Corolla / Matrix 2009-13 :: End Link Tab On Front Right Coilover Bent
Mar 4, 2014
So last week I bought and installed a set of Megan EZ street coilovers for my 2011 corolla s. Everything was installed correctly and I lowered them as far as they would go without messing with the spring preload. They don't rub and I don't bottom out and everything was going fine until I pulled the wheels off to re plasti-dip them. At this point I noticed that the end link tab on my front right coil-over was bent. After doing some research I have found that this is a common problem when you lower a car and don't adjust the sway bar preload with adjustable end links. However I have looked high and low on the internet and cant find adjustable end links for a 2011 corolla. I can try and bend the tab back before it breaks or if it does break I can re-weld it back on but I don't want the problem to persist.
View 10 Replies
Advertisement
I just installed BC BR type coilovers on my 2010 Toyota Corolla S and now even driving at 55 on a smooth highway my car is a bit bouncy. Its really bouncy if I hit a dip or hole. The dampening setting is still at factory setting which is 8 clicks from full hard. I haven't lowered the car anymore than just putting the coilovers on so its about .5-1 inch lower than stock I would say.
View 11 Replies
I just got my bc extreme drop kit installed, after taking out struts i imagined my corolla would be lighter and faster cuz the struts weigh way more than the coilovers, but when i drove it for first time after install, i noticed the acceleration is weaker and not as responsive, why this is? is it supposed to be like that, whats happening?
View 5 Replies
Recently purchased my first Toyota, a 2012 Corolla S with 76,000 miles on the ODO. I have a concern about a front end rumbling.
First, the problem...
This "rumble" (the best way I can describe it) starts becoming noticeable around 20-25 mph, depending on the condition of the road I'm on (it could be lower, but I'm in Michigan, all the roads are bad here). This rumble isn't a noise, but more of a low frequency sensation that can be felt in the car and through the steering wheel, and vibrates the rear view mirror. The rumble comes and goes, it isn't constant. Sort of like driving over a rumble strips put on roads before stop signs/intersections, it seems to have an oscillation to it. The rumble intensifies very little with speed. It doesn't seem to oscillate any faster or rumble much harder, it's just there.
Things I've ruled out...
Brakes. When I bought the car, the first thing I noticed was that the front brake rotors were slightly warped, so I installed new rotors and good pads. That didn't get rid of the problem, though I didn't really expect it to.
Tires. The previous owner had seriously over-inflated these tires. Once taken down to their proper pressure, they were noticeably cupped down the middle. These tires were also horribly noisy would not balance, so brand new tires went on (Michelins). The new tires greatly improved the ride, reduced noise, and got rid of a lot of other shakes and vibrations, but the "rumble" remains.
Wheel Bearings. I'm not 100% on this one, but as far as I can tell, it's not the wheel bearings. I've taken the car out on twisty roads and there is no change in the rumble through hard turns, nor any additional vibrations of any kind. Usually bad wheel bearings will exhibit some noise or vibration when being loaded in a turn, but not in this case, so I've ruled them out.
Things I'm not sure about...
CV Joints. I've never had a CV joint go bad or fail on me, so I am unfamiliar with the common signs and symptoms. I have inspected the boots, and they appear to be in good condition and crack free, though that doesn't mean a joint isn't failing. There's no clicking during slow sharp turns, but I think that would only present itself if an outer joint was failing. I'm going to get the car in the air this weekend to do a drain and fill on the tranny (the fluid is getting pretty dark, so I want to get some new in there).
I drove a Ford Focus for the past 10 years and a Ford Contour for 10 years before that, putting over 200,000 miles on both, and never experienced any sort of problem like this.
View 8 Replies
My Axles started to make noises couple months ago While making Sharp turns. I bought some new axles for the front, but this will be my first time replacing CV Axles.
Any tips and or recommendations on what to do and not do, and tools to use? I watched a couple Youtube videos already. I plan on changing them out this weekend.
View 1 Replies
There Is a click in my front wheels that is audible as I slow down. What is going on. nothing else is wrong with the car. I have a 2013 corolla le....
View 3 Replies
Speaker brackets and bracket preparation.
View 2 Replies
Basically, whenever I brake, my front brakes squeal. But they only do this if I use about 25% to 33% force. If I press on the pedal harder, the squealing goes away and the same if I reduce the force.
I replaced my pads with Wagner ThermoQuiet pads in March 2015. The noise started a month or 2 after replacing my pads, and I've only put about 12k miles on them. I had my car in a couple weeks ago for an oil change, and the inspection showed that the pads still had plenty of life on them. I brought it up to the service advisor, and he suggested that my rotors might be warped and need to be machined. The problem with that is I feel absolutely no vibration in my brake pedal that would indicate warpage.
So the only other thing I can think of is the shims might be causing the noise. I was going to get some grease and apply that and see if it works. Also, when I was replacing the pads I bled out a little more brake fluid than I intended. But it hasn't seemed to affect my braking ability so I ruled that out.
Any guesses for what might cause this? Like I said, I have plenty of material left on the pads and I can stop without problems, so it's not a safety issue, just a tad annoying.
View 3 Replies
I have a 2010 Corolla with 32K miles and I hear this humming or low groaning rotational noise that seems to get louder with faster speeds over 40 mph. If I turn to the right above 40MPH around a curve in the road, I hear it a lot louder and it oscillates in and out. What it is? I had it checked at the Toyota dealer and they said there was no issue with the wheel bearing but since the noise is still there today, I think I have to take it back. Is this something I could troubleshoot with the car parked?
View 14 Replies
I have a buzzy, vibrating speaker in my right front door. Is the speaker itself shot or is it just loose? Or does the plastic door panel vibrate against the steel door. Placing my hand on the door doesn't seem to reduce noise ( 2010 Corolla )
View 2 Replies
What are the front speaker cutout dimensions. I think I read somewhere that it was 5 and 9/16" but how to verify this. I'm trying to put 6 3/4" speakers in there and was wondering if they will fit?
View 10 Replies
Tomorrow I'm taking my car in to have them look at my transmission. I started noticing that whenever I put the car in first, it almost feels like the front tires are skipping off the ground. It does the same thing when I put it in second. At first, I thought it might have been caused by my 18" rims, so I switched over to the stock wheels. Same crap.
View 12 Replies
I checked my pads today and noticed that the drivers pad is worn about 50% more than the passenger in the front. What could be the problem??
View 5 Replies
I have a 2010 Model S that has 38,000 miles on it. I am hearing a rattling in the front brakes when cruising along at almost all speeds. If i hold a little peddle pressure it goes away. Sounds like the pads are rattling to me. I am running the stock pads with about 45 to 50% remaining on them.
View 6 Replies
So while I was driving I thought I heard a rattling. I checked under my front bumper and there is this piece dangling kind of on the driver's side in front of the radiator. What is this piece? It is initially connected towards the front bumper.
View 2 Replies
My wife's 2010 Corolla has an issue where the key fob will open the truck and all the doors except the front driver door. Is this a common issue with the Corolla? What are the potential fixes?
View 2 Replies
I have a 2009 toyota matrix that as over 140,00 miles when I drive down the road the front passenger side bounces up and down. There is no difference in speed from 25 all the way up to 60 plus.
View 2 Replies
Got a 2010 Corolla S (105k mi) . I have a noise in the front end. I hear it occasionally when I'm braking, and other times when I'm turning left. Just started tonight. I really need to get this fixed before I go out of town in a few weeks. Don't want to leave my wife with am unsafe car.
Anyway the sound varies, sometimes it's more noticeable then others. The first time I heard it I thought I ran over something metal. It has a sound as if someone pulled on a bar and let go and it sprung into place.
The sound is in this short video, don't worry about seeing anything, but you can hear it at the end.
View 2 Replies
I would like to install a usb power cord that would somehow run out from the front of my dash (near the windshield). How difficult is this and have others on this site done it (links)? I would like to route the wire to either my GPS or cell phone mount and not take up a cigarette lighter plug.
View 1 Replies
I have a 2009 Corolla S and the symptoms are as follows:
1. Normal forward driving, brakes work fine (and as expected without sound).
2. In reverse, when I apply the brakes I hear a click (clunk) sound from the front brakes. It only makes the sound when I'm going from moving to stopping (IE: I cant just keep pressing the brake once stopped to generate the noise). But if I let myself continue in reverse and press pedal again, it will make the same sound (very repeatable). I don't need to go forward to replicate the sound, I can just stay in reverse, stop (CLICK), continue in reverse, stop (CLICK), etc.
3. The it's noticable in the pedal. I can feel it on the brake with my foot when the noise happens.
4. It happens when I depress the brake pedal about 1/4 down, a gentle stop. And usually happens every time when I back out of my driveway or parking spot.
5. GF's sister's 2009 corolla CE does NOT make this noise in reverse.
6. 20,000 miles, Orig tires/brakes, didn't happen 4ish months ago.
I plan on putting winter tires on next month. Perhaps I'll take a look at the pads to make sure they aren't moving around, but wouldn't I also hear the noise in forward motion? Or when I switch from forward to reverse?
View 13 Replies
Vehicle: 2009 Toyota Corolla
Mileage: 55000 kms
I am recently experiencing some weird squeaking/creaking noises coming from my front suspension.. It manifests whenever I am going over humps faster than usual (or if the humps is not "perfectly sloped"). I seldom experience this during daytime but during nighttime, it is very evident.
this is the list of things that I replaced already:
2x ball joints
2x stabilizer links
2x shock absorbers
2x tie rod
2x rack ends
Did some wheel balancing and wheel alignment already...
I was able to replicate this by parking the car in a slope - parallel to the street with the wheels turned to right or left, and pushing the top fender downwards.
Driving along our streets, highway, and highway curved ramps is flawless.. Could this be bushings on stabilizer bars? or the control arms?
View 1 Replies
