggest that I check or replace the input and ouput sensors on the transmission, but from what I understand those are each a unique code, and the p0501 is for a sensor located on the transaxle. Is this the case?
I was under the impression that because my car did not have ABS that I did not have the latter sensor on the transaxle, only the input/output on the transmission. If that is the case, will replacing both eliminate the CEL/p0501?
View 1 Replies
My daughters '09 Corolla was shaking and misfiring occasionally. When she took it to the shop the mechanic had it for a couple days and after many attempts finally reproduced the issue. After several diagnostics tests they determined it to be a damaged cylinder. We had the option of
1. replacing the engine
2. retooling it
I called around to a couple other mechanics and they told me the same thing. One particular mechanic (no affiliated with Toyota) told us that he had heard this happening on both the Camry and the Corolla. Sound like a manufacturer issues if it's been seen frequently.
View 5 Replies
I installed an aftermarket cruise (Rostra) in my manual 2007 Corolla. Other than cutting the hole for the stalk the only real difficulty was getting my fat hands up under the dash to install the clutch disconnect switch. It certainly didn't involve any wire cutting or messing around with the ECM.
It's a long story, but through a sequence of events I have to opportunity to buy a 2010 base Corolla 5 speed at a pretty good deal. It also doesn't have a cruise control. I went tot eh Rostra website just to make sure cruise units are available and I looked at the installation instructions. Unless I read the wrong sheet, their instructions make it seem like installing cruise on a 2010 involves messing with the ECM wiring harness, moving connectors and a bunch of scary stuff like that.
It seems strange to me that the older car would be "plug and play" but a newer one would need changes to the main wiring harnesses. I'm not talking about a steering wheel mounted system where the clock spring has to be replaced, just a basic cruise.
View 2 Replies
The Aux input on my 09 Corolla has started to malfunction.I plug my ipod into the auxiliary input and if the cable wobbles as i drive and hit bumps, the AUX mode switches over to RADIO mode and the radio starts to play, instead of the ipod. I have to wiggle the cable before i press the AUX button for it to start playing the ipod.
View 14 Replies
I want to disable that beep beep sound when you lock or unlock the vehicle with the remote. Does this can be disable?
On my previous Nissan Altima, you can toggle this feature by pressing the lock+unlock simultaneously. I tried that on the Corolla, it does not work.
View 14 Replies
I purchased this car used last year. It is a 2002 Camry with a 4cyl 2.4L and an automatic transmission, with 75,000 miles on it. The car was driven about 7 months and a little over 2000 mile before the problem started.
I had a P0500 code read by dealer after check engine light came on. The vehicle kind of surged and the motor rpm increased and I seem to loose power. I also told them the tach and speedometer started jumping around. This only last a minute or so and then runs normal. They tested the vehicle speed sensor and said it was working fine and reset the light. After driving it a couple hundred miles the light came on again and they did the same thing. The next time it came on they decided the signal from the sensor going through the cluster (speedometer and tach) might be where the problem lies, since the signal went through there before going to the ecm.
They could not guarantee this was the source, but it was their best diagnosis since the car would not repeat the fluctuating power problem. I went ahead and replaced the cluster and drove it about 1 month and 250 miles before the light came on again. It is the same code P0500. I forgot to mention that the 3rd time the check engine light came on they said they also pulled a P1730 code. The car runs fine after the initial check engine light comes on.
View 7 Replies
I am looking at a 2013 S 1.8 with 38k miles... it seems to have oil leaking at or near what looks like the oil pressure sensor, but i have struck out finding a picture of one in place on the engine.
The oil stain is above and behind the harmonic balancer at a sensor that sticks straight out towards the firewall and looks like the oil pressure sensor.
The engine has not been washed and there are no other stains above it. I am more than capable of changing the sensor... if that is what it is. Is this a cause for concern?
View 4 Replies
I have read several of the post on here about speedo's acting up, but I'm not finding anything that pertains to my specific problem. A few months ago I bought a 2000 Excursion, it currently has around 179,000 miles on it. When I got it the ABS light was on and this site is actually where I found out to replace the sensor on the rear end to fix that. My problem is that until a few weeks ago even with the ABS light on my speedo worked just fine and then it started acting up every time I hit the brake pedal and then eventually quit working all together and my cruise control light would flash as well as the OD light.
I replaced the sensor in the rear end and also found out about a recall for the cruise control and had that repaired as well. Now the ABS light is no longer on and the cruise light is not flashing, however the OD light still flashes and 95% of the time my speedo does not work at all. On Monday while heading to town it started working, hit the brakes and all was good, set the cruise control and used it all the way to town, but as soon as I hit the brakes the needle started jumping around and went back to zero and stayed there. I have ohmed the sensors and wires from sensors to harness under the hood and all seems good. The only code I can pull with my meter is P0500 which is just a generic code.
View 6 Replies
i have Ksport kontrol pros and no mattter how i attach the brake line or abs sensor it rubs! how to rout them. i bought 3/8 heater hose for the brake line and spliced it to make a sleeve. sway bar endlinks used to pinch the ABS against the coilover but now it rubs the cv axle. 09 rolla s
View 2 Replies
