Corolla / Matrix 2009-13 :: Hissing Noise After Brake Pads Changed
May 19, 2014
I changed out the brake pads, now it is making a hissing noise. I bled all the brakes starting from the back. Here is the video : [URL] .....
View 2 Replies
May 19, 2014
Advertisement
Corolla / Matrix 2009-13 :: Changed Rotors And Pads - Car In Limp Mode And Won't Shift Out Of 3rd Gear
Today I decided to change my rotors and pads out.. Got everything back together and i believe car is in limp mode.. It wont shift out of 3rd.. Abs light on ,check engine light, traction control and stability control light on.. Also my speedometer doesn't work but my rpm"s do...hooked up scan tool and comes back as wheel speed sensors.. I never touched them or removed them....
View 3 RepliesCorolla / Matrix 2009-13 :: How Good Is Ceramic Brake Pads
i have a 2010 Corolla XRS and was wondering the following:
-How good are ceramic brake pads?
-Do they last longer than normal OEM pads?....under normal driving.
I was considering buying a complete set of drilled rotors and ceramic pads for my car.
Corolla / Matrix 2009-13 :: Brake Pedal Spongy And Making Hissing Sound
2009 XRS ABS brakes .... I changed all four brake pads and flushed out most of the old brake fluid. Bled all four sides. But now while I am in idle (like waiting for a light to turn) my brake pedal is spongy and is making a hissing sound. All was good before I did this job.
View 3 RepliesCorolla / Matrix 2009-13 :: New Brakes Rotors And Pads - Grinding Noise When Turning
I performed brake maintenance today with my brother on my 2010 corolla CE, my front rotors were warped and my pads were used ( and also uneven) and I replaced both front rotors and pads.
The install went smoothly, my brother changed a couple of brakes sets and knew what he was doing and showed me up.
Took it for a spin, the brakes work very nicely ( i bought the ceramic wagner bundle ) but theres a slight grinding noise when driving, like the pads are touching and rubbing a bit too much on the rotor, but the driving is unnafected. Also, there's a sqealing noise coming from either side when you turn only.
Braking itself produces no noise whatsoever, only when you turn that it squeals.
Corolla / Matrix 2009-13 :: Rear Brakes Pads Sticking / Wearing Quickly?
At about 25,000 miles I had one of my rear brake pads sticking so had to change the rear brakes. The non-stuck pads on the other side looked decent still, so I'm assuming I'd have gotten quite a few more miles out of them if the one hadn't been sticking. Changed the front pads at about the same time, although they were in pretty good shape still (but it was taken apart already, so did them while it was apart and the chance was there). At about 50,000 miles later the rear pads are again unevenly (and I feel perhaps prematurely?) worn, and the fronts look fine. Is it something with the screw-type e-brake mechanism on the rear disc brake that lends itself to sticking? Or am I just especially unfortunate?
View 10 RepliesCorolla / Matrix 2009-13 :: 2010 - Metallic Pads Cause Premature Pedal Shudder?
I bought my 2010 Corolla 5 years ago with 17,000 miles on it. Since then I've put on about another 46,000. With 63,000 miles it needs it's 4th set of rotors due to brake pulse and shudder. We live in the prairie and I'm not hard on brakes. The brakes have never felt like my 05 Corolla.
Can this be caused by too aggressive of brake pads?
Corolla / Matrix 2009-13 :: On Cold Startup Car Makes Loud Hissing Sound Then Runs Normally
It has happened three times now on cold startup my car makes this loud hissing sound then the car runs normally. Once a few months ago. Again a few weeks ago and this morning it was pretty cold maybe low 50's. I normally turn the key in the ignition to the "acc" position let it "ding" once then start the car. What could this loud hissing be that only happens on cold startup then the car runs like nothing happened? I called my local mechanic and he said he wouldn't know if he can't recreate the sound. Which you really can't because it happens once every blue moon but I wanna make sure I'm not ignoring a problem that could get worse.
View 9 RepliesCorolla / Matrix 2009-13 :: Rear Brake Making Noise
I have a 2009 matrix 1.8 automatic with 103,000km on it. The brakes were making a noise so I pulled off the front wheels and inspected and cleaned the front brakes which were in great shape. I pulled the rear wheels and found that the outer disc pads were wearing on about a 30 degree angle. The inners were just fine! I've been doing brakes for over 40 years and have never seen this! Also, the rears don't work hard and should outlast the fronts by at least 2! I called Toyota Canada and they blew me off until I asked to talk to someone higher up! They are doing a technical review, but I believe they will tell me it's just my car! I think it's a design flaw!
View 13 RepliesCorolla / Matrix 2009-13 :: Buzzing Noise After Replacing Brake Fluid
Last Thursday Nov 22nd, I took my 2010 Corolla for a regular oil change service by an Toyota agent. The service representative recommended to have the brake fluid replace since it had already 39000 km since new. I agreed.
The same evening, I start hearing a strange high pitch noise from the front while braking light at low speed. It does not occur all the time. I did a search in this forum about the brake noise.
That strange high pitch noise could come from the ABS actuator when it activates or modulates at that light braking.
I did a visual check on the bleeding nipples of the brakes today. It seems that the two nipples for rear brake were untouched and this would mean they did not bleed the rear brakes and air could be trapped in the rear brake lines.
Will take the car back the Toyota service. As search from our forum, the cause for the abnormal modulating of the ABS actuator could be :
(a) a bad speed sensor or
(b) air trapped in the brake line.
Since it starts at the same day of replacing the brake fluid, the most likely cause is air trapped in the brake line.
Sonata NF (2006-10) :: Changed Brake Pads And Pedal Hits Floor?
So I took the pads off and saw pistons that push caliper against rotor were to far out to install new pads. (rear pads were still intact, both front pads were out when i pumped) So im pumped the brakes thinking it would reset them and alls it did was push the fronts out more.. I noticed fluid leaked out of the pistons after fully pushing them out.
After seeing that pushing the pedal only pushed them out and didn't reset them, i pryed them in with a C wrench. Was quite difficult but managed to do it. Note I only did this on the front pads..
Rear was just fine, piston went back in easily. I filled brake fluid fully and still does it - Now pedal hits the floor when i first hit it and seems very light when braking.
Corolla / Matrix 2009-13 :: ABS And E-Brake Light Go On Randomly
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 RepliesCorolla / Matrix 2009-13 :: Brake Reservoir Cap Popped On
Our brake reservoir cap is rubber, and just pops on. There's a little top hat on top of that that plugs the tiny little breather in the actual cap. I lost mind down in the depths of the engine bay.
View 2 RepliesCorolla / Matrix 2009-13 :: Shakes When Brake On The Freeway
I have an 09 corolla S with 119000 miles.
My car shakes when i brake on the freeway and I just got new tires so Im sure it must be the rotors.
Is it better to just get new rotors or have a shop machine the old ones down.
Which way is more cost effective?? and how hard would it be to install them myself?
Corolla / Matrix 2009-13 :: Brake Pedal Working On Low Position
On my 2010 s ,my pedal brake begin to work on low position, I have 35000km it is normal? my wife hate this car because this.
View 4 RepliesCorolla / Matrix 2009-13 :: Right Rear Brake Pad Is Wearing Unevenly
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
Corolla / Matrix 2009-13 :: Squealing And Screeching When Brake In Reverse
So I have a 2010 corolla s with 30k miles. I replaced my rotors and pads about 2 weeks ago to get rid of this problem. The problem was gone for a week and now it's back. I get tons of squealing and screeching when I brake in reverse.
View 5 RepliesCorolla / Matrix 2009-13 :: Intermittent Front Brake Squealing
Basically, whenever I brake, my front brakes squeal. But they only do this if I use about 25% to 33% force. If I press on the pedal harder, the squealing goes away and the same if I reduce the force.
I replaced my pads with Wagner ThermoQuiet pads in March 2015. The noise started a month or 2 after replacing my pads, and I've only put about 12k miles on them. I had my car in a couple weeks ago for an oil change, and the inspection showed that the pads still had plenty of life on them. I brought it up to the service advisor, and he suggested that my rotors might be warped and need to be machined. The problem with that is I feel absolutely no vibration in my brake pedal that would indicate warpage.
So the only other thing I can think of is the shims might be causing the noise. I was going to get some grease and apply that and see if it works. Also, when I was replacing the pads I bled out a little more brake fluid than I intended. But it hasn't seemed to affect my braking ability so I ruled that out.
Any guesses for what might cause this? Like I said, I have plenty of material left on the pads and I can stop without problems, so it's not a safety issue, just a tad annoying.
Corolla / Matrix 2009-13 :: ABS / Traction Control / VSC Off Flashing - Brake Went On
My Abs traction control vsc off (keeps flashing) and brake light went on in my 2010 corolla....
View 2 RepliesCorolla / Matrix 2009-13 :: Rear Brake On Driver Side Squeaking
My 2009 Toyota Corolla LE is squeaking. The noise is coming from its rear break -- driver side. It happens only at a low speed when pressing the brake half way to slow down the car until it stops. Only 60-70% of the time though that it has the noise and only when going slow in the traffic and hit the brake. It doesn't seem to squeak on the highway.
The car has about 40k miles. I've heard that the rear brakes suppose to last ~100k miles. My questions and concerns are:
1. Is it too soon to replace rear drum breaks?
2. How to check the rear break pads to see if I really need to change them?
3. Are they just dirty? How to clean the rear breaks?
4. Finally, if I really need to replace them, how much does it cost in general?
I wish they were dish brakes -- so much easier to replace them.
Corolla / Matrix 2009-13 :: How To Attach Brake Line Or Abs Sensor It Rubs
i have Ksport kontrol pros and no mattter how i attach the brake line or abs sensor it rubs! how to rout them. i bought 3/8 heater hose for the brake line and spliced it to make a sleeve. sway bar endlinks used to pinch the ABS against the coilover but now it rubs the cv axle. 09 rolla s
View 2 Replies