Corolla / Matrix 2009-13 :: Oil Leaking At Or Near Pressure Sensor
May 30, 2016
I am looking at a 2013 S 1.8 with 38k miles... it seems to have oil leaking at or near what looks like the oil pressure sensor, but i have struck out finding a picture of one in place on the engine.
The oil stain is above and behind the harmonic balancer at a sensor that sticks straight out towards the firewall and looks like the oil pressure sensor.
The engine has not been washed and there are no other stains above it. I am more than capable of changing the sensor... if that is what it is. Is this a cause for concern?
View 4 Replies
Advertisement
I am having trouble figuring out what a nut on my 2011 Corolla LE is called, so I am having alot of trouble looking up a solution on my own. There is a bolt above the oil filter and near a sensor that is leaking. I marked it in red in the below picture. I am having trouble looking up what to do without knowing enough about it to search.
View 5 Replies
What is the part number to the TPMS sensors for a 2011 Corolla S. Or any stock toyota ones that will work?
View 2 Replies
I have a 2010 Toyota Corolla 1.8L, the base model.
I recently had a check engine light, VSC off light (blinking) and traction control light come on. I took it to Autozone and had a p0037 code ring up for a new Bank 1 Sensor 2 oxygen sensor (downstream). I believe I have found the correct sensor (located under car, approximately near drivers seat) and it looks simple to replace, aside from the fact that the wires go through the car body.
Can confirm that I have located the correct sensor? And if so, what is the best way to get to where the wires connect?
Is it located under the drivers seat? What should I do about the rubber grommet located under the car where the wires appear to pass through?
View 2 Replies
know where the Oil Pressure Sending Unit is located on a 2011 Corolla. I am planning on taping into that so that I can attach a bypass oil filter that will slow filter the oil down to 2 microns. Although in doing that, I will not ever have to change the oil again, but only change out the filters and top the oil off. I will occasionally need to send in an oil sample to make sure that there is no degradation in the oil.
View 5 Replies
My indicator light came on. I put some air on the two front tires to make it 33/34. But the light is still on. I need to check the two rear tires?
View 5 Replies
i have Ksport kontrol pros and no mattter how i attach the brake line or abs sensor it rubs! how to rout them. i bought 3/8 heater hose for the brake line and spliced it to make a sleeve. sway bar endlinks used to pinch the ABS against the coilover but now it rubs the cv axle. 09 rolla s
View 2 Replies
My engine light just went on and the fault codes are:
P0138 -PowerTrain (O2 Sensor Circuit High Voltage Bank 1 Sensor 2)
P0607 - PowerTrain Control Module Performance
I have just bought Denso 234-4305 Rear Sensor but I was wondering if there are any guides to show where it's located?
The only guides I found is for the 9th Gen Corolla.
The Car has 88k miles on it so I guess it's outside the emissions warranty. Thus what is the price of a new ECU just in case that's the problem?
View 7 Replies
My friend was told by Toyota that the Air Fuel Sensor code was the reason why her 2010 Corolla VSC and engine lights were on. This was after she visited her mechanic who changed the O2 sensor.
Is there a way to change the Air fuel sensor herself without having to pay Toyota...
View 2 Replies
Both the P2195 (Oxygen sensor or A/F sensor stuck lean - bank 1 sensor 1) and P0031 (Oxygen sensor heater control circuit low - bank 1 sensor 1) were pulled on my 2009 LE (77K miles). Is it safe to assume that the upstream b1s1 sensor is the culprit?
I believe I've found the OE Denso part 234-9056 - is this the right one?
General question about O2 sensors - is it recommended to replace both the upstream and downstream at the same time, or is it not necessary to do that?
View 8 Replies
My car was shaking badly during idle and the Engine and VSC Off lights came on simultaneously. I took it to a local garage (not dealership) and they said that there is anti-freeze leaking into a cylinder. They said the only way to clean it out/fix it is to first remove the entire engine from the car so it could be worked on. It will cost a total of $2,700. My engine has 141,000 miles on it so they said this may be risky since it is so used. They said for $3,500 they could swap it with an engine that only has 31,000 miles on it (and a 6 month guarantee.) By numbers this sounds like a no brainer (I am assuming?) but I am curious if swapping the engines would be worth it seeing as the rest of the car has still traveled 141,000 miles. I have kept it in good condition and such though. I am also curious if the engine really does need to be removed to fix this sort of problem or it it could be done cheaper.
View 4 Replies
This morning while driving with a/c on, water was coming out on the side of the center console. It's leaking a lot, that a spot is soaking wet.
View 4 Replies
I just bought a used Toyota Corolla 2009 LE. I found that the indicators for Low engine oil pressure warning, Charging system warning, and Malfunction/Check Engine are on when the engine switch at "On" and goes off after engine is started. Is this normal or something is wrong with the car?
View 2 Replies
As the title says, I can't get the light to go off. I followed the procedure to reset it but after it blinks three times, the light is still on. I've also read that I need to take the car above speeds of 19mph and/or an hour, for light to disappear but still nothing. Although I didn't drive it more than an hour since my commute is short. I've made sure that the pressure is around 30psi on all four tires.
View 4 Replies
My car is now 24/7 with this error which is Vehicle Speed Sensor malfunction an there seems to be no way of solving it, symptoms are:
*Speedometer not working, needle always in 0
*Power steering not working
*Car wont past 3rd gear
*Check engine light and power steering light on
I checked all 4 speed sensors and the wiring looks good and they look good. Also if i hit a bump, issue goes away for a couple of minutes, until i hit another, etc, so looks like a wire or short circuit, cant tell. Is there a speed sensor on the transmission as well? where is located?
View 1 Replies
My '09 2.4L Vibe has started to leak coolant around the coolant temperature sensor. It seems rather odd to me.
Who makes the OEM model? It shows as GM Part 88975489.
View 1 Replies
My father put my f150 into reverse he says he didn't gas it. It was 2-3 feet in between the cars and the hitch went into the bottom grill below the front license plate. Coolant is leaking from the left side between the radiator and the block. Now the trucks hitch didn't go far enough to hit the radiator, or anything else I can see. I have cleaned the coolant and am in the waiting process try to identify the location. I believe that it is oozing from the water pump ( most of the coolant is underneath it), on the other hand there is coolant also by the radiator just not as much. I have the ability to fix this just not the tools. My family is going to take it to the dealer ship I just do not want them to get finagled around.
View 3 Replies
Last week I was losing pressure on my left rear tire. It turned out to be a 3 inch spike that was bent inside the tire. The tires are the original Goodyears with 37k miles on them. I decided to replace 2 rear tires with Yokohama YK580s and turned the extra Goodyear in to a full size spare
Question. At high speeds 50 plus the rear feels like it's sliding a bit if I barely move the steering wheel. Having issues with 2 different tires.
View 14 Replies
I have never had this problem with my 2010 Matrix until this week when I put the summer rims with transponders back on.
As per the manual, I turned the key to "on" and held the reset button. The pressure warning light is supposed to slowly flash 3 times to indicate that it has been reset, then go out. Holding the reset button has no effect this year and the pressure warning light just stays on.
The manual says to take it to a Toyota service centre if the reset procedure fails.
View 2 Replies
So I just bought new wheels, and had them put on. Went from stock 16's to 17's now. After I had them put on there was no issue.
Now after I was driving for about 30 mins, I noticed that the Low Tire Pressure Indicator started flashing for 20-30 seconds, then stayed solid.
And now the indicator has been there ever since. I've tried reinitializing the TPMS but it stlll didn't go away.
View 4 Replies
For those with a sunroof do you have the same issue as me?
On the passenger side when I apply slight pressure to the headliner, I get the following noise. In person it sounds like plastic tubes knocking around. The driver's side does not do this.
View 7 Replies
