I am far from home. Taking a road trip. Day 2 out of 6. My check engine light came on, so I just pulled over. All fluids were fine. Found some place to read the code:
P2757 TCC pressure control Sol Ckt Perf / Stuck off
The guy said it was something to do with trans.
I have a 2009 Corolla S w/ 79K miles on it and recently my check engine light came on with the trouble code P0352. The engine would misfire while accelerating and then was extremely rough when at a stop light. This issue and check engine light have been happening intermittently over the last few days. I don't really know anything about engines/cars but doing some research came back with the following...
Possible causes
- Faulty Ignition Coil 2
- Ignition Coil 2 harness is open or shorted
- Ignition Coil 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
Basically my question is how do I troubleshoot and figure out what the real problem is? I would rather not buy and replace the Ignition Coil if it is something else. From everything I have seen it seems the simplest method to test the coil is to switch out the ignition coil and spark plug on coil 2 with one of the other 3 ignition coils and see if the the trouble code follows it or stays on 2.
After taking my 2009 Corolla S to the dealer on 4/07 for an oil change, about 4 or 5 days later the check engine light, the traction control light, and the VSC light come on (VSC off blinks). The first day it came on, I took it to autozone to look the code up and they said it was P0353 (issue with ignition coil c I think). I immediately afterwards drove to the dealer to see what they would say. But after parking in their garage speaking with the greeters, they said the light wasnt on, and asked if I wanted to wait the 2 hours to see a tech. So I took it home.
The code came back about 3 days later, and this time there was a slight stall/jolt for about 4 or 5 seconds. This occured on startup and not during driving. After the 4 or 5 seconds of the mild jolting it felt like it was running smooth. I took it home and after leaving it off for about 20 minutes, the light went out again. A couple days later it came back and stayed on over night and was still present when I started it the next day. It went off again later that day.
My question is what could be causing this that might be a simple fix. Do toyota techs check anything with the spark plugs during normal Oil Changes? I know they checked my brakes but Im not a car guy and am not really sure all that they do. Could it be a loose spark plug? Code P0353 coming up sporadically after dealer Oil change. Is there any steps they normally do during the oil change that could be causing this, like leaving a spark plug loose after checking them or something? Would the coil / wiring harness fall under an engine warranty?
Check engine light came on. Codes are P0300, P0302, P0304. Plugs were previously changed. Plugs look good. Changed both coils. Light still one. Injectors also previously cleaned. What else should we check for? Valves hanging? Anything else to check for?
View 5 RepliesSo basically I woke up one morning, was gonna go to work when I tried to start my corolla nothing happened...tried that couple of times and still nothing ....then couple tries later, you could hear the car try to start but then nothing happens. The check Engine light is on when I try to turn on car
The battery and such seems fine. And I don't recall having any problems before, now even the remote control for the key wont work for the car...
I have the code P0500 on my 2009 Matrix. The odometer doesn't function, all error lights are on, the power steering is not completely out but it's reduced. Also, the rear windshield wiper is constantly on. I replaced the vehicle transmission sensor today because I thought that would fix it all. It had absolutely no effect.
View 5 RepliesI have a 2010 Corolla. The car is flashing the infamous VSC Off, trac, engine light! The car is still has the powertrain warranty. I was wondering if I should take it to a Toyota dealership.
But I read just getting the diagnostic itself is around $100. I don't want to end up paying for that if the repairs end up being something that's not even covered under the warranty.
I own a 2012 Toyota Corolla S w/ 8700 miles on it I am the first owner. Check engine light blinks on and off 8 times. I cleaned the gas cap threads and neck, then I reset the computer by removing the positive terminal for 1 minute. I also checked the oil it's fine. Light still blinks? I have many years of mechanical back ground, without running codes I don't know this one
View 4 RepliesThe fuel line is fine.
Today after work I started the car in a sheltered car garage and as soon as I started the car the after the initial start up sequence the check engine light stayed on and the traction control light stayed on and right next to it on the left side the "VSC Off" light kept blinking and flashing. I turned off the car and started it several times to see if that did anything and to no avail nothing happened.
While I was driving those lights stayed on and the VSC off light kept on blinking. I also checked the brakes and the brake fluid and they all seem to be fine, I even checked the fuel door as well.
I am not sure what is wrong. I was looking at some of the complaint sites and most people say it happens when you drive through a deep puddle or if it is cold and wet outside. But that didn't make sense because I drove in the snow and those lights never turned on. The only time I used the ETS button is during the snow storms and I drive at low speeds.
I need to know why this VSC off light is blinking? Is it a bad sensor or is the ABS/ETS brake system broken or is it an ECU issue or is it because of an alignment. Since I was told to get an alignment soon.
My friend was told by Toyota that the Air Fuel Sensor code was the reason why her 2010 Corolla VSC and engine lights were on. This was after she visited her mechanic who changed the O2 sensor.
Is there a way to change the Air fuel sensor herself without having to pay Toyota...
Went on a trip Sunday, and i saw my engine light come on after i put gas in the car. I pulled over, re-checked the gas cap, and it was fine. Car felt fine.
When i got home, i used my OBD2 scanner, and got the error P0304 Code - Cylinder #4 Misfire. I cleared the error and drove the car some more, no issues.
Yesterday, my wife took the car and she said it was hesitating and sputtering, but the light hasn't come back. I have an appointment at the dealer tomorrow, the car has under 80,000k, so the warranty should kick in.
My check engine light keeps coming on sporadically and giving me a PO101 error code...then I'll reset it after making sure my MPG hasn't dipped a significant amount (which is my "concrete" way of gauging if it's performance is impaired) and it'll come on 1-600 miles later. There's no consistency in environment or conditions that are triggering this sensor, at least it's not obvious to me. I finally looked under the hood at the filter and it's a little dirty, but not nearly dark enough for it to be the problem.
View 4 RepliesI have 2006 Lexus GS300 with 95K miles. My check engine, check VSC and traction lights came on. I get an error code: "P2757 Torque Converter Clutch Pressure Control Solenoid Control Circuit Performance or Stuck Off ". I was given the following different solutions that may work: replace the solenoid, service the transmission or replace transmission.
View 14 RepliesSo today I start my car, I get the check engine on (steady not flashing) and have stability control flashing with my traction control light on. I found out it could be the gas cap not on right so I removed it and screwed it on again, check engine light was still on though. However, after starting the car again after a drive it was gone .
I do turn off stability control sometimes if it's nice out?
Corolla has this code : B1801
When i erase it comes right back!
Open in (D) Squib Circuit. What to start looking for?
2012 Corolla S with 84000 miles, for the last month the check engine and trac off light keeps coming on randomly. I disconnect the negative battery charge and wait 10min and reconnect and it goes away. I havnt counted how many miles I go until the light come back on. But since the last time I disconnected the battery my car has been on for 8hours on the engine time. I had them scan it at autozone and the car is throwing two codes one was the MAF and I can't recall the other.
View 5 RepliesA few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
2003 1.8t passat wagon. 50k miles... The check engine light came on today. Oil and engine temp are fine. Can most shops plug in and diagnose? Can I get one of those code readers at Advanced Auto parts to read the error code?
View 5 RepliesWhat is the meaning or the fault concerning 4608. The above error code was reported on the computer diagnose machine and it referred me to look into the vehicle ownership manual book BUT its rather unfortunate that i could not find that book. So, what to tackle or replace on the engine to enable the check engine lite go off.
View 17 RepliesI got a P0118 error code on my car. Looked up some things and most people were saying change coolant temperature sensor. I changed it 2 days ago and have not had a chance to clear the CEL. Its still on now, guy at Autozone would not clear it, said it was against company policy.
Will this turn off automatically once problem corrects itself? I went to Autozone and had them rescan the error, this time another code poped up P0444, EVAP(Evaporative Emission System)Evaporative Emission Control System Purge Control Valve Circuit Open. What this can be?
Currently I haven't been tweaking anything to my car after driving to go and home I left to go get something to eat and after driving for a few min out of nowhere the engine light, brake and abs comes up. So I freak out a pull over to the nearest gas station and turn my engine off for 2 min and turn it back on and this time only the engine light come up. So I drove to autozone to get it scan and error p0500 comes up. Which means short circuit, vss and poor electricity something I am not exact but is it serious? Like I am freaking out right now.
View 1 Replies