Corolla / Matrix 2009-13 :: Gear Grinding Noise For Approximately One Second Immediately After Startup
May 13, 2014
I have a 2010 S with 70,000 miles. At 60,000 miles, just after the warranty ran out on me, I started to get a gear grinding noise for approximately one second immediately following a cold startup. It doesn't happen all the time, but I'd say once out of every eight starts on cold mornings after it's been sitting. I researched the issue pretty extensively and it seems to narrow down to the cam timing gear being the issue or a bad starter relay. The 2009's had a TSB for the issue being a cam timing gear, but the dealer assures me that my vehicle is not one of the ones covered by the TSB.
I'm inclined to try the relay fix, since a new relay is only $60. The thing is, I would hate to install the part and find out that the issue remains and then be out $60. Any identical relay elsewhere in the car that I can swap it with to see if that work. Of course, if the relay is bad, I'd be breaking something else possibly. Or, even better, is there a way to test the relay to see if is the cause of the problem?
View 14 Replies
Advertisement
So the grind in 3rd gear is getting pretty bad. I have to put it into third slowly and 4th sometimes grinds a bit. Could it be the slave or master cylinder?
View 8 Replies
I just got my '09 Corolla last night and it's doing something I'm not sure it is supposed to do. When I go out to my car I press the unlock button and open the door. A beeping noise starts immediately before the key is even in the ignition. When I do put the key in the beeping continues and does not stop until I close the door. The car I had before this was an '89 Corolla so I don't have any experience with these keyless entry things.
View 14 Replies
My corolla has been making this noise since I purchased it January 2013. I haven't been able to figure out any variables as to why it makes the noise, it can happen at anytime. It doesn't happen often, but I would like to know if this is a quick fix.
[URL] ....
It is this exact same noise.
View 5 Replies
I hear a loud screeching noise (like a loose belt) when the 2009 Corolla starts cold. It disappears, and when the car gets a little warmer, it's gone. I had the belt replaced, made no difference. Car runs fine, otherwise.
View 3 Replies
So ever since I bought my car in April, I hear this noise when I accelerate. It only happens when I first start the car. Its a grinding light noise but you can definitely hear it when you are in the car. I only hear it when after I start the car, go reverse, and right after I step on the gas on drive. Today I took it in for my 10k service and told the Assistant Service Manager about it. We went and took my car for a test drive and now we also hear the noise right after we he start the car then reverse.
View 11 Replies
I have a 2009 Corolla with 67k on the odometer so it is outside of warranty. I recently found about the TSB for the grinding noise on start up and took the car to my mechanic to have it looked at. He said he wasn't able to do the job because he would have to do some sort of computer update (ECU reflash?) and he doesn't have the means.
My car is currently at the dealership, and they want around 1800 dollars, 1400 for the VVTI gear, and another 400 for a tensioner. I have a friend who used to be a Toyota mechanic, and he says he can do the work as stated in the TSB, but he's unsure if the ECU would need updating, and it does not mention anything in the TSB. So what I am wondering is if :
1. Does changing the VVTI gear actually fix the grinding noise? I was reading an old thread where members said it was still there after having the TSB done.
2. Does there need to be anything done to the ECU after doing the TSB?
View 7 Replies
I have a 2009 corolla S. no warranty. 59k miles. my car gets a grinding noise whenever i start it. this is the example of the sound.
YouTube ....
View 14 Replies
I've been having this issue with my 2009 Toyota Corolla for some time now. When I turn the car on, there is a noise coming from under the hood that sounds like a screeching/grinding noise. I have captured the noise in this video: [URL] ....
It happens most times I turn my car on in the morning, after it has been sitting off and untouched for the night. When I am turning the car on afterwards throughout the day, the noise is less likely to appear.
I recently took my car in and got the water pump and belt replaced, because a few months ago I was driving down the highway and I heard a similar noise coming from under the hood, and I opened the hood and red coolant liquid was splashed everywhere. I am not knowledgeable about cars at all, but the dealership replaced the water pump and the belt and that seemed to fix that issue, but the grinding noise upon ignition is still there.
I took it into the dealership, but they were not able to replicate the issue because it had not been the first time the car was turned on for the day, so there was no grinding noise. I would like to know if it is the water pump or belt, since those are still under a 2 year warranty with the dealership. Otherwise, I need to know what this is so I can get it fixed.
View 6 Replies
I hear a loud screeching noise (like a loose belt) when the 2009 Corolla starts cold. It disappears and when the car gets a little warmer, it's gone. I had the belt replaced, made no difference. Car runs fine, otherwise.
View 1 Replies
Sometimes when I start my car it makes a weird cranking/grinding noise for half a second. The closest thing I have to engine mods are my TWM short shifter, and my borla axle back exhaust.
The noise only happens after my car has been sitting there, parked for a few hours. So to bring it to Toyota/mechanic would be nearly impossible to replicate, unless I left it there for a while. And even then, the noise only happens sometimes.
Yes I'm pressing my clutch pedal all the way down. No I am not holding the key too long when starting the car. What it might be?
View 14 Replies
I performed brake maintenance today with my brother on my 2010 corolla CE, my front rotors were warped and my pads were used ( and also uneven) and I replaced both front rotors and pads.
The install went smoothly, my brother changed a couple of brakes sets and knew what he was doing and showed me up.
Took it for a spin, the brakes work very nicely ( i bought the ceramic wagner bundle ) but theres a slight grinding noise when driving, like the pads are touching and rubbing a bit too much on the rotor, but the driving is unnafected. Also, there's a sqealing noise coming from either side when you turn only.
Braking itself produces no noise whatsoever, only when you turn that it squeals.
View 4 Replies
I have a question about my 2009 Toyota corolla. About a week ago it was pretty cold out and when I started my car and I heard a grinding type noise for just a split second and it was over. It never did it again after that. Well I went to start my car yesterday and it will not start or even turn over. The dash doesn't light up, the head lights, radio, windows are door locks will not work. The battery was checked and it's fine. My husband is thinking that it maybe the ignition switch. Does this sound right?
View 3 Replies
It's a 2012 Corolla. I disconnected the battery and the 2 grounds where the fender mounts in the front. I did this to do some body repairs. When I reconnected everything, the car started, but immediately shut off. What is wrong? Is it a computer issue where it needs to relearn?
View 5 Replies
...... 2010 Corolla LE 1.8L ...... View the video I uploaded ....... The noise is seems to be getting worse. My first thought is the bearings in the water pump may have failed. I'm also thinking that there isn't adequate lubrication near the gear assembly or the belt. Could there be a problem with the tension in the belt?
View 7 Replies
I have a 2010 Corolla XRS that been flawless until today. This morning I moved my car in my yard, it was about a 20 second adventure and all was good. About 2 hours later, I went to use the car and it wouldn't start. Now it just starts then immediately dies. If I try and crank it over without turning off the ignition, it just cranks. If I turn off the ignition and try again, it starts, then dies again. This is 100% repeatable.
Battery posts and voltage are good. No OBDII codes. Fuses all look good.
View 7 Replies
I have a 2009 Toyota Corolla and it's making a loud grinding metallic noise on the front left side. It does it while I drive the faster I go the louder it gets. When I turn to the left it makes it louder, when I turn right the noise decreases. PG&E have been breaking the roads by where I live and there's a lot of little rocks I drive thru. I'm wondering if that's the problem?? What do I do?
View 4 Replies
I bought a new corolla 2009, automatic transmission (Not Robotic!) From the first day, when shifting from first to second gear the car makes an unnatural noise, like a whistle or a whine. (during shifting and sometimes a little bit before).
It only happens in the transition from first to second. It does not depend on the RPM at the moment. When the engine is cold, in the morning, the sound is still there, but weaker, when the engine warms up, the sound keeps appearing for the rest of the day. (I live in a country with a hot climate)
I have been told, 2009 model has the same transmission just as previous models, is it true? or there have been some changes in it?
View 10 Replies
My 2010 LE has been having this issue for a little while now. Whenever I start up the car when the engine is still warm, (an hour or two after initially driving it), the engine will sputter for around 3-4 seconds, but will always start up. On cold starts, like every morning, the car will start normally. There are no noticeable rpm problems while driving either.
View 2 Replies
So I just traded my old car in for this one and I've had it maybe a little over a month. Anyways, when I go to start it now, even if I just turn on the main power and let the radio start up and the computer and then turn the engine. When it turns, majority of the time it will "squeal" like there something might be going wrong with a belt in there. I know that the timing belt should be changed once every so many miles, just not so sure on my vehicle. Also, if it could be anything else besides that.
View 1 Replies
2009 Matrix 2ZR-FE, briefly rattles on restart after sitting for one hour after reaching running temp. This engine doesn't rattle on a cold startup so I'm wondering what else other than the intake cam gear could cause this. 42,000 miles, 5-20 dino, regular service.
View 14 Replies
