Corolla / Matrix 2009-13 :: CEL / ABS / VCS Light Blinking Steadily?
Dec 3, 2012
This morning I started my car, which was parked on an incline, with the car in gear (manual tranny) without remembering that I had left the car in gear. So, when I started the car, it lurched forward when I took my foot off of the clutch pedal. No big deal. I started the car again, but now the check engine light and abs lights are on steady, and the VCS is blinking. The car drove normal all the way to work. When I got to work, I shut the car off and started it up again, but the 3 warning lights are still on.
Is there a re-set procedure for the lights that happens automatically, or do I have to have someone with a scan tool reset it?
Could there actually be something wrong with the car?
View 7 Replies
Advertisement
Woke up this morning and found a red light blinking by my shift knob. It was the passenger air bag. There was a lock on it. How come its doing that? My car is turned off. Could there be a problem with my air bag or was it just a code?
View 3 Replies
I just purchased a used 2010 Toyota Corolla with Airbag Light ON (not blinking). Yes car was in an accident, but Air Bags did not deployed as per the seller. It needs to re-calibrate by Dealer.
As a novice, and avid Toyota person, since it's a good deal I decided to take the car with the airbag lights on. I have seen on youtube, the cause is likely the spiral cable.
View 10 Replies
The fuel line is fine.
Today after work I started the car in a sheltered car garage and as soon as I started the car the after the initial start up sequence the check engine light stayed on and the traction control light stayed on and right next to it on the left side the "VSC Off" light kept blinking and flashing. I turned off the car and started it several times to see if that did anything and to no avail nothing happened.
While I was driving those lights stayed on and the VSC off light kept on blinking. I also checked the brakes and the brake fluid and they all seem to be fine, I even checked the fuel door as well.
I am not sure what is wrong. I was looking at some of the complaint sites and most people say it happens when you drive through a deep puddle or if it is cold and wet outside. But that didn't make sense because I drove in the snow and those lights never turned on. The only time I used the ETS button is during the snow storms and I drive at low speeds.
I need to know why this VSC off light is blinking? Is it a bad sensor or is the ABS/ETS brake system broken or is it an ECU issue or is it because of an alignment. Since I was told to get an alignment soon.
View 14 Replies
I have a 2009 Matrix. The AC just stopped working as we were going down the road. The voltage at the compressor was 2.6 volts. the same voltage at the HVAC module I don't hear the compressor kick on at all, engine speed doesn't change when the AC button is toggled on and off.
The AC light stays on steady not blinking. I am pretty sure that there is enough refrigerant in the system.
View 4 Replies
I parked my 2010 gti at work this morning, walked away, hit the lock button, and noticed a red light on the drivers door that flashed rapidly then kept on blinking steadily indefinitely. i never noticed that before! so... what is that? the alarm? this may be REALLY dumb, but I did not know this car had an alarm!
View 3 Replies
What the problem is? still drive-able?
View 14 Replies
2010 Corolla LE ... This started today, on the ride home from work. Mid 50 degrees, light rain, driving down straight road it started. Engine light also on. No mods in car. is this something the dealer has to se, or can I bring it to my own mechanic?
View 1 Replies
One of my light bulbs for the rear license plate light is out.
what kind of light bulb I need to get?
View 8 Replies
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 Replies
So I bought and installed bc coilovers and my abs light and 2 other lights came on. I did accidently mess up one of the wires on the front left strut but it is not torn in half or anything just sliced into a little. I electrical taped it back together.
View 4 Replies
I noticed my tail light isnt working, so I decided to change the bulb. And bought a 7443LL Sylvania bulb from Oreilly. Fits perfectly but noob that hasnt opened a car before. Old bulb is greyish, I guess its blown out or something. I change both bulb because you buy them in pairs. Anyhow, I thought its the bulb is the problem but now its not. Since both break light and tail are of the same bulb but tail light isnt working. So I figured the bulb isn't the culprit. I called a friend and he says its the fuse. Found the fuse, bought and replace the fuse. I turn on the car, tail light is still not working. Check the new fuse, its blown, put another one, the same thing happen. It keeps blowing my tail light fuse everytime I start the car. Im quite sure I got the right 7443, its dual filament bulb (I can see 4 wires at the base and 2 string that would light up for tail and break.
Is there 2 fuse for the tail light, I only found one by the break pedal, its just below the turn signal/hazard relay.
View 4 Replies
I am trying to change the color of the light on my dash board and center console from the standard orange to a light blue color. I've tried searching the internet looking for any advice but I haven't come across anything for a 2009 Toyota corolla. I understand that some cars need to have the light bulbs soldered and some can you can change out a colored film. Which of these options applies to my car? If it's the light bulb change then what size and how many. Also, how to take out the instrumental cluster.
View 6 Replies
My wife's 2009 Corolla S has 107,000 miles. Early on it developed a low idle and vibration while stopped at a light. It was idling about 600 rpm after it warmed up. It never stalled but occasionally vibrated. After doing some research I found some were having success cleaning the throttle body and throttle plate. I did that along with changing the spark plugs. At that time I disconnected the battery to reset the computer. She has put about 2,000 miles on it since then and it never idles below 800 rpm. The vibration hasn't been back either.
I believe it was the throttle body/ plate cleaning and disconnecting the battery that resets the computer that fixed it. The plugs still looked good at 105 K miles, but I had new ones so I put them in. I bought a can of Berryman b12 choke & carb cleaner and sprayed a little on the throttle body and plate and then sprayed some on a rag and wiped down the body and plate. It was quite dirty.
View 14 Replies
So I'm having a problem, which I'm pretty sure is the switch. The traction control light won't turn off no matter how many times I've pressed the button. The orange light is really annoying now and I need to get it fixed. What should I do?
View 1 Replies
Is there a way to adjust the dome light timer? I want it to stay on longer than it does.
View 1 Replies
So basically I woke up one morning, was gonna go to work when I tried to start my corolla nothing happened...tried that couple of times and still nothing ....then couple tries later, you could hear the car try to start but then nothing happens. The check Engine light is on when I try to turn on car
The battery and such seems fine. And I don't recall having any problems before, now even the remote control for the key wont work for the car...
View 10 Replies
Lately I would be stopped at a red light and my rpms would drop to 600. And when I turn my headlights on the rpms go up and the rough idle stops. Should I check it out if so what should I check? My corolla has 49.5k.
View 1 Replies
We just purchased a used 2010 LE model a couple weeks ago and for the first time actually drove it during the night. So I decided to check out how the fog lights look. Problem is, when I turned them on it didn't light up any of the road between the low beams and the front bumper of the car. In fact acted kind of acted as high beams. They are currently aimed higher than my low beams!!!
This doesn't seem right to me.
- Were the lights installed upside down?
- They should be lighting up the area on the road between my low beams and front bumper correct?
- Is it possible that they are able to be aimed that high if installed correctly?
View 4 Replies
Corolla has this code : B1801
When i erase it comes right back!
Open in (D) Squib Circuit. What to start looking for?
View 1 Replies
I just got an oil change, and my maintenance light is flashing when I start up. It has about 36 thousand miles on it. I don't know when the previous oil change was before the one I got two weeks ago.I have read about resetting the maintenance light, but this is my first car and I have only had it for about 8 months, so I don't want to ignore a potential issue here.
View 4 Replies
