Corolla / Matrix 2009-13 :: Dome Light Timer Adjustment?
Apr 21, 2015
Is there a way to adjust the dome light timer? I want it to stay on longer than it does.
View 1 RepliesIs there a way to adjust the dome light timer? I want it to stay on longer than it does.
View 1 RepliesIs the battery draining if you leave the door open all the way with dome light off?
View 1 RepliesI got Corolla 2012. Dome light fuse 10 amp is blowing off as soon as you put it in. Light bulbs checked seems it is not a problem. Maybe relay?
View 11 RepliesIs there anyway we can adjust our throttle or gas pedal? Cause when I press down on gas, it doesn't open until about an inch down the pedal. Pretty much, I just want the throttle to be more responsive.
View 7 RepliesI have two 2004 F350s. In both of them, the dome light stays on for roughly 10 seconds after I shut the door, and also comes on when I shut off the engine. I HATE this feature! Is there any way to disable this? All I want is the light to come on when I open the door and go off when I shut it. Nothing else.
I read something about some computer setting on this for police vehicles, but I'm not sure if or how that applies to my 2004.
What the problem is? still drive-able?
View 14 Replies2010 Corolla LE ... This started today, on the ride home from work. Mid 50 degrees, light rain, driving down straight road it started. Engine light also on. No mods in car. is this something the dealer has to se, or can I bring it to my own mechanic?
View 1 RepliesOne of my light bulbs for the rear license plate light is out.
what kind of light bulb I need to get?
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 RepliesSo I bought and installed bc coilovers and my abs light and 2 other lights came on. I did accidently mess up one of the wires on the front left strut but it is not torn in half or anything just sliced into a little. I electrical taped it back together.
View 4 RepliesThis morning I started my car, which was parked on an incline, with the car in gear (manual tranny) without remembering that I had left the car in gear. So, when I started the car, it lurched forward when I took my foot off of the clutch pedal. No big deal. I started the car again, but now the check engine light and abs lights are on steady, and the VCS is blinking. The car drove normal all the way to work. When I got to work, I shut the car off and started it up again, but the 3 warning lights are still on.
Is there a re-set procedure for the lights that happens automatically, or do I have to have someone with a scan tool reset it?
Could there actually be something wrong with the car?
I noticed my tail light isnt working, so I decided to change the bulb. And bought a 7443LL Sylvania bulb from Oreilly. Fits perfectly but noob that hasnt opened a car before. Old bulb is greyish, I guess its blown out or something. I change both bulb because you buy them in pairs. Anyhow, I thought its the bulb is the problem but now its not. Since both break light and tail are of the same bulb but tail light isnt working. So I figured the bulb isn't the culprit. I called a friend and he says its the fuse. Found the fuse, bought and replace the fuse. I turn on the car, tail light is still not working. Check the new fuse, its blown, put another one, the same thing happen. It keeps blowing my tail light fuse everytime I start the car. Im quite sure I got the right 7443, its dual filament bulb (I can see 4 wires at the base and 2 string that would light up for tail and break.
Is there 2 fuse for the tail light, I only found one by the break pedal, its just below the turn signal/hazard relay.
I am trying to change the color of the light on my dash board and center console from the standard orange to a light blue color. I've tried searching the internet looking for any advice but I haven't come across anything for a 2009 Toyota corolla. I understand that some cars need to have the light bulbs soldered and some can you can change out a colored film. Which of these options applies to my car? If it's the light bulb change then what size and how many. Also, how to take out the instrumental cluster.
View 6 RepliesMy wife's 2009 Corolla S has 107,000 miles. Early on it developed a low idle and vibration while stopped at a light. It was idling about 600 rpm after it warmed up. It never stalled but occasionally vibrated. After doing some research I found some were having success cleaning the throttle body and throttle plate. I did that along with changing the spark plugs. At that time I disconnected the battery to reset the computer. She has put about 2,000 miles on it since then and it never idles below 800 rpm. The vibration hasn't been back either.
I believe it was the throttle body/ plate cleaning and disconnecting the battery that resets the computer that fixed it. The plugs still looked good at 105 K miles, but I had new ones so I put them in. I bought a can of Berryman b12 choke & carb cleaner and sprayed a little on the throttle body and plate and then sprayed some on a rag and wiped down the body and plate. It was quite dirty.
So I'm having a problem, which I'm pretty sure is the switch. The traction control light won't turn off no matter how many times I've pressed the button. The orange light is really annoying now and I need to get it fixed. What should I do?
View 1 RepliesSo basically I woke up one morning, was gonna go to work when I tried to start my corolla nothing happened...tried that couple of times and still nothing ....then couple tries later, you could hear the car try to start but then nothing happens. The check Engine light is on when I try to turn on car
The battery and such seems fine. And I don't recall having any problems before, now even the remote control for the key wont work for the car...
Lately I would be stopped at a red light and my rpms would drop to 600. And when I turn my headlights on the rpms go up and the rough idle stops. Should I check it out if so what should I check? My corolla has 49.5k.
View 1 RepliesWe just purchased a used 2010 LE model a couple weeks ago and for the first time actually drove it during the night. So I decided to check out how the fog lights look. Problem is, when I turned them on it didn't light up any of the road between the low beams and the front bumper of the car. In fact acted kind of acted as high beams. They are currently aimed higher than my low beams!!!
This doesn't seem right to me.
- Were the lights installed upside down?
- They should be lighting up the area on the road between my low beams and front bumper correct?
- Is it possible that they are able to be aimed that high if installed correctly?
Corolla has this code : B1801
When i erase it comes right back!
Open in (D) Squib Circuit. What to start looking for?
I just got an oil change, and my maintenance light is flashing when I start up. It has about 36 thousand miles on it. I don't know when the previous oil change was before the one I got two weeks ago.I have read about resetting the maintenance light, but this is my first car and I have only had it for about 8 months, so I don't want to ignore a potential issue here.
View 4 RepliesI just bought a used Toyota Corolla 2009 LE. I found that the indicators for Low engine oil pressure warning, Charging system warning, and Malfunction/Check Engine are on when the engine switch at "On" and goes off after engine is started. Is this normal or something is wrong with the car?
View 2 Replies