So the grind in 3rd gear is getting pretty bad. I have to put it into third slowly and 4th sometimes grinds a bit. Could it be the slave or master cylinder?
View 8 RepliesI have a 2010 S with 70,000 miles. At 60,000 miles, just after the warranty ran out on me, I started to get a gear grinding noise for approximately one second immediately following a cold startup. It doesn't happen all the time, but I'd say once out of every eight starts on cold mornings after it's been sitting. I researched the issue pretty extensively and it seems to narrow down to the cam timing gear being the issue or a bad starter relay. The 2009's had a TSB for the issue being a cam timing gear, but the dealer assures me that my vehicle is not one of the ones covered by the TSB.
I'm inclined to try the relay fix, since a new relay is only $60. The thing is, I would hate to install the part and find out that the issue remains and then be out $60. Any identical relay elsewhere in the car that I can swap it with to see if that work. Of course, if the relay is bad, I'd be breaking something else possibly. Or, even better, is there a way to test the relay to see if is the cause of the problem?
My Toyota corolla 2011 started to shift a bit hard from first gear to second gear and sometimes it feels a bit like choking since November of last year after I started to commute about 38 miles to work. It happens when I am taking off and going straight and it doesn't happen when I am turning left or right. I have taken it to the dealer once, they reset the transmission computer, but it still felt the same and the way the other gears shift felt a bit differently.
I have seen a similar complaint about the same issue of gear shift from first to second in the NHTSA website and another forum with the same issue with a 2009 corolla with a seemingly loose motor mount.
So ever since I bought my car in April, I hear this noise when I accelerate. It only happens when I first start the car. Its a grinding light noise but you can definitely hear it when you are in the car. I only hear it when after I start the car, go reverse, and right after I step on the gas on drive. Today I took it in for my 10k service and told the Assistant Service Manager about it. We went and took my car for a test drive and now we also hear the noise right after we he start the car then reverse.
View 11 RepliesI have a 2009 Corolla with 67k on the odometer so it is outside of warranty. I recently found about the TSB for the grinding noise on start up and took the car to my mechanic to have it looked at. He said he wasn't able to do the job because he would have to do some sort of computer update (ECU reflash?) and he doesn't have the means.
My car is currently at the dealership, and they want around 1800 dollars, 1400 for the VVTI gear, and another 400 for a tensioner. I have a friend who used to be a Toyota mechanic, and he says he can do the work as stated in the TSB, but he's unsure if the ECU would need updating, and it does not mention anything in the TSB. So what I am wondering is if :
1. Does changing the VVTI gear actually fix the grinding noise? I was reading an old thread where members said it was still there after having the TSB done.
2. Does there need to be anything done to the ECU after doing the TSB?
I have a 2009 corolla S. no warranty. 59k miles. my car gets a grinding noise whenever i start it. this is the example of the sound.
YouTube ....
I've been having this issue with my 2009 Toyota Corolla for some time now. When I turn the car on, there is a noise coming from under the hood that sounds like a screeching/grinding noise. I have captured the noise in this video: [URL] ....
It happens most times I turn my car on in the morning, after it has been sitting off and untouched for the night. When I am turning the car on afterwards throughout the day, the noise is less likely to appear.
I recently took my car in and got the water pump and belt replaced, because a few months ago I was driving down the highway and I heard a similar noise coming from under the hood, and I opened the hood and red coolant liquid was splashed everywhere. I am not knowledgeable about cars at all, but the dealership replaced the water pump and the belt and that seemed to fix that issue, but the grinding noise upon ignition is still there.
I took it into the dealership, but they were not able to replicate the issue because it had not been the first time the car was turned on for the day, so there was no grinding noise. I would like to know if it is the water pump or belt, since those are still under a 2 year warranty with the dealership. Otherwise, I need to know what this is so I can get it fixed.
We got a 15 F150 yay for her but I got stuck with her 113k.
So the engine makes a chain grinding sound on cold start ups and the tranny is slipping pretty hard.
Can I swap a 2.4 with a 5spd without doing a bunch of wiring?
Sometimes when I start my car it makes a weird cranking/grinding noise for half a second. The closest thing I have to engine mods are my TWM short shifter, and my borla axle back exhaust.
The noise only happens after my car has been sitting there, parked for a few hours. So to bring it to Toyota/mechanic would be nearly impossible to replicate, unless I left it there for a while. And even then, the noise only happens sometimes.
Yes I'm pressing my clutch pedal all the way down. No I am not holding the key too long when starting the car. What it might be?
I performed brake maintenance today with my brother on my 2010 corolla CE, my front rotors were warped and my pads were used ( and also uneven) and I replaced both front rotors and pads.
The install went smoothly, my brother changed a couple of brakes sets and knew what he was doing and showed me up.
Took it for a spin, the brakes work very nicely ( i bought the ceramic wagner bundle ) but theres a slight grinding noise when driving, like the pads are touching and rubbing a bit too much on the rotor, but the driving is unnafected. Also, there's a sqealing noise coming from either side when you turn only.
Braking itself produces no noise whatsoever, only when you turn that it squeals.
I have a question about my 2009 Toyota corolla. About a week ago it was pretty cold out and when I started my car and I heard a grinding type noise for just a split second and it was over. It never did it again after that. Well I went to start my car yesterday and it will not start or even turn over. The dash doesn't light up, the head lights, radio, windows are door locks will not work. The battery was checked and it's fine. My husband is thinking that it maybe the ignition switch. Does this sound right?
View 3 Replies...... 2010 Corolla LE 1.8L ...... View the video I uploaded ....... The noise is seems to be getting worse. My first thought is the bearings in the water pump may have failed. I'm also thinking that there isn't adequate lubrication near the gear assembly or the belt. Could there be a problem with the tension in the belt?
View 7 RepliesWhere is the Air Filter? How do you access it? 2011 LE
View 4 RepliesI just got a 2011 corolla le with 45k miles and the gas millage is terrible. I have a 2005 acura rsx and I drive about 20 miles a day and I can go a whole month without refilling. I Put in half a tank in our corolla and only got 115 miles out of it. I drive the same way I do in my acura which Is pretty fuel efficient. My car tells me I am getting 27 mpg. But if I calculated correctly (115miles /7 gallons= about 1 8 mpg, my acura will get nearly twice that millage. What do you think I need to do. I've only put 500-1000 miles on it and not sure when the last tune up was. Should I take it to Toyota?
View 7 RepliesI have the 1.8L engine with automatic transmission and when I start my car, it has a loud grinding sound that lasts about 3-5 seconds. The Initial rpm after you start the car also idles around 1800-2200 rpm for almost 10 seconds before it goes back to 1000rpm.
The high idling also stops if you shift it into Drive (D) or Reverse (R) but in Neutral (N) it will jump back up to the high idle.
This started occuring november of last year. At first I took it to dealership but they could not diagnose it because they never heard the sound. It ONLY happened when it was cold below 30 F, but recently it has been becoming MORE and MORE frequent and now almost happens everytime I start the car. But it won't happen if the outdoor temperature is above 60 degrees or if I start the car shortly after I shut the engine off (like a 2-3 hour break in between).
I thought it might be a loose flywheel, bad torque convertor, or a faulty electronic throttle control system. I do NOT think it is the starter because it starts everytime even on the coldest of days just that the grinding sound is annoying.
Having an issue with 2nd gear in their automatic trans. I find that 1st pulls great, but then it shifts and just feels bogged down until it gets out of 2nd, and then it feels free again in 3rd and 4th. Wondering if this could be a problem with the transmission itself or if it just needs the shift points re-tuned?
View 2 RepliesI have a 2009 Toyota Corolla and it's making a loud grinding metallic noise on the front left side. It does it while I drive the faster I go the louder it gets. When I turn to the left it makes it louder, when I turn right the noise decreases. PG&E have been breaking the roads by where I live and there's a lot of little rocks I drive thru. I'm wondering if that's the problem?? What do I do?
View 4 RepliesI noticed while driving my car there was a unusual rumble or grinding sound coming from my drivers side front wheel well. I get out and look I see a bunch of Fluid all over my wheel well. I look around turn my wheel around and see this fluids all on my rotors and suspension. Ive noticed couple weeks back the boots on the struts were ripped in two pieces from deteriorating or dry rotting (this was on both sides) and ive also been hearing some odd squeaking sound for over 15k miles every once in a while going over big bumps or train tracks. Struts go out at only 80k miles on their corolla? Yeah struts do usually lose their life around 60-80k miles but I've never seen them leak around that many miles. Is this a common issue?
View 5 Replies2011 Corolla S 1.8L 4 speed a/t
I have noticed that when my car shifts from second into third gear at around 50 km/hr that the rpm drops twice. It shifts (almost seemingly to a 2.5 gear) and the rpm drops and then a second later it's like it shifts again and the rpm drops again, is this torque converter lock up I am experiencing?
This also usually happens when I give it light throttle and not when I am heavily accelerating.
I have a 2010 Corolla S that I bought new. It has a manual transmission, 19k miles and I have not had any problems until recently. Let me start by saying I've been driving a manual for over 20 years so I know how to drive them.
That night, in 1st gear it rolled out of my driveway. My driveway has a mild incline that the car has been parked on for a year this way with no problems. When I went to pull it back on it gave me trouble starting as if the starter got stuck but did not engage with the motor. Once started I pulled it back on and noticed that every few seconds it rolls back a couple inches then stops and holds for 15-20 seconds then rolls again.
It does this until it finds a flat spot to land on. Everytime its parked on my driveway now it wont stay there. Now before you tell me to use the p-brake, which by the way is the dealerships solution, let me remind you that the car has been parked in this spot everyday for a year with NO issues until last week.
Since this started I've been using the p-beake but I want to know why its doing this all of a sudden.
Clear water comes into car my Corolla 2011 on drivers side and both the passenger and drivers rear floor panels. I checked and not coming from the body. Think it's from A/C but it's a lot of water. Front passenger side is bone dry. Looks like it may be coming from the center console and spreading out. Could the A/C evaporator drain be plugged. If so where do I find the hose?
View 11 Replies