Corolla / Matrix 2009-13 :: Check Engine Light Came On With Code P0352
Jun 18, 2015
I have a 2009 Corolla S w/ 79K miles on it and recently my check engine light came on with the trouble code P0352. The engine would misfire while accelerating and then was extremely rough when at a stop light. This issue and check engine light have been happening intermittently over the last few days. I don't really know anything about engines/cars but doing some research came back with the following...
Possible causes
- Faulty Ignition Coil 2
- Ignition Coil 2 harness is open or shorted
- Ignition Coil 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
Basically my question is how do I troubleshoot and figure out what the real problem is? I would rather not buy and replace the Ignition Coil if it is something else. From everything I have seen it seems the simplest method to test the coil is to switch out the ignition coil and spark plug on coil 2 with one of the other 3 ignition coils and see if the the trouble code follows it or stays on 2.
View 3 Replies
Advertisement
2009 1.8 Corolla . I'm chasing an intermittent P0352 code and misfire. Code points to coil pack #2 . Question is, which one is #2 ? I want to swap coils and see if the error follows the coil but I can figure out which cylinder is #2 and since all of the coil wires disappear into a loom, I'm not sure how else to tell.
View 2 Replies
After taking my 2009 Corolla S to the dealer on 4/07 for an oil change, about 4 or 5 days later the check engine light, the traction control light, and the VSC light come on (VSC off blinks). The first day it came on, I took it to autozone to look the code up and they said it was P0353 (issue with ignition coil c I think). I immediately afterwards drove to the dealer to see what they would say. But after parking in their garage speaking with the greeters, they said the light wasnt on, and asked if I wanted to wait the 2 hours to see a tech. So I took it home.
The code came back about 3 days later, and this time there was a slight stall/jolt for about 4 or 5 seconds. This occured on startup and not during driving. After the 4 or 5 seconds of the mild jolting it felt like it was running smooth. I took it home and after leaving it off for about 20 minutes, the light went out again. A couple days later it came back and stayed on over night and was still present when I started it the next day. It went off again later that day.
My question is what could be causing this that might be a simple fix. Do toyota techs check anything with the spark plugs during normal Oil Changes? I know they checked my brakes but Im not a car guy and am not really sure all that they do. Could it be a loose spark plug? Code P0353 coming up sporadically after dealer Oil change. Is there any steps they normally do during the oil change that could be causing this, like leaving a spark plug loose after checking them or something? Would the coil / wiring harness fall under an engine warranty?
View 10 Replies
I am far from home. Taking a road trip. Day 2 out of 6. My check engine light came on, so I just pulled over. All fluids were fine. Found some place to read the code:
P2757 TCC pressure control Sol Ckt Perf / Stuck off
The guy said it was something to do with trans.
View 3 Replies
Check engine light came on. Codes are P0300, P0302, P0304. Plugs were previously changed. Plugs look good. Changed both coils. Light still one. Injectors also previously cleaned. What else should we check for? Valves hanging? Anything else to check for?
View 5 Replies
My 2003 Camry with 160k miles is running OK but the check engine light came on and P0341, P0352 and P0354 are displayed with my code checker. I looked up the three codes and could not determine anything that would cause all three codes to display at the same time. I plan to reset the codes to see if and how fast they come back. Is there anything common that could cause all three to display at the same time?
View 1 Replies
So basically I woke up one morning, was gonna go to work when I tried to start my corolla nothing happened...tried that couple of times and still nothing ....then couple tries later, you could hear the car try to start but then nothing happens. The check Engine light is on when I try to turn on car
The battery and such seems fine. And I don't recall having any problems before, now even the remote control for the key wont work for the car...
View 10 Replies
I have a 2010 Corolla. The car is flashing the infamous VSC Off, trac, engine light! The car is still has the powertrain warranty. I was wondering if I should take it to a Toyota dealership.
But I read just getting the diagnostic itself is around $100. I don't want to end up paying for that if the repairs end up being something that's not even covered under the warranty.
View 4 Replies
I own a 2012 Toyota Corolla S w/ 8700 miles on it I am the first owner. Check engine light blinks on and off 8 times. I cleaned the gas cap threads and neck, then I reset the computer by removing the positive terminal for 1 minute. I also checked the oil it's fine. Light still blinks? I have many years of mechanical back ground, without running codes I don't know this one
View 4 Replies
The fuel line is fine.
Today after work I started the car in a sheltered car garage and as soon as I started the car the after the initial start up sequence the check engine light stayed on and the traction control light stayed on and right next to it on the left side the "VSC Off" light kept blinking and flashing. I turned off the car and started it several times to see if that did anything and to no avail nothing happened.
While I was driving those lights stayed on and the VSC off light kept on blinking. I also checked the brakes and the brake fluid and they all seem to be fine, I even checked the fuel door as well.
I am not sure what is wrong. I was looking at some of the complaint sites and most people say it happens when you drive through a deep puddle or if it is cold and wet outside. But that didn't make sense because I drove in the snow and those lights never turned on. The only time I used the ETS button is during the snow storms and I drive at low speeds.
I need to know why this VSC off light is blinking? Is it a bad sensor or is the ABS/ETS brake system broken or is it an ECU issue or is it because of an alignment. Since I was told to get an alignment soon.
View 14 Replies
My friend was told by Toyota that the Air Fuel Sensor code was the reason why her 2010 Corolla VSC and engine lights were on. This was after she visited her mechanic who changed the O2 sensor.
Is there a way to change the Air fuel sensor herself without having to pay Toyota...
View 2 Replies
So today I start my car, I get the check engine on (steady not flashing) and have stability control flashing with my traction control light on. I found out it could be the gas cap not on right so I removed it and screwed it on again, check engine light was still on though. However, after starting the car again after a drive it was gone .
I do turn off stability control sometimes if it's nice out?
View 1 Replies
Corolla has this code : B1801
When i erase it comes right back!
Open in (D) Squib Circuit. What to start looking for?
View 1 Replies
2012 Corolla S with 84000 miles, for the last month the check engine and trac off light keeps coming on randomly. I disconnect the negative battery charge and wait 10min and reconnect and it goes away. I havnt counted how many miles I go until the light come back on. But since the last time I disconnected the battery my car has been on for 8hours on the engine time. I had them scan it at autozone and the car is throwing two codes one was the MAF and I can't recall the other.
View 5 Replies
Just bought a XLE (currently have had the car for 2 weeks and a total of 275miles) and am experiencing a very strange rattle coming from the engine compartment when accelerating very lightly and engine being fully warm (being ran for atleast 15min). The rattle is coming during 2000-2300rpm. Below and above that range, the problem does not occur. The rattling noise sounds as if some metal is grinding on one another. I understand that the Dual VVT-i is notoriously known for it's noise (ticking/tapping of valves, naturally being a 4cyl, and a small amount of "roar" when applying large amount of throttle) but I think this problem I am exhibiting is by far, not normal.
Symptoms/Conditions:
1. Car must be hot/warm (must be driven for atleast 15 minutes)
2. Must be in a drive or reverse direction. Problem does not occur in park or neutral.
3. You have to be acclerating lightly, the engine rattle occurs from 2000rpm - 2300rpm. It's not a tapping or ticking sound but rather a "buzzing" metal to metal grinding.
4. Sounds like the sound is coming from the intake or exhaust systems and the rpm's is causing a natural vibration frequency that is causing a metal part to vibrate (or resonate). Could explain
5. The car doesn't seem to be power limited or anything abnormal. Drives just fine - just a rattling sound that I hate to believe is normal!
I'm under assumption that this is an engineering design flaw! I would encourage you as Toyota Corolla 2009 owners (1.8L, 4spd autos, manuals) to see if you can replicate this issue. Warm your car up, turn off heat/ac & radio (so you can clearly hear the engine), put it in drive, slowly excelerate, and listen as your rpm's increase (noise will only occur at 2000-2300rpm).
View 14 Replies
I bought a 2007 Toyota Matrix new, and it now has 41,800-something miles on it. At 38K miles the check engine light came on while I was on vacation out of state. The nearest Toyota dealer checked it out, told me the check engine light code was P0741 - problem with the torque converter - but they didn't see any obvious problem and the car drove fine for them and for me. They turned the light off but it went back on before very long. The car has now been to 2 different Toyota dealerships near my home because the check engine light keeps turning on. They also report seeing the same code, also seeing nothing obviously amiss,and tell me I need my transmission replaced. This seems preposterous to me for such a low mileage Toyota.
In December, when the check engine light went on again, I discovered it would turn off if I filled the car with gas. It still comes back on; if I either fill the car with gas, or simply open and close the gas cap, the check engine light will turn off after 3 - 4 trips with the car. What does the gas cap have to do with the torque converter?
What's really weird is that the light always comes on under the same conditions. Most of my driving is short trips, a couple of miles in town at around 30 mph. The light never comes on during "town" driving. My highway driving consists of trips of about 1 hour; parking for an hour or two; then returning home -- again, about an hour's drive. The check engine light always comes on when I'm doing highway driving on the trip home. I've clocked the mileage for the last 3 times the light came on. It came on after highway driving a total of 48, 51, and 48 miles, respectively.
View 6 Replies
About two weeks ago, while driving on a hot, humid summer night, the check engine light in my 1998 Toyota Corolla came on. The following day, I took it into my mechanic, who plugged it in and came up with the code P0441 (Purge flow fault). He told me it was likely related to the fuel vapor canister, though I see this can also have to do with vacuum lines for the purge valve and canister or a bad purge valve itself. My gas cap was, and had been, tight, so it wasn't something as simple as that.
Reluctant to deal with this immediately, I went back to driving it, and lo and behold - the light went off after several days! Unfortunately, the light came BACK ON after several more. And most recently (a few days after coming on again), the light has now gone off!
Both times the light has gone off, the weather has been rather wet, but otherwise, there doesn't seem to be a clear pattern. What this on again off again pattern might say about the problem?
View 10 Replies
My Corolla has the P0441 code, but not the typical 0445 code that comes with a loose gas cap. I cleared it and it came back (yes, I checked the gas cap). Googling the issue, I found service bulletin SB 0392-08, which implies the ECM could need to be replaced if the issue is not in the Evap system.
View 1 Replies
I have a 2009 corolla LE with 81,000 miles on it. Today after I got gas, the check engine light came on. I checked the OBD code and it said P0607. I cleared the code and continued to drive it and it ran fine and the light has not came back on yet. I'm a little worried about driving it on long trips now.
View 2 Replies
I have a 2009 Corolla with a 1.8 L. I have the misfire code P0301. I have changed the plugs, ignition coil, and fuel injector on cylinder one. It still has the misfire.
View 5 Replies
I have the code P0500 on my 2009 Matrix. The odometer doesn't function, all error lights are on, the power steering is not completely out but it's reduced. Also, the rear windshield wiper is constantly on. I replaced the vehicle transmission sensor today because I thought that would fix it all. It had absolutely no effect.
View 5 Replies
