I own a 2012 Toyota Corolla S w/ 8700 miles on it I am the first owner. Check engine light blinks on and off 8 times. I cleaned the gas cap threads and neck, then I reset the computer by removing the positive terminal for 1 minute. I also checked the oil it's fine. Light still blinks? I have many years of mechanical back ground, without running codes I don't know this one
View 4 RepliesSo basically I woke up one morning, was gonna go to work when I tried to start my corolla nothing happened...tried that couple of times and still nothing ....then couple tries later, you could hear the car try to start but then nothing happens. The check Engine light is on when I try to turn on car
The battery and such seems fine. And I don't recall having any problems before, now even the remote control for the key wont work for the car...
I have a 2010 Corolla. The car is flashing the infamous VSC Off, trac, engine light! The car is still has the powertrain warranty. I was wondering if I should take it to a Toyota dealership.
But I read just getting the diagnostic itself is around $100. I don't want to end up paying for that if the repairs end up being something that's not even covered under the warranty.
I have a 2009 Corolla S w/ 79K miles on it and recently my check engine light came on with the trouble code P0352. The engine would misfire while accelerating and then was extremely rough when at a stop light. This issue and check engine light have been happening intermittently over the last few days. I don't really know anything about engines/cars but doing some research came back with the following...
Possible causes
- Faulty Ignition Coil 2
- Ignition Coil 2 harness is open or shorted
- Ignition Coil 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
Basically my question is how do I troubleshoot and figure out what the real problem is? I would rather not buy and replace the Ignition Coil if it is something else. From everything I have seen it seems the simplest method to test the coil is to switch out the ignition coil and spark plug on coil 2 with one of the other 3 ignition coils and see if the the trouble code follows it or stays on 2.
The fuel line is fine.
Today after work I started the car in a sheltered car garage and as soon as I started the car the after the initial start up sequence the check engine light stayed on and the traction control light stayed on and right next to it on the left side the "VSC Off" light kept blinking and flashing. I turned off the car and started it several times to see if that did anything and to no avail nothing happened.
While I was driving those lights stayed on and the VSC off light kept on blinking. I also checked the brakes and the brake fluid and they all seem to be fine, I even checked the fuel door as well.
I am not sure what is wrong. I was looking at some of the complaint sites and most people say it happens when you drive through a deep puddle or if it is cold and wet outside. But that didn't make sense because I drove in the snow and those lights never turned on. The only time I used the ETS button is during the snow storms and I drive at low speeds.
I need to know why this VSC off light is blinking? Is it a bad sensor or is the ABS/ETS brake system broken or is it an ECU issue or is it because of an alignment. Since I was told to get an alignment soon.
After taking my 2009 Corolla S to the dealer on 4/07 for an oil change, about 4 or 5 days later the check engine light, the traction control light, and the VSC light come on (VSC off blinks). The first day it came on, I took it to autozone to look the code up and they said it was P0353 (issue with ignition coil c I think). I immediately afterwards drove to the dealer to see what they would say. But after parking in their garage speaking with the greeters, they said the light wasnt on, and asked if I wanted to wait the 2 hours to see a tech. So I took it home.
The code came back about 3 days later, and this time there was a slight stall/jolt for about 4 or 5 seconds. This occured on startup and not during driving. After the 4 or 5 seconds of the mild jolting it felt like it was running smooth. I took it home and after leaving it off for about 20 minutes, the light went out again. A couple days later it came back and stayed on over night and was still present when I started it the next day. It went off again later that day.
My question is what could be causing this that might be a simple fix. Do toyota techs check anything with the spark plugs during normal Oil Changes? I know they checked my brakes but Im not a car guy and am not really sure all that they do. Could it be a loose spark plug? Code P0353 coming up sporadically after dealer Oil change. Is there any steps they normally do during the oil change that could be causing this, like leaving a spark plug loose after checking them or something? Would the coil / wiring harness fall under an engine warranty?
I am far from home. Taking a road trip. Day 2 out of 6. My check engine light came on, so I just pulled over. All fluids were fine. Found some place to read the code:
P2757 TCC pressure control Sol Ckt Perf / Stuck off
The guy said it was something to do with trans.
Check engine light came on. Codes are P0300, P0302, P0304. Plugs were previously changed. Plugs look good. Changed both coils. Light still one. Injectors also previously cleaned. What else should we check for? Valves hanging? Anything else to check for?
View 5 RepliesI've got a '96 Sierra manual transmission with 215K that's been running fine. I just ran it 400 miles without a problem. Recently I downshifted into fourth to go up a hill and I had a sudden loss of power and a rough ride like I had a flat tire. The harder I press the gas the rougher the ride and it idles almost normally. The check engine light came on and blinks 12 times.
View 1 Replies09 corolla. Wife said it was hard to start this morning and when she got off work. it started fine right after she got home. i waited a few hours, after dinner and went out to start it and it takes the engine about 3 seconds to start.
Normally when I turn the key the engine cranks up and starts. today it cranks or turns over about 3 times before starting. and there's no error/engine lights. tested the battery, full charge. not sure what else to check.
We are in Houston TX, with about 95'F day temps, you could call it a cold start since the engine has been resting and cooling off. but not cold like freezing temp.
So today I start my car, I get the check engine on (steady not flashing) and have stability control flashing with my traction control light on. I found out it could be the gas cap not on right so I removed it and screwed it on again, check engine light was still on though. However, after starting the car again after a drive it was gone .
I do turn off stability control sometimes if it's nice out?
I have a problem with my wife's 2010 Corolla where the AC only comes on at random times. The blower blows constantly, but only blows cold air every once in awhile. When it blows the cold air, it feels perfect. We had it checked at three different places and they still haven't found out what's wrong.
The first place refilled the coolant and got it working, but it only lasted a day. When we took it back they said it worked fine for them, but took it home and again it crapped out the next day. Took it back to them and they couldn't figure it out.
Second place said it needed a new or refurbished compressor, but that didn't make sense to me since when it's working, it works great. Also pressure was normal on hi and lo.
Third place took a look at it today and said they got it to work briefly by turning on the heat??? Doesn't make sense. They're closed on weekends so we'll take it back to them on Monday and they'll continue to troubleshoot.
2012 Corolla S with 84000 miles, for the last month the check engine and trac off light keeps coming on randomly. I disconnect the negative battery charge and wait 10min and reconnect and it goes away. I havnt counted how many miles I go until the light come back on. But since the last time I disconnected the battery my car has been on for 8hours on the engine time. I had them scan it at autozone and the car is throwing two codes one was the MAF and I can't recall the other.
View 5 RepliesI am very happy with my 2010 corolla, except for the annoying beeping. I live in a very quiet townhouse row and the cars are parked right in front of the houses. So, when I get up in the morning to get in the car, it beeps when I unlock it and on good weather days when the windows are open, there are at least 20 units that can hear it. It is very embarrassing. What is worse, randomly in the middle of the night, at 230 or 3am, it will beep five times quickly. My neighbors want to kill me! The engine light has been on for a few weeks because I am due for an oil change. Could it be related to that? And how do I turn this thing off?
View 4 RepliesJust bought a XLE (currently have had the car for 2 weeks and a total of 275miles) and am experiencing a very strange rattle coming from the engine compartment when accelerating very lightly and engine being fully warm (being ran for atleast 15min). The rattle is coming during 2000-2300rpm. Below and above that range, the problem does not occur. The rattling noise sounds as if some metal is grinding on one another. I understand that the Dual VVT-i is notoriously known for it's noise (ticking/tapping of valves, naturally being a 4cyl, and a small amount of "roar" when applying large amount of throttle) but I think this problem I am exhibiting is by far, not normal.
Symptoms/Conditions:
1. Car must be hot/warm (must be driven for atleast 15 minutes)
2. Must be in a drive or reverse direction. Problem does not occur in park or neutral.
3. You have to be acclerating lightly, the engine rattle occurs from 2000rpm - 2300rpm. It's not a tapping or ticking sound but rather a "buzzing" metal to metal grinding.
4. Sounds like the sound is coming from the intake or exhaust systems and the rpm's is causing a natural vibration frequency that is causing a metal part to vibrate (or resonate). Could explain
5. The car doesn't seem to be power limited or anything abnormal. Drives just fine - just a rattling sound that I hate to believe is normal!
I'm under assumption that this is an engineering design flaw! I would encourage you as Toyota Corolla 2009 owners (1.8L, 4spd autos, manuals) to see if you can replicate this issue. Warm your car up, turn off heat/ac & radio (so you can clearly hear the engine), put it in drive, slowly excelerate, and listen as your rpm's increase (noise will only occur at 2000-2300rpm).
My friend was told by Toyota that the Air Fuel Sensor code was the reason why her 2010 Corolla VSC and engine lights were on. This was after she visited her mechanic who changed the O2 sensor.
Is there a way to change the Air fuel sensor herself without having to pay Toyota...
My son has a 09 Vibe 1.8L automatic and it won't start. Among other things, I also I want to check to see if it has spark and fuel pressure.
First of all, can I check for spark by looking at the signals into the coil packs? I realize that this won't actually tell me if there is spark at the plugs, but I'd like to know if the ECU is commanding spark or not. One of the coil packs was replaced a couple of months ago, so I'm fairly confident that it is OK. And it's hard to believe that all of the rest of them would suddenly have a problem.
As far as the fuel pressure is concerned, I don't see a valve on the fuel rail to connect a standard fuel pressure gauge. I'm assuming that I need to some how tap a gauge into the rubber supply line, prior to the metal line going to the fuel rail, but I'm not sure this is the recommended way.
Recently, my check engine light blinks when I start my car. Once I put the car in drive or reverse, it turns off. The light does not come on when I put the car back in park. What this means?
View 1 Replies08 RX350 with ~100K miles. Two weeks ago the Check Engine/TRAC light were on, VSC light blinks, so I tightened the gas cap, and pull the negative and cleared the code. Hoping this is just a gas cap issue.
2 weeks later all those lights are back again, so my mechanic pulled the code and came up with P0128. He told me it should be the problem with the Coolant Temperature Sensor. The water pump, thermostat was replaced last year and coolant level is OK. No issue with coolant temperature and the car drives like normal. My mechanic cleared the code and told me to drive it again until the lights come back and he will pull the code again.
08 RX350 AWD
08 Avalon Touring
So I have 69,500 miles on my car. I leave it parked on a small hill for 3 days and when I turn it on after 3 days of sitting it sounds like it is going to stall and the check engine light blinks. I roll it to the bottom of the hill and turn it on and the light doesn't blink but just stays on. On top of this, randomly but always after stopping when driving i smell a really strong burning oil smell. The smell is so bad i have to open the windows.
I don't think it has anything to do with the CEL but it has been happening for some time. It only smells after you have been driving (mostly Highway) and then stop. It wont happened if your in traffic or driving around town, you have to be on the highway then get off and stop and you smell it. It can happen once a month or twice a week, it is completely random.
What the problem is? still drive-able?
View 14 Replies