I have an airbag light indicator issue with my matrix 2009.
Whenever I start the car in cold, the indicator says " Airbag is off". After driven for like 30 mins and turn off and turn engine, everything is normal.
Is it possible for the brakes to make some kind of noise when it's cold outside?
I've been noticing some kind of noise after a cold start, I'd drive the car a little bit then apply the brakes and it would just make this random noise coming from the front-right side of the car. It sounds like a grinding noise, but I can't really tell. It doesn't create an issue either, I'll let go of the steering wheel and the car doesn't drift in any direction at all, the noise appears but the car is slowing down properly.
The noise disappears though after the 1st time it happens, and would only reappear after you've turned the car off, parked it where it's cold and it would only appear after not using it for at least 2 hours. My dad already took it to the dealership and they said the brakes are perfectly fine.
Every now and then I have rattling noise when trying to start on a cold start in the morning. Mainly just sounds like a dry start. Battery is good, oil is full (high mileage Valvoline 5W20). Ive tried 5W-30 and it didn't do anything, just made the mpgs about 1 less.
Ive had the car fixed for the main TSB issue with the starter/camshaft so that is not it, which caused a full on grinding noise.
Everyday commuter car, use 87 chevron gas always, and I just used Lucas gas additive the last two fill ups (used normally every 1k miles) and still getting the noise every now and then in the morning. Are there any better injector cleaners out there?
Should I get the fuel injectors fully 3step cleaned? when talking to the service rep at brake-masters, they stated that I should use 91 premium gas to work with dry starts to burn off extra carbon buildup. Wasn't sure if that was a good idea for a 09 corolla S?
93k miles, new spark plugs last week, oil changes every 3k.
We got a 15 F150 yay for her but I got stuck with her 113k.
So the engine makes a chain grinding sound on cold start ups and the tranny is slipping pretty hard.
Can I swap a 2.4 with a 5spd without doing a bunch of wiring?
2009 Matrix with 2Zr-Fe engine (233,000 km or 145000 miles).
Engine has been getting progressively harder to start in the morning, especially when it is cold. Once its warmed up then it starts no problem next time. Occasionally I get the dreaded P0304 code upon startup. Also runs a lot rougher but that's hard to quantify here, I'm just going by sound.
Decided tonight to go through a complete checkup and here is what I found:
1. Looked for a dead cylinder by idling the car and disconnecting each fuel injector one at a time - everything was as it should be.
2. Used my spark tester (OTC 6589) and tested each coil in turn (yes I had the tester connected to battery negative using a battery booster cable). Each sparked strong and correct colour.
3. Pulled all spark plugs and checked them for cracks, carbon tracks and electrode gap, all were fine.
4. Did a dry compression test.
- Uh oh , 2 cylinders (3 and 4) were @ 115 psi, 1 and 2 were at 150 psi (which is also low as standard spec for 2zrfe notes it should be between 157 and 199).
5. Did a wet compression test
- cylinders 3 and 4 now ended up at 150 Psi so that indicates worn rings or pistons?
6. I didn't bother with the fuel injector testing as it looks like the problem is with compression...
So, first, is my diagnosis correct? Could it be a bad head gasket?
Second, is there something in my procedure above that I could have done wrong? The car was warm but not hot. I pulled all spark plugs before starting testing. I didn't take much time between plug holes.
Third, other than rebuilding or replacing engine, are there other options or am I out of luck?
My 2009 corolla recently started producing a brief metallic sound (less than a second) when i start in a cold morning. I noticed that when I warm up my battery (by starting the heat ventilator or other electrical equipment) for 10-20 seconds the car starts normally. The other thing I noticed that I have some white powder deposits on the top of my battery. There is no any other changes in the way my car runs.
View 2 RepliesI have a 2010 Corolla S Got it brand new in november of 2009. Its been 5 years since I had it and never had this problem.
So this has been happening for a month now, and I can't figure out what it is? It only sounds at first startup of the day when the engine is cold and only sounds off for 1 second right when you start the car.
Corolla has this code : B1801
When i erase it comes right back!
Open in (D) Squib Circuit. What to start looking for?
I just purchased a used 2010 Toyota Corolla with Airbag Light ON (not blinking). Yes car was in an accident, but Air Bags did not deployed as per the seller. It needs to re-calibrate by Dealer.
As a novice, and avid Toyota person, since it's a good deal I decided to take the car with the airbag lights on. I have seen on youtube, the cause is likely the spiral cable.
A squirrel chewed through some wires in my 2009 Toyota Corolla. My left headlight went dim and my airbag light came on, all within a matter of days. I had the wires repaired and the airbag light never went off. I waited for months until I found out that my airbags won't deploy if I am in an accident. I did some research and from what I gathered until the problem is fixed the light will remain on, (Problem cannot be reset).
I took it to the same guy who fixed the wires .The code that came up was a faulty module. He said since my bags did not deploy the module most likely tripped and he could try to reset it. He tried to do it manually and by the SRS reader with no luck and told me I should go to a shop with a more advanced reader so they could try to reset the module and if that doesn't work go to Toyota.
Can this problem be reset? If it is reset how do I know there still is not a problem that needed to be fixed?
The warning light on the dash is on that shows the seatbelt and airbag. What does tis mean as the book only says to take it to a dealer.
View 2 RepliesI'm trying to remove the airbag so I can get to the steering wheel lights to change them. I took the covers off of each side of the steering wheel, expecting to find T30 torx screws to take off so that I can remove the airbag, but there seem to be no screws at all holding it in! Am I missing something here? Will have pictures in a couple minutes.
Not sure why my pictures aren't working, here are the links :
[URL] ....
[URL] ....
I have seen a lot of threads about air coming from the glove box, I have the same problem. So I open up the glove box and see directly above the cabin filter there are three openings that should be covered with a mesh material. This material has broken and fallen off completely. What is the reason why I couldn't just tape them up, does the material have to be porous?
View 7 Replies2011 corolla ... My AC have not been working well lately and it's been incredibly hot out here in so cal.
The problem: AC takes a while to blow out cold air. It blows as if it was a fan, instead of AC... even at max. Ive let it run for about 30 mins, and no luck. Just a hot air blowing fan with the AC light on. It would get slightly cold at times, but it isn't enough for me.
I took my car to the dealership a couple of weeks ago with this concern... and they said they could not find any problems, and that it was working properly, blowing cold air at 44 degrees.
I've looked at the car myself to see if i could find any possible culprits... a refrigerant leak came to mind, or it may need to be recharged... but i could not see it.
In colder climates have frost on the inside of the glass first thing in the morning?
View 3 RepliesHaving this issue? Should I have it look at? Or is this normal?
View 11 RepliesI do have an issue with a 2010 Toyota Corolla A/C. It is not blowing any cold air, just ambient air.
Try troubleshooting it by checking the freon on the low port. Reading was very high so it seems like the compressor clutch is not engaged. However, in reading up about 2010 version, I found there is actual no physical compressor clutch. There is also no "relay" to bypass such that you can engage the clutch. Reading further seems to indicate that it's a solenoid system, which I'm not familiar with.
I hear a loud screeching noise (like a loose belt) when the 2009 Corolla starts cold. It disappears, and when the car gets a little warmer, it's gone. I had the belt replaced, made no difference. Car runs fine, otherwise.
View 3 RepliesWhen it is cold out or wet my serpentine belt squeals a lot or a couple of minutes. It had progressively gotten worse this past winter. The shop said the belt looks fine and Toyota wants me to pay for them to look at it...
View 2 RepliesI posted a few weeks ago about the 2009 Corolla XE that I purchased from a Toyota dealer with 95,500 miles. Within days a buying the car it began to make a brief loud rattle on cold starts. People on this forum directed me to the VVT and they were right on. The car came with a 60 day warranty so they replaced the timing gear at no cost to me problem solved.
Now several weeks later, last night when I got out of the car with the engine running I heard a pretty loud noise that sounded like one valve very out of adjustment. This morning when I started the car the noise was no longer there but when I checked the oil it was a quart low. I have put about 1800 miles on the car since I bought it and the oil was changed at the dealer right before I bought it. I thought it being low on oil might be causing the noise. I took the car to the dealer and explained everything, the put a quart of oil in it and said to bring it back in about 1000 miles to check it out.
When I got back home the noise was there again so I guess being low on oil wasn't the cause. In terms of oil consumption the service rep said Toyota considers up to 1.1 quarts per 1200 miles to be normal oil consumption. This sounds like a lot to me.
And in terms of the noise that sounds like a loose valve I'm beginning to think it had something to do with the work they did to replace the timing gear. What would make this noise come and go? Doesn't seem to be any relationship to operating temp or how long the engine has been running.
So I guess I have two problems, potentially an oil consumption problem and a intermittent loud noise that I don't like the sound of. My power train warranty expires Nov 19.
And do the valves on 2009 are adjustable, the service rep said they were auto adjust?
I've run into a very strange whining noise in the mornings on my 2010 Corolla S.
I've done some diagnosis and the issue only occurs when it gets chilly out (below about 50 degrees). When you go out to the car in the AM with things dead cold and turn the key into the run position before you start it the noise starts up right under the dash on what sounds like the passenger side. I've tried the fan on and off and it doesn't seem to affect it. It does seem to be lasting longer and it really sounds like a bad bearing in a small motor. As the car warms up the noise disappears and doesn't reappear unless it cools down all the way, which usually means it has to sit overnight.
It doesn't seem to affect how the car runs so I'm guessing it's not a primary system, likely something with climate control or AC?