The oil light on my 2005 Chrysler Town & Country comes on when started when it is cold outside. It stays on until I turn the key off and restart, then it goes out and does not come back on. My mechanic cannot find anything wrong. This only happens in cold weather, not in the summer.
View 15 RepliesThe oil light on my 2005 Chryler Town & Country comes on when started when it is cold outside. It stays on until I turn the key off and restart, then it goes out and does not come back on. My mechanic cannot find anything wrong. This only happens in cold weather, not in the summer.
View 10 RepliesMy Chysler Town and Country started fine on a morning when it was 9 degrees. (no garage, so it was out in the weather.) I let it run for a couple of minutes so things would begin to thaw and then I drove to work. It ran really rough. I figured that once it warmed up, it would smooth out, but it did not. Even after the weather warmed up into the 50's 5 days later, it still runs rough. Now, I am also getting a check engine light. What could be wrong?
View 3 RepliesI have A 2012 Chrysler T&C purchased new Sept. 2012. At times heat comes from one side and cold from the other. Varies which side is cold or hot. Had problem from start and Chrysler said was working on solution. Had back to dealer many times with no fix. Warm weather came, no problem. Cold weather now here and same problem. Chrysler's fix was turn heat control all the way up then back down.
View 3 RepliesBought new oct.2012. Fiirst time used heat blows cold from one side hot from other. not consistent, will vary from left cold, then hot from right or the opposite. been fighting with chrysler from then till now. engineers know problem exists and are working on a fix. haven't found it yet. contacted chrysler numerous times, just get passed from one to another.
View 2 RepliesMy 2008 Chrysler Town & Country has, since it was 2 mos. old, had a "no-start" problem. This is not a stalling problem. It happens when the car is off and I try to turn it on. The problem is very sporadic (sometimes several times a day - I do lots of short drives - sometimes several times over the course of a few weeks, then no problems for months). When I turn the key in the ignition, all electrical components come on (dashboard lights, air, radio, etc.) but nothing happens with the engine (it does not make a sound). The dealer has replaced a computer component, the battery, the starter, the electronic keys but the problem always happens again (within a few days of it the "repair"). I usually have to turn the key 3-12 times (sometimes I take it out of the ignition, sometimes I pray!) and eventually the engine starts. Because the problem is sporadic, the dealer has not been able to replicate the problem (though they have, at times, had it for a week or more and even driven it as if it were their own, home at night, to work, to run errands). Although the car eventually starts, it is very problematic when I have to be somewhere and it takes 10 minutes (not to mention a lot of worrying) to get it started.
View 3 Replieshave a 1999 town and country that wont start from time to time. some times it starts right up and starts right up for months.some times starts and then go to start it again it just won't start . dosent even make a sound. all the lights and radio etc. working, and its been to numerous times to the repair shop. each time at the repair shop it starts right up and when they put it on the diagnostic computer , the diagnostics says nothing is wrong.
it's a brand new battery, and when we took the battery to the auto parts store they checked it and said the battery is charging and then discharging in a cycle.just got back from the chrysler dealer repair and they put the diagnostic computure on it and it says nothing is wrong.
i live in tucson, az and when the temp is 105F outside and i buy ice and frozen things is when the town and country decides it dosent wanta start
My 1991 Town & Country will sporadically fail to start. e.g. I start and drive the vehicle,( this may be a short distance or a longer distance) I stop somewhere, I go to start the vehicle and nothing. No amount of tinkering will cause it to once again start. I wait for maybe 10 to 20 minutes and it starts. (Sometimes this can actually take many hours.) Seems to be worse when the weather is very hot. (What I know: There is fuel at the fuel rail. I have used a gauge and the pressure is correct at the fuel rail. There is no power whatsoever at the coil packs yet the Automatic Shutdown Relay is working correctly.) I have replaced the PCM and still the same problem. One time I started the vehicle, drove 200 feet and it stalled out completely. That just happened the one time. Finally, It seems to have gotten more frequent in its stalling behavior.
View 3 RepliesUsed 2000 Town & Country is a great ride EXCEPT it occasionally will not start. All the electrical systems work except the starter does not activate. No connection to temp. Happens when cold or when hot. Sometimes cuts off when running and will not start. With the ignition in run position prior to starting, the check engine light does not light up and starter doesn't work. When in run and the check engine light comes on the starter will work and starts easily.
Sometimes in run position the check engine light is flashing and starter will activate for split second before light and starter quit. It's gone for months without happening and I fantasize that it has miraculously healed itself then it will happen once, or perhaps daily for a week. Sometimes wait +/- 1/2 hour and it cranks right up. Sometimes it won't crank for a day. Have replaced computer twice, various sensors (cam shaft sensor?...I'm not a mechanic) Our very competent mechanic won't let us bring it near his shop.
I have a 99 Town & Country that occasionally has a starting problem that has stumped my otherwise excellent mechanic. Every once in awhile when I start my van it kills right away. Even if I rev the engine with the gas pedal it kills immediately. It will do that 3-5 times, then when I turn the key nothing will happen, no click no dash lights, nothing. Often if I let it sit at that point for a few hours it will start and run fine.
The alternator was changed two years ago in an attempt to fix this problem and the starter was just replaced a few months ago.
I have a 2008 Chrysler Town & Country with all the bells and whistles. About a year ago started with a strange problem. When you started the car these things happened: The windshield wipers would start flapping, the windows would be locked, fan on the heating system would go to full blast while the temperature would reset to 72 degrees and the automatic doors would not work. The problem is intermittent and seems to be worse on hot days. My mechanic was lost on this and sent us to the dealer. The dealer said it was the radio/DVD system? That didn’t sound right so I had them just disconnect the system to see first if it corrected the problem. Hooked the system back up. Now the DVD doesn’t work and still have the problem. We have tried turning off the car and unhooking the battery. this stops it sometimes. Then we found that just resetting the the temperature would straighten it out (sometimes and temporarily). The car has been doing great for the past 6 months (fall and winter) and now started doing it again.
View 19 RepliesMy 96 Town and Country won't start. It turns over and fires for about 1-2 seconds max. After that it only turns over, no fire. The key sign/symptom is that the odometer and PRNL do not light up. This is very sporadic. Sometimes months and months apart. I unhook the battery in an effort to reset the computer. Sometimes it works in 1/2 hr. Sometimes several hours. So I don't think it resets but I still do it anyway. I have replaced the computer but no luck. Could it somehow be the dash cluster?
View 8 Repliesi have a 2005 Town & Country that now won't turn over. When I just turn the key to the on position (not even to start) the gauges flip around, the odo flashes intermittently as if there's some kind of short, and i can hear a regular, repetitive clicking from an area behind the battery that sounds like an electrical relay of some sort trying to engage but failing. Short history that may be related: I recently replaced the blower motor resistor since the AC blower would stop after about 10 min of driving. (Btw, replacing the resistor worked for a while, then failed again, so something else is going on).
I had disconnected the battery when I replaced the resistor and then 5 days later the car wouldn't start. It's 2 year old battery, so I assumed there was corrosion on the terminal and I had not reconnected it tightly enough. At that time, a quick jumpstart got it going again. A couple days later, it wouldn't start again, would only "click" when turning the key (e.g. starter solenoid). Now, it won't even do that, just this repetitive relay sound and the "short-circuit" appearance on the gauges/readouts. At least it's in my garage!
We have had an engine light that comes on when it is wet out. (Usually from rain) Until recently, the codes were not stored in memory. The last time we tried this, there was a 420 code set. Our mechanic said it was the catalytic converter. This vehicle is a 2006 and only has a 100,000 miles on it. Neither of the oxygen sensors have been replaced. The car doesn't seem to run any differently when the engine light comes on.
View 10 RepliesI am the 2nd owner of a 2001 Chrysler Town and Country Minivan Limited. The vehicle is in very good shape and I service it every three months and have the tires rotated every six months.
Just recently I have been having a problem with it not wanting to start. I have had a bit of a squeal coming from the engine compartment and know it is the serpentine belt that needs to be changed out before it gets bad (I have only heard the squeal probably three times since December 2012.)
I would rather buy my parts and have the mechanic put them on instead of him buying them and charging me double.
My question is...do you think it is only my belt or should I think in the direction of the Starter or something else. After about threee or four tries it will finally start.
I recently picked up a 2003 chrysler town and country from a local GM dealer in central MN. After filling out the paperwork etc I was on my way home and the transmission made a loud CLUNK. I thought I must be imagining things. At the next intersection as I accelerated from the light "CLUNK". I called the dealer right away and they stood behind the van. The dealer had me bring it to the transmission shop covering all expenses. They fixed it, or so they said. We had it for a few days and had similar problems. Back to the transmission shop. They then completely went through the transmission. We got it back and again had issues... this time it was a slight shudder in the transmission as you slowly accelerated. I brought it back again. They replaced the torque convertor. I've only had it back for a few days and it still has an occasional slight shudder under slow acceleration... it usually happens around 30mph.
View 10 RepliesI am about an hour and a half from home at my cousins when my oil light came on. It only comes on when I have come to a complete stop. Once I accelerate it goes away. I checked the dipstick and it is full. Here is my question: what do you think this could be and would it be safe to drive home to my trusted mechanic. The car has 160,000 miles on it.
View 5 RepliesWhile driving idle seemed to increase. Noticed at red lite where van seemed to want to move forward with brakes applied. Went to parking lot put van in park engine RPM rose to around 2500 RPM on it's own. Opened hood and fiddled around with a wire???/hose thing near the throttle control line (wire that connects foot piece to engine). A bunch of black powder (carbon?) fell out. Turned the van off then back on a couple of times. On the third time idle returned to normal and has operated normal since. What caused this? What do I tell my mechanic? What was the wire/tube thing (it entered what I assume is the air intake at a right angle) right in front of where the wire from the foot control hooks up.
View 1 Replies2007 Chrysler Town and Country, 123k.
It's had an intermittent airbag light for a few weeks now. When it does come on, it stays on until the car is shut off. When I turn it back on, sometimes it comes on and sometimes it doesn't. Sometimes it comes on at startup and sometimes it comes on in the middle of driving. I took it into the shop when the light was off and the shop said whatever's wrong with it, it wasn't storing the code and to run it back in when the light is on.
Since yesterday, the fuel has been overflowing at fill up. I get maybe a half gallon in and then it overflows. I can hear it glug-glugging in when I pull out the gas hose. The flap at the neck of the tank seems to have gone missing too.
I have a 2003 Chrysler Town & Country and the check engine light is on. I brought the van to my mechanic and he told me there was a code that told him there was a misfire on cylinder #1. He started out with replacing the wire to cylinder #1, no change. He replaced the spark plug, no change. He installed a new fuel injector, no change. The van runs a little ruff at idle and when at a stop light.
View 9 Replies2007 Chrysler Town & Country with 74K. The check engine light comes on and the parts store diagnostic says P0404, a clogged EGR valve. On my model, replacing the EGR valve involves taking out the alternator, which involves removing the passenger wheel. That's beyond my skill set.
So, can I just replace the EGR tube and pour some Sea Foam motor treatment directly into the EGR? Would that hurt anything?