Corolla / Matrix 2009-13 :: 2010 Cruise Control Installation Different Than 2007 Vehicle?
Dec 27, 2012
I installed an aftermarket cruise (Rostra) in my manual 2007 Corolla. Other than cutting the hole for the stalk the only real difficulty was getting my fat hands up under the dash to install the clutch disconnect switch. It certainly didn't involve any wire cutting or messing around with the ECM.
It's a long story, but through a sequence of events I have to opportunity to buy a 2010 base Corolla 5 speed at a pretty good deal. It also doesn't have a cruise control. I went tot eh Rostra website just to make sure cruise units are available and I looked at the installation instructions. Unless I read the wrong sheet, their instructions make it seem like installing cruise on a 2010 involves messing with the ECM wiring harness, moving connectors and a bunch of scary stuff like that.
It seems strange to me that the older car would be "plug and play" but a newer one would need changes to the main wiring harnesses. I'm not talking about a steering wheel mounted system where the clock spring has to be replaced, just a basic cruise.
View 2 Replies
Advertisement
I'm at my wit's end trying to install cruise control in my 2009 Corolla. I thought it was a relatively easy install, but then after putting the airbag in place, I find that the horn no longer works. I test out the cruise control, and the green "Cruise" lights up on the dashboard..but it doesn't actually work.
View 9 Replies
Here is the deal I have an autocross event coming up this weekend, and a 2010 corolla with traction control. How can I disable the traction control for more than just a few seconds? It is strange that when I hit the button after about 15 seconds the traction control comes back on.
View 12 Replies
Temp control is stuck, but when it reaches over 55 degrees or so, it goes back to normal. Have a very slight clicking sound/feel when it is normal. Toyota wants 10 hours labor up front.
View 1 Replies
I have a 2012 Corolla S and I'm trying to install footwell LED lights that are wired to the dome light, which wires do I need to tap in order to make this happen and how do I tap them correctly/safely?
View 2 Replies
How to install an amp to the factory radio?
View 14 Replies
I really want to put Viper into my car, the remote start and security system. I was thinking about putting in the 5901 or 5704 in, is there a difference?
Should I get the extra accessories like the audio sensor and tilt sensor? And I'll probably need a transponder bypass module with it too?
View 4 Replies
Installing a remote engine start on corolla? 2013 Corolla with G key specifically.
View 13 Replies
I just got my bc extreme drop kit installed, after taking out struts i imagined my corolla would be lighter and faster cuz the struts weigh way more than the coilovers, but when i drove it for first time after install, i noticed the acceleration is weaker and not as responsive, why this is? is it supposed to be like that, whats happening?
View 5 Replies
I have a 2012 corolla le and I'm looking into getting TRD lowering springs as I don't want to go too low and they work with the stock strut, however; I read that they work best with the XRS' shock and strut (might be just the strut but I'm not sure), my question is what are the XRS' struts called and where would I find them, also from what year would the XRS' struts fit on my le?
View 3 Replies
Had snow tires on separate rims without pressure sensors installed today. Service rep said that the tire pressure warning light will come on and stay on. However I rode car home and the warning light did not stay on after the initial engine start up. Is this a problem and a concern, or a good thing ?
View 2 Replies
I was looking to lower my 2012 Corolla after seeing torres 16 running 18x10 all around on his car. I fell in love with his Corolla and have been craving to do something similar. Now here's the flip side. I am absolutely clueless about the in-and-outs of stance work or being "slammed". I was thinking running 18x10 all around is a bit too much and was looking to run 18x9.5 Grids - if I could find them new. I'd like to sit "flush." What offset would be recommended? From what I saw on wheeldude, they only come in +20 or +38. Would this be possible on BC coilovers? I'd like to achieve a look similar to Jzen 16 or torres 16. Would I be better off running an air suspension setup? The downfall is they get ridiculously costly.
View 14 Replies
I am trying to install interior led light strips under my driver and passenger side. I connected to wire to my front fog lights fuse. But when I connect the negative wire to a metal part the light turns on and doesn't turn off unless i take it off. I want to make the lights turn on when i turn on the fog lights. How can I do this / what did i do wrong. I am do this in a 2009 corolla S.
View 2 Replies
I have a 2009 Corolla LE. I've had these issues since buying the car last year. Issue #1 : when initially accelerating from a stop through 1st and 2nd gears, there's a slight vibration felt through the steering wheel and vehicle. If it's just a gentle acceleration it typically doesn't aggravate the issue as much as a quicker acceleration. Issue #2 : This car is very sensitive to varying types of road conditions. One patch of road can seem smooth as silk. Then another patch will feel rough and bumpy. The road appears to have no bumps or imperfections. I just put brand new tires on the other day, and its still doing this. And I feel all of the road imperfections the most through the steering wheel. I'll briefly take my hands off the steering wheel to see if I feel it in the cabin, and its not as bad as it is through the steering wheel.
View 9 Replies
My daughters '09 Corolla was shaking and misfiring occasionally. When she took it to the shop the mechanic had it for a couple days and after many attempts finally reproduced the issue. After several diagnostics tests they determined it to be a damaged cylinder. We had the option of
1. replacing the engine
2. retooling it
I called around to a couple other mechanics and they told me the same thing. One particular mechanic (no affiliated with Toyota) told us that he had heard this happening on both the Camry and the Corolla. Sound like a manufacturer issues if it's been seen frequently.
View 5 Replies
My car is now 24/7 with this error which is Vehicle Speed Sensor malfunction an there seems to be no way of solving it, symptoms are:
*Speedometer not working, needle always in 0
*Power steering not working
*Car wont past 3rd gear
*Check engine light and power steering light on
I checked all 4 speed sensors and the wiring looks good and they look good. Also if i hit a bump, issue goes away for a couple of minutes, until i hit another, etc, so looks like a wire or short circuit, cant tell. Is there a speed sensor on the transmission as well? where is located?
View 1 Replies
I have a corolla 2009 and i noticed a whistle or a chirping sound every time i tap the gas pedal or if i cruise around 2000-2500 rpm , it looks like it's coming around the air intake.
View 5 Replies
I want to disable that beep beep sound when you lock or unlock the vehicle with the remote. Does this can be disable?
On my previous Nissan Altima, you can toggle this feature by pressing the lock+unlock simultaneously. I tried that on the Corolla, it does not work.
View 14 Replies
I've got an 09 XRS. Every time I slide it in a corner the thing beeps to tell me I've slid and the traction control (or whatever they call it) has engaged. I know I can turn it all off but sometimes I don't want to come to a complete stop and sit there holding the button for 5 seconds, I just want to drive and don't really care if I slide around and get "saved" by my car. This morning I was driving in about 6" of fresh pud (heavy snow) on the road and it was driving me nuts. All I really want to do is make it stop beeping, it keeps waking my wife up. Is it possible to shut the damned thing up?
View 8 Replies
Alright so I have an 09 Corolla sport and cannot find the traction control button. I feel extremely stupid but I just can't find it..
View 2 Replies
Is it would be possible or easy to upgrade the wiper control in the S to the variable int. wipers in some other models? I tried doing a search but I didn't see this subject ever being brought up.
View 14 Replies
