Corolla / Matrix 2009-13 :: Could Inflated Tire Cause Engine To Wear Out Faster?
Dec 19, 2013
I purchased the 2010 corolla back in October of 2010 and never noticed until almost 2 years later that all of my tires were inflated to 62 PSI.
I went to the dealer and they didn't know anything, I myself didn't put any air into it nor did my brother who drives the car too. However he has always complained that the ride was stiff.
Iam wondering if it cause my engine to wear out faster since the tires were so stiff and it bumps when going over pot whole. I could be 100% certain I drove it off the lot with 62 PSIs.....
View 14 Replies
Advertisement
I have 3 new tires and 1 with wave or cupping wear. It is a new tire not even a year used. I went in to get my alignment fixed because I was told the cupping is due to car being out of alignment. They told me I have to replace the tire with the cupping wear on it before they do the alignment. Is this true? or can i keep the tire and not have to shell out more money for a tire that is not even a year old. that being said, I am now doing more research and realizing that cupping is actually due to problems with the shocks. not alignment.
It's a 2009 toyota matrix xrs....
View 1 Replies
I checked my pads today and noticed that the drivers pad is worn about 50% more than the passenger in the front. What could be the problem??
View 5 Replies
Potholes are nasty where I live .It sounds like there's something in my trunk rolling back and fourth. When I accelerate it knocks back. When I brake it knocks forward. Just like rolling, it only happens once in each direction. Sort of sounds like the noise of bending/popping metal.I'm taking my car in later this week.
View 2 Replies
The 2010 Corolla Manual illustrates on page 329 pattern "D" as if to suggest we have "same size directional" tires. It is my understanding directional tires will have an arrow on the sidewall. If it doesn't have an arrow, it's non-directional and it doesn't matter which way it rotates. I don't see an arrow on my tires. Which of the following patterns are you using?
View 13 Replies
My indicator light came on. I put some air on the two front tires to make it 33/34. But the light is still on. I need to check the two rear tires?
View 5 Replies
I slid, probably going about 20-25mph. Driver side tire hit the curb. Rim looks scraped, tire appears to be fine, steering wheel is a little loose feeling.
View 4 Replies
As the title says, I can't get the light to go off. I followed the procedure to reset it but after it blinks three times, the light is still on. I've also read that I need to take the car above speeds of 19mph and/or an hour, for light to disappear but still nothing. Although I didn't drive it more than an hour since my commute is short. I've made sure that the pressure is around 30psi on all four tires.
View 4 Replies
What is the part number to the TPMS sensors for a 2011 Corolla S. Or any stock toyota ones that will work?
View 2 Replies
Last week I was losing pressure on my left rear tire. It turned out to be a 3 inch spike that was bent inside the tire. The tires are the original Goodyears with 37k miles on them. I decided to replace 2 rear tires with Yokohama YK580s and turned the extra Goodyear in to a full size spare
Question. At high speeds 50 plus the rear feels like it's sliding a bit if I barely move the steering wheel. Having issues with 2 different tires.
View 14 Replies
I have never had this problem with my 2010 Matrix until this week when I put the summer rims with transponders back on.
As per the manual, I turned the key to "on" and held the reset button. The pressure warning light is supposed to slowly flash 3 times to indicate that it has been reset, then go out. Holding the reset button has no effect this year and the pressure warning light just stays on.
The manual says to take it to a Toyota service centre if the reset procedure fails.
View 2 Replies
So I just bought new wheels, and had them put on. Went from stock 16's to 17's now. After I had them put on there was no issue.
Now after I was driving for about 30 mins, I noticed that the Low Tire Pressure Indicator started flashing for 20-30 seconds, then stayed solid.
And now the indicator has been there ever since. I've tried reinitializing the TPMS but it stlll didn't go away.
View 4 Replies
Had snow tires on separate rims without pressure sensors installed today. Service rep said that the tire pressure warning light will come on and stay on. However I rode car home and the warning light did not stay on after the initial engine start up. Is this a problem and a concern, or a good thing ?
View 2 Replies
I bought a wall mounted tire rack and its maximum weight capacity is 300 lbs.I need to know how much a stock 15" wheel weight including the tire. I don't have a scale.This is for a 2012 Corolla.
View 2 Replies
I have a 2011 corolla. the engine just dont have any pep. is there a way to swap 1.8 for a 2.4 . is it worth the effort. or how can i get more pep without sinking lots into it.
View 14 Replies
2014 FX4 F. Got 6000 miles on the truck, front tires are wearing on the outside edge, and also when turning the wheels to the max in either direction I get a loud creaking sound,??
View 14 Replies
I own a 2009 superwhite corolla xrs. I've owned the car now for several months . Ever since I got It, I've heard a noise coming from the engine bay . Sounds like a Metallic rattling .seems to do it in the cold and warm weather . I have a feeling that its the water pump . Every time I take it to the dealer it doesn't make the noise. It's makes the noise on a regular basis . Check out the video... ignore the dirty dash low fuel light... I was parked by a gas station i swear.
View 3 Replies
My daughters 2009 will start right up but after about a second it shuts right off we tried it several times and it shuts right down.If you wait for 10 to 20 mins it starts and runs fine.
View 4 Replies
My 2009 , 1.8 Corolla gets terrible gas mileage. 23 city (lowest was 12), best ever was 30 highway. I have approx 14K on the odo because the MPG makes me want to leave at home.
The MPG has been verified in writing by 2 different dealers, so I do not consider myself the problem. I drive conservatively and calculate MPG based on actual miles / gallons. Toyota Corp did not bother to fix this issue. It has been serviced regularly and had whatever fixes Toyota offered.
What I think is causing my terrible mileage is some glitch in an engine sensor that causes it to rev from 900 to 1100 RPM when I take my foot off the accelerator and attempt to coast. The revs go down when I press the brake. This happens constantly, especially at around 25 MPH. If I do not brake, the car will pull for a while without slowing down like normal cars.
I showed my Toyota dealers but they all said nothing is wrong. My Corolla even went up a slight hill without my foot near the accelerator. One tech told me the Corolla is burning off extra fuel, but my car will pull itself for over 1/2 mile, too much time for "burning". Something IS wrong. I have driven dozens of vehicles and never had one jump like this. Where to start diagnosing?
View 14 Replies
My engine just went out in my 2009 Corolla XRS. What vehicles have the same engine as a 2009 Corolla XRS 2.4L manual transmission?
Also, what would it take to put in the 1.8L engine? Would it bolt straight up? Would I need a new ecu/wiring harness/mounts/exhaust/trans etc?
I am considering putting in a rebuilt or used transmission at the same time because my syncros were failing.
View 14 Replies
A couple weeks ago, my check engine light popped on and I noticed my engine misfire. I happened to be driving by an autozone, so I pulled in and had them check the code. Came back as a misfire on cylinder 4, possibly bad ignition coil or clogged injector. I ran some techron for the next couple of gas tanks, didn't seem to do much, as I would still occasionally get the check engine light.
It has been getting more and more common for it to happen while driving since. Today on the way home from work, it misfired several times in a row and got so bad that I couldn't get above 40mph. This lasted for a minute or two, then cleared up and I made it home without a hitch. Took it back to autozone, same code..Cylinder 4 misfire, probably ignition coil or primary/secondary ignition b fault. I went ahead and bought an ignition coil, came back home and installed. Just took it for a test drive and now I've got the same issue.
I only replaced the one coil that has been throwing a code as misfiring. I did not also replace the spark plug on that cylinder.
View 6 Replies
