Corolla / Matrix 2009-13 :: P0031 And P0172 Error Codes - Car Sputters And Hesitates
Oct 9, 2013
My girlfriend drives an 09 corolla (1.8L I believe). I have an OBDII bluetooth reader w/ Torque App so to identify the issue I can get some data:
Last week I was driving the corolla and I got P0031: HO2S Heater Control Circuit Low (Bank 1 Sensor 1). Car seemed to run fine without any issues. My girlfriend brought her car in to her "mechanic". "mechanic" who will replace have of your engine only to realize that your gas cap was cracked. He apparently replaced 02 Bank 1 Sensor 2 (I'm still trying to confirm this and to get the part # to make sure). He reset the ECU and she drove for about 30 miles after which these codes popped up:
P0172: System too Rich (Bank 1)
P0101: Mass or Volume Air Flow Circuit Range/Performance Problem
The car was idling rough. I reset the codes and the car was running fine until all monitor systems were ready. When Catalyst, 02 Heater & 02 Sensor are not ready everything is running fine and I don't see any error codes. I cleared ECU a few times. The last time I was able to drive for over 20 miles without any issues. Currently the only sensor not ready is 02 and car is running fine but I have a feeling once its ready the car will start having issues again:
Summary (if you don't want to read everything)
*P0031: H02S Heater Control Circuit Low (Bank 1 Sensor 1) - Car runs fine
*Mechanic replaces 02 Bank 1 Sensor 2 (Trying to find part # and double check sensor name)
*ECU reset and car runs fine for 30 miles
*P0172: System too Rich (Bank 1) and P0101: Mass or Volume Air Flow Circuit Range/Performance Problem
*ECU reset - car sputters and hesitates
*When all monitors are ready same codes (P0172 & P0101)
View 2 Replies
Advertisement
Both the P2195 (Oxygen sensor or A/F sensor stuck lean - bank 1 sensor 1) and P0031 (Oxygen sensor heater control circuit low - bank 1 sensor 1) were pulled on my 2009 LE (77K miles). Is it safe to assume that the upstream b1s1 sensor is the culprit?
I believe I've found the OE Denso part 234-9056 - is this the right one?
General question about O2 sensors - is it recommended to replace both the upstream and downstream at the same time, or is it not necessary to do that?
View 8 Replies
My car refused to start after being in the driveway for about 2 days, the battery seems to be fine, the electronics are working, and the gas tank is full. The car seems like its trying to start and when you twist the key but after a seconds just sputters out. I checked under the hood, on the battery terminals there is some sort of red sticky buildup...
View 14 Replies
I have the code P0500 on my 2009 Matrix. The odometer doesn't function, all error lights are on, the power steering is not completely out but it's reduced. Also, the rear windshield wiper is constantly on. I replaced the vehicle transmission sensor today because I thought that would fix it all. It had absolutely no effect.
View 5 Replies
So driving home today cel came on and vsc started flashing.
The codes I got were pretty out there
P0420 - cat converter (this one I did expect)
B0cc0 ???
C3a32 ???
U0a8e ???
B3e1f ???
I'm wondering if this was poor communications between the unichip and ecu? As for the vsc flashing, people complained about this during rain. It is currently raining. But not certain this is the issue.
View 4 Replies
Went on a trip Sunday, and i saw my engine light come on after i put gas in the car. I pulled over, re-checked the gas cap, and it was fine. Car felt fine.
When i got home, i used my OBD2 scanner, and got the error P0304 Code - Cylinder #4 Misfire. I cleared the error and drove the car some more, no issues.
Yesterday, my wife took the car and she said it was hesitating and sputtering, but the light hasn't come back. I have an appointment at the dealer tomorrow, the car has under 80,000k, so the warranty should kick in.
View 2 Replies
I am far from home. Taking a road trip. Day 2 out of 6. My check engine light came on, so I just pulled over. All fluids were fine. Found some place to read the code:
P2757 TCC pressure control Sol Ckt Perf / Stuck off
The guy said it was something to do with trans.
View 3 Replies
I have a 2010 coroola "S" and the ABS and Brake light have come on recently and it seems to drive fine. I have read the codes and the are : P000A and P050B
View 4 Replies
Alright, so I've been battling this for a few hours. I know I need to replace a sensor, and that's about it. The issue, is I don't know if I need to replace an oxygen sensor or an air fuel ratio sensor. I have searched, but I keep finding conflicting information. So which do I need?
View 3 Replies
I have a check engine light come on in my 07 Avalon and had the car scanned. It was throwing error code P0031. I'm gonna go ahead and replace this O2 sensor, however, I'm having a hard time finding the correct part# for this sensor.
View 1 Replies
1999 Toyota Corolla
Error codes: P0301 ... P0304 ... P0300 ... P0420
Symptoms: Car had short touch of the shakes in the morning, parked it for 8 hrs, drove half a mile, and it got the shakes bad and seems like it wants to stall out and the check engine started flashing. After a minute it went back to normal, and then the whole thing happened off and on the last half mile home.
Background: I was told the catalytic converter was in bad shape last time I took her in so I'm assuming that's it. Friend of mine suggested driving it hard to burn out impurities in the cat, but I'm worried about damaging the engine. Going to replace the sparks and spark wires (they're about due anyways).
View 1 Replies
As the title says it all I have a 2010 Malibu LS with roughly 88k on it and just noticed that the CEL light came on last weekend. On Monday the light went ahead but it came back on this morning. Took it to Autozone and the error code was P0172, Fuel System Too Rich, Bank 1. I noticed this happened last weekend after putting in some gas at QT. The Autozone guy recommended some fuel injector cleaner as a starting point and recommended using pure gasoline (premium).
View 12 Replies
I have 2 x P0031 and 2 x P0051 after an accident. I rear ended an SUV. My hood got bent and the radiator got pushed in. The body shop said they don't think it was due to an accident. I can't possibly have 4 sensors go on me.
View 9 Replies
I received error code P0031 on my 06 Avalon the other day. It states that the HO2S (Heated Oxygen Sensor) is bad. Bank 1 Sensor 1. I located the sensor but have a few questions...
Just to give an over view for those that don't know where these are, there are 4 sensors the one in the front on the manifold (upper - B2, S1), (lower - B2, S2) and the rear manifold (upper - B1, S1), (lower - B1, S2).
All of the sensors look the same with 4 wires. what the part number is for the sensor? Also since this is the hardest one to get to, I would like to know where the wire routes to. I found the wire up to the connector on every other sensor except the one I need (B1S1). It looks like it runs towards the top of the engine but from the top I don't see it.
View 2 Replies
Actually I bought a used Corolla 2002 with 120K which seemed fine and the driving is fine. After I bought it, I just found out that the seller has removed the check engine light. When I read the ODB codes, It shows three codes of 0171, 0420, 0441. Also I have recently found out that the engine burns excessive amount of oil. (about a quarter per 200 miles). Actually the driving of the car is fine and as long as I add oil engine it seems fine.I think all of these errors might be just due to a small problem like a broken valve (since it's not high mileage). It seems that there is no vacuum leak from hoses as well.
View 8 Replies
My driver side bi-xenon bulb was out, so I go to replace the bulb and it still doesn't turn on. I scanned my car with my vagcom, and I get this error.
Address 09: Cent. Elect. Labels: 3C0-937-049-30-H.lbl
Part No SW: 3C8 937 049 E HW: 3C8 937 049 E
Component: Bordnetz-SG H54 2602
Revision: 00H54000 Serial number: 00000008706034
Coding: E78C8FA300041C004719000014000000002AF7475C40012539 0000000000
[Code] .....
View 5 Replies
Still having problems with my 2.4l 2002 santa fe. At stand still the MAF readings are within range. At 2000rpm it reads 9.3 gm/s. the info I have says it should be between 7.89-9.83.
When driving along at 50mph, 5th gear, engine speed 2000rpm it reads approx. 25.0 gm/s. at 3000rpm it reads 48 gm/s. Is the MAF sensor faulty?
It is now not running very well with fault codes P0171(fuel system to lean) That code comes up whilst driving at speed. I also get P0172(fuel system to rich). I got that one whilst driving slowly in a car park.
View 3 Replies
So I didn't pass the smog check for the new used car that I just purchased 10 days ago. Although my old car (same model), was five years older, I never had this problem. I was told that it is a gross polluter. These are the problem that I have to fix:
OBD Fault Codes - P1128 Manufacturer specific codeP0411 Secondary Air inj Incorrect FlowP0172 System too Rich (Bank 1)P0134 O2 Sensor CKT Inactive (Bank 1 Sensor 1)
How this happens?? 2001 VW ...
View 4 Replies
My wife has a 09 Santa Fe and we were getting code p0464 fuel sensor circuit intermittent. I changed both parts that need replacing. After about 20 miles now code p0442 small evap leak detected. I can only assume that it is coming from the fuel sensors that were replaced. Is there anything that I could have screwed up on?
View 1 Replies
I recently bought a 2004 Hyundai Sonata 4cyl with about 65k miles. In the past few months I've noticed that it likes to sputter and hesitate at times, mostly in lower gears when I'm not accelerating hard. At highway speeds it's mostly fine. It's also fairly random - some days it's really bad and others it's fine. Also seems worse when in reverse. I don't think the plugs have been changed so that's one idea, but I'm wondering if it's a bad fuel filter, exhaust manifold leak or something else. It's not throwing any codes (and yes the light works) and it has never stalled completely out.
View 4 Replies
I got my truck to throw some codes. As many of you know I have been having an issue where when I stomp my truck to the floor it sputters and hesitates. Some days its worse then others. It only happens under a load, and it generally doesn't last to long, however today it did it a whole bunch and lasted for a good bit any time I got on it hard. My engine light begin to flash, and there was a smell of exhaust. I went to Autozone quickly as possible. The guy read the code, and this time no lean codes, just a "P0430" which the code reader said was O2 Sensor Bank 2. It also had a pending code, which was "multiple cylinder misfire detected". So my question is can an O2 sensor cause this? Could my CAT on that side be bad?
If that is all it is, is a bad cat or O2 sensor then I will be very happy... Like I said I can sit in my driveway in park all day long, and rev outta my truck. It will never misfire or hesitate at all. Soon is I put it in gear and am going down the road and punch it sometimes it pop and sputter.
Another cool thing is some how their code reader was able to read my ABS light, and I found out that this whole time I have had a bad ABS Speed Sensor in the rear end. That is a plus as well.
View 14 Replies
