We got a lot of snow here in the last 72 hours and so driving on the roads has been a bit more slick than usual.
But last night I found a patch of snow that I thought I'd test my traction on (lots of room, nobody around, etc.) and while the ABS worked very effectively and I stopped with full control... I noticed my exterior lights dimmed a fair bit.
Is this a normal thing? Never seen that before.
I have a magnetic grey '10 Corolla LE and was wanting to do mods to my car to customize it and make it look better. I'm extremely new to this and was wondering what you all recommend for certain things like the headlights, tail lights, touch screen radio, etc.?URL....
View 3 RepliesThe issue is I drove a few km's with the handbrake engaged in my moms 2nd gen matrix. I reasoned that it was showing me the exclamation mark and beeping to tell me the fuel was REALLY low, so I assumed it was going so hesitant to go to save gas...............
I drove a few km's slowly, and when I got to my street I stepped on the gas as a "hell yeah I made it", only to come out the car to see the rear brakes smoking all over the place.
Only about 20 minutes after I came home I realized what happened, (don't even ask what my reasoning for breaks smoking was this time) went and disengaged the handbrake, but now about 5 hours later I just saw my mom leaving in the car and there was a slight creaking sound coming from what seemed to be the rear.
Could the handbrake being engaged for another 20-30 minutes after the breaks getting so hot from all the friction potentially WELD the drums to the other part of the brakes? I hope I didn't mess up the wheels or the parts they are sitting on.
I have a 2012 Toyota Corolla LE (automatic transmission) with 90000 miles on it.
For a long time now I have dealt with a whining sound in my 2012 Toyota corolla. The symptoms are that the sound only happens when the accelerator pedal is slightly engaged. This happens at any speed. At the slightest push of the pedal a whining/spinning sound happens and if you maintain pedal engagement the sound of whining/spinning continues. The sound goes away instantly when the pedal is depressed and will again come back when engaged subsequent times.
I have been researching on the internet and I seem to be pointed in the direction of the transmission fluid to change from the Toyota Genuine ATF WS currently being used in the 2012 Toyota Corolla as the stock transmission fluid to Redline D4 as others have experienced a similar noise problem in 2010 corolla models and have made the noise go away by using the Redline D4 because of viscosity differences. I am not sure however if the same transmission model (U341E) is being used in all Corolla models.
My center console, gear lights, and steering wheel control buttons are not illuminating. Could it be a fuse? If so, which one would it be? I looked through the fuse section in the manual and could not find anything about it.
View 2 RepliesI got a 2009 Corolla LE and I am wondering if the a/c dial lights up with the dash lights? Its been a while since I've been inside the car but I have this feeling that the dial used to light up. The dial has an on/off push button to activate the ac. That ac button does light up when depressed, the rest of it does not. if the dial does indeed light up, how would one fix this? is there a fuse or something just for the dial?
View 4 RepliesI have the code P0500 on my 2009 Matrix. The odometer doesn't function, all error lights are on, the power steering is not completely out but it's reduced. Also, the rear windshield wiper is constantly on. I replaced the vehicle transmission sensor today because I thought that would fix it all. It had absolutely no effect.
View 5 RepliesAt night, when I turn the key to "on". The stereo light (orange)'s illuminated but no light coming from the dashboard. Other lights on the dashboard -- e.g. engine check, oil, door indicators are fine. When I start the car, the stereo light's gone away and I still have no dashboard lights. I tried to change the channel, put in a CD, increase/decrease volumes but none of those activated the light. All other functionalities seem to be working fine.
I checked the fuse box under the dashboard console. All fuses look good to me. What might be going on or I just simply have bad dashboard light bulbs? What's about the stereo lights?
We just purchased a used 2010 LE model a couple weeks ago and for the first time actually drove it during the night. So I decided to check out how the fog lights look. Problem is, when I turned them on it didn't light up any of the road between the low beams and the front bumper of the car. In fact acted kind of acted as high beams. They are currently aimed higher than my low beams!!!
This doesn't seem right to me.
- Were the lights installed upside down?
- They should be lighting up the area on the road between my low beams and front bumper correct?
- Is it possible that they are able to be aimed that high if installed correctly?
I replaced my tail lights tonight once finished I clean up my mess and decide to go grab dinner.
Started the car, VSC flashing along with ABS light on... Did I blow a fuse when I turned the car on from the new tails?
Just purchased a 2009 Matrix XRS Manual transmission with 67,000 miles on it. I can't get the VSC Off and Traction lights on the panel to go out.
During our test drive, I had turned the system on and off to make sure it was working, and didn't seem to have any trouble with it.
I went to have it inspected yesterday. During the test, they hook up to the ODBII port to check emissions. The tech had trouble getting it connected the first time, saying the connection was going in and out. Eventually, they were able to get it connected properly and passed the inspection.
After they pulled the car out of the bay, the VSC Off and Traction lights were solid on, and they have been every time I've started the car since. Checking the manual, all I should have to do to turn the system back on is press the traction button, but that doesn't seem to be working at all. I also tried holding it down for 30 seconds or so with no luck.
The lights aren't flashing, so I don't think this is an error, I'm wondering if the computer got confused somehow with the ODBII port issues.
Stuff I've tried:
1. Followed these instructions for the Highlander Hybrid thinking maybe Toyotas will generally do this. That just caused most of the lights to flash on the panel and didn't bring up any VSC diagnostic messages.
2. I pulled the panel from the dash out to check to make sure the button was working, and I do get connectivity between the two outside pins while the button is pushed in.
how to get this to reset, or what the problem might be?
The LED Daytime Running Lights are at maximum brightness when the headlights aren't on. When I turn on my headlights, the LED Daytime Running Lights dim down drastically. Is there a way to make the LED Daytime Running Lights not dim down when I turn my headlights on?
View 3 RepliesI have a 2009 with the 2.4L, 130Kmiles. I have engine shudder at idle and upon deceleration only. No check engine light so no codes-ran a hand held scanner no codes. Cleaned the MAF with MAF cleaner, pulled the spark plugs/coils and swapped them around- still getting shudder and no check engine light. Only thing I noticed is the spark plugs were dry to very wet with oil going right to left. Car was parked on level ground. I am completely stumped.
Other thing is I just got the car back from the dealers to fix the clock spring airbag recall, and the vsc light popped up on the drive home. I did call them but afraid the car will not make it there and my wallet might go on a severe diet after. Out of warranty and dealer said if it is their doing because they knock something loose while fixing the airbag clock spring there will be no charge otherwise it's 129 just to look.
I am planning on adding fog lights to my Corolla 2011 LE.
I am considering this one ....
and these LEDs for my license plate ....
Was driving the other day then suddenly fog lights stopped working, I changed the bulbs still wont work, so I checked the fuses to make sure all was ok, and everything was perfect. And now I am completely lost, have no clue what to check to make them working..
View 3 RepliesI recently bought a 2012 used Corolla LE from a dealer and i've noticed that when I drive at night the lights don't turn on automatically. They daylight running ones are one, but the actual headlights used for night-time use don't come on automatically. I'm able to turn the on automatically by just turning the switch, but I'm just curious why they aren't turning on automatically. I mean they're supposed to right, since its a standard feature nowadays?
View 14 RepliesI'm trying to remove the airbag so I can get to the steering wheel lights to change them. I took the covers off of each side of the steering wheel, expecting to find T30 torx screws to take off so that I can remove the airbag, but there seem to be no screws at all holding it in! Am I missing something here? Will have pictures in a couple minutes.
Not sure why my pictures aren't working, here are the links :
[URL] ....
[URL] ....
I haven't been on in a while due to my laptop breaking on me well recently i purchased the V3 triton switchback from vleds as well as just red V3 triton leds. After the install i blew my flasher fuse which i replaced then when i attempted it again i must have blown something else because my corner lights no longer go on and when i turn my lights on i no longer get the sign on the cluster notifying me that they are on. I have removed the lights and the issue was i did not order ck socket adapter. So what i have done so far is checked all fuses and i have nothing burned under the driver side and under the hood. I must have looked over everything 10 times checked all fuses with a test light and i don't see anything with DRL or Corner lights labeled anywhere on the fuse panels. Is it possible i burned the module DRL module?
View 9 Replies2012 Corolla S with 84000 miles, for the last month the check engine and trac off light keeps coming on randomly. I disconnect the negative battery charge and wait 10min and reconnect and it goes away. I havnt counted how many miles I go until the light come back on. But since the last time I disconnected the battery my car has been on for 8hours on the engine time. I had them scan it at autozone and the car is throwing two codes one was the MAF and I can't recall the other.
View 5 RepliesI have a 2010 Corolla LE w/ about 90k miles. I took it to work. parked. Went back to car. Engine cranks. Won't start. Lights are bright. Radio on. Jumped it and it started up no problem. Took it and got a brand new battery. turned car on and it worked with no problems. took it home. next day went to work. started w/ no problem. After work, started with no problem.
NEXT DAY... Engine cranks again....won't start. Tried to jump it again but NOTHING.
(also, just want to mention there is no history or indication that this was gonna happen. no jumpy starts...no shaking...nothing.)
Someone came out and checked: alternator, battery, starter, everything checks out good and working.
Spark plugs: GOOD but no spark...thought it might be crank sensor. Tried to change that out, still won't start.
In the midst of all this my key was acting up. finally it broke out of the lock part....the actual key separated (not broke) from the alarm part. i went to go make a duplicate w/ the key part and tried the duplicate key and it still won't start. do these things have a chip in them that activates the crank sensor? I've been w/o my car for about a week and i feel as though it's right in front of me.
I'm having a few issues I have 2010 corolla le.
For some reason when my daytime running lights are on my rpms drop to 600 rpms and I get a rough idle. My needle jumps up and down. Happens when car is warmed up. Once I turn my low beam on rpms go up to normal 800 rpms. No rough idle and car runs normal.
Yesterday I was parked with radio on ignition off for about 10 15 min and turned the car on and idle went really low. I Rev it up and the needle dropped to the bottom before going up. Hesitating. Did the same a 2nd time needle dropped all the way down and car shut off. I shut the car off and turned it back on and car was hesitating. Then after a few revs car was normal.
Car is running fine now no light on my dash.
Is it a throttle body problem? I cleaned throttle plate recently it's not dirty.
I'm wondering if I should replace throttle body?