My center console, gear lights, and steering wheel control buttons are not illuminating. Could it be a fuse? If so, which one would it be? I looked through the fuse section in the manual and could not find anything about it.
View 2 RepliesI got Corolla 2012. Dome light fuse 10 amp is blowing off as soon as you put it in. Light bulbs checked seems it is not a problem. Maybe relay?
View 11 RepliesHow do you clean the interior fabric (seat and panels)? The fabric i have is suede I think, so it's easy to get dirty.. lints all over, stain from mini drink spills, etc. I've tried a few methods but none seem to take out the stain...SO I was wondering how to clean out everything from this fabric? And make it look new Also anyway to coat it to prevent it from getting any more dirty later on?
View 3 RepliesI have a magnetic grey '10 Corolla LE and was wanting to do mods to my car to customize it and make it look better. I'm extremely new to this and was wondering what you all recommend for certain things like the headlights, tail lights, touch screen radio, etc.?URL....
View 3 RepliesI attempted to remove a 7.5 amp fuse from the interior panel under the dash on the left side. Using the fuse removal tool in from the fuse block under the hood, I grabbed one and worked it out slowly.
When I got it out, the metal prongs were broken off of the plastic housing. I thought this was weird and looked into the fuse block trying to see if I can see the prongs. No luck!
I attempted to pull another fuse to see if it will come out and sure enough, the metal prongs are broken off in the fuse block. I tried again to see if I could see the the prongs but again, no luck!
I put the plastic housing (top half of the fuse) back into the slot and the electronics for that fuse is working. However, I am concerned that something is wrong and causing the fuses to break when attempting to pull them out.
My 2011 Toyota Matrix (with Moon roof) driver side interior light won't turn off. It's in the off position. I've checked all doors and closed them properly and turned the dimmer switch down.
View 1 RepliesI am trying to install interior led light strips under my driver and passenger side. I connected to wire to my front fog lights fuse. But when I connect the negative wire to a metal part the light turns on and doesn't turn off unless i take it off. I want to make the lights turn on when i turn on the fog lights. How can I do this / what did i do wrong. I am do this in a 2009 corolla S.
View 2 RepliesWe got a lot of snow here in the last 72 hours and so driving on the roads has been a bit more slick than usual.
But last night I found a patch of snow that I thought I'd test my traction on (lots of room, nobody around, etc.) and while the ABS worked very effectively and I stopped with full control... I noticed my exterior lights dimmed a fair bit.
Is this a normal thing? Never seen that before.
I got a 2009 Corolla LE and I am wondering if the a/c dial lights up with the dash lights? Its been a while since I've been inside the car but I have this feeling that the dial used to light up. The dial has an on/off push button to activate the ac. That ac button does light up when depressed, the rest of it does not. if the dial does indeed light up, how would one fix this? is there a fuse or something just for the dial?
View 4 RepliesI have the code P0500 on my 2009 Matrix. The odometer doesn't function, all error lights are on, the power steering is not completely out but it's reduced. Also, the rear windshield wiper is constantly on. I replaced the vehicle transmission sensor today because I thought that would fix it all. It had absolutely no effect.
View 5 RepliesAt night, when I turn the key to "on". The stereo light (orange)'s illuminated but no light coming from the dashboard. Other lights on the dashboard -- e.g. engine check, oil, door indicators are fine. When I start the car, the stereo light's gone away and I still have no dashboard lights. I tried to change the channel, put in a CD, increase/decrease volumes but none of those activated the light. All other functionalities seem to be working fine.
I checked the fuse box under the dashboard console. All fuses look good to me. What might be going on or I just simply have bad dashboard light bulbs? What's about the stereo lights?
We just purchased a used 2010 LE model a couple weeks ago and for the first time actually drove it during the night. So I decided to check out how the fog lights look. Problem is, when I turned them on it didn't light up any of the road between the low beams and the front bumper of the car. In fact acted kind of acted as high beams. They are currently aimed higher than my low beams!!!
This doesn't seem right to me.
- Were the lights installed upside down?
- They should be lighting up the area on the road between my low beams and front bumper correct?
- Is it possible that they are able to be aimed that high if installed correctly?
I replaced my tail lights tonight once finished I clean up my mess and decide to go grab dinner.
Started the car, VSC flashing along with ABS light on... Did I blow a fuse when I turned the car on from the new tails?
Just purchased a 2009 Matrix XRS Manual transmission with 67,000 miles on it. I can't get the VSC Off and Traction lights on the panel to go out.
During our test drive, I had turned the system on and off to make sure it was working, and didn't seem to have any trouble with it.
I went to have it inspected yesterday. During the test, they hook up to the ODBII port to check emissions. The tech had trouble getting it connected the first time, saying the connection was going in and out. Eventually, they were able to get it connected properly and passed the inspection.
After they pulled the car out of the bay, the VSC Off and Traction lights were solid on, and they have been every time I've started the car since. Checking the manual, all I should have to do to turn the system back on is press the traction button, but that doesn't seem to be working at all. I also tried holding it down for 30 seconds or so with no luck.
The lights aren't flashing, so I don't think this is an error, I'm wondering if the computer got confused somehow with the ODBII port issues.
Stuff I've tried:
1. Followed these instructions for the Highlander Hybrid thinking maybe Toyotas will generally do this. That just caused most of the lights to flash on the panel and didn't bring up any VSC diagnostic messages.
2. I pulled the panel from the dash out to check to make sure the button was working, and I do get connectivity between the two outside pins while the button is pushed in.
how to get this to reset, or what the problem might be?
The LED Daytime Running Lights are at maximum brightness when the headlights aren't on. When I turn on my headlights, the LED Daytime Running Lights dim down drastically. Is there a way to make the LED Daytime Running Lights not dim down when I turn my headlights on?
View 3 RepliesI have a 2009 with the 2.4L, 130Kmiles. I have engine shudder at idle and upon deceleration only. No check engine light so no codes-ran a hand held scanner no codes. Cleaned the MAF with MAF cleaner, pulled the spark plugs/coils and swapped them around- still getting shudder and no check engine light. Only thing I noticed is the spark plugs were dry to very wet with oil going right to left. Car was parked on level ground. I am completely stumped.
Other thing is I just got the car back from the dealers to fix the clock spring airbag recall, and the vsc light popped up on the drive home. I did call them but afraid the car will not make it there and my wallet might go on a severe diet after. Out of warranty and dealer said if it is their doing because they knock something loose while fixing the airbag clock spring there will be no charge otherwise it's 129 just to look.
I am planning on adding fog lights to my Corolla 2011 LE.
I am considering this one ....
and these LEDs for my license plate ....
Was driving the other day then suddenly fog lights stopped working, I changed the bulbs still wont work, so I checked the fuses to make sure all was ok, and everything was perfect. And now I am completely lost, have no clue what to check to make them working..
View 3 RepliesI recently bought a 2012 used Corolla LE from a dealer and i've noticed that when I drive at night the lights don't turn on automatically. They daylight running ones are one, but the actual headlights used for night-time use don't come on automatically. I'm able to turn the on automatically by just turning the switch, but I'm just curious why they aren't turning on automatically. I mean they're supposed to right, since its a standard feature nowadays?
View 14 RepliesI'm trying to remove the airbag so I can get to the steering wheel lights to change them. I took the covers off of each side of the steering wheel, expecting to find T30 torx screws to take off so that I can remove the airbag, but there seem to be no screws at all holding it in! Am I missing something here? Will have pictures in a couple minutes.
Not sure why my pictures aren't working, here are the links :
[URL] ....
[URL] ....
I haven't been on in a while due to my laptop breaking on me well recently i purchased the V3 triton switchback from vleds as well as just red V3 triton leds. After the install i blew my flasher fuse which i replaced then when i attempted it again i must have blown something else because my corner lights no longer go on and when i turn my lights on i no longer get the sign on the cluster notifying me that they are on. I have removed the lights and the issue was i did not order ck socket adapter. So what i have done so far is checked all fuses and i have nothing burned under the driver side and under the hood. I must have looked over everything 10 times checked all fuses with a test light and i don't see anything with DRL or Corner lights labeled anywhere on the fuse panels. Is it possible i burned the module DRL module?
View 9 Replies